Peroxides rate constants

The first detailed investigation of the reaction kinetics was reported in 1984 (68). The reaction of bis(pentachlorophenyl) oxalate [1173-75-7] (PCPO) and hydrogen peroxide cataly2ed by sodium saUcylate in chlorobenzene produced chemiluminescence from diphenylamine (DPA) as a simple time—intensity profile from which a chemiluminescence decay rate constant could be determined. These studies demonstrated a first-order dependence for both PCPO and hydrogen peroxide and a zero-order dependence on the fluorescer in accord with an earher study (9). Furthermore, the chemiluminescence quantum efficiencies Qc) are dependent on the ease of oxidation of the fluorescer, an unstable, short-hved intermediate (r = 0.5 /is) serves as the chemical activator, and such a short-hved species "is not consistent with attempts to identify a relatively stable dioxetane as the intermediate" (68). 

Decomposition of diphenoylperoxide [6109-04-2] (40) in the presence of a fluorescer such as perylene in methylene chloride at 24°C produces chemiluminescence matching the fluorescence spectmm of the fluorescer with perylene was reported to be 10 5% (135). The reaction follows pseudo-first-order kinetics with the observed rate constant increasing with fluorescer concentration according to = k [flr]. Thus the fluorescer acts as a catalyst for peroxide decomposition, with catalytic decomposition competing with spontaneous thermal decomposition. An electron-transfer mechanism has been proposed (135). 

Fig. 2. Steps in advanced oxidation process (AOPs) involving o2one, hydrogen peroxide, and uv light of 254 nm. ( D) represents the doublet state ( ) represents quantum yield, and the other numbers associated with the reaction arrows are rate constants in units of (Af-s). Dashed arrows indicate...

The table below gives first-order rate constants for reaction of substituted benzenes with w-nitrobenzenesulfonyl peroxide. From these data, calculate the overall relative reactivity and partial rate factors. Does this reaction fit the pattern of an electrophilic aromatic substitution If so, does the active electrophile exhibit low, moderate, or high substrate and position selectivity ... 

An alternating copolymer of a-methyl styrene and oxygen as an active polymer was recently reported [20]. When a-methyl styrene and AIBN are pressurized with O2, poly-a-methylstyreneperoxide is obtained. Polymerization kinetic studies have shown that the oligoperoxides mentioned above were as reactive as benzoyl peroxide, which is a commercial peroxidic initiator. Table 1 compares the overall rate constants of some oligoperoxides with that of benzoyl peroxide. 

Table 1 Overall Rate Constants, k, of Some Peroxidic Initiators for Styrene Polymerization at 80 C...

Aliphatic acyloxy radicals undergo facile fragmentation with loss of carbon dioxide (Scheme 3,69) and, with few exceptions,428 do not have sufficient lifetime to enable direct reaction with monomers or other substrates. The rate constants for decarboxylation of aliphatic acyloxy radicals are in the range l 10xl09 M 1 s at 20 °C.429 lister end groups in polymers produced with aliphatic diacyl peroxides as initiators most likely arise by transfer to initiator (see 3.3.2.1,4). The chemistry of the carbon-centered radicals formed by (3-scission of acyloxy radicals is discussed above (see 3.4.1). 

Vichutinsky, "Chemiluminescent Methods for the Determination of the Absolute Magnitude of the Termination Rate Constants of Peroxide Radicals in the Liquid Phase , PA Tech Translation 66(1967) 17) R. Czerepinski G.H. 

More recently Minisci et al. (1986) compared the rate constants for phenylation of 4-cyanopyridine in the 2- and 3-positions by benzenediazonium ions, catalyzed by Cu+ and by Fe2+, with the rates of the same phenylations using benzoyl peroxide under similar conditions. The rate constants found for the phenylation steps were, within experimental error, the same. 

Heterogeneous rate constants, 12, 113 Hofmeister sequence, 153 Hybridization, 183, 185 Hydrodynamic boundary layer, 10 Hydrodynamic modulation, 113 Hydrodynamic voltammetry, 90 Hydrodynamic voltammogram, 88 Hydrogen evolution, 117 Hydrogen overvoltage, 110, 117 Hydrogen peroxide, 123, 176... 

The determination of A V is illustrated by data for the thermal decomposition of di-ferf-butyl peroxide.10 The rate constants at 120 °C in toluene are as follows ... 

A plot of the logarithm of the rate constant for the thermal decomposition of di-rm-butyl peroxide with pressure. The data, from Ref. 10, refer to a temperature of 120 °C in toluene. 

For benzoyl and acetyl peroxides, loss of carbon dioxide occurs in a stepwise process. Estimates of the rate constants for step c in Scheme 1 are 7 x 10 sec (benzene, 60°). The corresponding process for acetyl peroxide has k = 2x 10 sec (n-hexane, 60°), so that the lifetime of radical pairs containing acetoxy radicals is comparable to the time necessary for nuclear polarization to take place (Kaptein, 1971b Kaptein and den Hollander, 1972 Kaptein et al., 1972). Propionoxy radicals are claimed to decarboxylate 15-20 times faster than acetoxy radicals (Dombchik, 1969). 

