Epoxides hydrolytic

In general, the enantiomeric excess and the configuration of the optically active alcohols are strongly dependent on the structure of the starting carbonyl compound many examples of diastereo-selective reduction have also been reported. The reduction of an epoxy ketone is accompanied by a stereocontrolled epoxide hydrolytic opening to afford a racemic triol, diastereomerically pure (eq 4). ... 

Only the second step, the catalytic cleavage of DSA or methyl dihydroxystearate (MDS), was carried out using oxygen when two-stage processes for the synthesis of AA or MMA from fatty acids or esters were developed (Scheme 20.3). The first step, a direct dihydroxylation or an epoxidation/hydrolytic ring scission of an epoxide formed as intermediate, may be performed using H2O2 or performic acid as oxidant, for example. 

The hydrogeh atom bound to the amide nitrogen in 15 is rather acidic and it can be easily removed as a proton in the presence of some competent base. Naturally, such an event would afford a delocalized anion, a nucleophilic species, which could attack the proximal epoxide at position 16 in an intramolecular fashion to give the desired azabicyclo[3.2.1]octanol framework. In the event, when a solution of 15 in benzene is treated with sodium hydride at 100 °C, the processes just outlined do in fact take place and intermediate 14 is obtained after hydrolytic cleavage of the trifluoroacetyl group with potassium hydroxide. The formation of azabi-cyclo[3.2.1]octanol 14 in an overall yield of 43% from enone 16 underscores the efficiency of Overman s route to this heavily functionalized bicycle. 

The principle cost determinant in typical hydrolytic or phenolic resolutions is the cobalt catalyst, despite the relatively low catalyst loadings used in most cases and the demonstrated recyclability with key substrates. From this standpoint, recently developed oligomeric (salen)Co complexes, discussed earlier in this chapter in the context of the hydrolytic desymmetrization of meso-epoxides (Scheme 7.16), offer significant advantages for kinetic resolutions of racemic terminal epoxides (Table 7.3) [29-31]. For the hydrolytic and phenolic kinetic resolutions, the oligo-... 

Several reports regarding the directed evolution of enantioselective epoxide hydrolases (EHs) have appeared [23,57-59]. These enzymes constitute important catalysts in synthetic organic chemistry [4,60]. The first two reported studies concern the Aspergillus niger epoxide hydrolase (ANEH) [57,58]. Initial attempts were made to enhance the enantioselectivity of the AN E H -catalyzed hydrolytic kinetic resolution of glycidyl phenyl ether (rac-19). The WT leads to an Evalue of only 4.6 in favor of (S)-20 (see Scheme 2.4) [58]. 

In another study that appeared prior to the advent of CASTing, the traditional combination of epPCR and DNA shuffling was used to enhance the enantioselectivity of the hydrolytic kinetic resolution of p-nitro phenyl glycidyl ether and other epoxides catalyzed by the EH from Agrobacterium radiobacter [59]. Several mutants were obtained with up to 13-fold improved enantioselectivity. The amino acid exchanges took place around the active site. 

Figure 2.15 Iterative CASTing in the evolution of enantioseiective epoxide hydrolases as catalysts in the hydrolytic kinetic resolution ofrac-19[23].

Another application of salen ligands is the hydrolytic kinetic resolution of epoxides (Scheme 3). For this purpose cobalt complexes are efficient, and fiu-... 

The asymmetric ring opening (ARO) of racemic terminal epoxides with H2O via hydrolytic kinetic resolution provides an efficient synthetic route to prepare optically pure terminal epoxides. The dimeric type chiral Co(salen)AlX3 complex has great potential to catalyze HKR of terminal epoxides in a highly reactive and enantioselective manner in comparison to their monomeric analogy. 

The hydrolytic kinetic resolution of terminal epoxides catalyzed by the monomer la and dimer lb... 

