Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Material hazards asbestos

Most people will tolerate greater risk from activities when the threat to life is offset in time from when the risk (and the benefit) is originally accepted. For example, people may feel worse (and usually accept less risk) about a threat of immediate harm (e.g., the blast wave from an explosion) than a threat of latent harm (e.g., an increase in the chance of getting a fatal disease following a 20-year exposure to a hazardous material, like asbestos), even though the risks may be equivalent. [Pg.59]

Lipoproteins may denature on heating and if present during pasteurization can result in the formation of haze or turbidity in the final product. This material was removed traditionally by filtration through asbestos (qv) sheets (6) however, health hazards associated with asbestos have led to its replacement by alternative filter materials (23,37,193). These media have been less effective than asbestos and further measures have been required to ensure the visual clarity of albumin products, eg, further filtration developments for Hpid removal (194), preferential denaturation of contaminants using in-process heat treatment, and anion-exchange chromatography (49). [Pg.533]

Inhalation of certain fine dusts may constitute a health hazard. Eor example, exposure to siUca, asbestos, and beryllium oxide dusts over a period of time results ki the potential risk of lung disease. OSHA regulations specify the allowable levels of exposure to kigestible and respkable materials. Material Safety Data Sheets, OSHA form 20, available from manufacturers, provide information about hazards, precautions, and storage pertinent to specific refractory products. [Pg.35]

In Great Britain the COSHH Regulations cover virtually all substances hazardous to health. (Excluded are asbestos, lead, materials dangerous solely due to their radioactive, explosive, or flammable properties, or solely because of high or low temperatures or pressures, or where risk... [Pg.108]

Typical insulating materials, therefore, are usually made of nonmetallic materials and are filled with small air pockets. They include magnesium carbonate, cork, felt, cotton batting, rock or glass wool, and diatomaceous earth. Asbestos was once widely used for insulation, but it has been found to be a health hazard and has, therefore, been banned in new construction in the U.S. [Pg.8]

Applicability Most hazardous waste slurried in water can be mixed directly with cement, and the suspended solids will be incorporated into the rigid matrices of the hardened concrete. This process is especially effective for waste with high levels of toxic metals since at the pH of the cement mixture, most multivalent cations are converted into insoluble hydroxides or carbonates. Metal ions also may be incorporated into the crystalline structure of the cement minerals that form. Materials in the waste (such as sulfides, asbestos, latex and solid plastic wastes) may actually increase the strength and stability of the waste concrete. It is also effective for high-volume, low-toxic, radioactive wastes. [Pg.180]

Chemical Reactivity - Reactivity with Water No reaction Reactivity with Common Materials Can catch fire when in contact with porous materials such as wood, asbestos, cloth, soil, or rusty metals Stability During Transport Stable at ordinary temperatures, however when heated this material can decompose to nitrogen and ammonia gases. The decomposition is not generally hazardous unless it occurs in confined spaces Neutralizing Agents for Acids and Caustics Flush with water and neutralize the resulting solution with calcium hypochlorite Polymerization Not pertinent Inhibitor of Polymerization Not pertinent. [Pg.201]

Eor example, the federal Oeeupational Safety and Health Administration (OSHA) regulates asbestos, lead, and other hazardous substanees. It would be very diffieult to provide the reader with every regulatory ageney that may have jurisdietion over hazardous materials. It is not our intent to provide the reader with every detail. However, the information offered in this book ean aid the reader in general eompli-anee issues and assist in planning for safety. This, in the long run, will help to improve on-site safety performanee. [Pg.1]

Coordinates public programs administered by the federal government that control potential health hazards from exposure to asbestos and other fibrous materials. Has numerous links to asbestos programs, courses and resources. [Pg.285]

The Control of Substances Hazardous to Health (COSHH) Regulations 1989 covers virtually all substances hazardous to health. Only asbestos, lead, materials producing ionizing radiation and substances below ground in mines (which all have their own legislation) are excluded. The Regulations set out measures that employers must implement. Failure to comply with COSHH, in addition to exposing employees and others to risk, constitutes an offence and is subject to penalties under the Health and Safety at Work Act, etc. 1974. [Pg.1066]

Asbestos It is not the name of a distinct mineral species but is a commercial term applied to fibrous varieties of several silicate minerals such as amosite and crocido-lite. These extremely fine fibers are useful as fillers and/or reinforcements in plastics. Property performances include withstanding wear and high temperatures, chemical resistance, and strengths with high modulus of elasticity. When not properly handled or used, like other fibrous materials, they can be hazardous. [Pg.631]

Confined vapour cloud explosion, 13, 214, 215 Construction materials, 59, 60 Contact dermatitis, See Dermatitis Containment, 135, 165, 220, 221 Control of Asbestos at Work Regulations, 148, 594 Control of Major Accident Hazard Regulations 1999, 5, 424, 594... [Pg.601]

From the above it can be concluded that the risk for lung cancer induction from chronic indoor exposure to Rn-d is unlikely to be higher than 1.10 4/mSv. in order to understand the magnitude of this risk it has to be emphasized that man can be exposed to a multitude of different hazardous materials in the indoor atmosphere besides Rn-d, such as formaldehyde, nitrogen dioxide, carbon monoxide, nitrosamines, polyaromatic hydrocarbons, volatile organic compounds, asbestos and pesticides (Gammage and Kaye, 1985). [Pg.441]

The use of materials such as asbestos in buildings and machinery is now largely discontinued, but poses a health hazard when the material is disturbed. Recognition of the importance of atmospheric particles is reflected in a dedicated volume in this series [3]. In this chapter we emphasise the interaction with the biosphere. [Pg.358]

The plasma vitrification can be used also for asbestos waste which is a hazardous, fibrous, dusty material causing danger for human beings such as lung cancer - mesothelioma. [Pg.104]

Address environmental concerns (runoff, verification sampling for contamination from toxic and hazardous materials such as asbestos, PCBs and other possible hazards)... [Pg.120]


See other pages where Material hazards asbestos is mentioned: [Pg.108]    [Pg.108]    [Pg.2072]    [Pg.582]    [Pg.911]    [Pg.9]    [Pg.136]    [Pg.22]    [Pg.120]    [Pg.120]    [Pg.9]    [Pg.922]    [Pg.275]    [Pg.1720]    [Pg.77]    [Pg.77]    [Pg.140]    [Pg.20]    [Pg.383]    [Pg.43]    [Pg.77]    [Pg.922]    [Pg.1319]    [Pg.50]    [Pg.161]    [Pg.192]    [Pg.192]    [Pg.292]   
See also in sourсe #XX -- [ Pg.1413 ]




SEARCH



Asbestos

Asbestos hazards

Hazard hazardous materials

Hazardous materials

Material hazards

© 2024 chempedia.info