HO-oxidation of an individual NMHCj produces H02 radicals with a yield aj, and oxidation of the NMHC oxidation product produces H02 in stoichiometric amount The lumped coefficients or yields a and p need not be integers, and represent the effectiveness of a particular NMHCj in producing RO2. and H02 radicals (lumped together as HO2) that will then oxidize NO. to N02 in processes such as R6 and R13, producing one net ozone molecule each. Alternatively, when the NO. concentration is low, peroxyl radicals may form PAN (as in R22) or hydrogen peroxide (as in R33) which are other oxidant species. In this formulation, transport is expressed by an overall dilution rate of the polluted air mass into unpolluted air with a rate constant (units = reciprocal time dilution lifetime=1// ). This rate constant includes scavenging processes such as precipitation removal as well as mixing with clean air. 

Uncertainties in Photochemical Models. The ability of photochemical models to accurately predict HO concentrations is undoubtedly more reliable in clean vs. polluted air, since the number of processes that affect [HO ] and [H02 ] is much greater in the presence of NMHC. Logan et al (58) have obtained simplified equations for [HO ] and [HO2 ] for conditions where NMHC chemistry can be ignored. The equation for HO concentration is given in Equation E6. The first term in the numerator refers to the fraction of excited oxygen atoms formed in R1 that react to form HO J refers to the photodissociation of hydrogen peroxide to form 2 HO molecules other rate constants refer to numbered reactions above. 

A strong acceptor TCNE undergoes [2+2] rather than [4+2] cycloaddition reactions even with dienes. 1,1-Diphenylbutadiene [20] and 2,5-dimethyl-2,4-hexadiene (Scheme 5) [21] afford mainly and exclusively vinyl cyclobutane derivatives, respectively. In the reactions of 2,5-dimethyl-2,4-hexadiene (1) the observed rate constant, is greater for chloroform solvent than for a more polar solvent, acetonitrile (2) the trapping of a zwitterion intermediate by either methanol or p-toluenethiol was unsuccessful (3) radical initiators such as benzyl peroxide, or radical inhibitors like hydroquinone, have no effect on the rate (4) the entropies of activation are of... 

Fukuzawa, K. et ah. Rate constants for quenching singlet oxygen and activities for inhibiting lipid peroxidation of carotenoids and alpha-tocopherol in liposomes. Lipids, 33, 751, 1998. 

If the rate constant kd for spontaneous decomposition of the initiator is known, the efficiency / of initiation may be determined. (This is a refinement of the molecular weight method set forth in Sec. Ic) The spontaneous decomposition rate of benzoyl peroxide in styrene, according to the work of Swain, Stockmayer, and Clarke is 3.2X10- sec. at 60°C. Hence the efficiency of initiation of the polymerization of styrene by benzoyl peroxide at 60°C is indicated to be about 0.60. 

Mouse peritoneal macrophages that have been activated to produce nitric oxide by 7-interferon and lipopolysac-charide were shown to oxidize LDL less readily than unactivated macrophages. Inhibition of nitric oxide synthesis in the same model was shown to enhance LDL oxidation (Jessup etal., 1992 Yates a al., 1992). It has recently been demonstrated that nitric oxide is able to inhibit lipid peroxidation directly within LDL (Ho etal., 1993c). Nitric oxide probably reacts with the propagating peroxyl radicals thus terminating the chain of lipid peroxidation. The rate constant for the reaction between nitric oxide and peroxyl radicals has recently been determined to be 1-3 X10 M" s (Padmaja and Huie, 1993). This... 

Literature data for the suspension polymerization of styrene was selected for the analysi. The data, shown in Table I, Includes conversion, number and weight average molecular weights and initiator loadings (14). The empirical models selected to describe the rate and the instantaneous properties are summarized in Table II. In every case the models were shown to be adequate within the limits of the reported experimental error. The experimental and calculated Instantaneous values are summarized in Figures (1) and (2). The rate constant for the thermal decomposition of benzoyl peroxide was taken as In kd 36.68 137.48/RT kJ/(gmol) (11). 

The accepted kinetic scheme for free radical polymerization reactions (equations 1-M1) has been used as basis for the development of the mathematical equations for the estimation of both, the efficiencies and the rate constants. Induced decomposition reactions (equations 3 and 10) have been Included to generalize the model for initiators such as Benzoyl Peroxide for... 

The Instantaneous values for the initiator efficiencies and the rate constants associated with the suspension polymerization of styrene using benzoyl peroxide have been determined from explicit equations based on the instantaneous polymer properties. The explicit equations for the rate parameters have been derived based on accepted reaction schemes and the standard kinetic assumptions (SSH and LCA). The instantaneous polymer properties have been obtained from the cummulative experimental values by proposing empirical models for the instantaneous properties and then fitting them to the cummulative experimental values. This has circumvented some of the problems associated with differenciating experimental data. The results obtained show that ... 

The data given below are typical of the polymerization of vinyl phenylbutyrate in dioxane solution in a batch reactor using benzoyl peroxide as an initiator. The reaction was carried out isothermally at 60 °C using an initial monomer concentration of 73 kg/m3. From the following data determine the order of the reaction and the reaction rate constant. Note that there is an induction period at the start of the reaction so that you may find it useful to use a lower limit other than zero in your integration over time. The reaction order may be assumed to be an integer. 

Scheme 2 Bolland-Gee scheme of free radical oxidation of polymer pH. P denotes macromolecular chain, InH is chain-breaking inhibitor, D peroxide decomposer and parameters above arrows are the corresponding rate constants.

The set of the rate constants k determined for experimental runs of Figure 15 and their comparison with the rate constants of hydroperoxide decomposition determined by other methods may be seen in Table 3. When we take into account that PPs of different origin were examined, the agreement seems quite satisfactory. This agreement is valid for faster decomposing peroxides, which are the species determining the resulting rate of oxidation [49]. 

---