Chain radical mechanisms

A number of reactions involving alkane photooxidation by polyoxometalates have been run under aerobic conditions. Those by PWi2O40 and Wio032 are summarized at the end of Table I (see section 5). Unfortunately these reactions, collectively, are rather uninformative with respect to mechanism. Radical chain autoxidation processes are undoubtedly present and few if any of the reported papers have addressed the requisite experiments to differentiate autoxidation from other oxidation pathways. A similar general limitation exists in the literature on photocatalytic aerobic oxidation of organic compounds by semiconductor materials [66]. 

Bromine reacts with alkanes by a free radical chain mechanism analogous to that of chlorine There is an important difference between chlorination and brommation how ever Brommation is highly selective for substitution of tertiary hydrogens The spread m reactivity among pnmary secondary and tertiary hydrogens is greater than 10 ... 

The reaction proceeds by a free radical chain mechanism involving the following prop agation steps... 

Photoinitiation is not as important as thermal initiation in the overall picture of free-radical chain-growth polymerization. The foregoing discussion reveals, however, that the contrast between the two modes of initiation does provide insight into and confirmation of various aspects of addition polymerization. The most important application of photoinitiated polymerization is in providing a third experimental relationship among the kinetic parameters of the chain mechanism. We shall consider this in the next section. 

Both modes of ionic polymerization are described by the same vocabulary as the corresponding steps in the free-radical mechanism for chain-growth polymerization. However, initiation, propagation, transfer, and termination are quite different than in the free-radical case and, in fact, different in many ways between anionic and cationic mechanisms. Our comments on the ionic mechanisms will touch many of the same points as the free-radical discussion, although in a far more abbreviated form. 

We begin our discussion of copolymers by considering the free-radical polymerization of a mixture of two monomers. Mi and M2. This is already a narrow view of the entire field of copolymers, since more than two repeat units can be present in copolymers and, in addition, mechanisms other than free-radical chain growth can be responsible for copolymer formation. The essential features of the problem are introduced by this simpler special case, so we shall restrict our attention to this system. 

In writing Eqs. (7.1)-(7.4) we make the customary assumption that the kinetic constants are independent of the size of the radical and we indicate the concentration of all radicals, whatever their chain length, ending with the Mj repeat unit by the notation [Mj ], This formalism therefore assumes that only the nature of the radical chain end influences the rate constant for propagation. We refer to this as the terminal control mechanism. If we wished to consider the effect of the next-to-last repeat unit in the radical, each of these reactions and the associated rate laws would be replaced by two alternatives. Thus reaction (7. A) becomes... 

In contrast, the ultrasonic irradiation of organic Hquids has been less studied. SusHck and co-workers estabHshed that virtually all organic Hquids wiU generate free radicals upon ultrasonic irradiation, as long as the total vapor pressure is low enough to allow effective bubble coUapse (49). The sonolysis of simple hydrocarbons (for example, alkanes) creates the same kinds of products associated with very high temperature pyrolysis (50). Most of these products (H2, CH4, and the smaller 1-alkenes) derive from a weU-understood radical chain mechanism. 

Thermal Oxidative Stability. ABS undergoes autoxidation and the kinetic features of the oxygen consumption reaction are consistent with an autocatalytic free-radical chain mechanism. Comparisons of the rate of oxidation of ABS with that of polybutadiene and styrene—acrylonitrile copolymer indicate that the polybutadiene component is significantly more sensitive to oxidation than the thermoplastic component (31—33). Oxidation of polybutadiene under these conditions results in embrittlement of the mbber because of cross-linking such embrittlement of the elastomer in ABS results in the loss of impact resistance. Studies have also indicated that oxidation causes detachment of the grafted styrene—acrylonitrile copolymer from the elastomer which contributes to impact deterioration (34). 

Aqueous Phase. In pure water, the decomposition of ozone at 20°C iavolves a complex radical chain mechanism, initiated by OH and propagated by O2 radical ions and HO radicals (25). O3 is a radical ion. 

Ethylene Dichloride Pyrolysis to Vinyl Chloride. Thermal pyrolysis or cracking of EDC to vinyl chloride and HCl occurs as a homogenous, first-order, free-radical chain reaction. The accepted general mechanism involves the four steps shown in equations 10—13 ... 

The mechanism by which an oiganic material (RH) undergoes autoxidation involves a free-radical chain reaction (3—5) ... 

Chemical initiation generates organic radicals, usually by decomposition of a2o (11) or peroxide compounds (12), to form radicals which then react with chlorine to initiate the radical-chain chlorination reaction (see Initiators). Chlorination of methane yields all four possible chlorinated derivatives methyl chloride, methylene chloride, chloroform, and carbon tetrachloride (13). The reaction proceeds by a radical-chain mechanism, as shown in equations 1 through. Chain initiation... 

Addition Chlorination. Chlorination of olefins such as ethylene, by the addition of chlorine, is a commercially important process and can be carried out either as a catalytic vapor- or Hquid-phase process (16). The reaction is influenced by light, the walls of the reactor vessel, and inhibitors such as oxygen, and proceeds by a radical-chain mechanism. Ionic addition mechanisms can be maximized and accelerated by the use of a Lewis acid such as ferric chloride, aluminum chloride, antimony pentachloride, or cupric chloride. A typical commercial process for the preparation of 1,2-dichloroethane is the chlorination of ethylene at 40—50°C in the presence of ferric chloride (17). The introduction of 5% air to the chlorine feed prevents unwanted substitution chlorination of the 1,2-dichloroethane to generate by-product l,l,2-trichloroethane. The addition of chlorine to tetrachloroethylene using photochemical conditions has been investigated (18). This chlorination, which is strongly inhibited by oxygen, probably proceeds by a radical-chain mechanism as shown in equations 9—13. 

