Ammonium action

Gramatikos SI, Valley U, Nimtz M, Conrad HS, Wagner R (1998), Intracellular UDP-V-acetylhexosamine pool affects Ai-glycan complexity a mechanism of ammonium action on protein glycosylation, Biotechnol. Prog. 14 410-419. 

All ammonium salts evolve ammonia on heating with alkali. Ammonia may be delected by (a) its smell, (b) its action in turning red litmus blue and (c) the orange-brown colour produced with Nessler s reagent. This is a very sensitive test. 

Ammonia may be estimated by dissolving the gas in a known volume of standard acid and then back-titrating the excess acid. In a method widely used for the determination of basic nitrogen in organic substances (the Kjeldahl method), the nitrogenous material is converted into ammonium sulphate by heating with concentrated sulphuric acid. The ammonia is then driven off by the action of alkali and absorbed in standard acid. 

The contents of B, which act as a control, are treated with mercuric chloride in order to inhibit the action of the enzyme, and then 10 ml. of urease solution are added. The solution is diluted with water and ammonium chloride added (in order to balance the ammonium chloride subsequently formed in A). Meth) l-red is then added and the solution is titrated with Mj 10 HCl from a second burette B until a bright red colour is obtained. 

Amino acids may be prepared by the action of a large excess of concentrated ammonia solution upon a-chloro- or a-bromo-acids the presence of a considerable amount of ammonium carbonate often increases the yield of monoamino acid, for example ... 

Mix 42 5 g. of acetone cyanohydrin (Section 111,75) and 75 g. of freshly powdered ammonium carbonate in a small beaker, warm the mixture on a water bath FUME CUPBOARD) and stir with a thermometer. Gentle action commences at 50° and continues during about 3 hours at 70-80°. To complete the reaction, raise the temperature to 90° and maintain it at this point until the mixture is quiescent (ca. 30 minutes). The colourless (or pale yellow) residue solidifies on coohng. Dissolve it in 60 ml. of hot water, digest with a little decolourising carbon, and filter rapidly through a pre-heated Buchner funnel. Evaporate the filtrate on a hot plate until crystals appear on the surface of the liquid, and then cool in ice. Filter off the white crystals with suction, drain well, and then wash twice with 4 ml. portions of ether this crop of crystals of dimethylhydantoin is almost pure and melts at 176°. Concentrate the mother liquor to the crj staUisation point, cool in ice, and collect the... 

Nitro compounds and their reduction products. Tertiary nitro compounds (these are generally aromatic) are reduced by zinc and ammonium chloride solution to the corresponding hydroxylamines, which may be detected by their reducing action upon an ammoniacal solution of silver nitrate or Tollen s reagent ... 

Other sulfur compounds such as thiourea, ammonium dithiocarbamate, or hydrogen sulfide also lead to 2-mercaptothiazoles. Thus thiourea has been used in the syntheses of 4,5-dimethyl (369) and 4-aryl-2-mercapto-thiazoles (Table 11-30) (519). The reactions were carried out by condensing the ia -thiocyanatoketones with thiourea in alcohol and water acidified with hydrochloric acid. By this procedure, 4-aryl-2-mercaptothiazoles were obtained in yields of 40 to 80% with bis-(4-aryl-2-thiazolyl) sulfides as by-products (519). These latter products (194) have also been observed as a result of the action of thiourea on 2-chloro-4-arylthiazole under the same experimental conditions. They can be separated from 2-mercaptothiazoles because of their different degrees of solubility in sodium hydroxide solution at 5%. In this medium bis-(4-phenyl-2-thiazolyl)sulfide is... 

Orthophosphate Hquid mixtures are ineffective as micronuttient carriers because of the formation of metal ammonium phosphates such as ZnNH PO. However, micronutrients are much more soluble in ammonium phosphate solutions in which a substantial proportion of the phosphoms is polyphosphate. The greater solubiHty results from the sequestering action of the polyphosphate. The amounts of Zn, Mn, Cu, and Fe soluble in base solution with 70% of its P as polyphosphate are 10 to 60 times their solubiHties in ammonium orthophosphate solution. When a mixture of several micronutrients is added to the same solution, the solubiHty of the individual metals is lowered significantly. In such mixtures the total micronuttient content should not exceed 3% and the storage time before precipitates appear may be much shorter than when only one micronuttient is present. 

