Aminations palladium® acetate

Tributyl amine, palladium acetate, triphenyl phosphine from Fluka AG and N,N-dimethylformamide and formic acid from Farmitalia Carlo Erba Chemicals were used without further purification. 

Tetrakis(tripheiiylphosphine)palladium(0) is often used for this reaction. However, Pd(II) complexes such as bis(triphenylphosphine)palladium dichloride or palladium acetate are also commonly employed for convenience, as they are stable in ah. The base is typically a secondary or tertiary amine such as triethy-lamine. Weak bases such as sodium (potassium) acetate, bicarbonate, or carbonate are also used. 

The Suzuki reaction has been successfully used to introduce new C - C bonds into 2-pyridones [75,83,84]. The use of microwave irradiation in transition-metal-catalyzed transformations is reported to decrease reaction times [52]. Still, there is, to our knowledge, only one example where a microwave-assisted Suzuki reaction has been performed on a quinolin-2(lH)-one or any other 2-pyridone containing heterocycle. Glasnov et al. described a Suzuki reaction of 4-chloro-quinolin-2(lff)-one with phenylboronic acid in presence of a palladium-catalyst under microwave irradiation (Scheme 13) [53]. After screening different conditions to improve the conversion and isolated yield of the desired aryl substituted quinolin-2( lff)-one 47, they found that a combination of palladium acetate and triphenylphosphine as catalyst (0.5 mol %), a 3 1 mixture of 1,2-dimethoxyethane (DME) and water as solvent, triethyl-amine as base, and irradiation for 30 min at 150 °C gave the best result. Crucial for the reaction was the temperature and the amount of water in the... 

In this way, the consecutive reactions to give higher amines in the aqueous phase are avoided in contrast, these reactions are unavoidable in the homogeneous one-phase catalysis. The catalyst system consists of palladium acetate/tppts dissolved in water the second phase is an organic solvent such as toluene. 

Vinyl iodides are considerably more reactive than bromides in the vinylations. It may be presumed that chlorides are not generally useful, with one exception noted below, since they have not been employed in the reaction. The bromides are usually reacted with a palladium acetate-triphenyl- or tri-o-tolyl-phos-phine catalyst at about 100 C. The reaction will occur without the phosphine if a secondary amine is present. Vinyl iodides will react in the absence of a phosphine even with only a tertiary amine present.48 37 The iodides are so reactive, in fact, that reactions occur even at room temperature if potassium carbonate is the base and tetra-zi-butylammonium chloride is used as phase transfer agent in DMF solution when palladium acetate is the catalyst.88... 

Palladium catalysts that are free of halide ions effect the dimerization and carboxylation of butadiene to yield 3,8-nonadienoate esters. Palladium acetate, solubilized by a tertiary amine or an aromatic amine, gives the best yields and selectivities (equation 57).87 Palladium chloride catalyzes the hydrocarboxylation to yield primarily 3-pentenoates.88 The hydrocarboxylation of isoprene and chloroprene is regio-selective, placing the carboxy function at the least-hindered carbon (82% and 71% selectively) minor amounts of other products are obtained (equation 58). Cyclic dienes such as 1,3-cyclohexadiene and 1,3-cyclooctadiene are similarly hydrocarboxylated. 

Palladium acetate triarylphosphine complexes catalyze the addition of vinylic groups from vinylic halides to olefinic compounds in the presence of amines. Conjugated dienes are major products from 0,/3-unsaturated acids, esters, or nitriles while unactivated olefinic compounds react best in the presence of secondary amines where allylic amines are major products. The reactions are usually regio- and stereospecific. The synthetic utility of the reaction is illustrated with a wide variety of examples. 

This palladium-catalyzed three-component coupling reaction leading to the formation of aryl-substituted allylic amines was recently adapted to solid-phase synthesis (Scheme 8.23). Amines were chosen to attach to a solid support (Rink resin) in this three-component coupling process and were reacted with a variety of aryl halides and linear or cyclic non-conjugated dienes, the reaction being carried out at 100 °C for two days in the presence of palladium acetate and diisopropylethyl-amine. A wide variety of aryl-substituted allylic amines were then obtained after cleavage from the solid support by trifluoroacetic acid [60],... 