Pyrolysis. The pyrolysis of 1,1,1-trichloroethane at 325—425°C proceeds by a simultaneous unknolecular and radical-chain mechanism to yield... 

Physical properties of hexachloroethane are Hsted in Table 11. Hexachloroethane is thermally cracked in the gaseous phase at 400—500°C to give tetrachloroethylene, carbon tetrachloride, and chlorine (140). The thermal decomposition may occur by means of radical-chain mechanism involving -C,C1 -C1, or CCl radicals. The decomposition is inhibited by traces of nitric oxide. Powdered 2inc reacts violentiy with hexachloroethane in alcohoHc solutions to give the metal chloride and tetrachloroethylene aluminum gives a less violent reaction (141). Hexachloroethane is unreactive with aqueous alkali and acid at moderate temperatures. However, when heated with soHd caustic above 200°C or with alcohoHc alkaHs at 100°C, decomposition to oxaHc acid takes place. 

Reactions of 3-chloro-6-methoxypyridazine with ketone enolates in liquid ammonia exhibit characteristics consistent with a radical chain mechanism for substitution (8UOC294). 

The oxidation of hydrocarbons, including hydrocarbon polymers, takes the form of a free-radical chain reaction. As a result of mechanical shearing, exposure of ultraviolet radiation, attack by metal ions such as those of copper and manganese as well as other possible mechanisms, a hydrocarbon molecule breaks down into two radicals... 

The regioselectivity of addition of Itydrogen bromide to alkenes can be complicated if a free-radical chain addition occurs in competition with the ionic addition. The free-radical reaction is readily initiated by peroxidic impurities or by light and leads to the anti-Markownikoff addition product. The mechanism of this reaction will be considered more fully in Chapter 12. Conditions that minimize the competing radical addition include use of high-purity alkene and solvent, exclusion of light, and addition of free-radical inhibitors. ... 

The result of the steady-state condition is that the overall rate of initiation must equal the total rate of termination. The application of the steady-state approximation and the resulting equality of the initiation and termination rates permits formulation of a rate law for the reaction mechanism above. The overall stoichiometry of a free-radical chain reaction is independent of the initiating and termination steps because the reactants are consumed and products formed almost entirely in the propagation steps. 

Free-radical chain inhibitors are of considerable economic importance. The term antioxidant is commonly appUed to inhibitors that retard the free-radical chain oxidations, termed autoxidations, that can cause relatively rapid deterioration of many commercial materials derived from organic molecules, including foodstuffs, petroleum products, and plastics. The chain mechanism for autoxidation of hydrocarbons is ... 

Radical substitution reactions by iodine are not practical because the abstraction of hydrogen from hydrocarbons by iodine is endothermic, even for stable radicals. The enthalpy of the overall reaction is also slightly endothermic. Thus, because of both the kinetic problem excluding a chain reaction and an unfavorable equilibrium constant for substitution, iodination cannot proceed by a radical-chain mechanism. 

Free-radical chain oxidation of organic molecules by molecular oxygen is often referred to as autoxidation (see Section 12.2.1). The general mechanism is outlined below. 

The anti-Markownikoff addition of hydrogen bromide to alkenes was one of the earliest free-radical reactions to be put on a firm mechanistic basis. In the presence of a suitable initiator, such as a peroxide, a radical-chain mechanism becomes competitive with the ionic mechanism for addition of hydrogen bromide ... 

Because the bromine adds to the less substituted carbon atom of the double bond, generating the more stable radical intermediate, the regioselectivity of radical-chain hydrobromination is opposite to that of ionic addition. The early work on the radical mechanism of addition of hydrogen bromide was undertaken to understand why Maikow-nikofF s rule was violated under certain circumstances. The cause was found to be conditions that initiated the radical-chain process, such as peroxide impurities or light. 

The addition of S—H compounds to alkenes by a radical-chain mechanism is a quite general and efficient reaction. The mechanism is analogous to that for hydrogen bromide addition. The energetics of both the hydrogen abstraction and addition steps are favorable. Entries 16 and 17 in Scheme 12.5 are examples. 

Acrylic adhesives cure by a free radical chain growth mechanism. In contrast, epoxy and urethane adhesives cure by a step growth mechanism. This has a major impact on the cure kinetics, as well as the composition of the adhesive during cure ([9], pp. 6-9). Cyanoacrylate adhesives (such as Super Glue ) also cure by chain growth, but the mechanism is ionic with initiation by surface moisture. 

Fig. I. Mechanism for free radical chain growth polymerization.

Atoms and free radicals are highly reactive intermediates in the reaction mechanism and therefore play active roles. They are highly reactive because of their incomplete electron shells and are often able to react with stable molecules at ordinary temperatures. They produce new atoms and radicals that result in other reactions. As a consequence of their high reactivity, atoms and free radicals are present in reaction systems only at very low concentrations. They are often involved in reactions known as chain reactions. The reaction mechanisms involving the conversion of reactants to products can be a sequence of elementary steps. The intermediate steps disappear and only stable product molecules remain once these sequences are completed. These types of reactions are refeiTcd to as open sequence reactions because an active center is not reproduced in any other step of the sequence. There are no closed reaction cycles where a product of one elementary reaction is fed back to react with another species. Reversible reactions of the type A -i- B C -i- D are known as open sequence mechanisms. The chain reactions are classified as a closed sequence in which an active center is reproduced so that a cyclic reaction pattern is set up. In chain reaction mechanisms, one of the reaction intermediates is regenerated during one step of the reaction. This is then fed back to an earlier stage to react with other species so that a closed loop or... 

---