Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

INDEX table

Choosing a Mobile Phase Several indices have been developed to assist in selecting a mobile phase, the most useful of which is the polarity index. Table 12.3 provides values for the polarity index, P, of several commonly used mobile phases, in which larger values of P correspond to more polar solvents. Mobile phases of intermediate polarity can be fashioned by mixing together two or more of the mobile phases in Table 12.3. For example, a binary mobile phase made by combining solvents A and B has a polarity index, of... [Pg.580]

It is thus seen that for polymers in which polarisations other than electronic ones are negligible (i.e. P = P ) the dielectric constant is equal to the square of the refractive index Table 6.2). [Pg.118]

In Figure 10.30 the predietive neural network model traeks the ehanging dynamies of the plant. Following a suitable time delay, em(kT) is passed to the performanee index table. If this indieates poor performanee as a result of ehanged plant dynamies, the rulebase is adjusted aeeordingly. Riehter (2000) demonstrated that this teehnique eould improve and stabilize a SOFLC when applied to the autopilot of a small motorized surfaee vessel. [Pg.364]

Section 5.3, Data Table Presentation, illustrates the format used for data tables and explains the type of information contained. Data tables have been presented only for those data cells where data existed at that level in the taxonomy. These are listed by taxonomy number in the Data Cell Index, Table 5.2. [Pg.126]

Register, n. index (table of) contents register record, -band, n. index volume. >karte, /, index card. [Pg.361]

The hydroboration/oxidation sequence does not change the molecular-weight distribution. Gel permeation chromatography (GPC) measurements in dimethyl-formamide (DMF) with the resulting polystyrene-ft-polyalcohol polymers show very similar polydispersity indexes (Table 10.2). Here, the hydroboration/oxidation sequence is clearly superior to the epoxidation reaction, which leads to a... [Pg.154]

There are many different types of soil, and extractant formulations have been fine-tuned to suit the soil. The particular extractant may also be chosen on the basis of familiarity over the years, and because it is easier to compare results with those previously obtained, and hence make recommendations to correct deficiencies based on experience. Usually one is not interested in the total amount of a soil nutrient, rather in the amount that is in a form available to the roots of the plant. Regional advisory laboratories over a long period may have developed index tables relating to the found concentration of nutrient in local soil types and the corrective amount of fertilizer required. It would probably be wise to adopt the same methods that have been used to... [Pg.50]

Analyses will be those in common use for soils from fields for both grass and arable crops. MAFF/ADAS (now DEFRA) methods and Index Tables are reproduced by permission of the Controller of Her Majesty s Stationery Office (Ref. 20001327). Analyses for nitrogen mineralization are included. Special consideration will be given to composts and recycled urban waste. [Pg.280]

The Concise Guides address topics of special concern to psychiatrists in clinical practice. The books in this series contain a detailed table of contents, along with an index, tables, figures, and other charts for easy access. The books are designed to fit into a laboratory coat pocket or jacket pocket, which makes them a convenient source of information. References have been limited to those most relevant to the material presented. [Pg.258]

Functions of properties such as the viscosity index or the viscosity gravity constant may be useful. However, the values of a function for a series of fractions of the same oil may be of approximately equal magnitude or may not be serial, as illustrated by the viscosity index (Table I). [Pg.35]

This kind of software information is now also available to the wider marketplace through, for example, electronic books that provide an infinitely customizable, all-in-one package, combining technical manual calculations for all common water treatment areas, displays for system material balance, saturation index tables, report generator, etc. An example of this type of software is the Water Treatment Handbook On-Disk from LXF Inc. [Pg.395]

Q. kelloggii tree seedlings grown under experimentally controlled daytime temperatures of 22 °C (low temperature treatment) or 27 °C (high temperature treatment) do not show a significant difference in either stomatal density or stomatal index (Table 4 Fig. 8). [Pg.217]

The Colour Index (C.I.) is almost exclusively a listing of textile dyes (and pigments), and dyes for leather appear only in a supplementary chapter and are classified mostly as acid, direct, and mordant dyes [2], About 1500 leather dyes are listed in the Colour Index (Table 5.1), with more then 1000 acid and more than... [Pg.429]

The pyrrolopyridines contain one nitrogen heteroatom in the five-membered pyrrole ring and one nitrogen atom in the six-membered pyridine ring. A more common name is azaindoles, with 7-azaindole (l//-pyrrolo[2,3-6]pyridine (1)) being the most widely studied isomer of the series. Twelve isomers of pyrrolopyridines are listed in the Chemical Abstracts Ring Formula Index. Table 1 lists the pyrrolopyridines with their Chemical Abstracts Registry Numbers. The 1//-pyrrolopyridines (l)-(6) are the most frequently prepared, but some work has also been carried out on the isomers (7), (8), and (10). Isomers (8), (9), (11), and (12) are tautomeric structures which are considered later (see Section 7.06.4.4). [Pg.169]

Each of the technical sections in the review copy must be separately bound in its own particular color folder as previously discussed. Each technical section should include an index (table of contents) for the section, a copy of the application form (FDA 356h), a copy of the cover letter, any letters of authorization, and a copy of the application summary. These items should be separated by tabs clearly marked as to the information being submitted. [Pg.149]

Many different types of cost indexes are published regularly. Some of these can be used for estimating equipment costs others apply specifically to labor, construction, materials, or other specialized fields. The most common of these indexes are the Marshall and Swift all-industry and process-industry equipment indexes, the Engineering News-Record construction index, the Nelsotl-Fatrar refinery construction index, and the Chemical Engineering plant cost index. Table 3 presents a list of values for various types of indexes over the past 15 years. [Pg.164]

Solution. If Eq. (8) is used with a 0.6 power factor and the Marshall and Swift all-industry index (Table 3), the fixed-capital investment is... [Pg.190]


See other pages where INDEX table is mentioned: [Pg.59]    [Pg.346]    [Pg.347]    [Pg.375]    [Pg.490]    [Pg.793]    [Pg.277]    [Pg.999]    [Pg.242]    [Pg.95]    [Pg.95]    [Pg.225]    [Pg.459]    [Pg.20]    [Pg.158]    [Pg.775]    [Pg.225]    [Pg.284]    [Pg.281]    [Pg.499]    [Pg.277]    [Pg.960]    [Pg.188]   
See also in sourсe #XX -- [ Pg.502 ]

See also in sourсe #XX -- [ Pg.239 ]




SEARCH



Alphabetical Index to Substances in Tables

Formula Index of Substances in Tables

Formula index table

Index to the Tables

Logarithms, table INDEX

Performance index table

Periodic table 116 index

Refractive index table

Refractive indices, defined table

Relative thermal indices table

Retention index table

Soil Index Table

Subject index The abbreviations , in Tables

Tables ligand index

© 2024 chempedia.info