Metal ions redox processes

Concerning the role of the active site Fe ion, it has been argued that the observed FTIR band shifts (typically 20 cm ) resulting from one-electron redox changes are too small to correspond to metal-based redox processes, whose band shifts should amount to about 100 cm per electron (90, 101). There is, however, one example where the shift in f(CN ) upon one-electron reduction of a Fe(III) center is only of... 

Although all potentiometric measurements (except those involving membrane electrodes) ultimately are based on a redox couple, the method can be applied to oxidation-reduction processes, acid-base processes, precipitation processes, and metal ion complexation processes. Measurements that involve a component of a redox couple require that either the oxidized or reduced conjugate of the species to be measured be maintained at a constant and known activity at the electrode. If the goal is to measure the activity of silver ion in a solution, then a silver wire coupled to the appropriate reference electrodes makes an ideal potentiometric system. Likewise, if the goal is to monitor iron(UI) concentrations with a platinum electrode, a known concentration of... 

The electrochemistry of the polymeric and isomorphous cobalt(II) and nickel(II) methylsquarates was also studied by Iwuoha et al. In aqueous solutions, they found evidence that both the nickel(II) methylsquarate and its cobalt analog were dissociated without any reversible redox processes occurring for the metal ions. However, the cyclic and Osteryoung square wave voltammograms, obtained using a Pt electrode for solutions of these complexes in dimethylformamide and dimethylsulfoxide, contained signals attributable to both ligand-based and metal-based redox processes 142). 

The vast majority of the coordination compounds of Os that have been prepared are in the oxidation states 11 and III. Moreover, many of these compounds show reversible or well defined Os / couples in which the electronic and redox properties at the metal are controlled by the a-donor, 7r-acceptor, and r-donor properties of the ligands. Indeed, the study of the redox behavior in Os / and Ru / species, metal ions in which octahedral coordination is almost universally retained in both redox partners, has been central in recent developments to parameterize metal centered redox processes as a function of ligand donor and acceptor capacity. The chemistries of Os and Os are, therefore, intimately linked, and have been extended to studies of important mixed valence Os / binuclear and polynuclear species (see Mixed Valence Compounds). For the purposes of brevity and convenience, this section will deal with Os and Os complexes together. The extensive literature on Os / complexes has been developed with a very wide range of donor ligands a comprehensive assessment of this work is beyond the scope of this article, and the reader is directed to published comprehensive reviews. " ... 

In resolving complex metal-ion mixtures, more than one masking or demasking process may be utilized with various aliquots of the sample solution, or applied simultaneously or stepwise with a single aliquot. In favorable cases, even four or five metals can be determined in a mixture by the application of direct and indirect masking processes. Of course, not all components of the mixture need be determined by chelometric titrations. For example, redox titrimetry may be applied to the determination of one or more of the metals present. 

Without the addition of corrosion inhibitors, acid cleaning or pickling processes to remove oxides and scales would result in severe corrosion of exposed metal surfaces. Acid corrosion is an electrochemical or redox process, and raising cleaning temperatures or acid strength (lowering the pH) increases the hydrogen ion concentration and consequently the rate of corrosion. 

On the other hand, Doblhofer218 has pointed out that since conducting polymer films are solvated and contain mobile ions, the potential drop occurs primarily at the metal/polymer interface. As with a redox polymer, electrons move across the film because of concentration gradients of oxidized and reduced sites, and redox processes involving solution species occur as bimolecular reactions with polymer redox sites at the polymer/solution interface. This model was found to be consistent with data for the reduction and oxidation of a variety of species at poly(7V-methylpyrrole). This polymer has a relatively low maximum conductivity (10-6 - 10 5 S cm"1) and was only partially oxidized in the mediation experiments, which may explain why it behaved more like a redox polymer than a typical conducting polymer. 

Finally, we consider the alternative mechanism for electron transfer reactions -the inner-sphere process in which a bridge is formed between the two metal centers. The J-electron configurations of the metal ions involved have a number of profound consequences for this reaction, both for the mechanism itself and for our investigation of the reaction. The key step involves the formation of a complex in which a ligand bridges the two metal centers involved in the redox process. For this to be a low energy process, at least one of the metal centers must be labile. 

The beauty of bromide-mediated oxidations is that they combine mechanistic complexity with practical simplicity and, hence, utility. They involve an intricate array of electron transfer steps in which bromine atoms function as go-betweens in transfering the oxidizing power of peroxidic intermediates, via redox metal ions, to the substrate. Because the finer mechanistic details of these elegant processes have often not been fully appreciated we feel that their full synthetic potential has not yet been realized. Hence, we envision further practical applications in the future. 

As discussed earlier the whole process is a redox reaction. Selenium is reduced using sodium borohydride to give selenide ions. In the above reaction, the metal ion reacts with the polymer (PVP or PVA) solution to form the polymer-metal ion solution. Addition of the selenide ion solution to the polymer-metal ion solutions resulted in instantaneous change in the colour of the solutions from colourless to orange (PVA) and orange red (PVP). This indicates the formation of CdSe nanoparticles. The addition of the selenide solution to the polymer - metal ion solution resulted in gradual release of selenide ion (Se -) upon hydrolytic decomposition in alkaline media (equation 4). The released selenide ions then react with metal ion to form seed particles (nucleation). 

