Economics conversion

Private CO. H A 70 organic farmers in micro-basin Hierarchical/ technical relationship Super-planning Input and technical assistance Group certification High visual quality City supermarkets Demand- stimulated conversion Economic realism, technological orientation High environment impact... 

Downstream Conversion Economic Outlook Future Prospects Acknowledgments References... 

Plots of economic potential versus reactor conversion allow the optimal reactor conversion for a given flowsheet to be identified (Fig. 8.2). Although this approach allows the location of the optimum to be found, it does not give any indication of why the optimum occurs where it does. 

Rgure 8.2 A plot of economic potential versus conversion shows where the optimum is, but why does the optimum occur where it is ... 

Economic tradeoffs. Interactions between the reactor and the rest of the process are extremely important. Reactor conversion is the most significant optimization variable because it tends to influence most operations through the process. Also, when inerts are present in the recycle, the concentration of inerts is another important optimization variable, again influencing operations throughout the process. ... 

A detailed study of the properties of the potential products is of prime technical and economic importance, because it allows the refiner to have a choice in selecting feedstocks for his different units for separation, transformation and conversion, to set their operating conditions, in order to satisfy the needs of the marketplace in the best ways possible. 

A catalyst is a material that accelerates a reaction rate towards thennodynamic equilibrium conversion without itself being consumed in the reaction. Reactions occur on catalysts at particular sites, called active sites , which may have different electronic and geometric structures than neighbouring sites. Catalytic reactions are at the heart of many chemical industries, and account for a large fraction of worldwide chemical production. Research into fiindamental aspects of catalytic reactions has a strong economic motivating factor a better understanding of the catalytic process... 

The equilibrium constant for this reaction decreases with increase in temperature but the higher temperature is required to achieve a reasonable rate of conversion. Hydrogen chloride is now being produced in increasing quantities as a by-product in organic chlorination reactions and it is economic to re-convert this to chlorine. 

Ca.ta.lysts, Catalyst performance is the most important factor in the economics of an oxidation process. It is measured by activity (conversion of reactant), selectivity (conversion of reactant to desked product), rate of production (production of desked product per unit of reactor volume per unit of time), and catalyst life (effective time on-stream before significant loss of activity or selectivity). 

The propylene-based process developed by Sohio was able to displace all other commercial production technologies because of its substantial advantage in overall production costs, primarily due to lower raw material costs. Raw material costs less by-product credits account for about 60% of the total acrylonitrile production cost for a world-scale plant. The process has remained economically advantaged over other process technologies since the first commercial plant in 1960 because of the higher acrylonitrile yields resulting from the introduction of improved commercial catalysts. Reported per-pass conversions of propylene to acrylonitrile have increased from about 65% to over 80% (28,68—70). 

A survey of nonelectrolytic routes for CI2 production was conducted by Argonne National Laboratory the economics of these processes were examined in detail (76). One route identified as energy efficient and economically attractive is the conversion of waste NH Cl to CI2. 

Coal is used ia industry both as a fuel and ia much lower volume as a source of chemicals. In this respect it is like petroleum and natural gas whose consumption also is heavily dominated by fuel use. Coal was once the principal feedstock for chemical production, but ia the 1950s it became more economical to obtain most industrial chemicals from petroleum and gas. Nevertheless, certain chemicals continue to be obtained from coal by traditional routes, and an interest in coal-based chemicals has been maintained in academic and industrial research laboratories. Much of the recent activity in coal conversion has been focused on production of synthetic fuels, but significant progress also has been made on use of coal as a chemical feedstock (see Coal CONVERSION processes). 

In 1991, the relatively old and small synthetic fuel production faciHties at Sasol One began a transformation to a higher value chemical production facihty (38). This move came as a result of declining economics for synthetic fuel production from synthesis gas at this location. The new faciHties installed in this conversion will expand production of high value Arge waxes and paraffins to 123,000 t/yr in 1993. Also, a new faciHty for production of 240,00 t/yr of ammonia will be added. The complex will continue to produce ethylene and process feedstock from other Sasol plants to produce alcohols and higher phenols. 

Because an excess of ammonia is fed to the reactor, and because the reactions ate reversible, ammonia and carbon dioxide exit the reactor along with the carbamate and urea. Several process variations have been developed to deal with the efficiency of the conversion and with serious corrosion problems. The three main types of ammonia handling ate once through, partial recycle, and total recycle. Urea plants having capacity up to 1800 t/d ate available. Most advances have dealt with reduction of energy requirements in the total recycle process. The economics of urea production ate most strongly influenced by the cost of the taw material ammonia. When the ammonia cost is representative of production cost in a new plant it can amount to more than 50% of urea cost. 

Economic Aspects. Pertinent statistics on the U.S. production and consumption of fluorspar are given in Table 4. For many years the United States has rehed on imports for more than 80% of fluorspar needs. The principal sources are Mexico, China, and the Repubflc of South Africa. Imports from Mexico have declined in part because Mexican export regulations favor domestic conversion of fluorspar to hydrogen fluoride for export to the United States. 

Direct conversion of natural gas to Hquids has been actively researched. Process economics are highly variable and it is unclear whether direct natural gas conversion technologies are competitive with the estabUshed indirect processes. Some emerging technologies in this area are presented herein. 

---