Palladium on barium

The reaction is used for the chain extension of aldoses in the synthesis of new or unusual sugars In this case the starting material l arabinose is an abundant natural product and possesses the correct configurations at its three chirality centers for elaboration to the relatively rare l enantiomers of glucose and mannose After cyanohydrin formation the cyano groups are converted to aldehyde functions by hydrogenation m aqueous solution Under these conditions —C=N is reduced to —CH=NH and hydrolyzes rapidly to —CH=0 Use of a poisoned palladium on barium sulfate catalyst prevents further reduction to the alditols... 

An equal weight of precipitated barium carbonate (93 g.) may be substituted for the barium hydro.xide and sulfuric acid to give a palladium on barium carbonate catalyst. The amount of hydrochloric acid should then be reduced to 8.2 ml. 

As catalyst for the Rosenmund reaction palladium on a support, e.g. palladium on barium sulfate, is most often used. The palladium has to be made less active in order to avoid further reduction of the aldehyde to the corresponding alcohol. Such a poisoned catalyst is obtained for example by the addition of quinoline and sulfur. Recent reports state that the reactivity of the catalyst is determined by the morphology of the palladium surface." ... 

Support has been shown to influence selectivity and some workers have obtained higher yields of cis isomer over palladium-on-calcium carbonate or palladium-on-barium sulfate 21), whereas others find carbon satisfactory. In general, carbon support makes the more active catalyst and it is, therefore, more prone to become hydrogen poor. 

A suspension of palladium on barium carbonate (3.7 grams of 30%) in water (20 ml) is shaken in an atmosphere of hydrogen at room temperature. The catalyst is then filtered and washed well with water, care being taken that it does not become dry, A solution of the... 

Partial reduction of the acetylenes 1 over 10 % palladium on barium sulfate yields the ra-alkenes 2 which ring close spontaneously to the 3//-2-benzazepines 3.78 Reduction with Raney nickel is less successful and produces mixtures of the 3-benzazepines and their 4,5-dihydro derivatives. 

The title compounds LTB4, 21 (Z) and 22 (Z), have been synthesized23 by stereoselective reduction with deuterium gas of a 1 1 mixture of the suitable diacetylenic precursors 23 and 24 using Lindlar catalyst or palladium on barium sulphate catalyst (equation 10). Leukotriene B4, a 5-lipoxygenase metabolite of arachidonic acid, playing... 

In the above mentioned reaction, platinum oxide and palladium on barium sulfate showed no perceptible change in the rate of hydrogen uptake. On the other hand, platinum oxide was selective in the hydrogenation of cyclohexa-2,4-diene-l,2-dicarboxylic acid to 1,4,5,6-tetrahydrophthalic acid140. A similar result may be the favored reduction of a symmetrical disubstituted double bond over a more hindered trisubstituted bond. The retarding effect of additional substitution is demonstrated in the hydrogenation of a trisubstituted double bond in the presence of a tetrasubstituted double bond (equation 53)141. 

Cyclododecene may be prepared from 1,5,9-cyclododecatriene by the catalytic reduction with Raney nickel and hydrogen diluted with nitrogen, with nickel sulfide on alumina, with cobalt, iron, or nickel in the presence of thiophene, with palladium on charcoal, with palladimn chloride in the presence of water, with palladium on barium sulfate, with cobalt acetate in the presence of cobalt carbonyl, and with cobalt carbonyl and tri- -butyl phosphine. It may also be obtained from the triene by reduction with lithium and ethylamine, by disproportionation, - by epoxidation followed by isomerization to a ketone and WoliT-Kishner reduction, and from cyclododecanone by the reaction of its hydrazone with sodium hydride. ... 

Acyl chloride (acid chloride) is hydrogenated over catalyst, palladium on barium sulphate. This reaction is called Rosenmund reduction. 

Pyrazole was hydrogenated over palladium on barium sulfate in acetic acid to 4,5-dihydropyrazole (A -pyrazoline), and 1-phenylpyrazole at 70-80° to 1-phenylpyrazolidine [478]. In benzopyrazole (indazole) and its homologs and derivatives the six-membered ring is hydrogenated preferentially to give... 

