Cobalt 01 chloride

Cobalt chloride, C0CI2. Obtained as red crystals of CoCl2 6H20 from aqueous solution, CoCU HiO and C0CI2 are blue as is the (CoCU) " ion. No higher chloride is known although cobalt-haloammines, e.g. (Co(NH3)5C1) are stable. 

The following simple test distinguishes fructose from all other carbohydrates. Upon heating a little fructose with dilute cobalt chloride solution, cooling and treating with a little ammonia solution, a violet to purple colour is developed, - the colour gradually fades and must be observed immediately after the addition of the ammonia solution. Green cobalt hydroxide is formed with all other carbohydrates. 

A typical Ziegler-Natta catalyst might be made from TiCl or TiCl and Al(C2H )3. Vanadium and cobalt chlorides are also used, as is A1(C2H3)2C1. When these substances are mixed in an inert solvent, a crystalline soHd is obtained. Early catalysts consisted of the finely divided soHd alone, but in modern catalysts, it is often supported on Si02 or MgCl2. 

Many forms of chromatography have been used to separate mixtures of quinoline and isoquinoline homologues. For example, alumina saturated with cobalt chloride, reversed-phase Hquid chromatography, and capillary gas chromatography (gc) with deactivated glass columns have all been employed (38,39). 

Color. Many water samples have a yellow to brownish-yeUow color which is caused by natural substances, eg, leaves, bark, humus, and peat material. Turbidity in a sample can make the measurement of color uncertain and is usually removed by centrifiigation prior to analysis. The color is usually measured by comparison of the sample with known concentrations of colored solutions. A platinum—cobalt solution is used as the standard, and the unit of color is that produced by 1 mg/L platinum as chloroplatinate ion. The standard is prepared from potassium chloroplatinate (K PtCl ) and cobalt chloride (C0CI26H2O). The sample may also be compared to suitably caUbrated special glass color disks. 

Choline Bitartrate. This substance [87-67-2] is a white crystalline material possessing an acid taste. It melts at 149—I53°C. Analysis by cobaltous chloride shows more than 99% as the bitartrate. Free ethylene glycol is less than 0.25%, with free alkaU at 0.0%. 

Cobalt(II) chloride hexahydrate [7791-13-1], C0CI2 6H20 is a deep red monoclinic crystalline material that deflquesces. It is prepared by reaction of hydrochloric acid with the metal, simple oxide, mixed valence oxides, carbonate, or hydroxide. A high purity cobalt chloride has also been prepared electrolyticaHy (4). The chloride is very soluble in water and alcohols. The dehydration of the hexahydrate occurs stepwise ... 

As with polybut-l-ene and many other vinyl monomers that contain an asymmetric carbon, isotactic, syndiotactic and atactic stmctures may be drawn. Using co-ordination catalysts such as mixtures of cobalt chlorides, aluminium alkyls, pyridine and water high-1,2 (high vinyl) polymers may be obtained. One product marketed by the Japan Synthetic Rubber Company (JSR 1,2 PBD) is 91% 1,2, and 51-66% of the 1,2 units are in the syndiotactic state. The molecular mass is said to be several hundred thousand and the ratio MJM is in the range 1.7-2.6. 

Chemical Designations - Synonyms Cobalt (II) Chloride Cobaltous Chloride Cobaltous Chloride Dihydrate Cobaltous Chloride Hexahydrate Chemical Formula CoClj,... 

When cobaltous chloride is added instead of cuprous chloride, a 20% yield of the conjugate addition product and a 40% yield of compound 29 are obtained from 7. The isolation of some biphenyl indicates the probable presence of phenyl radicals. 

Kobalto-. cobaltous, cobalto-, cobalt(II). -chlorid, n. cobaltous chloride, cobalt(II) chloride, -cyanwasserstoff, m., -cyanwasser-stoffs ure, /. cobaltocyanic acid, -nitrat, n. cobaltous nitrate, cobalt(II) nitrate, -oxyd, n. cobaltous oxide, cobalt (II) oxide, -salz, n. cobaltous salt, cobalt(IJ) salt, -sulfat, n. cobaltous sulfate, cobalt(II) sulfate, -sulfid, n. cobaltous sulfide, cobalt (II) sulfide, -verbindung, /. cobaltous compound. cobalt(II) compound. 

Calcium carbonate Cobalt chloride Tap water Antifoam (GE 60)... 

Nylon-6,6 (7.5 g), nylon-6 (7.5 g), and 0.25 g of Lewis acid catalysts such as zinc chloride, cobalt chloride, calcium chloride, and barium carbonate were charged... 

Observation of colour changes in active ingredients, such as cobaltous chloride. 

An ionic compound is named with the cation name first, followed by the name of the anion the word ion is omitted in each case. The oxidation number of the cation is given if more than one charge is possible. However, if the cation comes from an element that exists in only one charge state (as listed in Fig. C.6), then the oxidation number is omitted. Typical names include potassium chloride (KC1), a compound containing K+ and Cl" ions and ammonium nitrate (NH4NOs), which contains NH4+ and NO3" ions. The cobalt chloride that contains Co2+ ions (CoCl,) is called cobalt(II) chloride C0CI3 contains Co3+ ions and is called cobalt(III) chloride. 

It was shown that dibenzothiophene oxide 17 is inert to 1-benzyl-1,4-dihydro nicotinamide (BNAH) but that, in the presence of catalytic amounts of metalloporphyrin, 17 is reduced quantitatively by BNAH. From experimental results with different catalysts [meso-tetraphenylporphinato iron(III) chloride (TPPFeCI) being the best] and a series of substituted sulfoxides, Oae and coworkers suggest an initial SET from BNAH to Fe followed by a second SET from the catalyst to the sulfoxide. The results are also consistent with an initial coordination of the substrate to Fe , thus weakening the sulfur-oxygen bond in a way reminiscent of the reduction of sulfoxides with sodium borohydride in the presence of catalytic amounts of cobalt chloride . ... 

Poly(dG-dC) poly(dG-dC) and its methylated analogue structures assume left-handed conformation (Z-DNA) in high molar sodium salt (Na", K" ), in low molar divalent cations (Ca", Mg", Ni ), micromolar concentrations of hexaamine cobalt chloride (Co(NH3)6)Cl3 and in millimolar concentrations of polyamines. In order to analyse the binding of berberine to Z-form DNA, Kumar et al. [186] reported that the Z-DNA structure of poly(dG-dC) poly(dG-dC) prepared in either a high salt concentration (4.0 M) or in 40 mM (Co(NH3)6)Cl3 remained invariant in the presence of berberine up to a nucleotide phosphate/alkaloid molar ratio of 0.8 and suggested that berberine neither bormd to Z-form DNA nor converted the Z-DNA to the... 

---