Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Additions sequential

Synthesis of Alkviamines. General Procedures. Method (A). The synthesis of p-phenethylamine is representative. A flame dried, nitrogen-flushed, 100 ml flask, equipped with a septum inlet, magnetic stirring bar and reflux condenser ivas cooled to 0°C. Sodium borohydride (9.5 mmol, 0.36 g) was placed in the flask followed by sequential addition of THF (13-15 ml) and BF3-Et20 (12 mmol, 1.5 ml) at 0°C. After the addition, the ice bath was removed and the contents were stirred at room temperature for 15 min. The solution... [Pg.139]

In a related procedure A -melhyl-o-loluidine can be A-lithiated, carboxylated and C-lithiated by sequential addition of n-butyllithium, CO2, and n-butyl-lithium[5]. The resulting dilithiated intermediate reacts with esters to give 1.2-disubstituted indoles. [Pg.50]

Block copolymers are closer to blends of homopolymers in properties, but without the latter s tendency to undergo phase separation. As a matter of fact, diblock copolymers can be used as surfactants to bind immiscible homopolymer blends together and thus improve their mechanical properties. Block copolymers are generally prepared by sequential addition of monomers to living polymers, rather than by depending on the improbable rjr2 > 1 criterion in monomers. [Pg.434]

Covalent synthesis of complex molecules involves the reactive assembly of many atoms into subunits with aid of reagents and estabUshed as well as innovative reaction pathways. These subunits are then subjected to various reactions that will assemble the target molecule. These reaction schemes involve the protection of certain sensitive parts of the molecule while other parts are being reacted. Very complex molecules can be synthesized in this manner. A prime example of the success of this approach is the total synthesis of palytoxin, a poisonous substance found in marine soft corals (35). Other complex molecules synthesized by sequential addition of atoms and blocks of atoms include vitamin potentially anticancer KH-1 adenocarcinoma antigen,... [Pg.206]

Pi is a growing polymer chain with one monomer unit. The chain end remains an active radical and propagates by the sequential addition of monomer. [Pg.436]

A further improvement in the cuprate-based methodology for producing PGs utilizes a one-pot procedure (203). The CO-chain precursor (67) was first functionalized with zirconocene chloride hydride ia THF. The vinyl zirconium iatermediate was transmetalated direcdy by treatment with two equivalents of / -butyUithium or methyUithium at —30 to —70° C. Sequential addition of copper cyanide and methyUithium eUcited the /V situ generation of the higher order cyanocuprate which was then reacted with the protected enone to give the PG. [Pg.162]

While it is rarely possible to add solids first, in certain cases it might be possible to reduce flammability hazards by planned sequential additions of solids and liquids, the objective being to avoid additions of easily ignitable powders where the solvent vapor exceeds about 50% LFL. Hybrid mixtures are discussed in 6-1.3. [Pg.135]

In the presence of excess hydrogen halide, geminal dihalides aie fonned by sequential addition of two molecules of hydrogen halide to the caibon-caibon triple bond. [Pg.378]

Silicon cluster reactions are an example of a newly emerging field of research which is very amenable to study with electronic structure methods. This exercise will examine the potential surface for silicon cation reacting with silane (SiH4). Such reactions are central to the growth of large silicon clusters, which occurs by sequential additions of -SiHj ... [Pg.199]

In a separate report, preparation of the lithium enolate of 31 in the presence of indium trichloride and benzaldehyde provided a 77% yield of 32 with complete trans selectivity however, sequential addition of indium trichloride and benzaldehyde provided Barbier-type products. Organotin enolates have also been used in a Darzens-type... [Pg.18]

An interesting intermediate 30 was proposed to result from the sequential addition of pyridine to tetrachlorocyclopropene (31). Compound 30 represents an alkyl nitrogen ylide with two 1-chloroalkyl pyridinium moieties in the same molecule. Pyridines with electron-withdrawing groups and heterocycles with an electron-deficient nitrogen, for example, pyridine-3-carbaldehyde or quinoline, react with 31 to yield the corresponding mono-substituted products 32a and 32b (83JOC2629) (Scheme 8). [Pg.188]

