Isolated yield

The percentages cited in the preceding equation reflect the composition of the monochloride fraction of the product mixture rather than the isolated yield of each component... 

The yield cited in this reac tion IS the isolated yield of purified product Isomeric bromides constitute only a tiny fraction of the product... 

An asymmetric synthesis of estrone begins with an asymmetric Michael addition of lithium enolate (178) to the scalemic sulfoxide (179). Direct treatment of the cmde Michael adduct with y /i7-chloroperbenzoic acid to oxidize the sulfoxide to a sulfone, followed by reductive removal of the bromine affords (180, X = a and PH R = H) in over 90% yield. Similarly to the conversion of (175) to (176), base-catalyzed epimerization of (180) produces an 85% isolated yield of (181, X = /5H R = H). C8 and C14 of (181) have the same relative and absolute stereochemistry as that of the naturally occurring steroids. Methylation of (181) provides (182). A (CH2)2CuLi-induced reductive cleavage of sulfone (182) followed by stereoselective alkylation of the resultant enolate with an allyl bromide yields (183). Ozonolysis of (183) produces (184) (wherein the aldehydric oxygen is by isopropyUdene) in 68% yield. Compound (184) is the optically active form of Ziegler s intermediate (176), and is converted to (+)-estrone in 6.3% overall yield and >95% enantiomeric excess (200). 

The reaction was carried out on a 1.0-5.0 mmol scale. Determined by gas chromatography. Tetrakis(triphenylphosphine)palladiura was used, isolated yield. 

This remarkably selective internal epoxidation of peroxyarachidonic acid to form 14,15-oxido-arachidonic acid occurs as shown because of unusually favorable stereoelectronics. The corresponding reaction sequence with eicosa-(E)-8,ll,14-trienoic acid affords the Ai4,i5 epoxide in 94% isolated yield and >95% purity. 

In comparison with manganese dioxide, the DDQ reagent has several advantages for the oxidation of allylic alcohols. The quinone method is more reproducible only one equivalent of oxidant need be added and generally fewer side reactions are observed. On the other hand, the workup of DDQ reactions often requires chromatography and in the simpler cases lower isolated yields may be realized. 

In radical reactions not involving bromine or chlorine on the substrate, rearrangements are much rarer One example is the fluorination of di-tert butyl ketone which produces perfluormated / rt-buty isobutyl ketone [J5] Although isolated yields are poor only the rearranged ketone could be isolated This is perhaps only the second example of a 1,2-acyl shift Low fluorine substrate ratios show that this rearrangement occurs after monofluorination... 

Cyclic sulfates rapidly react with the fluoride ion sources to give monofluoro derivatives Thus, the 2,3-cyclic sulfate of methyl-4 6 O benzylidene p D manno pyranoside cleanly reacts with tetramethylammonium fluoride to give methyl 4,6-0-benzylidene 2 deoxy 2 fluoro-p-D-glucopyranoside-3-sulfate Acid hydrolysis followed by acetylation gives 2 deoxy 2 fluoro-P-D-glucopyranoside triacetate in 84% isolated yield [5S] (equation 38)... 

Unless otherwise noted, a shghl excess of halogen and three-fold excess of KF was used NMR yield versus PhCF3 When two values are given, the second value is the isolated yield Products were identified either by spiking with an authentic sample or by combinanon of IR and mass spectra data of the isolated products. 

GLC yield is based on thermal conductivity corrections reladve to an appropriate internal standard. Product identity was confirmed by comparison of F NMR, H NMR, IR, and/or mass spectra with those of authentic samples prepared by alternative routes when possible Yields are based on ylide Isolated yields are given m parentheses. 

Yields were determined by %NMRvs benzomfluonde, isolated yields are given in parentheses All products exhibited spectral data in accord with the assigned structure and gave satisfactory elemental analyses... 

A Ester treatment first with DIBAL and then with [(C2H50)2P(0) CFC02C2H5], B ester added to a solution of [(C2H50)2P(0) CFC02C2H5] and then reduced by DIBAL. Isolated yields are based on R cOOR ... 

