Ammonia acid chlorides

When treated with ammonia, acid chlorides are converted into amides. 

When treated with ammonia, acid chlorides are converted into amides. Two equivalents of ammonia are required one to serve as a nucleophile and the other to serve as a base. 

Method (1) is most frequently used for aliphatic acid amides, while Methods (2a), (2b) and (zc) are used most frequently for aromatic acid amides. Of the last three methods, the Acid Chloride Method (zb) is the most rapid and certain. The Ester Method (za) is practicable only when the amide is insoluble in water, and even then is often very slow unless the ester itself is appreciabb soluble in the aqueous ammonia solution. 

The choice of type of derivative should be based on whether the chloride or anhydride is aliphatic or aromatic, because this factoi largely determines the reactivity. Aliphatic acid chlorides are best converted into their anilides, as in 4 above aromatic acid chloride may be similarly converted into their anilides, or they may be converted into their amides by shaking with an excess of ammonia (p, 120). (M.ps., pp. 544-545.) Aliphatic acid anhydrides should be converted into their crystalline anilides, but aromatic acid anhydrides arc best hydrolysed to the acid, which can then be converted into one of the standard derivatives (p. 349). 

The by-products are both gaseous and the excess of thiouyl chloride (b.p. 78°) may be readily removed by distillation. Interaction of the acid chloride with ammonia solution, aniline or p-toluidiiie yields the amide, anilide or p-toluidide respectively ... 

Amides. TVeat the acid chloride cautiously with about 20 parts of concentrated ammonia solution (sp. gr. 0 - 88) and warm for a few moments. If no solid separates on cooling, evaporate to dryness on a water bath. Recrystallise the crude amide from water or dilute alcohol. 

Alternatively, dissolve or suspend the acid chloride in 5-10 ml. of dry ether or dry benzene, and pass in dry ammonia gas. If no solid separates, evaporate the solvent. Recrystallise the amide from water or dilute alcohol. 

Place 125 ml. of concentrated ammonia solution (sp. gr. 0-88) in a 600 ml. beaker and surround the latter with crushed ice. Stir the ammonia solution mechanically, and introduce the n-caproyl chloride slowly by means of a suitably supported separatory funnel with bent stem. The rate of addition must be adjusted so that no white fumes are lost. The amide separates immediately. Allow to stand in the ice water for 15 minutes after all the acid chloride has been introduced. Filter oflF the amide at the pump use the flltrate to assist the transfer of any amide remaining in the beaker to the Alter (2). Spread the amide on sheets of Alter or drying paper to dry in the air. The crude n-capro-amide (30 g.) has m.p. 98-99° and is sufficiently pure for conversion into the nitrile (Section 111,112) (3). Recrystallise a small quantity of the amide by dissolving it in the minimum volume of hot water and allowing the solution to cool dry on filter paper in the air. Pure n-caproamide has m.p. 100°. 

By the action of concentrated ammonia solution upon the appropriate acid chloride, for example ... 

Treatment of acid chlorides with ammonia or amines in benzene gives thiazolecarboxamides (71, 77. 78). 

Rea.ctlons, As with other tertiary alcohols, esterification with carboxyUc acids is difficult and esters are prepared with anhydrides (181), acid chlorides (182), or ketene (183). Carbamic esters may be prepared by treatment with an isocyanate (184) or with phosgene followed by ammonia or an amine (185). 

The hydrogenolysis of hydroxamic acids (22) and hydra2ides (23) has also been used to synthesi2e amides. One of the earliest methods for the preparation of amides consists of treating acid chlorides with dry ammonia or an amine (24). 

Silver Chloride. Silver chloride, AgCl, is a white precipitate that forms when chloride ion is added to a silver nitrate solution. The order of solubility of the three silver halides is Cl" > Br" > I. Because of the formation of complexes, silver chloride is soluble in solutions containing excess chloride and in solutions of cyanide, thiosulfate, and ammonia. Silver chloride is insoluble in nitric and dilute sulfuric acid. Treatment with concentrated sulfuric acid gives silver sulfate. 

Addition compounds form with those organics that contain a donor atom, eg, ketonic oxygen, nitrogen, and sulfur. Thus, adducts form with amides, amines, and A/-heterocycles, as well as acid chlorides and ethers. Addition compounds also form with a number of inorganic compounds, eg, POCl (6,120). In many cases, the addition compounds are dimeric, eg, with ethyl acetate, in titanium tetrachloride-rich systems. By using ammonia, a series of amidodichlorides, Ti(NH2) Cl4, is formed (133). 

Amides are also formed by the reaction of an acid chloride with ammonia or an amine ... 

Cl Vat Red 10 is prepared by condensation of l-nitroanthraquinone-2-carboxyhc acid chloride with 2-amino-3-hydroxyanthraquinone followed by ring closure in sulfuric acid and subsequent replacement of the nitro group with aqueous ammonia. 

