Atmospheric pressure laser ionization

Atmospheric pressure laser ionization (APLl) is a complementary technique to existing API methods. It is based on resonant or near-resonant two-photon ionization of aromatic ring systems. APLI utilizes resonantly enhanced multiphotonionization (REMPI) as the primary ion-production mechanism, nevertheless it occurs at atmospheric pressure [80],... 

O.J. Schmitz, T. Benter, Atmospheric pressure laser ionization (APLI). In A. Cappiello (Ed.) Advances in LC-MS Instrumentation, vol. 72 (Journal of Chromatography Library), Elsevier, Amsterdam, the Netherlands, 2007, pp. 89-113. 

Schmidt, S., M. F. Appel, R. M. Garnica, R. N. Schindler, and Th. Benter, Atmospheric Pressure Laser Ionization (APLI). A New Analytical Technique for Highly Selective Detection of Ultra-Low Concentrations in the Gas Phase, Anal Chem., in press (1999). 

Schmidt et al. [111] developed an atmospheric pressure laser ionization (APLI) source based on REMPI in pulsed gas expansions close to the inlet nozzle orifice (at high... 

The recently introduced atmospheric-pressure laser ionization system (APLI) can be considered as a modification of APPI (Ch. 5.7.3). In APLI, the one-step photoionization of APPI is replaced by a two-photon process in resonantly-enhanced multi-photon ionization [148]. Enhanced response for polycyclic aromatic hydrocarbons (relative to APCI) was demonstrated. Molecular ions rather than protonated molecules are generated in APLI (cf. Ch. 6.5). 

In the last 10 years, several new ionization methods for AP mass spectrometers were developed. Some of these are only available in some working groups. Therefore, only four commercially available ion sources are presented in detail here. The most common atmospheric pressure ionization (API) is ESI, followed by APCI and atmospheric pressure photo ionization (APPI). A significantly lower significance shows the atmospheric pressure laser ionization (APLI). However, this ion source is well suited for the analysis of aromatic compounds, and, for example, the gold standard for polyaromatic hydrocarbon (PAH) analysis. This ranking reflects more or less the chemical properties of the analytes, which are determined with API MS ... 

El = electron ionization Cl = chemical ionization ES = electrospray APCI = atmospheric-pressure chemical ionization MALDI = matrix-assisted laser desorption ionization PT = plasma torch (isotope ratios) TI = thermal (surface) ionization (isotope ratios). 

Figure 2.1 Mass spectrometric approach. Dl, direct inlet GC, gas chromatography HPLC, high performance liquid chromatography CZE, capillary zone electrophoresis El, electron ionization Cl, chemical ionization ESI, electrospray ionization DESI, desorption electrospray ionization APCI, atmospheric pressure chemical ionization MALDI, matrix assisted laser desorption ionization B, magnetic analyzer E, electrostatic analyzer...

DGE a AC AMS APCI API AP-MALDI APPI ASAP BIRD c CAD CE CF CF-FAB Cl CID cw CZE Da DAPCI DART DC DE DESI DIOS DTIMS EC ECD El ELDI EM ESI ETD eV f FAB FAIMS FD FI FT FTICR two-dimensional gel electrophoresis atto, 10 18 alternating current accelerator mass spectrometry atmospheric pressure chemical ionization atmospheric pressure ionization atmospheric pressure matrix-assisted laser desorption/ionization atmospheric pressure photoionization atmospheric-pressure solids analysis probe blackbody infrared radiative dissociation centi, 10-2 collision-activated dissociation capillary electrophoresis continuous flow continuous flow fast atom bombardment chemical ionization collision-induced dissociation continuous wave capillary zone electrophoresis dalton desorption atmospheric pressure chemical ionization direct analysis in real time direct current delayed extraction desorption electrospray ionization desorption/ionization on silicon drift tube ion mobility spectrometry electrochromatography electron capture dissociation electron ionization electrospray-assisted laser desorption/ionization electron multiplier electrospray ionization electron transfer dissociation electron volt femto, 1CT15 fast atom bombardment field asymmetric waveform ion mobility spectrometry field desorption field ionization Fourier transform Fourier transform ion cyclotron resonance... 

