Acid amides Reactions

The lysergic acid to lysergic acid amide reaction has been designed to utilize minimal quantities of solvents in order to squeeze as much material as possible into ordinary laboratory glassware. 

The synthetic importance of reaction (a) ° comes from the fact that it reduces to one step the pathway for conversion of an acid chloride into a nitrile (instead of the classical and rather inconvenient two-step route via an acid amide). Reaction is an example of a new transformation for aliphatic amines. Previously, there were no methods available for the direct transformation of an amino into a nitro group and the stepwise procedures were too cumbersome to be of practical use. Transformation of a nitro group into a carbonyl is a well-known reaction. Its modification, shown in reaction represents a welcome opportunity to obtain a protected carbonyl group as the immediate result of such a transformation. The viability of the sequential reactions (b) plus (c) enables the employment of a > CHNH2 moiety as a synthetic equivalent to a protected carbonyl group. A one-pot sequence of imine formation and its reduction with sodium triacetoxyborohydride represents a convenient... 

Ammonolysis anhydrous ammonia reacts with PET producing terephthalic acid amide. Reaction conditions include a temperature range of 120-180 C, 2 MPa and 1-7 h duration [33]. 

Indole (I) condenses with formaldehyde and dimethylamine in the presence of acetie acid (Mannich reaction see Section VI,20) largely in the 3-position to give 3 dimethylaminomethylindole or gramine (II). The latter reaets in hot aqueous ethanol with sodium cyanide to give the nitrile (III) upon boiling the reaction mixture, the nitrile undergoes hydrolysis to yield 3-indoleaeet-amide (IV), part of which is further hydrolysed to 3-indoleacetic acid (V, as sodium salt). The product is a readily separable mixture of 20 per cent, of (IV) and 80 per cent, of (V). 

To a mixture of 65 ml of dry benzene and 0.10 mol of freshly distilled NN-di-ethylamino-l-propyne were added 3 drops of BFa.ether and 0.12 mol of dry propargyl alcohol was added to the reddish solution in 5 min. The temperature rose in 5-10 min to about 45°C, remained at this level for about 10 min and then began to drop. The mixture was warmed to 60°C, whereupon the exothermic reaction made the temperature rise in a few minutes to B5 c. This level was maintained by occasional cooling. After the exothermic reaction (3,3-sigmatropic rearrangement) had subsided, the mixture was heated for an additional 10 min at 80°C and the benzene was then removed in a water-pump vacuum. The red residue was practically pure acid amide... 

Amides are sometimes prepared directly from carboxylic acids and amines by a two step process The first step is an acid-base reaction m which the acid and the amine combine to form an ammonium carboxylate salt On heating the ammonium carboxy late salt loses water to form an amide... 

The acid-base reactions that occur after the amide bond is broken make the overall hydrolysis irreversible m both cases The amine product is protonated m acid the car boxylic acid is deprotonated m base... 

Section 27 5 Ammo acids undergo reactions characteristic of the ammo group (e g amide formation) and the carboxyl group (e g esterification) Ammo acid side chains undergo reactions characteristic of the functional groups they contain... 

As with polyesters, the amidation reaction of acid chlorides may be carried out in solution because of the enhanced reactivity of acid chlorides compared with carboxylic acids. A technique known as interfacial polymerization has been employed for the formation of polyamides and other step-growth polymers, including polyesters, polyurethanes, and polycarbonates. In this method the polymerization is carried out at the interface between two immiscible solutions, one of which contains one of the dissolved reactants, while the second monomer is dissolved in the other. Figure 5.7 shows a polyamide film forming at the interface between an aqueous solution of a diamine layered on a solution of a diacid chloride in an organic solvent. In this form interfacial polymerization is part of the standard repertoire of chemical demonstrations. It is sometimes called the nylon rope trick because of the filament of nylon produced by withdrawing the collapsed film. 

Amides. Reaction of acryhc acid with ammonia or primary or secondary amines forms amides. However, acrylamide (qv) is better prepared by... 

Aluminum chloride [7446-70-0] is a useful catalyst in the reaction of aromatic amines with ethyleneknine (76). SoHd catalysts promote the reaction of ethyleneknine with ammonia in the gas phase to give ethylenediamine (77). Not only ammonia and amines, but also hydrazine [302-01-2] (78), hydrazoic acid [7782-79-8] (79—82), alkyl azidoformates (83), and acid amides, eg, sulfonamides (84) or 2,4-dioxopyrimidines (85), have been used as ring-opening reagents for ethyleneknine with nitrogen being the nucleophilic center (1). The 2-oxopiperazine skeleton has been synthesized from a-amino acid esters and ethyleneknine (86—89). 