To a solution of 0 01 mol of lithium hexamethyldisilazide and 0 01 mol of HMPA dissolved in 50 mL of anhydrous THF at 78 °C was added 0 5 g (0 004 mol) of l-fluoro-3,3-dimethylbutanone m THF over 1 mm To the solution of the enolate was then rapidly added 0 003 mol of the aldehyde m THF After stimng an additional 2 mm, the reaction was quenched by rapid addition of a saturated ammonium chlonde soluuon Extractive workup with hexanes yielded on evaporation the product as a clear colorless oil isolated yield... 

The ability to perform the AE reaetion under eatalytie eonditions via the addition of moleeular sieves has greatly enhaneed the synthetie utility of the reaetion. For water-soluble epoxy aleohols, the eatalytie eonditions are benefieial for both enantioseleetivity and isolated yield. In addition, epoxy aleohols that are suseeptible to ring opening via nueleophilie substitution at the C-3 position also greatly benefit from eatalytie eonditions, sinee the substitution reaetion is known to be promoted by Ti(IV) speeies. 

In an analogous study by Meske, the impact of various oxazaborolidinone catalysts for the 1,3-dipolar cycloaddition reactions between acyclic nitrones and vinyl ethers was studied [31]. Both the diastereo- and the enantioselectivities obtained in this work were low. The highest enantioselectivity was obtained by the application of 100 mol% of the tert-butyl-substituted oxazaborolidinone catalyst 3d [27, 32] in the 1,3-dipolar cycloaddition reaction between nitrone la and ethyl vinyl ether 8a giving endo-9a and exo-9a in 42% and 27% isolated yield, respectively, with up to 20% ee for endo-9a as the best result (Scheme 6.10). 

The above described reaction has been extended to the application of the AlMe-BINOL catalyst to reactions of acyclic nitrones. A series chiral AlMe-3,3 -diaryl-BINOL complexes llb-f was investigated as catalysts for the 1,3-dipolar cycloaddition reaction between the cyclic nitrone 14a and ethyl vinyl ether 8a [34], Surprisingly, these catalysts were not sufficiently selective for the reactions of cyclic nitrones with ethyl vinyl ether. Use of the tetramethoxy-substituted derivative llg as the catalyst for the reaction significantly improved the results (Scheme 6.14). In the presence of 10 mol% llg the reaction proceeded in a mixture of CH2CI2 and petroleum ether to give the product 15a in 79% isolated yield. The diastereoselectiv-ity was the same as in the acyclic case giving an excellent ratio of exo-15a and endo-15a of >95 <5, and exo-15a was obtained with up to 82% ee. 

Wlien 0.5 equivalents of dialkylzinc were used, ees of mote than 9096 were obtained, with reasonable isolated yields of up to 38 96 [52] of the Su2 -suhstituted... 

The nib o-aldol reaction using l,l-diethoxy-2-nib oethane is useful for lengthening of the carbon chain of carbohydrates. The reaction of Eq. 3.86 proceeds in a stereoselective way (ds 75%) to give the syn-niho alcohol in 58% isolated yield.The product is converted into 2-amino-2-deoxyaldoses by reaction with Ha/Raney Ni. 

The chiral catalyst was made from Raney nickel, which was prepared by addition in small portions of 3.9 g Raney nickel alloy to 40 ml water containing9 g NaOH. The mixture was kept at 100 C for 1 h, and then washed 15 times with 40 ml water. Chirality was introduced by treatment of the Raney nickel for I h at lOO C with 178 ml water adjusted to pH 3.2 with NaOH and containing 2g (S,S)-tartaric acid and 20 g NaBr. The solution was then decanted, and the modifying procedure was twice repeated. Hydrogenation over this catalyst of acetylacctone (100 atm, 100" C) in THF containing a small amount of acetic acid gave an isolated yield of chiral pentanediol of 44% (99.6% optical purity). 

Catalyst Solvenl Ratio (%) Isolated yields or amines (%)... 

---