Anionic surfactants separation

Boiani, J. A., Spectator ion indirect photometric detection of aliphatic anionic surfactants. separated by reversed-phase HPLC, Anal. Chem., 1987,59, 2583-2586. 

An unknown commercial detergent may contain some combination of anionic, nonionic, cationic, and possibly amphoteric surfactants, inorganic builders and fillers as weU as some minor additives. In general, the analytical scheme iacludes separation of nonsurfactant and inorganic components from the total mixture, classification of the surfactants, separation of iadividual surfactants, and quantitative determination (131). 

Many platiag plants use electrocleaners both anodicaHy and cathodicaHy through the use of reversing switches or ia two separate tanks. Not all anionic surfactants do well ia cathodic cleaning. Proprietary electrocleaners are commonly used and highly recommended. 

Nonionic surfactants, including EO-PO block copolymers, may be readily separated from anionic surfactants by a simple batch ion exchange method [21] analytical separation of EO-PO copolymers from other nonionic surfactants is possible by thin-layer chromatography (TLC) [22,23] and paper chromatography [24], and EO-PO copolymers may themselves be separated into narrow molecular weight fractions on a preparative scale by gel permeation chromatography (GPC) [25]. 

Naphthalenedisulfonate-acetonitrile as the only mobile phase with a silica column coated with a crosslinked aminofluorocarbon polymer has proven to be an effective combination for the separation of aliphatic anionic surfactants. Indirect conductivity and photometric detection modes are used to monitor these analytes. The retention of these surfactants is found to depend on both the ionic strength and the organic solvent content of the mobile phase. The mechanism of retention is considered to be a combination of both reverse phase and ion exchange processes. Selective separation of both alkanesulfonates and... 

A sensitive determination of alkanesulfonates combines RP-HPLC with an on-line derivatization procedure using fluorescent ion pairs followed by an online sandwich-type phase separation with chloroform as the solvent. The ion pairs are detected by fluorescence. With l-cyano-[2-(2-trimethylammonio)-ethyl]benz(/)isoindole as a fluorescent cationic dye a quantification limit for anionic surfactants including alkanesulfonates of less than 1 pg/L per compound for a 2.5-L water sample is established [30,31]. 

The ion pair extraction by flow injection analysis (FIA) has been used to analyze sodium dodecyl sulfate and sodium dodecyl ether (3 EO) sulfate among other anionic surfactants. The solvating agent was methanol and the phase-separating system was designed with a PTFE porous membrane permeable to chloroform but impermeable to the aqueous solution. The method is applicable to concentrations up to 1.25 mM with a detection limit of 15 pM [304]. 

The amount of residual sulfonate ester remaining after hydrolysis can be determined by a procedure proposed by Martinsson and Nilsson [129], similar to that used to determine total residual saponifiables in neutral oils. Neutrals, including alkanes, alkenes, secondary alcohols, and sultones, as well as the sulfonate esters in the AOS, are isolated by extraction from an aqueous alcoholic solution with petroleum ether. The sulfonate esters are separated from the sultones by chromatography on a silica gel column. Each eluent fraction is subjected to saponification and measured as active matter by MBAS determination measuring the extinction of the trichloromethane solution at 642 nra. (a) Sultones. Connor et al. [130] first reported, in 1975, a very small amount of skin sensitizer, l-unsaturated-l,3-sultone, and 2-chloroalkane-l,3-sultone in the anionic surfactant produced by the sulfation of ethoxylated fatty alcohol. These compounds can also be found in some AOS products consequently, methods of detection are essential. 

MacMillan and Wright [133] identified and measured saturated and unsaturated 1,3- and saturated 1,4-sultones in anionic surfactants by a series of separation maneuvers. Ion exchange treatment separates sultones from the bulk of the ionic surfactant. TLC concentrates the sultones systems for HPLC analysis. They found that pentane-ether is preferable to the usual hexane-ether system and that the addition of a little methanol sharpens the separations. Finally, HPLC using a micro-Porasil column with 90 1 isooctane/ethanol provides quali-... 

Fatty alcohol- (or alkyl-)ethoxylates, CoE, are considered to be better candidates for LLE based on their ability to induce rapid phase separation for Winsor II and III systems. (Winsor III systems consist of excess aqueous and organic phases, and a middle phase containing bicontinuous microemulsions.) However, C,E,-type surfactants alone cannot extract biomolecules, presumably because they have no net negative charge, in contrast to sorbitan esters [24,26,30,31]. But, when combined with an additional anionic surfactant such as AOT or sodium benzene dodecyl sulfonate (SDBS), or affinity surfactant, extraction readily occurs [30,31]. The second surfactant must be present beyond a minimum threshold value so that its interfacial concentration is sufficiently large to be seen by... 