The hydrophobic central segment is first synthesized by sequential addition of propylene oxide to a propylene glycol initiator ... [Pg.765]

One of the most striking features of the common fatty adds is that they have an even number of carbon atoms (Table 27.1, p. 1062). This even number results because all fatty acids are derived biosynthelically from acetyl CoA by sequential addition of two-carbon units to a growing chain. The acetyl CoA, in turn, arises primarily from the metabolic breakdown of carbohydrates in the glycolysis pathway that weTl see in Section 29.5. Thus, dietary carbohydrates consumed in excess of immediate energy needs are turned into fats for storage. [Pg.1138]

GPI anchoring is a posttranslational modification occurring in the endoplasmic reticulum where preassembled GPI anchor precursors are transferred to proteins bearing a C-terminal GPI signal sequence. The GPI anchor precursors are synthesized in the endoplasmic reticulum by sequential addition of sugar and other components to phosphatidylinositol. Protein GPI anchors are ubiquitous in eukaryotic cells. In mammalian cells, GPI anchored proteins are often found in lipid rafts which are subdomains of the plasma membrane, containing various signaling components. [Pg.557]

Cases of addition-abstraction" polymerization have also been reported where propagation occurs by a mechanism involving sequential addition and intramolecular 1,5-hydrogen atom transfer steps (Section 4.4.3.4). [Pg.208]

An alternative procedure involved the coupling of polysilanolate, obtained by sequential addition of cyclotrisiloxane to the polystyrene anion, with a, co-diacetoxy-siloxane385-386- 399>. [Pg.35]

Several pathways have been explored for their synthesis sequential addition of monomers to an initiator solution, reaction between co-functional polymers and more recently site transformation techniques. Each of these methods has advantages and drawbacks. [Pg.164]

Sequential addition of monomers 6 7-26-27-114) is the most obvious procedure. Once the first monomer has been polymerized, the resulting living species is used as a polymeric initiator for the polymerization of the second one. The monomers are to be added in the order of increasing electron affinity to provide efficient and fast initiation 26 U4). This condition is rather restrictive, and the number of monomer systems that can be used is limited (Table 5). Moreover, when the second monomer contains an electrophilic function (e.g. ester) which could lead to side reactions, it is necessary to first lower the nucleophilicity of the living site. This is best done by intermediate addition of 1.1-diphenylethylene25). The stabilized diphenylmethyl anions do not get involved in side reactions with ester functions, while initiation is still quantitative and fast. [Pg.164]

ABA triblock copolymers (as well as multiblock copolymers) cannot be made by sequential addition of monomer A, monomer B, and again monomer A, except in the few cases in which the electron affinity of both monomers is almost the same 27,28, 118>. There are however two ways to circumvent this difficulty ... [Pg.166]

An alternate way to make block copolymers involving PDMS blocks 124,125) is to have these chains fitted with epoxide functions at chain end, and to react them with a vinylic or dienic polymer carrying terminal COOH functions. Sequential addition of monomers has also been used, the ring opening polymerization of the cyclic trimer (D3) being initiated by the anionic site of a living polymer126). [Pg.167]

Seeding technique, procedure 130, 131 Sequential addition of monomers 164, 167 Silicon-carbide fibers 8 Silicon-nitride fibers 8 Silicone rubber, crosslinked 4, 7-9, 31, 67 Siloxane, definition of 5 Siloxane-acrylate copolymers 27, 29, 56, 57, 64, 70, 71, 73, 74... [Pg.253]

A useful synthesis of polysubstituted pyridines (i.e., 11) is based on the legioselective addition of Uthiated -enaminophosphonates to unsaturated carbonyl compounds. These pyridines can also be obtained via a one-pot reaction from metalated phosphonates and sequential addition of nitriles and unsaturated caibonyl compounds <96TL(37)4577>. [Pg.224]

