Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Organic solvents procedures

Figure 13. Preparation of immobilized enzymes with different solubilities in aqueous solutions and organic solvents. Procedure A mixture of an enzyme (3 mg) and the polymer (10 mg) was incubated at pH 7.5 for 20 min. Ammonium phosphate (0.1 M, pH 7, 1 mL) was then added to react with the remaining active ester. After 20 min, the solution was ready for use, or lyophilization to give the immobilized enzyme as a powder to be used for reaction in organic solvents. Each gram of the polymer contains approximately 0.7 mmol of the active ester. Figure 13. Preparation of immobilized enzymes with different solubilities in aqueous solutions and organic solvents. Procedure A mixture of an enzyme (3 mg) and the polymer (10 mg) was incubated at pH 7.5 for 20 min. Ammonium phosphate (0.1 M, pH 7, 1 mL) was then added to react with the remaining active ester. After 20 min, the solution was ready for use, or lyophilization to give the immobilized enzyme as a powder to be used for reaction in organic solvents. Each gram of the polymer contains approximately 0.7 mmol of the active ester.
Methods of preparing ultrapure reagents in the laboratory have been described in detail by Ziefand Mitchell (1976) and Howard and Statham (1993). This section therefore presents only the basic techniques for easily purified reagents such as, in addition to water, hydrochloric and nitric acid, ammonia solution, and some organic solvents. Procedures for the purification of special reagents will be outlined in the chapters of the book where analytical methods are described in detail. [Pg.261]

Endo-exo product mixtures were isolated using the following procedure. A solution of cyclopentadiene (concentration 2-10" M in water and 0.4 M in oiganic solvents) and the dienophile (concentration 1-5 mM) in the appropriate solvent, eventually containing a 0.01 M concentration of catalyst, was stirred at 25 C until the UV-absorption of the dienophile had disappeared. The reaction mixture (diluted with water in the case of the organic solvents) was extracted with ether. The ether layer was washed with water and dried over sodium sulfate. After the evaporation of the ether the... [Pg.67]

In a second attempt to extend the scope of Lewis-acid catalysis of Diels-Alder reactions in water, we have used the Mannich reaction to convert a ketone-activated monodentate dienophile into a potentially chelating p-amino ketone. The Mannich reaction seemed ideally suited for the purpose of introducing a second coordination site on a temporary basis. This reaction adds a strongly Lewis-basic amino functionality on a position p to the ketone. Moreover, the Mannich reaction is usually a reversible process, which should allow removal of the auxiliary after the reaction. Furthermore, the reaction is compatible with the use of an aqueous medium. Some Mannich reactions have even been reported to benefit from the use of water ". Finally, Lewis-acid catalysis of Mannich-type reactions in mixtures of organic solvents and water has been reported ". Hence, if both addition of the auxiliary and the subsequent Diels-Alder reaction benefit from Lewis-acid catalysis, the possibility arises of merging these steps into a one-pot procedure. [Pg.114]

A number of organic compounds, eg, acetylacetone [123-54-6] and cupferron [135-20-6] form compounds with aqueous actinide ions (IV state for reagents mentioned) that can be extracted from aqueous solution by organic solvents (12). The chelate complexes are especially noteworthy and, among these, the ones formed with diketones, such as 3-(2-thiophenoyl)-l,l,l-trifluoroacetone [326-91-0] (C4H2SCOCH2COCF2), are of importance in separation procedures for plutonium. [Pg.220]

Thiosulfate titration of iodine is limited to an iodine concentration of 7.5 fig/mL (69). The use of organic solvents such as benzene, toluene, chloroform, and carbon tetrachloride as indicators in the titration of iodine have been proposed (70—72). These procedures increase the sensitivity of the titration so that 6.0 fig/mL of iodine can be detected, although a sensitivity of 2 fig/mL has been claimed (73). [Pg.364]

Latexes of synthetic resins are identified by ir spectrometry. Selective extraction with organic solvents is used to obtain purified fractions of the polymers for spectrometric identification. Polymeric films can be identified by the multiple internal reflectance ir technique, if the film is smooth enough to permit intimate contact with the reflectance plate. TAPPI and ASTM procedures have not been written for these instmmental methods, because the interpretation of spectra is not amenable to standardization. [Pg.11]