Tl(III) < Pb(IV), and this conclusion has been confirmed recently with reference to the oxythallation of olefins 124) and the cleavage of cyclopropanes 127). It is also predictable that oxidations of unsaturated systems by Tl(III) will exhibit characteristics commonly associated with analogous oxidations by Hg(II) and Pb(IV). There is, however, one important difference between Pb(IV) and Tl(III) redox reactions, namely that in the latter case reduction of the metal ion is believed to proceed only by a direct two-electron transfer mechanism (70). Thallium(II) has been detected by y-irradiation 10), pulse radiolysis 17, 107), and flash photolysis 144a) studies, butis completely unstable with respect to Tl(III) and T1(I) the rate constant for the process 2T1(II) Tl(III) + T1(I), 2.3 x 10 liter mole sec , is in fact close to diffusion control of the reaction 17). 

C19-0050. What are the half-reactions for these redox processes (a) Aqueous hydrogen peroxide acts on Co, and the products are hydroxide and Co , in basic solution, (b) Methane reacts with oxygen gas and produces water and carbon dioxide, (c) To recharge a lead storage battery, lead(II) sulfate is converted to lead metal and to lead(IV) oxide, (d) Zinc metal dissolves in aqueous hydrochloric acid to give ions and hydrogen gas. 

Cathodic electrodeposition of microcrystalline cadmium-zinc selenide (Cdi i Zn i Se CZS) films has been reported from selenite and selenosulfate baths [125, 126]. When applied for CZS, the typical electrocrystallization process from acidic solutions involves the underpotential reduction of at least one of the metal ion species (the less noble zinc). However, the direct formation of the alloy in this manner is problematic, basically due to a large difference between the redox potentials of and Cd " couples [127]. In solutions containing both zinc and cadmium ions, Cd will deposit preferentially because of its more positive potential, thus leading to free CdSe phase. This is true even if the cations are complexed since the stability constants of cadmium and zinc with various complexants are similar. Notwithstanding, films electrodeposited from typical solutions have been used to study the molar fraction dependence of the CZS band gap energy in the light of photoelectrochemical measurements, along with considerations within the virtual crystal approximation [128]. 

Late transition metal or 3d-transition metal irons, such as cobalt, nickel, and copper, are important for catalysis, magnetism, and optics. Reduction of 3d-transition metal ions to zero-valent metals is quite difficult because of their lower redox potentials than those of noble metal ions. A production of bimetallic nanoparticles between 3d-transi-tion metal and noble metal, however, is not so difficult. In 1993, we successfully established a new preparation method of PVP-protected CuPd bimetallic nanoparticles [71-73]. In this method, bimetallic hydroxide colloid forms in the first step by adjusting the pH value with a sodium hydroxide solution before the reduction process, which is designed to overcome the problems caused by the difference in redox potentials. Then, the bimetallic species... 

Our first attempt of a successive reduction method was utilized to PVP-protected Au/Pd bimetallic nanoparticles [125]. An alcohol reduction of Pd ions in the presence of Au nanoparticles did not provide the bimetallic nanoparticles but the mixtures of distinct Au and Pd monometallic nanoparticles, while an alcohol reduction of Au ions in the presence of Pd nanoparticles can provide AuPd bimetallic nanoparticles. Unexpectedly, these bimetallic nanoparticles did not have a core/shell structure, which was obtained from a simultaneous reduction of the corresponding two metal ions. This difference in the structure may be derived from the redox potentials of Pd and Au ions. When Au ions are added in the solution of enough small Pd nanoparticles, some Pd atoms on the particles reduce the Au ions to Au atoms. The oxidized Pd ions are then reduced again by an alcohol to deposit on the particles. This process may form with the particles a cluster-in-cluster structure, and does not produce Pd-core/ Au-shell bimetallic nanoparticles. On the other hand, the formation of PVP-protected Pd-core/Ni-shell bimetallic nanoparticles proceeded by a successive alcohol reduction [126]. 

Figure 3. Schematic illustration of core/shell nanoparticle formation via redox transmetalation process. Metal ions (Mu) of reactant metal complexes (Mn-L ) are reduced on the surface of Mi nanoparticles while neutral Mi atoms are oxidized to Mi " by forming a Mi-ligand complex (Mi-Lj) as a resultant reaction byproduct. Repeating this process results in the complete coverage of shell layers on core metals. (Reprinted from Ref [145], 2005, with permission from American Chemical Society.)...

Because electrons are neither products nor reactants in chemical reactions, the two processes are interdependent and neither can occur alone. The zinc metal dissolution must furnish electrons for the copper metal plating. The reaction of zinc and copper sulfate solution is a spontaneous reaction involving a transfer of electrons, i.e., is a spontaneous redox process. The spontaneity of the reaction is commonly explained by saying that zinc loses electrons more readily than copper or, alternatively, that Cu2+ ions gain electrons more readily than Zn2+ ions. 

Attempts were made to quantitatively treat the elementary process in electrode reactions since the 1920s by J. A. V. Butler (the transfer of a metal ion from the solution into a metal lattice) and by J. Horiuti and M. Polanyi (the reduction of the oxonium ion with formation of a hydrogen atom adsorbed on the electrode). In its initial form, the theory of the elementary process of electron transfer was presented by R. Gurney, J. B. E. Randles, and H. Gerischer. Fundamental work on electron transfer in polar media, namely, in a homogeneous redox reaction as well as in the elementary step in the electrode reaction was made by R. A. Marcus (Nobel Prize for Chemistry, 1992), R. R. Dogonadze, and V. G. Levich. 

---