Pyridazinecarboxamides are prepared from the corresponding esters or acid chlorides with ammonia or amines or by partial hydrolysis of cyanopyridazines. Pyridazinecarboxamides with a variety of substituents are easily dehydrated to nitriles with phosphorus oxychloride and are converted into the corresponding acids by acid or alkaline hydrolysis. They undergo Hofmann degradation to give the corresponding amines, while in the case of two ortho carboxamide groups pyrimidopyridazines are formed. 

Treatment of ammoniabearing waste from chemical industry Liberation of gaseous ammonia Ammonium chloride Nitric acid... 

A substituted benzoic acid serves as precursor for the nontricyclic antidepressant bipena-mol (175). Selective. saponification of ester 171 afford.s the half-acid 172. Reaction of the acid chloride derived from this intermediate (173) with ammonia gives the amide 174. Reduction of the last by means of lithium aluminum hydride gives bipenamol (175) [44]. 

IB.2 grams of a-phenylbutyric acid chloride are dissolved in 25 ml of toluene. To this solution, there is slowly added a solution of 16.1 grams of diethylaminoethoxyethanol in 25 ml of toluene, the reaction mixture thereby becoming hot. It is then heated for B hr under reflux. The reaction mixture, after cooling, is carefully poured onto 75 grams of ice and made alkaline with dilute ammonia. After thorough shaking of the solution, the toluene layer is removed and washed until neutral with water. The toluene solution is treated with carbon and dried over sodium sulfate. The toluene is distilled off from the filtered solution. 

To a solution of 93.8 g of the monoglycol ester in 500 ml of benzene, there are added 55 g of nicotinic acid chloride and 25 g of trimethylemine dissolved in 200 ml of benzene. The solution is stirred gently at a temperature of 60°C for two hours. After this time, the solution is cooled and washed successively with water, dilute hydrochloric acid, dilute ammonia and water until neutrality, it is dried over anhydrous sodium sulfate, and the sol vent Is evaporated under vacuum In this wey llOg of glycol 2-(p-chlorophenoxy)-2-methylpropionate nico-tlnate Is prepared, which represents a yield of 84%. The product is a sllghly yellow oil having a refraction index of no = 1.5422 and which is distilled with decomposition et 214°C at a pressure of 0.3 mm. 

Conversion of Acid Halides into Amides Aminolysis Acid chlorides react rapidly with ammonia and amines to give amides. As with the acid chloride plus alcohol method for preparing esters, this reaction of acid chlorides with amines is the most commonly used laboratory method for preparing amides. Both monosubstituted and disubstituted amines can be used, but not trisubstituted amines (R3N). 

Problem 21.12 How could you prepare the following amides using an acid chloride and an amine or ammonia ... 

Conversion of Esters into Amides Aminolysis Esters react with ammonia and amines to yield amides. The reaction is not often used, however, because it s usually easier to start with an acid chloride (Section 21.4). 

Amides are usually prepared by reaction of an acid chloride with an amine (Section 21.4). Ammonia monosubstituted amineS and disubstituted amines all undergo the reaction. 

The monoethanolamine-hydrochloric acid buffer has a buffering capacity equal to the ammonia-ammonium chloride buffer commonly employed for the titration of calcium and magnesium with EDTA and solochrome black (compare Section 10.54). The buffer has excellent keeping qualities, sharp end points are obtainable, and the strong ammonia solution is completely eliminated. 

Reagents. In view of the sensitivity of the method, the reagents employed for preparing the ground solutions must be very pure, and the water used should be re-distilled in an all-glass, or better, an all-silica apparatus the traces of organic material sometimes encountered in demineralised water (Section 3.17) make such water unsuitable for this technique unless it is distilled. The common supporting electrolytes include potassium chloride, sodium acetate-acetic acid buffer solutions, ammonia-ammonium chloride buffer solutions, hydrochloric acid and potassium nitrate. 

This fluorescent acid chloride can be used to form derivatives of alcohols, amines, and phenols. Using these fluorescent derivatives, an analysis of a series of n-alcohols from Ci to C4 was developed. A chromatogram produced by this technique is shown in Figure 3. Derivatives were also formed from ammonia, dimethylamine, and phenol. A derivative was formed from pentachlorophenol but was not fully characterized. The quantum yields of fluorescence of the alcohol derivatives of V were lower than those of the alkyl halide derivatives of III. 

When the -OH of a carboxylic acid is replaced by an -NH2, the compound produced is an amide. Amides are neutral to mildly basic compounds. They can be made from acids, acid chlorides, acid anhydrides, and esters by reaction with ammonia or primary and secondary amines. The amide linkage is found in polyamide resins such as nylon. 

---