Linear triblock copolymers of the type styrene-butadiene-styrene (SBS) and styrene-isoprene-styrene (SIS) are produced commercially by anionic polymerization through sequential addition of monomers in the reaction chamber [10] as shown below ... [Pg.107]

Sequential addition of a second monomer (e.g., styrene,p-terbutyl styrene, p-methyl styrene, indene, -chloro styrene, isoprene, and a-methyl styrene) to make glassy outer-block... [Pg.107]

Optically pure a-amino acids can be converted to 1,2-diamines by a route that involves the preliminary formation of N-protected a-aminonitriles through the intermediate amides. The addition of organometallic reagents to these a-aminonitriles gives a-amino ketimines, which are then reduced in situ to 1,2-diamines. However, this route has been scarcely applied to acychc a-aminonitriles. As a matter of fact, the sequential addition of methylmag-... [Pg.40]

The formation of the PIC described above is based on the sequential addition of purified components in in vitro experiments. An essential feature of this model is that the assembly takes place on the DNA template. Accordingly, transcription activators, which have autonomous DNA binding and activation domains (see Chapter 39), are thought to function by stimulating either PIC formation or PIC function. The TAF coactivators are viewed as bridging factors that communicate between the upstream activators, the proteins associated with pol II, or the many other components of TFIID. This view, which assumes that there is stepwise assembly of the PIC—promoted by various interactions between activators, coactivators, and PIC components— is illustrated in panel A of Figure 37-10. This model was supported by observations that many of these proteins could indeed bind to one another in vitro. [Pg.351]

The tetrahedron can be visualized as built by the sequential addition of hydrogen atoms to carbon, always keeping the C—H bonds as far apart as possible. [Pg.605]

Whereas DNA has a single role as the storehouse of genetic information, RNA plays many roles in the operation of a cell. There are several different types of RNA, each having its own function. The principal job of RNA is to provide the information needed to synthesize proteins. Protein synthesis requires several steps, each assisted by RNA. One type of RNA copies the genetic information from DNA and carries this blueprint out of the nucleus and into the cytoplasm, where construction of the protein takes place. The protein is assembled on the surface of a ribosome, a cell component that contains a second type of RNA. The protein is consfructed by sequential addition of amino acids in the order specified by the DNA. The individual amino acids are carried to the growing protein chain by yet a third type of RNA. The details of protein synthesis are well understood, but the process is much too complex to be described in an introductoiy course in chemistry. [Pg.942]

In a second-generation star, fusion of protons to produce helium occurs in a catalytic cycle by the sequential addition of protons to... [Pg.1597]


See other pages where Additions sequential is mentioned: [Pg.206]    [Pg.361]    [Pg.28]    [Pg.6]    [Pg.206]    [Pg.383]    [Pg.281]    [Pg.1036]    [Pg.454]    [Pg.540]    [Pg.541]    [Pg.368]    [Pg.26]    [Pg.146]    [Pg.164]    [Pg.249]    [Pg.337]    [Pg.306]    [Pg.1215]    [Pg.41]    [Pg.283]    [Pg.604]   
See also in sourсe #XX -- [ Pg.8 ]

See also in sourсe #XX -- [ Pg.30 , Pg.72 ]

See also in sourсe #XX -- [ Pg.1038 ]




SEARCH



Addition elimination, sequential reactions

Addition substitution, sequential reactions

Block copolymers by sequential addition of monomers to living systems

Copolymerization sequential monomer addition

Copolymers by sequential addition of monomers

Michael addition sequential

Propylene oxide sequential addition

Sequential 1,4-Additions to 2,5-Cyclohexadienones

Sequential addition method

Sequential addition of propylene oxide

Sequential monomer addition

Sequential processing additional information

© 2024 chempedia.info