Colloid stabilizer

A number of refinements and applications are in the literature. Corrections may be made for discreteness of charge [36] or the excluded volume of the hydrated ions [19, 37]. The effects of surface roughness on the electrical double layer have been treated by several groups [38-41] by means of perturbative expansions and numerical analysis. Several geometries have been treated, including two eccentric spheres such as found in encapsulated proteins or drugs [42], and biconcave disks with elastic membranes to model red blood cells [43]. The double-layer repulsion between two spheres has been a topic of much attention due to its importance in colloidal stability. A new numeri-... 

Two nucleation processes important to many people (including some surface scientists ) occur in the formation of gallstones in human bile and kidney stones in urine. Cholesterol crystallization in bile causes the formation of gallstones. Cryotransmission microscopy (Chapter VIII) studies of human bile reveal vesicles, micelles, and potential early crystallites indicating that the cholesterol crystallization in bile is not cooperative and the true nucleation time may be much shorter than that found by standard clinical analysis by light microscopy [75]. Kidney stones often form from crystals of calcium oxalates in urine. Inhibitors can prevent nucleation and influence the solid phase and intercrystallite interactions [76, 77]. Citrate, for example, is an important physiological inhibitor to the formation of calcium renal stones. Electrokinetic studies (see Section V-6) have shown the effect of various inhibitors on the surface potential and colloidal stability of micrometer-sized dispersions of calcium oxalate crystals formed in synthetic urine [78, 79]. 

The remainder of this contribution is organized as follows. In section C2.6.2, some well studied colloidal model systems are introduced. Methods for characterizing colloidal suspensions are presented in section C2.6.3. An essential starting point for understanding the behaviour of colloids is a description of the interactions between particles. Various factors contributing to these are discussed in section C2.6.4. Following on from this, theories of colloid stability and of the kinetics of aggregation are presented in section C2.6.5. Finally, section C2.6.6 is devoted to the phase behaviour of concentrated suspensions. 

The first case is relevant in the discussion of colloid stability of section C2.6.5. It uses the potential around a single sphere in the case of a double layer that is thin compared to the particle, Ka 1. Furthennore, it is assumed that the surface separation is fairly large, such that exp(-K/f) 1, so the potential between two spheres can be calculated from the sum of single-sphere potentials. Under these conditions, is approximated by [42] ... 

For a more complete understanding of colloid stability, we need to address the kinetics of aggregation. The theory discussed here was developed to describe coagulation of charged colloids, but it does apply to other cases as well. First, we consider the case of so-called rapid coagulation, which means that two particles will aggregate as soon as they meet (at high salt concentration, for instance). This was considered by von Smoluchowski 1561 here we follow [39, 57]. 

Altliough tire tlieories of colloid stability and aggregation kinetics were developed several decades ago, tire actual stmcture of aggregates has only been studied more recently. To describe tire stmcture, we start witli tire relationship between tire size of an aggregate (linear dimension), expressed as its radius of gyration and its mass m ... 

Hidalgo-Alvarez R, Martin A, Fernandez A, Bastes D, Martinez F and de las Nieves F J 1996 Electro kinetic properties, colloidal stability and aggregation kinetics of polymer colloids Adv. Colloid Interface Sc/. 67 1-118... 

Table 4. Representative Solution and Surface Equilibria Influencing Colloidal Stability...

Colloidal Stabilization. Surfactant adsorption reduces soil—substrate interactions and faciUtates soil removal. For a better understanding of these interactions, a consideration of coUoidal forces is required. 

At the pH = Jt there is a balance of charge and there is no migration in an electric field. This is referred to as the isoelectric point and is determined by the relative dissociation constants of the acidic and basic side groups and does not necessarily correspond to neutrality on the pH scale. The isoelectric point for casein is about pH = 4.6 and at this point colloidal stability is at a minimum. This fact is utilised in the acid coagulation techniques for separating casein from skimmed milk. 

Neoprene latex 115 contains a copolymer of chloroprene and methacrylic acid, stabilized with polyvinyl alcohol [15], With respect to other polychloroprene latices, this latex has two major advantages (1) excellent colloidal stability, which gives high resistance to shear and a broad tolerance to several materials ... 

Surfactants. These enhance the colloid stability against mechanical and chemical stresses, help to disperse fillers, aid in wetting and enhance foaming. The most common surfactants are dodecylbenzene sulphonates and potassium oleate. 

Wetting agents. These facilitate the wetting of surfaces and aid colloidal stability without foaming. Naphthalene sulphonate/formaldehyde is the most common wetting agent. 

Figure 6.9 Influence of electrolyte concentration on colloid stability ( denotes change from a stable to an aggregated state)...

Petliica, B.A., 1986. A development chemists guide to colloidal stability. Colloids and Surfaces, 20, 151-170. 

J. F. Joanny, L. Leibler, P. G. de Gennes. Effects of polymer solutions on colloid stability. J Polym Sci Polym Phys Ed 77 1073-1084, 1979. 

Based on the application of the established theory of colloid stability of water treatment particles [8,85-88], the colloidal particles in untreated water are attached to one another by van der waals forces and, therefore, always tend to aggregate unless kept apart by electrostatic repulsion forces arising from the presence of electrical charges on the particles. The aggregation process... 

The particles therefore lose their charge. Since the charge provides the colloidal stability, the colloidal paint destabilises and deposits on the nearest surface, the car body. Primer coatings 12-35 /im thick are applied according to primer type. Each particle also contains a crosslinker for the resin, usually a blocked isocyanate. After rinsing, the primed article is passed into a hot... 

The early attempts at NMP of S in emulsion used TEMPO and related nitroxides and needed to be carried out at high temperatures (100-130 °C) necessitating a pressure reactor. Problems with colloidal stability and molecular weight control and limiting conversions were reported.215 217... 

The surface force apparatus (SFA) is a device that detects the variations of normal and tangential forces resulting from the molecule interactions, as a function of normal distance between two curved surfaces in relative motion. SFA has been successfully used over the past years for investigating various surface phenomena, such as adhesion, rheology of confined liquid and polymers, colloid stability, and boundary friction. The first SFA was invented in 1969 by Tabor and Winterton [23] and was further developed in 1972 by Israela-chivili and Tabor [24]. The device was employed for direct measurement of the van der Waals forces in the air or vacuum between molecularly smooth mica surfaces in the distance range of 1.5-130 nm. The results confirmed the prediction of the Lifshitz theory on van der Waals interactions down to the separations as small as 1.5 nm. 

First though, we must outline albeit very briefly, the basic factors important to colloidal stability and self-assembly. It is these areas that clearly hold the insights we require. Throughout the section, we highlight possible control mechanisms available to the natural system. 

The mechanism of formation of Pt particles by the or-ganometallic reduction route, however, was found to proceed differently, for example in the reductive stabilization of Pt nanoparticles produced by reacting Pt-acetylacetonate with excess trimethylaluminium. Here, derivates of aluminium alkyls act as both reducing agents and colloidal stabilizers. As was shown by a combination... 

---