Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Procedures meaning

The equations were solved analytically after substitution of the assumed relationships of interest into the exact energy factored force field. For the Cotton-Kraihanzel treatment of species M(CO)5X, v B2) was not used. In the corresponding treatment of species cw-M(CO)4X2, the expressions for K(Bi), K Bz), and K A ) - -K A were used this procedure means that all the available data are used, as well as obviating the need to solve a quadratic. [Pg.39]

The configuration mixing procedure means that the ground state of the complex is described by (36) while the excited state is described by (37). The... [Pg.110]

We will not go into further detail, but rather we will discuss the basic steps and the generally accepted distinction today of the notions principle , method , and procedure . The main steps of the analytical process are sampling, sample pretreatment, measurement, and interpretation of the results (the collected data) (Fig. 1-1). Procedure means all activities from sample definition to the extraction of information by interpreting the data. Methods may be defined as the processes carried out between sample pretreatment and interpretation of the results. And finally principle describes the process in which analyte matter produces a signal that is further treated. [Pg.5]

The signature application process must, by appropriate technical (compnter-controUed) and procedural means, ensure as a minimum that signature creation ... [Pg.365]

The activity concentrations of uranium and plutonium isotopes in air-dust ashes in Braunschweig were determined by a-spectrometric measurements after a radiochemical separation and purification procedure. Mean activity concentrations of and were measured in monthly samples in 1992 and 1993 and in one semi-annual sample (July-December 1993) and annual mean activity concentrations were calculated. Mean monthly activity concentrations of plutonium isotopes were measured in 1993 and 1994 and the mean annual activity concentrations were calculated. [Pg.436]

Because the key to successfully crystallizing a macromolecule often lies in the procedure, means, or solvent used to solubilize it, some careful consideration should be given to this initial step. This is particularly true of membrane, lipophilic, or other proteins which, for one reason or another, are only marginally soluble in water solutions. In addition to mild detergents there are chaotropic agents that can also be employed for the solubilization of proteins. These include such compounds as urea, guanidinium hydrochloride, and relatively innocuous anions such as SCN-, CIOJ, I-, Br", and NO- (HatefI and Hanstein, 1969). These compounds, even at relatively low concentrations, may serve to increase dramatically the solubility of a protein under conditions where it would otherwise be insoluble. [Pg.45]

Abstract In the ordinary sense the term analytical procedure means a description of what has to be done while performing an analysis without reference to quality of the measurement. A more sound definition of analytical procedure can be given in terms of measurement (quality) assurance, in which a specified procedure to be followed is explicitly associated with an established accuracy of the results produced. [Pg.148]

The approach used in the parameterisation procedure means that once a force-field has been developed, it can only be used together with the selected water model. In principle, use of the Charmm22 parameter set with water models other than TIP3P may lead to inconsistencies because the water-protein and protein-protein intermolecular parameterisation may not be well balanced. However, whether this is actually the case has not yet been systematically investigated. [Pg.453]

Under the mutual recognition procedure, the applicant company usually ends up receiving national marketing authorisations from some or all of the national drug regulatory authorities to whom the dossier is submitted. The centralised procedure, on the other hand, is all or none , and under it the applicant company would receive a single marketing approval from the EMEA valid in all European Union countries. Rejection of an application under the centralised procedure means that the product cannot be marketed in any Member State. [Pg.608]

A. Stochastic Difference in Time Definition A Stochastic Model for a Trajectory Weights of Trajectories and Sampling Procedures Mean Field Approach, Fast Equilibration, and Molecular Labeling Stochastic Difference Equation in Length Fractal Refinement of Trajectories Parameterized by Length... [Pg.93]

In former years, many efforts to promote safe practices consisted almost entirely of a campaign that alerted employees to the hazards in their workplace and urged them to work safely. The modem concept is that hazards that cannot be eliminated should be controlled, first by design and then by procedural means. Procedural means consist in relying on employees to perform tasks properly and safely. Use of procedures is a less desirable means of accident prevention than is good design but because all hazards cannot be eliminated by design companies rely on the safe practices of their workers. To ensure safe work practices by their employees, companies must have an effective safety promotion plan. [Pg.38]

ProCGdures. From a technological point of view heterophase polymerizations can be carried out either batchwise, semicontinuous (or semibatch), or continuous. In the batchwise case the reactor is filled with all ingredients before the polymerization is started and the reactor content is removed at the end of the polymerization. In a semibatch procedure, at the start of the poljunerization the reactor is filled only partially and a stream of either neat monomers or monomer emulsion with constant or deliberately changed composition is fed continuously until the reactor is filled. After a final post-feeding batch reaction period, the reactor is emptied. A continuous procedure means that all necessary ingredients are fed and final latex is removed continuously. In all three cases the poljunerization can be carried out in the absence or presence of preformed particles (so-called seed particles). Reactions in the absence of seed particles are frequently called ab initio polymerizations and require that particle nucleation takes place. Table 7 is an... [Pg.3708]

Unavailable procedures means procedures that are no longer available from the manufacturer, or have never been available, from the manufacturer. [Pg.1234]

Since the introduction of the Fire Services Act of 1947, the fire authorities have had the responsibility for fighting fires in all types of premises. In 1971, the Fire Precautions Act gave the fire authorities control over certain fire procedures, means of escape and basic fire protection equipment through the drawing up and issuing of Fire Certificates in certain categories of building. The Fire Certification was mainly introduced to combat a number of serious industrial fires that had occurred. [Pg.253]

The two main elements of fixed interval preventive maintenance are procedure and discipline. Procedure means that the correct tasks are done, the right lubricants applied, and consumables replaced at the best interval. Discipline requires that all the tasks are planned and controlled so that everything is done when it should be done. Both these areas deserve attention. The topic of procedures is covered in detail in following sections. [Pg.10]

The depth of structure achieved will depend on the processing time. The aspect ratio is 2-3, and the smallest structure that can be created is 50 pm. The masks are created with photolithography. The process permits both very fine tolerances of shape and position and also allows as many lateral structures/side by side as desired, densely packed. The mechanical nature of the procedure means that the chemical composition of the material is unimportant. As the items are not exposed to heat, there is no distortion. One disadvantage is the angle of the abraded contours to the surface of the substrate. It will be 70° to 85°, depending on the depth sought. Deeper... [Pg.69]

An unauthorized launch analysis to define the time, tools, and equipment required to accomplish certain actions leading to unauthorized launch. The results of this analysis are used by the nuclear safety evaluation agency in determining which components require additional protection, either by design or procedural means. [Pg.271]

Consequence Following Procedures Means Being Able to Deviate from them About an Average Point... [Pg.43]

There is currently no known solution that can preserve both the expertise of the operators in exceptional situations and the benefit of achieving maximum system safety by procedural means. [Pg.78]


See other pages where Procedures meaning is mentioned: [Pg.71]    [Pg.111]    [Pg.247]    [Pg.5]    [Pg.303]    [Pg.46]    [Pg.24]    [Pg.210]    [Pg.132]    [Pg.35]    [Pg.210]    [Pg.247]    [Pg.366]    [Pg.301]    [Pg.687]    [Pg.380]    [Pg.201]    [Pg.193]    [Pg.500]    [Pg.100]    [Pg.29]    [Pg.361]    [Pg.1606]    [Pg.383]    [Pg.386]    [Pg.173]    [Pg.252]    [Pg.52]    [Pg.118]    [Pg.179]    [Pg.469]   
See also in sourсe #XX -- [ Pg.174 , Pg.560 ]




SEARCH



MEANS procedure

© 2024 chempedia.info