Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Nonpolar phases

The behavior of insoluble monolayers at the hydrocarbon-water interface has been studied to some extent. In general, a values for straight-chain acids and alcohols are greater at a given film pressure than if spread at the water-air interface. This is perhaps to be expected since the nonpolar phase should tend to reduce the cohesion between the hydrocarbon tails. See Ref. 91 for early reviews. Takenaka [92] has reported polarized resonance Raman spectra for an azo dye monolayer at the CCl4-water interface some conclusions as to orientation were possible. A mean-held theory based on Lennard-Jones potentials has been used to model an amphiphile at an oil-water interface one conclusion was that the depth of the interfacial region can be relatively large [93]. [Pg.551]

Boiling-point separation of broad molecular weight range of compounds nonpolar phases ... [Pg.1098]

Two gas chromatograms showing the effect of polarity of the stationary phase on the separation efficiency for three substances of increasing polarity toluene, pyridine, and benzaldehyde. (a) Separation on silicone SE-30, a nonpolar phase, and (b) separation on elastomer OV-351, a more polar phase. Note the greatly changed absolute and relative retention times the more polar pyridine and benzaldehyde are affected most by the move to a more polar stationary phase. [Pg.249]

These are molecules which contain both hydrophilic and hydrophobic units (usually one or several hydrocarbon chains), such that they love and hate water at the same time. Familiar examples are lipids and alcohols. The effect of amphiphiles on interfaces between water and nonpolar phases can be quite dramatic. For example, tiny additions of good amphiphiles reduce the interfacial tension by several orders of magnitude. Amphiphiles are thus very efficient in promoting the dispersion of organic fluids in water and vice versa. Added in larger amounts, they associate into a variety of structures, filhng the material with internal interfaces which shield the oil molecules—or in the absence of oil the hydrophobic parts of the amphiphiles—from the water [3]. Some of the possible structures are depicted in Fig. 1. A very rich phase... [Pg.632]

Stationary Phases The best general purpose phases are dimethylsiloxanes (DB-1 or equivalent) and 5% phenyl/95% dimethylsiloxane (DB-5 or equivalent). These rather nonpolar phases are less prone to bleed than the more polar phases. The thickness of the stationary phase is an important variable to consider. In general, a thin stationary phase (0.3 /im) is best for high boilers and a thick stationary phase (1.0 /urn) provides better retention for low boilers. (For more detailed information, see Stationary Phase Selection in Appendix 2.)... [Pg.10]

As with urine, saliva (spumm) is easy to collect. The levels of protein and lipids in saliva or spumm are low (compared to blood samples). These matrices are viscous, which is why extraction efficiency of xenobioties amoimts to only 5 to 9%. By acidifying the samples, extraction efficiencies are improved as the samples are clarified, and proteinaceous material and cellular debris are precipitated and removed. Some xenobioties and their metabohtes are expressed in hair. Hair is an ideal matrix for extraction of analytes to nonpolar phases, especially when the parent xenobioties are extensively metabolized and often nondetectable in other tissues (parent molecules of xenobioties are usually less polar than metabolites). Hair is a popular target for forensic purposes and to monitor drug compliance and abuse. Human milk may be an indicator of exposure of a newborn to compounds to which the mother has been previously exposed. The main components of human milk are water (88%), proteins (3%), lipids (3%), and carbohydrates in the form of lactose (6%). At present, increasing attention is devoted to the determination of xenobioties in breath. This matrix, however, contains only volatile substances, whose analysis is not related to PLC applications. [Pg.195]

Rogers, K. S., Cammarata, A. A molecular orbilal description of the parfifioning of aromatic compounds between polar and nonpolar phases. Eiochim. Biophys. Acta 1969, 193,... [Pg.403]

The volumetric ratio of the two liquid phases (j6 = Forg/ Faq) can affect the efficiency of substrate conversion in biphasic media. The biocatalyst stability and the reaction equilibrium shift are dependent on the volume ratio of the two phases [29]. In our previous work [37], we studied the importance of the nonpolar phase in a biphasic system (octane-buffer pH 9) by varying the volume of solvent. The ratio /I = 2/10 has been the most appropriate for an improvement of the yield of the two-enzyme (lipase-lipoxygenase) system. We found that a larger volume of organic phase decreases the total yield of conversion. Nevertheless, Antonini et al. [61] affirmed that changes in the ratios of phases in water-organic two-phase system have little effect upon biotransformation rate. [Pg.567]

There are surprisingly few studies of the retention mechanism for open tubular columns but the theory presented for packed columns should be equally applicable. For normal film thicknesses open tubular columns have a large surface area/volume ratio and the contribution of interfacial adsorption to retention should be significant for those solutes that exhibit adsorption tendencies. Interfacial adsorption has been shown to affect the reproducibility of retention for columns prepared with nonpolar phases of different film thicknesses [322-324]. The poor reproducibility of retention index values for columns prepared from polar phases was demonstrated to be c(ue to interfacial... [Pg.611]

The un-ionized form is assumed to be sufficiently lipophilic to traverse membranes in the pH-partition hypothesis. If it were not, no transfer could be predicted, irrespective of pH. The lipophilicity of compounds is experimentally determined as the partition coefficient (log P) or distribution coefficient (log D) [16]. The partition coefficient is the ratio of concentrations of the neutral species between aqueous and nonpolar phases, while the distribution coefficient is the ratio of all species between aqueous and nonpolar phases [17,18],... [Pg.393]

