Benzoate reaction

Triphenyl-carbinol, (C6H5)3COHy from Ethyl Benzoate and Phenyl Magnesium Bromide. (Grignard Reaction 6 (a).)... 

Add 1 ml. of the alcohol-free ether to 0-1-0-15 g. of finely-powdered anhydrous zinc chloride and 0 5 g. of pure 3 5-dinitrobenzoyl chloride (Section 111,27,1) contained in a test-tube attach a small water condenser and reflux gently for 1 hour. Treat the reaction product with 10 ml. of 1-5N sodium carbonate solution, heat and stir the mixture for 1 minute upon a boiling water bath, allow to cool, and filter at the pump. Wash the precipitate with 5 ml. of 1 5N sodium carbonate solution and twice with 6 ml. of ether. Dry on a porous tile or upon a pad of filter paper. Transfer the crude ester to a test-tube and boil it with 10 ml. of chloroform or carbon tetrachloride filter the hot solution, if necessary. If the ester does not separate on cooling, evaporate to dryness on a water bath, and recrystallise the residue from 2-3 ml. of either of the above solvents. Determine the melting point of the resulting 3 5 dinitro benzoate (Section 111,27). 

Mix 31 g. (29-5 ml.) of benzyl alcohol (Section IV, 123 and Section IV,200) and 45 g. (43 ml.) of glacial acetic acid in a 500 ml. round-bottomed flask introduce 1 ml. of concentrated sulphuric acid and a few fragments of porous pot. Attach a reflux condenser to the flask and boil the mixture gently for 9 hours. Pour the reaction mixture into about 200 ml. of water contained in a separatory funnel, add 10 ml. of carbon tetrachloride (to eliminate emulsion formation owing to the slight difference in density of the ester and water, compare Methyl Benzoate, Section IV,176) and shake. Separate the lower layer (solution of benzyl acetate in carbon tetrachloride) and discard the upper aqueous layer. Return the lower layer to the funnel, and wash it successively with water, concentrated sodium bicarbonate solution (until effervescence ceases) and water. Dry over 5 g. of anhydrous magnesium sulphate, and distil under normal pressure (Fig. II, 13, 2) with the aid of an air bath (Fig. II, 5, 3). Collect the benzyl acetate a (colourless liquid) at 213-215°. The yield is 16 g. 

Dissolve 5 g. of phenol in 75 ml. of 10 per cent, sodium hydroxide solution contained in a wide-mouthed reagent bottle or conical flask of about 200 ml. capacity. Add 11 g. (9 ml.) of redistilled benzoyl chloride, cork the vessel securely, and shake the mixture vigorously for 15-20 minutes. At the end of this period the reaction is usually practically complete and a sohd product is obtained. Filter oflf the soUd ester with suction, break up any lumps on the filter, wash thoroughly with water and drain well. RecrystaUise the crude ester from rectified (or methylated) spirit use a quantity of hot solvent approximately twice the minimum volume required for complete solution in order to ensure that the ester does not separate until the temperature of the solution has fallen below the melting point of phenyl benzoate. Filter the hot solution, if necessary, through a hot water funnel or through a Buchner funnel preheated by the filtration of some boiling solvent. Colourless crystals of phenyl benzoate, m.p. 69°, are thus obtained. The yield is 8 g. 

The production of both an alcohol and the sodium salt of an acid might easily be confused with the hydrolysis products of an ester (in the above instance benzyl benzoate). Such an error would soon be discovered (e.g., by reference to the b.p. and other physical properties), but it would lead to an unnecessary expenditure of time and energy. The above example, however, emphasises the importance of conducting the class reactions of neutral oxygen-containing compounds in the proper order, viz., (1) aldehydes and ketones, (2) esters and anhydrides, (3) alcohols, and (4) ethers. 

Bemoyl chloride may replace acetyl chloride as a class reagent it possesses the advantage that it is only very slowly decomposed by cold water and consequently may be employed for detecting alcohols even in aqueous solution. The reaction is usually carried out in aqueous solution containing sufficient caustic alkali to decompose any excess of benzoyl chloride into the water-soluble alkali benzoate (Schotten - Baumann reaction compare Section IV,52). The benzoyl esters formed are insoluble in water ... 

Ingold and his co-workers used the competitive method in their experiments, in which nitration was brought about in acetic anhydride. Typically, the reaction solutions in these experiments contained o-8-I 4 mol of nitric acid, and the reaction time, depending on the reactivities of the compounds and the temperature, was 0-5-10 h. Results were obtained for the reactivities of toluene, > ethyl benzoate, the halogenobenzenes, ethyl phenyl acetate and benzyl chloride. Some of these and some later results are summarized in table 5.2. Results for the halogenobenzenes and nitrobiphenyls are discussed later ( 9.1.4, lo.i), and those for a series of benzylic compounds in 5,3.4. 

Triflates of phenols are carbonylated to form aromatic esters by using PhjP[328]. The reaction is 500 times faster if dppp is used[329]. This reaction is a good preparative method for benzoates from phenols and naphthoates (473) from naphthols. Carbonylation of the bis-triflate of axially chiral 1,1 -binaphthyl-2,2 -diol (474) using dppp was claimed to give the monocarboxy-late 475(330]. However, the optically pure dicarboxylate 476 is obtained under similar conditions[331]. The use of 4.4 equiv. of a hindered amine (ethyldiisopropylamine) is crucial for the dicarbonylation. The use of more or less than 4.4 equiv. of the amine gives the monoester 475. 