Over 35 years ago, Richard F. Heck found that olefins can insert into the metal-carbon bond of arylpalladium species generated from organomercury compounds [1], The carbopalladation of olefins, stoichiometric at first, was made catalytic by Tsutomu Mizoroki, who coupled aryl iodides with ethylene under high pressure, in the presence of palladium chloride and sodium carbonate to neutralize the hydroiodic acid formed (Scheme 1) [2], Shortly thereafter, Heck disclosed a more general and practical procedure for this transformation, using palladium acetate as the catalyst and tri-w-butyl amine as the base [3], After investigations on stoichiometric reactions by Fitton et al. [4], it was also Heck who introduced palladium phosphine complexes as catalysts, enabling the decisive extension of the ole-fination reaction to inexpensive aryl bromides [5],... 

A dry two-neck flask was charged with amine (1.00 mmol), triflate or bromide (1.20 mmol), base (1.40 mmol), ligand (10 mol%), palladium acetate (Pd(OAc)2) or tris-(dibenzylidene-acetone)dipalladium (0) (Pd2dba3) (5 mol%), and toluene (2.00 mL/mmol of amine). The reaction was flushed with N2 and heated at 80 °C. The mixture was diluted with ether, filtered through a pad of Celite, and the volatile components were removed reduced pressure to give a crude product, which was purified by flash column chromatography on silica gel. 

Results on the amination of pyridyl halides conducted with two phosphine ligands and two different palladium precursors have been published (Table 2) [123]. The most general palladium precursor proved to be palladium acetate. Again, BINAP was found to be generally effective for amination with either primary or secondary amines. However, yields were lower with unbranched primary amines than those with branched amines, such as cydo-... 

The catalyst formed from 6 and palladium acetate mediates the reaction between a large number primary amines and aryl chlorides as room temperature, Eq. (105) [42a, 48]. This catalyst enjoys an even wider substrate scope, however, when the transformation is performed at elevated temperatures. Additionally, elevated temperatures allow for the use of mild bases in the C-N bond forming reaction. 

Among the nucleophiles that add exo to coordinated dienes are aUcoxides, amines, azide, acetates, halides, and stabilized carbon enolates, such as malonates and /3-diketones. The alkoxide addition is reversible if the product is treated with HCl. With a few nucleophiles, double addition reactions are observed. Acetate will react with 1,5-cod in the presence of Pb(OAc)4 and palladium salts to give a bicyclic product from addition of two acetate groups, both exo (equation 43). 

Three-component additions, comprising two conjugated diene molecules and a nucleophile, can be catalyzed by palladium salts, such as palladium acetate. The major products are 1-substituted 2,7-octadienes, along with minor amounts of 3-substituted 1,7-octadienes (equation 65). Water, alcohols, phenols, carboxylic acids, and amines are some of the nucleophiles that have been used in this reaction. 

Commercially available palladium compounds in the presence of various ligands have often been used as catalysts (Table 3-1). The first choice is often the air-stable and relatively inexpensive palladium acetate however, several of the other published variants can be preferable in certain applications. It is commonly assumed that the palladium(II) species is reduced in situ by the solvent, the alkene [11], the amine [12] or the added ligand (frequently a phosphane, which is oxidized to a phosphane oxide) [13]. In some cases, highly dispersed elemental palladium on charcoal can be applied. In the case of alkenyl or aryl bromides, phosphanes are necessary to avoid precipitation of palladium black (c.f., however. Section 3.2.4.), whereas iodides have been reported to be less reactive in the presence of phosphanes. Triflates have been found to be more reactive in the presence of chloride ions, as the chloride ligand is more easily removed from palladium than the tiiflate ion [14], However, this also has become questionable, because successful coupling reactions of alkenyl triflates have been performed in the absence of chloride ions [15]. 

An S—P-type chiral phosphinooxathiane was developed as an effective ligand for palladium-catalyzed allylic substitution reactions [131]. A polymer-supported chiral phosphinooxathiane 208 was also prepared and applied to asymmetric alkylations and aminations of acetate 201 [132]. Enanhoselechvihes of up to 99% ee were obtained in asymmetric Pd-catalyzed allylic amination of acetate 201 using the polymeric catalyst prepared from a PS-diethylsilyl support (Scheme 3.68). 

This paragraph details carbazole syntheses that involve the formation of new bonds to nitrogen. A direct C-H functionalization/amination of 2-acetaminobiphenyl compounds give carbazoles in one step <05JA14560>. For example, treatment of biphenyl 130 with palladium acetate and copper(II) acetate gave carbazole 131. A short s)mthesis of carbazoles involved the reductive cyclization of 2-nitrobiphenyl compounds mediated by triphenylphosphine... 

---