With chromium trioxide

We shall describe a specific synthetic example for each protective group given above. Regiosdective proteaion is generally only possible if there are hydroxyl groups of different sterical hindrance (prim < sec < tert equatorial < axial). Acetylation has usually been effected with acetic anhydride. The acetylation of less reactive hydroxyl groups is catalyzed by DMAP (see p.l44f.). Acetates are stable toward oxidation with chromium trioxide in pyridine and have been used, for example, for protection of steroids (H.J.E. Loewenthal, 1959), carbohydrates (M.L. Wolfrom, 1963 J.M. Williams, 1967), and nucleosides (A.M. Micbelson, 1963). The most common deacetylation procedures are ammonolysis with NH in CH OH and methanolysis with KjCO, or sodium methoxide. 

Usually, organoboranes are sensitive to oxygen. Simple trialkylboranes are spontaneously flammable in contact with air. Nevertheless, under carefully controlled conditions the reaction of organoboranes with oxygen can be used for the preparation of alcohols or alkyl hydroperoxides (228,229). Aldehydes are produced by oxidation of primary alkylboranes with pyridinium chi orochrom ate (188). Chromic acid at pH < 3 transforms secondary alkyl and cycloalkylboranes into ketones pyridinium chi orochrom ate can also be used (230,231). A convenient procedure for the direct conversion of terminal alkenes into carboxyUc acids employs hydroboration with dibromoborane—dimethyl sulfide and oxidation of the intermediate alkyldibromoborane with chromium trioxide in 90% aqueous acetic acid (232,233). 

There are many synthetic routes to alloxan. Probably the best is direct oxidation of barbituric acid (1004 R = H) with chromium trioxide (5208(32)6) but it may be made from barbituric acid via its benzylidene derivative by direct or indirect oxidation of uric acid from 5-chlorobarbituric acid (1004 R = C1) by nitration or from 5-nitrobarbituric acid (1004 R = N02) by chlorination, both via the intermediate (1005) (64M1057) or by permanganate oxidation of uracil (1006) under carefully controlled conditions (73BSF1167). 

Cyclodecanedione has also been prepared by oxidation of sebacoin with chromium trioxide in acetic acid, - Cupric acetate in acetic acid has been used for oxidation of an a-hydroxyketone by Ruggli and Zeller. ... 

TABLE 5-1 Relative Rates of Oxidation of Isolated Hydroxyl Groups with Chromium Trioxide in Aqueous Acetic Acid ... 

If homolytic reaction conditions (heat and nonpolar solvents) can be avoided and if the reaction is conducted in the presence of a weak base, lead tetraacetate is an efficient oxidant for the conversion of primary and secondary alcohols to aldehydes and ketones. The yield of product is in many cases better than that obtained by oxidation with chromium trioxide. The reaction in pyridine is moderately slow the intial red pyridine complex turns to a yellow solution as the reaction progresses, the color change thus serving as an indicator. The method is surprisingly mild and free of side reactions. Thus 17a-ethinyl-17jS-hydroxy steroids are not attacked and 5a-hydroxy-3-ket-ones are not dehydrated. 

The intermediacy of dipolar species such as 186 has been demonstrated by reaction of enamines with 2-hydroxy-1-aldehydes of the aromatic series (129). The enamine (113) reacts in benzene solution at room temperature with 2-hydroxy-1-naphthaldehyde to give the crystalline adduct (188) in 91 % yield. Oxidation with chromium trioxide-pyridine of 188 gave 189 with p elimination of the morpholine moiety. Palladium on charcoal dehydrogenation of 189 gave the known 1,2-benzoxanthone (129). 

D. Oxidation with Chromium Trioxide-Pyridine Complex General Procedure... 

By monitoring the intensity of the carbonyl absorption it was observed that oxidation of methyl 4,6-0-benzylidene-2-deoxy-a-D-Zt/ ro-hexopyrano-side with chromium trioxide-pyridine at room temperature gave initially the hexopyranosid-3-ulose (2) in low concentration, but attempts to increase this yield resulted in elimination of methanol to give compound 3. However, when methyl 4,6-0-benzylidene-2-deoxy-a-D-Zt/ ro-hexo-pyranoside is oxidized by ruthenium tetroxide in either carbon tetrachloride or methylene dichloride it affords compound 2 without concomitant elimination. When compound 2 was heated for 30 minutes in pyridine which was 0.1 M in either perchloric acid or hydrochloric acid it afforded compound 3, but in pyridine alone it was recoverable unchanged (2). Another example of this type of elimination, leading to the introduction of unsaturation into a glycopyranoid ring, was observed... 

Oxidation of PI with chromium trioxide. Fraction PI was twice acetylated as described above. The peracetylated polysaccharide (75 mg), together with 20 mg of mannitol hexacetate as internal standard was dissolved in 1.5 mL of HCCI3, and treated with 1.89 mL of glacial acetic acid and 189 mg of chromium trioxide, at 50°C. Aliquots were removed at zero, 30, 60 and 120 min, water then added, and the material recovered by extraction with chloroform, hydrolyzed and analysed by GLC of derived alditol acetates. 

An intere.sting example in the context of waste minimization is the manufacture of the vitamin K intermediate, menadione. Traditionally it was produced by stoichiometric oxidation of 2-methylnaphthalene with chromium trioxide (Eqn. (8)), which generates 18 kg of solid, chromium containing waste per kg of menadione. Catalytic alternatives have been reported, but selectivities tend to be rather low owing to competing oxidation of the second aromatic ring (the. selectivity in the classical process is only 50-60%). The best results were obtained with a heteropolyanion as catalyst and O2 as the oxidant (Kozhevnikov, 1993). 

When it is heated above 196°C, the mixture of this compound with chromium trioxide combusts. When it is submitted to friction or impact, the same mixture detonates violently. The same happens if it is heated with sodium nitrite. Nitrite gives rise to a detonation with potassium hexacyanoferrate (II) too. The dangerous site of these complex anions is the cyano group. 

Oxidation of that compound with chromium trioxide in sulfuric acid leads cleanly to the desired ketone (67). Treatment with hydrobromic acid serves to demethylate the phenolic ether function (68). Direct... 

Oxidation with chromium trioxide in acetic acid cleaved the indole ring to produce intermediate 23 which cyclodehydrated to give prazepam (24). 

Small quantities can be distilled at about 75°C/1.3 mbar, but larger amounts are liable to explode violently owing to local overheating [1], An attempt to prepare an analogous poly(dimethylsilyl) chromate by heating a polydimethylsiloxane with chromium trioxide at 140°C exploded violently after 20min at this temperature [2], See related alkylsilanes, metal oxides... 

ALDEHYDES FROM PRIMARY ALCOHOLS BY OXIDATION WITH CHROMIUM TRIOXIDE 1-HEPTANAL, 52, 5 ALDEHYDES FROM sym-TRITHIANE n-PENTADECANAL, 51, 39 Aldehydes, acetylenic, 54, 45 Aldehydes, aromatic, 54, 45 Aldehydes, benzyl, 54, 45 Aldehydes, olefinic, 54, 45... 

Oxidation, of primary alcohols to aldehydes, 52, 5 of terminal olefins with chromyl chloride, 51, 6 of 2,4,4-trimethyl-1-pentene with chromyl chloride, 51, 4 with chromium trioxide-pyridine complex, 52, 5... 

---