CE has been used for the analysis of anionic surfactants [946,947] and can be considered as complementary to HPLC for the analysis of cationic surfactants with advantages of minimal solvent consumption, higher efficiency, easy cleaning and inexpensive replacement of columns and the ability of fast method development by changing the electrolyte composition. Also the separation of polystyrene sulfonates with polymeric additives by CE has been reported [948]. Moreover, CE has also been used for the analysis of polymeric water treatment additives, such as acrylic acid copolymer flocculants, phosphonates, low-MW acids and inorganic anions. The technique provides for analyst time-savings and has lower detection limits and improved quantification for determination of anionic polymers, compared to HPLC. 

From the characteristics of the methods, it would appear that FD-MS can profitably be applied to poly-mer/additive dissolutions (without precipitation of the polymer or separation of the additive components). The FD approach was considered to be too difficult and fraught with inherent complications to be of routine use in the characterisation of anionic surfactants. The technique does, however, have a niche application in the area of nonpolar compound classes such as hydrocarbons and lubricants, compounds which are difficult to study using other mass-spectrometry ionisation techniques. 

At the termination of the activity period, each participant s hands were held over a bowl and doused with 250 mL of a dilute dioctyl sodium sulfosucci-nate (anionic surfactant) mixture. This soap wash was followed by a 250-mL rinse with deionized water. The soap and water fractions were stored together in the same container. Fifteen grams of sodium chloride were added to the container to facilitate phase separation. The chlorpyrifos was partitioned with 200 mL of ethyl acetate, which was also used to rinse the bowl. The ethyl acetate extract was later analyzed for chlorpyrifos content. The amount of test substance removed was used to assess adult hand exposures and dose and also to assess the theoretical amount of test substance removed when children put their hands in their mouths. 

High-efficiency separations of FQ-labeled proteins are only achieved in the presence of an anionic surfactant, such as SDS. As a result, capillary isoelectric focusing is not useful for the analysis of these proteins. Instead, we employ capillary sieving electrophoresis and micellar electrokinetic capillary chromatography for our two-dimensional electrophoresis. 

Surfactants, not surprisingly, exert a highly significant influence on the fluorescence of FBAs in solution. This effect is associated with the critical micelle concentration of the surfactant and may be regarded as a special type of solvent effect. Anionic surfactants have almost no influence on the performance of anionic FBAs on cotton, but nonionic surfactants may exert either positive or negative effects on the whiteness of the treated substrate [33]. Cationic surfactants would be expected to have a negative influence, but this is not always so [34]. No general rule can be formulated and each case has to be considered separately. 

Phase separation in polyion complexed mixed monolayers containing HC cationic and anionic surfactants and a FC anionic surfactant studied by SPMs and SIMS... 

Another possibility is to perform CE separation in electrolytes containing high amounts of organic solvents and anionic surfactants (SDS), based on the formation of association complexes between analytes and SDS without micelle formation. As shown in Fig. 2.2.5, SDS concentrations of 40-100 mmol L 1 and acetonitrile contents of... 

The recent use of HPLC for the analysis of sulfophenyl carboxylates (SPCs) has been one of the most interesting applications of this technique for the study of the environmental behaviour of anionic surfactants. SPCs are separated by reversed-phase ion-paired chromatography, in which a hydrophobic stationary phase is used and the mobile phase is eluted with aqueous buffers containing a low concentration of the counter-ion [19]. 

In 1998, UOP announced the development of a new Sorbex process called the MMP Sorbex process [15-19] that was capable of simultaneously separating both Cio i6 mono-branched paraffins and Cio i6 normal paraffins from a corresponding kerosene stream or n-paraffin-depleted Molex raffinate stream. Previously, no commercial process existed to isolate significant quantities of mono-methyl paraffin derived from either kerosene or n-paraffin depleted kerosene. Mono-methyl paraffins are desirable because they are needed for a new type of anionic surfactant. 

In MEKC, mainly anionic surface-active compounds, in particular SDS, are used. SDS and all other anionic surfactants have a net negative charge over a wide range of pH values, and therefore the micelles have a corresponding electrophoretic mobility toward the anode (opposite the direction of electro-osmotic flow). Anionic species do not interact with the negatively charged surface of the capillary, which is favorable in common CZE but especially in ACE. Therefore, SDS is the best-studied tenside in MEKC. Long-chain cationic ammonium species have also been employed for mainly anionic and neutral solutes (16). Bile salts as representatives of anionic surfactants have been used for the analysis of ionic and nonionic compounds and also for the separation of optical isomers (17-19). 

---