Laiko, V.V. Taranenko, N.I. Berkout, V.D. Musselman, B.D. Doroshenko, V.M. Atmospheric Pressure Laser Desorption/Ionization on Porous Silicon. Rapid Commun. Mass Spectrom. 2002,16, 1737-1742. 

Figure A.3A.1 Flow chart illustrating the selection of a suitable ionization technique for the mass spectrometric analysis of a sample. Abbreviations APCI, atmospheric pressure chemical ionization Cl, chemical ionization El, electron impact FAB, fast atom bombardment MALDI, matrix-assisted laser desorption/ionization.

Pihlainen, K., Grigoras, K., Franssila, S., Ketola, R., Kotiaho, T., and Kostiainen, R. (2005). Analysis of amphetamines and fentanyls by atmospheric pressure desorption/ionization on silicon mass spectrometry and matrix-assisted laser desorption/ionization mass spectrometry and its application to forensic analysis of drug seizures. J. Mass Spectrom. 40 539-545. 

Advanced analytical techniques, particularly mass spectrometry (MS), often combined with liquid chromatography (LC) or gas chromatography (GC), are requisite for lipid analysis and they have played the crucial role in the emergence as well as the progresses of lipidomics. MS is the principal choice for the lipid analysis, particularly using electrospray ionization (ESI) and sometimes also atmospheric pressure chemical ionization or laser-based MS methods for surface analysis. The MS-based techniques are the best choice for lipidomics due to their superior sensitivity and molecular specificity, and because they provide the ability to resolve the extensive compositional and structural diversity of lipids in biological systems. 

MAI,PI was introduced in the late 1980s and is one of the most successfully developed MS soft ionization techniques that uses the matrix assists laser ablation of sample-coated target to vaporize gas-phase ions for injection into a mass spectrometer. The advantage of MALDI is its gentleness compared with ESI and Atmospheric Pressure Chemical Ionization (APCI) and its ability to analyze the polar, nonvolatile, and large molecules. It has been very successfully used for the analysis of both biopolymers compounds and small molecular organic compounds (<1,500 Da). 

Strege summarized the technique of high-performance liquid chromatography-electrospray ionization mass spectrometry (HPLC-ESI-MS) in dereplication of natural products. In contrast to earlier electron impact ionization (El), ESI technique is applicable to virtually any ion in solution with a soft ionization process. A comparison of ESI with fast atom bombardment (FAB), matrix assisted laser desorption ionization (MALDI), atmospheric pressure chemical ionization (APCI) and other techniques demonstrates its superior sensitivity, compatibility and reliability when coupled with HPLC [51]. 

These direct ion sources exist under two types liquid-phase ion sources and solid-state ion sources. In liquid-phase ion sources the analyte is in solution. This solution is introduced, by nebulization, as droplets into the source where ions are produced at atmospheric pressure and focused into the mass spectrometer through some vacuum pumping stages. Electrospray, atmospheric pressure chemical ionization and atmospheric pressure photoionization sources correspond to this type. In solid-state ion sources, the analyte is in an involatile deposit. It is obtained by various preparation methods which frequently involve the introduction of a matrix that can be either a solid or a viscous fluid. This deposit is then irradiated by energetic particles or photons that desorb ions near the surface of the deposit. These ions can be extracted by an electric field and focused towards the analyser. Matrix-assisted laser desorption, secondary ion mass spectrometry, plasma desorption and field desorption sources all use this strategy to produce ions. Fast atom bombardment uses an involatile liquid matrix. 

