Sludge, definition

Thermal treatment is used to destroy, break down, or aid in the desorption of contaminants in gases, vapors, Hquids, sludges, and soHds. There are a variety of thermal processes that destroy contaminants, most of which are classified as incineration. Incineration HteraHy means to become ash (from Medieval Latin, incinerare in or into ashes). With respect to the incineration of hazardous wastes regulated in the United States, however, there is a strict legal definition of what constitutes an incinerator. The Resource Conservation and Recovery Act (RCRA) definition of incinerator at 40 CFR 260.10 is... 

A definitive determination of the waste sludge production and the oxygen requirement can be obtained using the pseudo constants referred to previously. The ultimate BOD in the waste will be accounted for by the sum of the oxidation and sludge synthesis (Eq. 25-20). 

Depth tends to be determined from the retention time and the surface overflow rate. As surface overflow rates were reduced, the depth of sedimentation tanks was reduced to keep retention time from being excessive. It was recognized that depth was a valid design parameter and was more critical in some systems than retention time. As mixed-liquor suspended-solids (MESS) concentrations increase, the depth should also be increased. Minimum sedimentation-tank depths for variable operations should be 3.0 m (10 ft) with depths to 4.5 m (15 ft) if 3000 mg/L MESS concentrations are to be maintained under variable hydraulic conditions. With MESS concentrations above 4000 mg/L, the depth of the sedimentation tank should be increased to 6.0 m (20 ft). The key is to keep a definite freeboard over the settled-sludge blanket so that variable hydraulic flows do not lift the solids over the effluent weir. 

The characteristics of the pump relate the applied pressure on the cake to the flowrate at the exit face of the filter medium. The cake resistance determines the pressure drop. During filtration, liquid flows through the porous filter cake in the direction of decreasing hydraulic pressure gradient. The porosity (e) is at a minimum at the point of contact between the cake and filter plate (i.e., where x = 0) and at a maximum at the cake surface (x = L) where sludge enters. A schematic definition of this system is illustrated in Figure 2. 

Splash condenser dross residue. The treatment of steel production pollution control sludge generates a zinc-laden residue, called dross. This material, generated from a splash condenser in a high-temperature metal recovery process, is known as a splash condenser dross residue. Because this material contains 50 to 60% zinc, it is often reclaimed, reused, or processed as a valuable recyclable material. Facilities commonly handle this material as a valuable commodity by managing it in a way that is protective of human health and the environment, so U.S. EPA excluded this residue from the definition of solid waste. 

Potential environmental hazards from wastewater sludges are associated with trace constituents (e.g., chlorinated organic compounds) that partition from the effluent into the sludge. It should be noted, however, that recent trends away from elemental chlorine bleaching have reduced these hazards. A continuing concern is the very high pH (>12.5) of most residual wastes. When these wastes are disposed of in an aqueous form, they may meet the RCRA definition of a corrosive hazardous waste.24... 

The Subpart O standards apply to units that treat or destroy hazardous waste and which meet the definition of an incinerator. An incinerator is any enclosed device that uses controlled flame combustion and does not meet the criteria for classification as a boiler, sludge dryer, carbon regeneration unit, or industrial furnace. Typical incinerators1 2 3 include rotary kilns, liquid injectors, fixed hearth units, and fluidized bed incinerators (Table 23.1). The definition of an incinerator also includes units that meet the definition of an infrared incinerator or plasma arc incinerator. An infrared incinerator is any enclosed device that uses electric-powered resistance as a source of heat and which is not listed as an industrial furnace. A plasma arc incinerator is any enclosed device that uses a high-intensity electrical discharge as a source of heat and which is not listed as an industrial furnace. 

First we will look at some classical definitions and then at a derivation for the Activated Sludge Equations for ASMl Defining terms first ... 

Separation of the spent activated sludge microorganisms from the aeration basin effluent by either a conventional sedimentation clarifier (with 2 hours definition time... 

The term solid waste is a very comprehensive term that can be difficult to dehne precisely. The United States Code of Federal Regulations (Chapter 1, Part 261, of Title 40) provides the legal dehnition. That document dehnes solid wastes rather simply as "any discarded material that is not excluded by other provisions of the chapter. Those provisions refer primarily to liquid wastes, such as sludge and domestic wastewater. The U.S. Army provides a somewhat more detailed definition of the term "any garbage, refuse, sludge, or other discarded material resulting from industrial, commercial, institutional, and residential activity. Discarded materials include those that are disposed of, abandoned, recycled, or are inherently waste-like. ... 

By providing more information on the identity of mutagenic compounds, their frequency of occurrence, their possible source, and their levels in sewage treatment plant sludges, our research will assist in the definition of waste management practices. 

The discharge from both domestic and industrial wastewater treatment plants (for example, from activated sludge processes) has been a low-cost source of makeup for cooling systems for many years. Efforts to reuse water continue to gain momentum for environmental conservancy and economic reasons, but the fact that secondary use waters are, by definition, of a lower grade than other supply sources inevitably means an increased risk of deposition or fouling problems in the cooling system. 

Oily matrices (sludge, fuel-contaminated soil) may undergo multiple dilutions during analysis. The interferences from the oil constituents and the analytical uncertainty induced by dilutions may reduce the data obtained with definitive analytical methods to screening data. 

Without the Web, the satellite photographs of the affected zone wouldn t have been shown publicly, people wouldn t have been coordinated quickly to act as volunteers in the most affected zones, information wouldn t have gotten to the volunteers about how to handle the sludge he said. Definitely, the (role) of the Internet has been decisive. (Scheeres 2002)... 

The reason for the inefiiciency of these bacteria in utilizing amino acids is not definitely known however, it seems probable, as is the case with some of the carbohydrate-fermenting rumen bacteria (8, 33), that these materials are not transported effectively into the cell. It seems probable that, in their adaptation to the natural habitat, their abilities to utihze proteins and amino acids were of little survival value and were lost. It is well known that amino acids are present in very small amounts in extracellular fiuid of rumen contents while relatively high concentrations of ammonia and acetate and other volatile acids including 2-methylbutyrate are present (8). A similar condition probably exists in sludge although the volatile acids are usually present in lower concentration than in the rumen. 

---