These results show that in the phenylation of thiazole with benzoyl peroxide two secondary reactions enter in competition the attack of thiazole by benzoyloxy radicals, leading to a mixture of thiazolyl benzoates, and the formation of dithiazolyle through attack of thiazole by the thiazolyl radicals resulting from hydrogen abstraction on the substrate and from the dimerization of these radicals. This last reaction is less important than in the case of thiophene but more important than in the case of pyridine (398). 

In an extension of the work described m the preceding section Bender showed that basic ester hydrolysis was not concerted and like acid hydrolysis took place by way of a tetrahedral intermediate The nature of the experiment was the same and the results were similar to those observed m the acid catalyzed reaction Ethyl benzoate enriched m 0 at the carbonyl oxygen was subjected to hydrolysis m base and samples were isolated before saponification was complete The recovered ethyl benzoate was found to have lost a por tion of Its isotopic label consistent with the formation of a tetrahedral intermediate... 

Esters of nonenolizable monocarboxylic acids such as ethyl benzoate give p diketones on reaction with ketone enolates... 

In one manufacturing process, aluminum chloride is treated with a solution containing sodium carbonate and sodium bicarbonate. The product of this reaction is mixed with the precipitate obtained by reaction of a solution of aluminum chloride and ammonia. The mixed magma is dialyzed, the product mixed with glycerol (qv), sodium benzoate is added, and the mixture is then passed through a coUoid mill. 

Aromatic diacyl peroxides such as dibenzoyl peroxide (BPO) [94-36-0] may be used with promoters to lower the usehil decomposition temperatures of the peroxides, although usually with some sacrifice to radical generation efficiency. The most widely used promoter is dimethylaniline (DMA). The BPO—DMA combination is used for hardening (curing) of unsaturated polyester resin compositions, eg, body putty in auto repair kits. Here, the aromatic amine promoter attacks the BPO to initially form W-benzoyloxydimethylanilinium benzoate (ion pair) which subsequentiy decomposes at room temperature to form a benzoate ion, a dimethylaniline radical cation, and a benzoyloxy radical that, in turn, initiates the curing reaction (33) ... 

Lithium Benzoate. Lithium benzoate [553-54-8], LiC2H 02, is formed by reaction of benzoic acid and lithium hydroxide in aqueous solution... 

The three chemical reactions in the toluene—benzoic acid process are oxidation of toluene to form benzoic acid, oxidation of benzoic acid to form phenyl benzoate, and hydrolysis of phenyl benzoate to form phenol. A typical process consists of two continuous steps (13,14). In the first step, the oxidation of toluene to benzoic acid is achieved with air and cobalt salt catalyst at a temperature between 121 and 177°C. The reactor is operated at 206 kPa gauge (2.1 kg/cm g uge) and the catalyst concentration is between 0.1 and 0.3%. The reactor effluent is distilled and the purified benzoic acid is collected. The overall yield of this process is beheved to be about 68 mol % of toluene. 

Mitsubishi Chemical Industries, Ltd. practiced a Henkel II technology starting with toluene to produce benzoic acid. Reaction of benzoic acid with potassium hydroxide resulted in potassium benzoate, which was subjected to a disproportionation reaction to produce dipotassium terephthalate and benzene. Dipotassium terephthalate reacted with sulfuric acid, and the resulting terephthahc acid was recovered by filtration and drying (65,66). Here, dipotassium sulfate was the by-product. 

As practiced by Hoffmann-La Roche, the commercial synthesis of vitamin is outlined ia Figure 1. Oxidation of 2-methylnaphthalene (4) yields menadione (3). Catalytic reduction to the naphthohydroquinone (5) is followed by reaction with a ben2oating reagent to yield the bis-benzoate (6). Selective deprotection yields the less hindered ben2oate (7). Condensation of isophytol (8) (see Vitamins, vitamins) with (7) under acid-cataly2ed conditions yields the coupled product (9). Saponification followed by an air oxidation yields vitamin (1) (29). 

In the Cannizaiio reaction, benzaldehyde is both oxidized and reduced to form benzoic acid (as the benzoate salt) and benzyl alcohol. 

Ben /ben ate [120-51-4] CgH COOCH2CgH, mp, 21°C, cff , 1.118 bp, 323—324°C at 101.3 kPa , 1.5681. This is a colorless, oily liquid with a faiat, pleasant aromatic odor and a sharp, burning taste. It occurs naturally iu Pern and Tolu balsams, is spariugly volatile with steam, and is iusoluble iu water. Benzyl benzoate is prepared commercially by the direct esterification of benzoic acid and benzyl alcohol or by reaction of benzyl chloride and sodium benzoate. The pleasant odor of benzyl benzoate, like other benzoic esters, has long been utilized iu the perfume iadustry, where it is employed as a solvent for synthetic musks and as a fixative. It has also been used iu confectionery and chewing gum flavors. 

Prior to the commercial development of this process benzyl alcohol was obtained from benzaldehyde [100-52-7] which undergoes the Cannizzaro reaction (2) upon treatment with potassium hydroxide. High yields of benzyl alcohol and potassium benzoate are obtained by this route which cannot compete with the present day process because of the high cost of benzaldehyde (qv). 

---