Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Test power

Field tests Power frequency withstand test on the primary windings (for un-grounded VTs). The value of the test voltage and the test procedure, is almost the same as that for a switchgear assembly (Section 14.5). [Pg.493]

Field tests (power frequency voltage withstand) after erection at site, if required, may be conducted at 85% of the values indicated above in LT and 80% in HT systems. [Pg.955]

In order to maintain gas purity, it is desirable to select a positive suction pressure in order to minimize air leakage into the loop. Apart from the need to minimize inlet density and, hence, test power, the selection of test inlet pressure is a matter of convenience. [Pg.417]

Brkich, A., Rid Vertical-Pump Intake Design of Guess With Model Tests, Power, No. 2, 1953, p. 90. [Pg.222]

Mendell, N.R., Finch, S.J. and Thode, H.C., Jr. (1993). Where is the likelihood ratio test powerful for detecting two component normal mixtures Biometrics 49 907-915. [Pg.968]

Confounding is not a concern in TDT because the allelic transmission within families is unaffected by population structure and admixture. Information on hap-lotypes is available in family-based design and may help increase the test power. There are two major drawbacks in family-based design. First, if the disease occurs... [Pg.36]

Abel Heat Test at 82.2° — 3 mins (NG 10 mins) Friction Sensitivity — very insensitive Impact Sensitivity — very insensitive Initiation by Detonators — incomplete with No 8 Briska Detonator in Trauzl Test Power by Ballistic Mortar — 62% Blasting Gelatin, which.corresponds to about 110% TNT Power by Trauzl Test — 106% TNT Thermal Stability at 120°— no brown fumes after 5 hours... [Pg.51]

Pendulum Friction Test Power(by Ballistic Mortar Test or by Trauzl Test), assuming 100% for TNT 130 Unaffected 128 120-125 120... [Pg.159]

V. Trigeminal nerve. Motor Tests power of jaw opening and sideways deviation against the resistance of a hand placed against the jaw. Sensory Test corneal reflex by touching cornea (also nasal mucosa) with a wisp of cotton. [Pg.1004]

XI. Spinal accessory nerve. Trapezius and sternomastoid muscles Test power of shrugging shoulders and turning the head to one side against resistance. [Pg.1004]

Under the basic design, the Type I error rate for the T-test and LRT was 2 and 1%, respectively, using a significance level of 1%. The power to detect the subpopulation increased for all methods when the proportion of subjects in the subpopulation increased. A total of 80% power was reached for the LRT when 20% of the population was in the subgroup and never reached 80% for the T-test. Power did not increase much for either method when the percent of subjects in the subpopulation was increased to 30%. The LRT had greater power at detecting a subpopulation than did T-test under all conditions studied. [Pg.294]

Sufficiently low viscosity is a prerequisite for good atomization of liquid fuels and wastes when they enter the jet or the atomizer because if liquid is not atomized into sufficiently small drops, it does not burn out completely. The liquid fuel management facility for testing power burners should therefore store, mix, prepare, and dose liquid fuels while keeping high quality standards in all steps. [Pg.421]

Untreated atmospheric air is mostly used as the oxidizer to test power burners before it enters the burner, it is possible to enrich it with oxygen or to preheat it. [Pg.422]

From information theory (Pierce, 1961) it is known that a duplicate determination contains 100% more information than a single determination, a triplicate 50% more than a duplicate, and a quadruplicate 30% more than a triplicate. So the gain in information from single to duplicate determination is as large as the single determination itselfl Here it follows that always at least a duplicate determination should be carried out. However, from a statistical viewpoint a duplicate determination is unsatisfactory as it contain too iittle test power. [Pg.260]

Field strengths have been measured at 20 V/m from a 15 W hand held cellular telephone, and 8 V/m from a 1 W hand held cellular telephone [2], The FDA-CDRH has tested power wheelchairs and scooters in a Gigahertz Transverse Electromagnetic (GTEM) cell, and in an anechoic chamber with exposure strengths from 3 to 40 V/m. The US FDA requires that a warning sticker be placed on each power wheelchair or scooter indicating the risk due to EMI. [Pg.1149]

The po-wer and Type II error rate (beta) Power and its related Type II error rate are probably the most neglected aspects of a statistical test. Power refers to the probability that a relationship in the population will be detected when one in fact exists. Therefore, power might reflect what R. A. Fisher called the "sensitivity" of an experiment (Fisher, 1942). Importantly, the power of an obtained statistical test reflects the probability that such a result can be replicated (Goodman, 1992). The effects of low statistical power on the reproducibility of research findings has been well documented (Goodman, 1992 Harris, 1997). The Type II error (beta) occurs when one fails to reject a felse null hypothesis. [Pg.62]

This error is inversely related to the power of a test power = 1 - beta... [Pg.63]

The determination of the hypothesis (1) LR test power fimction based on the x -asymptotics is also inaccurate for small samples. Therefore we recommend to compute the exact power of the LR test of the hypothesis (1) by the use of the theorem 2. [Pg.851]

The start-up tests consist of criticality test, reactor physics test, power-up test, etc. They are somewhat similar to the LWR s ones. [Pg.149]

The next major category of testing is power supply current tests. Current tests include active switching current or power test, power down test, and standby or stable quiescent current tests. This last test, often called /ddq. wiU be discussed later. [Pg.847]


See other pages where Test power is mentioned: [Pg.251]    [Pg.182]    [Pg.441]    [Pg.37]    [Pg.314]    [Pg.199]    [Pg.236]    [Pg.472]    [Pg.199]    [Pg.159]    [Pg.236]    [Pg.252]    [Pg.87]    [Pg.384]    [Pg.84]    [Pg.1198]    [Pg.106]    [Pg.158]    [Pg.175]    [Pg.222]    [Pg.57]    [Pg.767]    [Pg.24]    [Pg.1189]   
See also in sourсe #XX -- [ Pg.263 ]

See also in sourсe #XX -- [ Pg.263 ]




SEARCH



Explosive power, tests

Filling power tests

Greater power of the paired t-test

Hiding power test methods

Low Power Tests

Most powerful test

Nuclear power corrosion testing

Power Ascension Tests

Power circuits short-circuit tests

Power cycling test

Power frequencies tests

Power multiple testing

Power of a statistical test

Power of a test

Power of test

Power of the statistical test

Power of the test

Power presses testing

Power-law test

Power-on self test

© 2024 chempedia.info