Advances continue in the treatment of detonation mixtures that include explicit polar and ionic contributions. The new formalism places on a solid footing the modeling of polar species, opens the possibility of realistic multiple fluid phase chemical equilibrium calculations (polar—nonpolar phase segregation), extends the validity domain of the EXP6 library,40 and opens the possibility of applications in a wider regime of pressures and temperatures. [Pg.170]

Water molecules at the air-water interface experience unbalanced attraction for both water and the air phases [227-229]. This is a manifestation of the polar nature of water in contact with a nonpolar phase (i. e., the air). The water molecules are drawn together, resulting in a phenomenon called surface tension . The contact area between the water and the nonpolar phase is a region of relatively high interfacial tension and the system will naturally tend to minimize such contact. This polar structure of water will also make the aqueous medium relatively inhospitable to nonpolar, neutral (i.e., uncharged) molecules [230-234]. [Pg.141]

Indeed, recent results from our laboratory indicate that dendrimer-encapsulated CdS QDs can be prepared by either of two methods [192]. The first approach is analogous to the methodology described earlier for preparing dendrimer-encapsulated metal particles. First, Cd and S salts are added to an aqueous or methanolic PAMAM dendrimer solution. This yields a mixture of intradendrimer (templated) and interdendrimer particles. The smaller, dendrimer-encapsulated nanoparticles may then be separated via size-selective photo etching [193], dendrimer modification and extraction into a nonpolar phase [19], or by washing with solvent in which the dendrimer-encapsulated particles are preferentially soluble. An alternative, higher-yield method relies on sequential addition of very small aliquots of Cd + and S " to alcoholic dendrimer solutions. [Pg.128]

Factors that influence the retentive powers and selectivity of such bonded phases include the surface concentrations of hydrodartenaceous ligates and free silanol groups. The thermodynamic aspectitm solute interactions with the hydrocarbonaceous ligates at the surface, which are hydrophobic interactions in the case of aqueous eluents, are discussed later in this chapter within the framework of the solvophobic theory. In practice, however, solute interactions with surface silanol which may be termed silanophilic interactions can also contribute ]to retention (71, 75, 93), particularly in the case of amino compounds. Consequently the retention mechanism may be different from that which would be ol served with an ideal nonpolar phase. Therefore, increasing attention is paid to the estimation of the concentration of accessible sianols and to their elimination from the surface of bonded phases. [Pg.244]

To characterize the relative gas-chromatographic retentions of condensed aromatics and heteroaromatics, inclu g thienothiophenes, benzo[b]thiophene, dibenzothiophene, naphthobenzothiophenes, and anthrabenzothiophenes, a system of indices. In, was proposed, In this system a series of similar linearly condensed hydrocarbons (such as benzene, naphthalene, anthracene, tetracene, pentacene,...) was used as a reference scale. The logarithm of the corrected retention volume (adjusted to 0°), log Ft, depends linearly upon the number of condensed benzene rings (z) in the molecule, both in the polar and nonpolar phases. In is expressed by Eq. (58) ... [Pg.178]

Simulation of biological conditions for an extraction of any toxic substances from a water-insoluble and nonpolar phase by shaking and incubating the test samples with culture media as the extraction agent for 72 h at 37°C... [Pg.433]

Gold nanoparticles from 2.5 to 5 nm sizes have also been prepared by using a biphasic Winsor II [126] (a water-in-oil microemulsion that is in equilibrium with the excess water phase) type microemulsion of diethyl ether/AOT/water. The surfactant, AOT, performs the dual role of forming a microemulsion and the transferring of charged metal ions from the aqueous to organic phase. This provides gold nanoparticles, which are readily dispersed in the nonpolar phase. [Pg.207]

Figure 1.8 Micellar structure of a soap molecule on an oil-water interface. The nonpolar alkyl chains are in the nonpolar phase the polar carhoxylate head groups are in the aqueous phase. Figure 1.8 Micellar structure of a soap molecule on an oil-water interface. The nonpolar alkyl chains are in the nonpolar phase the polar carhoxylate head groups are in the aqueous phase.

See other pages where Nonpolar phases is mentioned: [Pg.115]    [Pg.328]    [Pg.333]    [Pg.515]    [Pg.120]    [Pg.199]    [Pg.200]    [Pg.248]    [Pg.250]    [Pg.84]    [Pg.95]    [Pg.96]    [Pg.98]    [Pg.585]    [Pg.589]    [Pg.595]    [Pg.606]    [Pg.612]    [Pg.615]    [Pg.615]    [Pg.225]    [Pg.295]    [Pg.63]    [Pg.317]    [Pg.132]    [Pg.66]    [Pg.253]    [Pg.150]    [Pg.587]    [Pg.31]   
See also in sourсe #XX -- [ Pg.149 ]




SEARCH



HPLC stationary phases nonpolar bonded

Nonpolar

Nonpolar liquid phase

Nonpolar polysiloxane phases

Nonpolar stationary phase

Nonpolarized

Orientational phase transitions in planar systems of nonpolar molecules

Polymer HPLC nonpolar bonded phase

Reversed-phase chromatography nonpolar bonded phases

© 2024 chempedia.info