Senses

The capital cost of most aqueous waste treatment operations is proportional to the total flow of wastewater, and the operating cost increases with decreasing concentration for a given mass of contaminant to be removed. Thus, if two streams require different treatment operations, it makes no sense to mix them and treat both streams in both treatment operations. This will increase both capital and operating costs. Rather, the streams should be segregated and treated separately in a distributed effluent treatment system. Indeed, effective primary treatment might mean that some streams do not need biological treatment at all. 

The term resonance has also been applied in valency. The general idea of resonance in this sense is that if the valency electrons in a molecule are capable of several alternative arrangements which differ by only a small amount in energy and have no geometrical differences, then the actual arrangement will be a hybrid of these various alternatives. See mesomerism. The stabilization of such a system over the non-resonating forms is the resonance energy. 

A completely updated edition of the well-known book by the author of The Mind. The clear and comprehensive text deals with everything from sex to the skeleton, sleep to the senses. 

Nevertheless, a molecule possesses sufficient vibrations so that all its frequencies taken together can be used to characterize it. In this sense the infrared spectrum is generally considered to be a molecule s fingerprint."... 

First of all, a technical clarification is necessary in the wider sense, motor fuels are chemical compounds, liquid or gas, which are burned in the presence of air to enable thermal engines to run gasoline, diesel fuel, jet fuels. The term heating fuel is reserved for the production of heat energy in boilers, furnaces, power plants, etc. 

Several parameters come into the relation between density and equivalence ratio. Generally, the variations act in the following sense a too-dense motor fuel results in too lean a mixture causing a potential unstable operation a motor fuel that is too light causes a rich mixture that generates greater pollution from unburned material. These problems are usually minimized by the widespread use of closed loop fuel-air ratio control systems installed on new vehicles with catalytic converters. 

Introduction and commercial application Safety and the environment have become important elements of all parts of the field life cycle, and involve all of the technical and support functions in an oil company. The Piper Alpha disaster in the North Sea in 1988 has resulted in a major change in the approach to management of safety of world-wide oil and gas exploration and production activities. Companies recognise that good safety and environmental management make economic sense and are essential to guaranteeing long term presence in the industry. 

The economic lifetime was introduced in Section 13.3, and was defined as the point at which the annual cashflow turned permanently negative. This is the time at which income from production no longer exceeds the costs of production, and marks the point when decommissioning should occur, since it does not make economic sense to continue to run a loss-making venture. Technically, the production of hydrocarbons could continue beyond this point but only by accepting financial losses. There are two ways to defer decommissioning ... 

At present time is the acoustic emission laboratory of the Institute of Design already equipped with modem analysers processing 4 and 16 AE sensors (each enables to sense up to 256 levels). All analysers have at disposal powerful computing technique and corresponding software. 

At contact fatigue tests of different steel and cast iron types was used the acoustic emission technique. Processed records from the AE analyser show importance of acoustic response of tested surface continuous sensing. In graphs are obvious characteristic types of summation curves, or may be from significant changes of AE signal course identified even phases of the wear process. 

Proc. SPIE Vol. 2766, March 1996 p. 185-201, Thermosense XVIII An International Conference on Thermal Sensing and Imaging... 

The SPATE 9000, used in the experimental activity, is a remote sensing system able to detect... 

Having set up the ultrasonic instrument (according to test specifications), the inspector scans the weld volume. Any indications subject to recording are interpreted and documented in a handwritten on-site report. The test report only describes the indications detected by the inspector, but not the completeness of the lest in the sense of a documented 100% volume testing as is the case with X-ray testing. 

BE-3246 Remote monitoring strain/extenslon using novel sensing element Or. Vlad Skarda ERA Tschnology Cleeve Road,... 

The scope of the directive covers the design, manufacture and conformity assessment of pressure equipment and assemblies with a maximum allowable pressure greater than 0,5 bar. A pressure equipment in the sense of the directive is any vessel, piping, safety accessory or pressure accessory. An assembly means several pieces of pressure equipment assembled by a manufacturer to constitute an integrated and functional whole. It is important to be aware that the directive relates exclusively to the pressure risk and that therefore other directives, such as for machinery, low voltage may be applicable to the equipment concerned. 

The topic of spreading rates is of importance in the technology of the use of mono-layers for evaporation control (see Section IV-6) it is also important, in the opposite sense, in the lubrication of fine bearings, as in watches, where it is necessary that the small drop of oil remain in place and not be dissipated by spreading. Zisman and coworkers have found that spreading rates can be enhanced or reduced by the presence of small amounts of impurities in particular, strongly adsorbed surfactants can form a film over which the oil will not spread [48]. 

Various kinds of potentials have been referred to in the course of this and the preceding chapter, and their interrelation is the subject of the present section. The chief problem is that certain types of potential differences are physically meaningful in the sense that they are operationally defined, whereas others that may be spoken of more vaguely are really conceptual in nature and may not be definable experimentally. 

Dislocation theory as a portion of the subject of solid-state physics is somewhat beyond the scope of this book, but it is desirable to examine the subject briefly in terms of its implications in surface chemistry. Perhaps the most elementary type of defect is that of an extra or interstitial atom—Frenkel defect [110]—or a missing atom or vacancy—Schottky defect [111]. Such point defects play an important role in the treatment of diffusion and electrical conductivities in solids and the solubility of a salt in the host lattice of another or different valence type [112]. Point defects have a thermodynamic basis for their existence in terms of the energy and entropy of their formation, the situation is similar to the formation of isolated holes and erratic atoms on a surface. Dislocations, on the other hand, may be viewed as an organized concentration of point defects they are lattice defects and play an important role in the mechanism of the plastic deformation of solids. Lattice defects or dislocations are not thermodynamic in the sense of the point defects their formation is intimately connected with the mechanism of nucleation and crystal growth (see Section IX-4), and they constitute an important source of surface imperfection. 

---