Isolation. Isolation procedures rely primarily on solubiHty, adsorption, and ionic characteristics of the P-lactam antibiotic to separate it from the large number of other components present in the fermentation mixture. The penicillins ate monobasic catboxyHc acids which lend themselves to solvent extraction techniques (154). Pencillin V, because of its improved acid stabiHty over other penicillins, can be precipitated dkecdy from broth filtrates by addition of dilute sulfuric acid (154,156). The separation process for cephalosporin C is more complex because the amphoteric nature of cephalosporin C precludes dkect extraction into organic solvents. This antibiotic is isolated through the use of a combination of ion-exchange and precipitation procedures (157). The use of neutral, macroporous resins such as XAD-2 or XAD-4, allows for a more rapid elimination of impurities in the initial steps of the isolation (158). The isolation procedure for cephamycin C also involves a series of ion exchange treatments (103). [Pg.31]

Polyethers are usually found in both the filtrate and the mycelial fraction, but in high yielding fermentations they are mosdy in the mycelium because of their low water-solubiUty (162). The high lipophilicity of both the free acid and the salt forms of the polyether antibiotics lends these compounds to efficient organic solvent extraction and chromatography (qv) on adsorbents such as siUca gel and alumina. Many of the production procedures utilize the separation of the mycelium followed by extraction using solvents such as methanol or acetone. A number of the polyethers can be readily crystallized, either as the free acid or as the sodium or potassium salt, after only minimal purification. [Pg.171]

AH volatile organic solvents are toxic to some degree. Excessive vapor inhalation of the volatile chloriaated solveats, and the central nervous system depression that results, is the greatest hazard for iadustrial use of these solvents. Proper protective equipment and operating procedures permit safe use of solvents such as methylene chloride, 1,1,1-trichloroethane, trichloroethylene, and tetrachloroethylene ia both cold and hot metal-cleaning operations. The toxicity of a solvent cannot be predicted from its chlorine content or chemical stmcture. For example, 1,1,1-trichloroethane is one of the least toxic metal-cleaning solvents and has a recommended threshold limit value (TLV) of 350 ppm. However, the 1,1,2-trichloroethane isomer is one of the more toxic chloriaated hydrocarboas, with a TLV of only 10 ppm. [Pg.507]

The variety of enzyme-catalyzed kinetic resolutions of enantiomers reported ia recent years is enormous. Similar to asymmetric synthesis, enantioselective resolutions are carried out ia either hydrolytic or esterification—transesterification modes. Both modes have advantages and disadvantages. Hydrolytic resolutions that are carried out ia a predominantiy aqueous medium are usually faster and, as a consequence, require smaller quantities of enzymes. On the other hand, esterifications ia organic solvents are experimentally simpler procedures, aHowiag easy product isolation and reuse of the enzyme without immobilization. [Pg.337]

Dissociation extraction is the process of using chemical reac tion to force a solute to transfer from one liquid phase to another. One example is the use of a sodium hydroxide solution to extract phenolics, acids, or mercaptans from a hydrocarbon stream. The opposite transfer can be forced by adding an acid to a sodium phenate stream to spring the phenolic back to a free phenol that can be extrac ted into an organic solvent. Similarly, primary, secondary, and tertiary amines can be protonated with a strong acid to transfer the amine into a water solution, for example, as an amine hydrochloride salt. Conversely, a strong base can be added to convert the amine salt back to free base, which can be extracted into a solvent. This procedure is quite common in pharmaceutical production. [Pg.1450]

Development of extraction-free photometric procedures for the determination of traces of metals for which hygienic and environmental regulations have been established is an urgent problem. For solution of this problem we used as an organic reagent l-(2- pyridylazo)-naphtol-2 (PAN) which forms intensely coloured complex compounds with many metals and is frequently used for their extraction-photometric determination however these procedures did not find wide application in water analysis due to lack of selectivity and necessity of using organic solvents. [Pg.199]

