Preparation with alcohols

Styrene-15% DVB copolymers obtained in the presence of polystyrene and C5-C10 aliphatic alcohols as the precipitating agents are characterized by smaller values of porosity, pore volume, and specific surface area compared with those of copolymers prepared with alcohols only. Kolarz [348] found that copolymerization in the presence of n-decyl alcohol and polystyrene at the diluents to comonomers volume ratio of 1.2 results in a copolymer having the porosity of 44%, surface area of 16.5 m /g, and total pore volume of 0.88 cm /g, 80% of pore volume being formed by voids with radii ranging from 2,000 to 4,000 A. In comparison, the pore volume of 1.94 cm /g and surface area of 43.6 m/g are characteristic of a copolymer synthesized with isodecyl alcohol under the same conditions. 

C2H4N2O3, NH2CONHCOOH. Unknown in the free state as it breaks down immediately to urea and COi- The NH4, Ba, Ca, K and Na salts are known and are prepared by treating ethyl allophanate with the appropriate hydroxide. The esters with alcohols and phenols are crystalline solids, sparingly soluble in water and alcohol. They are formed by passing cyanic acid into alcohols or a solution of an alcohol or phenol in benzene. The amide of allophanic acid is biuret. Alcohols are sometimes isolated and identified by means of their allophanates. 

Crude chlorophyll is prepared commercially from alfalfa meal or nettles by extraction with alcohol and partition into benzene. It is used as a colouring matter, particularly for foods and pharmaceutical products. 

Ethylamine, monoethylamine, CH3CH2NH2-B.p. 19 C. Prepared by reduction of acetonitrile or by heating ethyl chloride with alcoholic ammonia under pressure. It is a strong base and will displace ammonia from ammonium salts. Forms a crystalline hydrochloride and also crystalline compounds with various metallic chlorides. 

They are colourless liquids with characteristic odours, and are prepared by the condensation of ketones with alkyl orthoformates in the presence of alcohols, or by the reaction of acetylenes with alcohols in presence of HgO and BF3. In some cases trichloroethanoic acid is used as the catalyst. They lose alcohol when heated and form vinyl ethers. Exchange of alcohol groups occurs when the ketals of the lower alcohols are boiled with alcohols of greater molecular weight. See acetals. 

Prepared by epoxidation of styrene with per-oxyelhanoic acid. Reactions are similar to those of aliphatic epoxides (s e, e.g. ethylene oxide). Reacts with alcohols to give mono-ethers, e g. PhCH(0Me)CH20H. Phenols give resins. 

Although benzenesulphonyl chloride has for simplicity been used in the above discussion, tolucne-/>- sulphonyl chloride, CHaCeH SO Cl, is more frequently used in the laboratory, owing to its much lower cost, the latter being due in turn to the fact that toluene-p-sulphonyl chloride is a by-product in the commercial preparation of saccharin. Toluene-p sulphonyl chloride is a crystalline substance, of m.p. 68° the finely powdered chloride will, however, usually react readily with amines in the Schotten-Baumann reaction it does not react so readily with alcohols, but the reaction may be promoted considerably by first dissolving the chloride in some inert water-soluble solvent such as acetone. 

The industrial process for preparing the reagent usually permits a little hydrolysis to occur, and the product may contain a little free calcium hydroxide or basic chloride. It cannot therefore be employed for drying acids or acidic liquids. Calcium chloride combines with alcohols, phenols, amines, amino-acids, amides, ketones, and some aldehydes and esters, and thus cannot be used with these classes of compounds. 

Zinc cyanide. Solutions of the reactants are prepared by dis solving 100 g. of technical sodium cyanide (97-98 per cent. NaCN) in 125 ml. of water and 150 g. of anhydrous zinc chloride in the minimum volume of 50 per cent, alcohol (1). The sodium cyanide solution is added rapidly, with agitation, to the zinc chloride solution. The precipitated zinc cyanide is filtered off at the pump, drained well, washed with alcohol and then with ether. It is dried in a desiccator or in an air bath at 50°, and preserved in a tightly stoppered bottle. The yield is almost quantitative and the zinc cyanide has a purity of 95-98 per cent. (2). It has been stated that highly purified zinc cyanide does not react in the Adams modification of the Gattermann reaction (compare Section IV,12l). The product, prepared by the above method is, however, highly satisfactory. Commercial zinc cyanide may also be used. 