Subsequent chlorination of the amide takes place ia a two-phase reaction mixture (a dispersion of diamide ia hydrochloric acid) through which a chlorine stream is passed. The temperature of this step must be maintained below 10°C to retard the formation of the product resulting from the Hofmann degradation of amides. Reaction of the A/,A/-dichloroamide with diethylamine [109-89-7] ia the presence of base yields /n j -l,4-cyclohexane-bis-l,3-diethylurea (35), which is transformed to the urea hydrochloride and pyroly2ed to yield the diisocyanate (36). 

Acetoiicetyliition Reactions. The best known and commercially most important reaction of diketene is the aceto acetylation of nucleophiles to give derivatives of acetoacetic acid (Fig. 2) (1,5,6). A wide variety of substances with acidic hydrogens can be acetoacetylated. This includes alcohols, amines, phenols, thiols, carboxyHc acids, amides, ureas, thioureas, urethanes, and sulfonamides. Where more than one functional group is present, ring closure often follows aceto acetylation, giving access to a variety of heterocycHc compounds. These reactions often require catalysts in the form of tertiary amines, acids, and mercury salts. Acetoacetate esters and acetoacetamides are the most important industrial intermediates prepared from diketene. 

Amidation. Reaction of maleic anhydride or its isomeric acids with ammonia [7664-41-7] (qv), primary amines (qv), and secondary amines produces mono- or diamides. The monoamide derivative from the reaction of ammonia and maleic anhydride is called maleamic acid [557-24-4] (8). Another monoamide derivative formed from the reaction of aniline [62-53-3] and maleic anhydride is maleanilic acid [555-59-9] (9). 

Carboxylic Acid Group. Reactions of the carboxyl group include decarboxylation, reduction to alcohols, and the formation of salts, acyl hahdes, amides, and esters. 

Sulfated Acids, Amides, and Esters. Reaction with sulfuric acid may be carried out on fatty acids, alkanolamides, and short-chain esters of fatty acids. The disodium salt of sulfated oleic acid is a textile additive and an effective lime soap dispersant. A typical sulfated alkanolamide stmcture is CiiH23C0NHCH2CH20S03Na. Others include the sulfates of mono and diethanolamides of fatty acids in the detergent range. The presence of... 

Material is the reaction product of a fatty acid amide of N,iV-dimethylpropylenediamine and epichlorohydrin and hydrolyzed milk protein. 

These dyes aie prepared by the reaction of l-amino-4-nittoanthtaquinone-2-catboxylic acid amide (108) with cyanide in water (119). 

The isomerization of oxaziridines (1) to acid amides with migration of a substituent from C to N is a general reaction and is always observed when no other reactions predominate under the relatively harsh conditions (heating to above 150 °C or photolysis). Even then one can make acid amide formation the main reaction by working at 300 °C (57JA5739) and by dilution techniques. For example, caprolactam (63) is formed in 88% yield by flash pyrolysis of oxaziridine (52) at about 300 °C, whereas decomposition of (52) at lower temperatures gives almost no (63) (77JPR274). 

In the 2-aryloxaziridines, acid amide formation proceeds under mild conditions and is the most often observed stabilization reaction of these very unstable compounds. Heating at 75 °C for 30-45 min is sufficient to convert N-arylspirooxaziridines (64 R = Ar) to the isomeric lactams (65) in 75-90% yield. 

Diaryloxaziridines are even less stable. With oxaziridines (66 Ar = Ph or 4-Me2NC6H4) acid amide formation at 25 °C proceeded in the course of 66 and 10 h respectively in the latter case there were equal amounts of H and aryl migration. Ethanol as solvent again accelerated the reaction, in the latter case by a factor of lO. ... 

Homolytic oxaziridine decomposition can be easily initiated by iron(II) ion in acidic media. Catalytic amounts are sufficient because chain reactions proceed. The reaction proceeds obviously in the case of 2-r-alkyloxaziridines like (56), where it yields the isomeric acid amide (111) (57JA5739). 

When )3-scission can occur in the radical, further reactions compete with acid amide formation. Thus oxaziridine (112) with iron(II) ion and acid yields stabilization products of the isopropyl radical. If a-hydrogen is present in the Af-alkyl group, radical attack on this position in (113) occurs additionally according to the pattern of liquid phase decomposition. 

There are differences in the high temperature behavior. While oxaziridines almost always isomerize to acid amides, a similar reaction of diaziridines, which should lead to amidines, has not been observed. Sensitivity towards bases, often encountered in oxaziridines, is observed only in some special substituted diaziridines. The tendency of some classes of oxaziridines to transfer the nitrogen function also lacks in the diaziridine field. On homolytic reactions of diaziridines there are only a few observations. 

---