The amount and physical character of the char from rigid urethane foams is found to be affected by the retardant (20—23) (see Foams Urethane polymers). The presence of a phosphoms-containing flame retardant causes a rigid urethane foam to form a more coherent char, possibly serving as a physical barrier to the combustion process. There is evidence that a substantial fraction of the phosphoms may be retained in the char. Chars from phenohc resins (qv) were shown to be much better barriers to pyrolysate vapors and air when ammonium phosphate was present in the original resin (24). This barrier action may at least partly explain the inhibition of glowing combustion of char by phosphoms compounds. 

High Purity Aluminum Trifluoride. High purity anhydrous aluminum triduoride that is free from oxide impurities can be prepared by reaction of gaseous anhydrous HF and AlCl at 100°C, gradually raising the temperature to 400°C. It can also be prepared by the action of elemental fluorine on metal/metal oxide and subsequent sublimation (12) or the decomposition of ammonium duoroaluminate at 700°C. 

Uses. Alkah metal and ammonium fluoroborates are used mainly for the high temperature fluxing action required by the metals processing industries (see Metal surface treatments Welding). The tendency toward BF dissociation at elevated temperatures inhibits oxidation in magnesium casting and aluminum alloy heat treatment. 

PbF2 is readily prepared by the action of hydrogen fluoride on lead hydroxide, lead carbonate, or a-lead oxide. It can also be obtained by precipitation from lead nitrate or lead acetate solutions using potassium fluoride, ammonium fluoride, or ammonium bifluoride. 

Sodium fluorosulfate may be prepared by the action of fluorosulfuric acid on powdered, ignited sodium chloride (13) or of sulfur trioxide on sodium fluoride (48). In general, the alkah metal fluorosulfates may be prepared from the ammonium salt by evaporating a solution containing that salt and an alkah metal hydroxide (77). The solubiUties of some Group 1 and 2 fluorosulfates in fluorosulfuric acid have been deterrnined (93). 

The action of redox metal promoters with MEKP appears to be highly specific. Cobalt salts appear to be a unique component of commercial redox systems, although vanadium appears to provide similar activity with MEKP. Cobalt activity can be supplemented by potassium and 2inc naphthenates in systems requiring low cured resin color lithium and lead naphthenates also act in a similar role. Quaternary ammonium salts (14) and tertiary amines accelerate the reaction rate of redox catalyst systems. The tertiary amines form beneficial complexes with the cobalt promoters, faciUtating the transition to the lower oxidation state. Copper naphthenate exerts a unique influence over cure rate in redox systems and is used widely to delay cure and reduce exotherm development during the cross-linking reaction. 

The iodine compound is more stable and separates as so-called nitrogen trHodide monoammoniate [14014-86-9], NI NH, an insoluble brownish-black soHd, which decomposes when exposed to light in the presence of ammonia. In reactions of the halogens with the respective ammonium salts, however, the action is different. Chlorine replaces hydrogen and nitrogen chloride [10025-85-1], NCl, separates as oily, yeUow droplets capable of spontaneous explosive decomposition. 

General types of physiological functions attributed to quaternary ammonium compounds are curare action, muscarinic—nicotinic action, and ganglia blocking action. The active substance of curare is a quaternary that can produce muscular paralysis without affecting the central nervous system or the heart. Muscarinic action is the stimulation of smooth-muscle tissue. Nicotinic action is primary transient stimulation and secondary persistent depression of sympathetic and parasympathetic ganglia. 

Agrochemical Products. Hydrazones of vanillin have been shown to have a herbicidal action similar to that of 2,4-D, and the zinc salts of dithiovanillic acid. Made by the reaction of vanillin and ammonium polysulfide in alcohoHc hydrochloric acid, dithiovanillic acid is a vulcanization inhibitor. 5-Hydroxymerciirivanillin, 5- a cetoxym erci iri va n ill in, and 5-ch1oromercurivani11in have been prepared and found to have disinfectant properties. 

Other bicarbonates of considerable commercial importance are ammonium bicarbonate [1066-33-7] and potassium bicarbonate [298-14-6]. These compounds are decomposed by the oven heat, Hberating ammonia, carbon dioxide, and water to faciUtate leavening action. Their uses are limited to low moisture products such as cookies and crackers. 

---