The aqueous micellai solutions of some surfactants exhibit the cloud point, or turbidity, phenomenon when the solution is heated or cooled above or below a certain temperature. Then the phase sepai ation into two isotropic liquid phases occurs a concentrated phase containing most of the surfactant and an aqueous phase containing a surfactant concentration close to the critical micellar concentration. The anionic surfactant solutions show this phenomenon in acid media without any temperature modifications. The aim of the present work is to explore the analytical possibilities of acid-induced cloud point extraction in the extraction and preconcentration of polycyclic ai omatic hydrocai bons (PAHs) from water solutions. The combination of extraction, preconcentration and luminescence detection of PAHs in one step under their trace determination in objects mentioned allows to exclude the use of lai ge volumes of expensive, high-purity and toxic organic solvents and replace the known time and solvent consuming procedures by more simple and convenient methods. [Pg.422]

Metal impurities can be determined qualitatively and quantitatively by atomic absorption spectroscopy and the required purification procedures can be formulated. Metal impurities in organic compounds are usually in the form of ionic salts or complexes with organic compounds and very rarely in the form of free metal. If they are present in the latter form then they can be removed by crystallising the organic compound (whereby the insoluble metal can be removed by filtration), or by distillation in which case the metal remains behind with the residue in the distilling flask. If the impurities are in the ionic or complex forms, then extraction of the organic compound in a suitable organic solvent with aqueous acidic or alkaline solutions will reduce their concentration to acceptable levels. [Pg.53]

The mechanism of cyclization of diaminopyrimidines by nitrous acid appears not to have been studied in detail. For the preparative procedure an aqueous solution of alkaline nitrite is treated with the diaminopyrimidine either in the form of a salt or with simultaneous addition of hydrochloric or acetic acid. The first phase of the reaction is usually carried out at 0°C, in some cases the reaction being terminated by heating to 50-60°C. With diaminopyrimidines which are sparingly soluble in water, the reaction was carried out in an organic solvent using amylnitrite. Excess nitrous acid can possibly attack the amino groups present. This was employed in some cases for the preparation of the hydroxy derivatives. ... [Pg.243]

A modified procedure" uses activated zinc together with dry gaseous hydrogen chloride in an organic solvent, e.g. acetic acid, as reducing agent. Under those conditions the reaction occurs at lower temperatures as with the original procedure. [Pg.63]

On-line coupling of normal-phase liquid chromatography (NPLC) and gas chromatography is today a well developed and robust procedure and has been regularly applied to environmental analysis. When a fraction of the NPLC sample is introduced in to the GC unit, a large-volume interface (LVI) is needed but, due to the volatility of the organic solvent used in NPLC, this does not present such a great problem. [Pg.361]

A recent development in the technique of hydrogenation has been the use of homogeneous catalysts. The catalysts employed are soluble in organic solvents and allow for more rapid reactions under milder conditions. The procedures given are typical of low-pressure reactions. [Pg.39]

It has been found that the growth hormone can be obtained in crystalline form from human pituitary glands by procedures comprising (1) extraction of the fresh glands with acetone, (2) extraction of the acetone residue with aqueous salt solutions, (3) precipitation from aqueous salt solutions by the addition of suitable miscible organic solvents of alkaline and acid pH, and finally crystallization from aqueous salt solutions by the addition of suitable miscible organic solvents. [Pg.1381]


See other pages where Organic solvents procedures is mentioned: [Pg.175]    [Pg.168]    [Pg.55]    [Pg.175]    [Pg.168]    [Pg.55]    [Pg.128]    [Pg.130]    [Pg.47]    [Pg.222]    [Pg.286]    [Pg.8]    [Pg.476]    [Pg.223]    [Pg.230]    [Pg.400]    [Pg.34]    [Pg.393]    [Pg.9]    [Pg.1481]    [Pg.157]    [Pg.199]    [Pg.269]    [Pg.107]    [Pg.53]    [Pg.77]    [Pg.25]    [Pg.39]    [Pg.160]    [Pg.221]    [Pg.237]    [Pg.238]    [Pg.133]    [Pg.15]   
See also in sourсe #XX -- [ Pg.707 ]




SEARCH



Organic procedure

© 2024 chempedia.info