The hydrolytic kinetic resolution (HKR) of terminal epoxides using Co-salen catalysts provides a convenient route to the synthesis of enantioemiched chiral compounds by selectively converting one enantiomer of the racemic mixture (with a maximum 50% yield and 100% ee) (1-3). The use of water as the nucleophile makes this reaction straightforward to perform at a relatively low cost. The homogeneous Co(III) salen catalyst developed by Jacobsen s group has been shown to provide high... 

Hydrolytic Kinetic Resolution (HKR) of epichlorohydrin. The HKR reaction was performed by the standard procedure as reported by us earlier (17, 22). After the completion of the HKR reaction, all of the reaction products were removed by evacuation (epoxide was removed at room temperature ( 300 K) and diol was removed at a temperature of 323-329 K). The recovered catalyst was then recycled up to three times in the HKR reaction. For flow experiments, a mixture of racemic epichlorohydrin (600 mmol), water (0.7 eq., 7.56 ml) and chlorobenzene (7.2 ml) in isopropyl alcohol (600 mmol) as the co-solvent was pumped across a 12 cm long stainless steel fixed bed reactor containing SBA-15 Co-OAc salen catalyst (B) bed ( 297 mg) via syringe pump at a flow rate of 35 p,l/min. Approximately 10 cm of the reactor inlet was filled with glass beads and a 2 pm stainless steel frit was installed at the outlet of the reactor. Reaction products were analyzed by gas chromatography using ChiralDex GTA capillary column and an FID detector. 

A heterogeneous olefin epoxidation catalyst containing both V and Ti in the active site was prepared by sequential non-hydrolytic grafting. The silica was exposed first to VO(OiPr)3 vapor followed by Ti(0 Pr)4 vapor. Formation of propene is evidence for the creation of Ti-O-V linkages on the surface. Upon metathesis of the 2-propoxide ligands with BuOOH, the catalyst becomes active for the gas phase epoxidation of cyclohexene. The kinetics of epoxidation are biphasic, indicating the presence of two reactive sites whose activity differs by approximately one order of magnitude. 

S,12S)-2,12-Diacetoxytridecane (17) is a component of the female pheromone of pea midges (Contarinia pisi). Kitching synthesized 17 as shown in Scheme 28 by employing Jacobsen s hydrolytic kinetic resolution of terminal epoxides with a (salen)Co(OAc) complex, (S,S)-B [46]. By this reaction bis-... 

Based on the composition of the C18 family of cutin monomers we postulated that oleic acid would be > hydroxy la ted first, followed by epoxidation of the double bond at C-9 followed by the hydrolytic cleavage of the oxirane to yield 9,10,18-trihydroxy acid. This postulate was experimentally verified by the demonstration of specific incorporation of exogenous 18-hydroxyoleic acid into 18-hydroxy-9,10-epoxy C18 acid in grape berry skin slices and apple fruit skin disks, and incorporation of exogenous labeled 18-hydroxy-9,10-epoxy C18 acid into 9,10,18-trihydroxy C18 acid of cutin in apple fruit skin slices [61]. 

Jacobsen et al. reported enhanced catalytic activity by cooperative effects in the asymmetric ring opening (ARO) of epoxides.[38] Chiral Co-salen complexes (Figure 4.27) were used, which were bound to different generations of commercial PAMAM dendrimers. As a direct consequence of the second-order kinetic dependence on the [Co(salen)] complex concentration of the hydrolytic kinetic resolution (HKR), reduction of the catalyst loading using monomeric catalyst leads to a sharp decrease in overall reaction rate. 

FIGURE 6.10 Mechanism of epoxide hydrolase-catalyzed hydrolytic opening of an epoxide. 

Covalent attachment chiral Co(salen) complexes to polystyrene and silica gave efficient and highly enantioselective catalysts for the hydrolytic kinetic resolution (HKR) of terminal epoxides, including epichlorohydrin. These systems provide practical solutions to difficulties with the isolation of reaction products from the HKR. Removal of the supported catalyst by filtration and repeated recycling was demonstrated with no loss of reactivity or enantioselectivity. The immobilised catalysts have been adapted to a... 

---