An ideal interface should not cause extra-column peak broadening. Historical interfaces include the moving belt and the thermospray. Common interfaces are electrospray ionization (ESI) and atmospheric pressure chemical ionization (APCl). Several special interfaces include the particle beam—a pioneering technique that is still used because it is the only one that can provide electron ionization mass spectra. Others are continuous fiow fast atom bombardment (CF-FAB), atmospheric pressure photon ionization (APPI), and matrix-assisted laser desorption ionization (M ALDl). The two most common interfaces, ESI and APCI, were discovered in the late 1980s and involve an atmospheric pressure ionization (API) step. Both are soft ionization techniques that cause little or no fragmentation hence a fingerprint for qualitative identification is usually not apparent. 

Earlier methods of ionization applied to carotenoids, including electron impact (El), chemical ionization (Cl), a particle beam interface with El or Cl, and continuous-flow fast atom bombardment (CF-FAB), have been comprehensively reviewed elsewhere (van Breemen, 1996, 1997 Pajkovic and van Breemen, 2005). These techniques have generally been replaced by softer ionization techniques like electrospray ionization (ESI) and atmospheric pressure chemical ionization (APCI), and more recently atmospheric pressure photoionization (APPI). It should be noted that ESI, APCI, and APPI can be used as ionization methods with a direct infusion of an analyte in solution (i.e. not interfaced with an HPLC system), or as the interface between the HPEC and the MS. In contrast, matrix-assisted laser desorption ionization (MALDI) cannot be used directly with HPEC. 

Identification of the forms thus obtained using complementary molecule-specific techniques (nuclear magnetic resonance infrared [IR] matrix-assisted laser desorption/ionization electrospray ionization [ESl]/atmospheric pressure chemical ionization mass spectrometry [MS])... 

The dynamic development of mass spectrometry has had a huge impact on lipid analysis. Currently, a variety of suitable mass spectrometers is available. In principal, a mass spectrometer consists of an ion source, a mass analyzer, and an ion detector. The typical features of each instrument (Fig. 2) result mostly from the types of ion source and mass analyzer. To date, the ionization techniques apphed to lipid analysis include Electrospray Ionization (ESI or nano-ESI), Atmospheric Pressure Chemical Ionization (APCI), Matrix-Assisted Laser Desorption/Ionization... 

A variety of MS formats are widely accepted and applied in the pharmaceutical industry. The specific MS application is often defined by the sample introduction technique. The pharmaceutical applications highlighted in this article feature two types of sample introduction techniques dynamic and static. Dynamic sample introduction involves the use of high-performance liquid chromatography (HPLC) on-line with MS. The resulting liquid chromatography/mass spectrometry (LC/MS) format provides unique and enabling capabilities for pharmaceutical analysis. The electrospray ionization (ESI) and atmospheric pressure chemical ionization (APCI) modes are the most widely used. Static sample introduction techniques primarily use matrix-assisted laser desorption/ionization (MALDI). ... 

Liquid chromatography-mass spectrometiy (LC-MS) based on atmospheric-pressure ionization (API) was demonstrated as early as 1974 (Ch. 3.2.1). However, it took until the late 1980 s before API was starting to be widely applied. Today, it can be considered by far the most important interfacing strategy in LC-MS. More than 99% of the LC-MS performed today is based on API interfacing. In this chapter, instrumentation for API interfacing is discussed. First, vacuum system for MS and LC-MS are briefly discussed. Subsequently, attention is paid to instrumental and practical aspects of electrospray ionization (ESI), atmospheric-pressure chemical ionization (APCI), and other interfacing approaches based on API. The emphasis in the discussion is on commercially available systems and modifications thereof. Ionization phenomena and mechanisms are dealt with in a separate chapter (Ch. 6). Laser-based ionization for LC-MS is briefly reviewed (Ch. 5.9). 

Three popular ionization techniques are electrospray ionization (ESI), atmospheric pressure chemical ionization (APCI) and matrix-assisted laser desorption (MALDI). Electrospray is the most widely used ionization technique when performing LC-MS, and has proved to be a most versatile tool for soft ionization [72] of a large variety of analytes such as them described in paper I. Figure 6 shows the principle of the ESI. 

---