In a 250 ml. separatory funnel place 25 g. of anhydrous feri.-butyl alcohol (b.p. 82-83°, m.p. 25°) (1) and 85 ml. of concentrated hydrochloric acid (2) and shake the mixture from time to time during 20 minutes. After each shaking, loosen the stopper to relieve any internal pressure. Allow the mixture to stand for a few minutes until the layers have separated sharply draw off and discard the lower acid layer. Wash the halide with 20 ml. of 5 per cent, sodium bicarbonate solution and then with 20 ml. of water. Dry the preparation with 5 g. of anhydrous calcium chloride or anhydrous calcium, sulphate. Decant the dried liquid through a funnel supporting a fluted Alter paper or a small plug of cotton wool into a 100 ml. distilling flask, add 2-3 chips of porous porcelain, and distil. Collect the fraction boiling at 49-51°. The yield of feri.-butyl chloride is 28 g. 

The nucleophUic reactivity in neutral medium has been used extensively to prepare various thioethers of thiazole (122). In acidic medium, alkylation may be performed with alcohols (123, 124). An unexpected reaction encountered was the decarboxylation of 2-mercapto-4-methyl-5-thiazolecarboxyhc acid (60) when treated with butyl alcohol under acidic conditions (Scheme 27) (123). Reaction between A-4-thiazoline-2-thione... 

We now have a new problem Where does the necessary alkene come from Alkenes are prepared from alcohols by acid catalyzed dehydration (Section 5 9) or from alkyl halides by dehydrohalogenation (Section 5 14) Because our designated starting material is tert butyl alcohol we can combine its dehydration with bromohydrm formation to give the correct sequence of steps... 

Section 8 14 Nucleophilic substitution can occur with leaving groups other than halide Alkyl p toluenesulfonates (tosylates) which are prepared from alcohols by reaction with p toulenesulfonyl chloride are often used... 

A reaction useful only with sub strates that do not undergo E2 elimi nation readily It is rarely used for the synthesis of alcohols since alkyl halides are normally prepared from alcohols... 

A method that allows for alcohol preparation with formation of new carbon-carbon bonds Primary sec ondary and tertiary alcohols can all be prepared... 

Both reactants m the Williamson ether synthesis usually originate m alcohol pre cursors Sodium and potassium alkoxides are prepared by reaction of an alcohol with the appropriate metal and alkyl halides are most commonly made from alcohols by reaction with a hydrogen halide (Section 4 7) thionyl chloride (Section 4 13) or phosphorus tri bromide (Section 4 13) Alternatively alkyl p toluenesulfonates may be used m place of alkyl halides alkyl p toluenesulfonates are also prepared from alcohols as their imme diate precursors (Section 8 14)... 

Section 20 7 Esters occur naturally or are prepared from alcohols by Fischer estenfi cation or by acylation with acyl chlorides or acid anhydrides (see Table 20 3)... 

Secondary acetylenic alcohols are prepared by ethynylation of aldehydes higher than formaldehyde. Although copper acetyUde complexes will cataly2e this reaction, the rates are slow and the equiUbria unfavorable. The commercial products are prepared with alkaline catalysts, usually used in stoichiometric amounts. 

Rea.ctlons, As with other tertiary alcohols, esterification with carboxyUc acids is difficult and esters are prepared with anhydrides (181), acid chlorides (182), or ketene (183). Carbamic esters may be prepared by treatment with an isocyanate (184) or with phosgene followed by ammonia or an amine (185). 

Usually, organoboranes are sensitive to oxygen. Simple trialkylboranes are spontaneously flammable in contact with air. Nevertheless, under carefully controlled conditions the reaction of organoboranes with oxygen can be used for the preparation of alcohols or alkyl hydroperoxides (228,229). Aldehydes are produced by oxidation of primary alkylboranes with pyridinium chi orochrom ate (188). Chromic acid at pH < 3 transforms secondary alkyl and cycloalkylboranes into ketones pyridinium chi orochrom ate can also be used (230,231). A convenient procedure for the direct conversion of terminal alkenes into carboxyUc acids employs hydroboration with dibromoborane—dimethyl sulfide and oxidation of the intermediate alkyldibromoborane with chromium trioxide in 90% aqueous acetic acid (232,233). 

Magnesium iodide is soluble in alcohols and many other organic solvents, and forms numerous addition compounds with alcohols, ethers, aldehydes, esters, and amines. One example is magnesium iodide dietherate [29964-67-8], Mgl2 prepared by gradual addition of iodine to a... 

---