Oeavage of esters to acids and hydrocarbons mentioned above was achieved not only with hydrides but also by catalytic hydrogenation and reduction with metals. For example the acetate of mandelic acid was converted to mandelic acid and acetic acid by hydrogenation at 20° and 1 atm over palladium on barium sulfate in ethanol in the presence of triethylamine in 10 minutes [1035], and a,a-diphenylphthalide was reduced by refluxing for 5 hours with zinc in formic acid to a,a-diphenyl-o-toluic acid in 92% yield [1036]. Such reductions are of immense importance in esters of benzyl-type alcohols where the yields of the acids are almost quantitative. 

Phthalimide was hydrogenated catalytically at 60-80° over palladium on barium sulfate in acetic acid containing an equimolar quantity of sulfuric or perchloric acid to phthalimidine [7729]. The same compound was produced in 76-80% yield by hydrogenation over nickel at 200° and 200-250 atm [43 and in 75% yield over copper chromite at 250° and 190 atm [7730]. Reduction with lithium aluminum hydride, on the other hand, reduced both carbonyls and gave isoindoline (yield 5%) [7730], also obtained by electroreduction on a lead cathode in sulfuric acid (yield 72%) [7730]. 

The 5% palladium on barium sulfate was purchased from Engelhard Industries, Newark, NO. 

Dihydrophenanthrene has been prepared from 2,2 -bis(bromomethyl)biphenyl and sodium 8 from the reduction of 2,2 -diiodobibenzy 1 in the presence of 1% palladium on barium carbonate catalyst 8 by the hydrogenation of phenanthrene in the presence of nickel8 or copper-chromium oxide catalyst 10 and by the coupling of 2,2 -bis(bromomethyl)biphenyl with lithium phenyl.11... 

Hydrogenation of dimeric nitroso compounds with a palladium-on-barium sulfate catalyst [17] (Eq. 46). 

Acyl halides can be reduced to aldehydes1206 by treatment with lithium tri-f-butoxyaluminum hydride in diglyme at -78°C,1207 R may be alkyl or aryl and may contain many types of substituents, including N02, CN, and EtOOC groups. The reaction stops at the aldehyde stage because steric hindrance prevents further reduction under these conditions. Acyl halides can also be reduced to aldehydes by hydrogenolysis with palladium-on-barium sulfate... 

D, Palladium on barium sulphate catalyst (5 per cent. Pd). (4) Prepare a solution of 4-1 g. of anhydrous palladium chloride (1) in 10 ml. of concentrated hydrochloric acid and 25 ml. of water (as in A). Add all at once 60 ml. of 6.sulphuric acid to a rapidly stirred, hot (80°) solution of 63-1 g. of A.R. crystallised barium hydroxide in 600 ml. of water contained in a 2-litre beaker. Add more 6.sulphuric acid to render the suspension just acid to litmus (5). Introduce the palladium chloride solution and 4 ml. of 37 per cent, formaldehyde solution into the hot mechanically-stirred suspension of barium sulphate. Render the suspension slightly alkaline with 30 per cent, sodium hydroxide solution, continue the stirring for 5 minutes longer, and allow the catalyst to settle. Decant the clear supernatant liquid, replace it by water and resuspend the catalyst. Wash the catalyst by decantation 8-10 times and then collect it on a medium - porosity sintered glass funnel, wash it with five 25 ml. portions of water and suck as dry as possible. Dry the funnel and contents at 80°, powder the catalyst (48 g.), and store it in a tightly-stoppered bottle. 

Where it is advantageous to maintain the neutrality of the hydrogenation mixture, palladium on barium carbonate catalyst is recommended. For the preparation of this catalyst the experimental details noted above for the barium sulphate based catalyst are used, but the barium hydroxide and sulphuric acid are replaced by 46.5 g of precipitated barium carbonate and the volume of hydrochloric acid is reduced to 4.1 ml. 

With most hydrogenation catalysts of the platinum and nickel groups (Sections 4.2.61, p. 459 and 4.2.50, p. 450), a mixture of products is obtained even if an attempt is made to stop the reaction at the half-way stage. An alkene may only be obtained in good yield if particular attention is paid to the selection of a deactivated hydrogenation catalyst. An early, highly effective formulation of a deactivated palladium catalyst is Lindlar s catalyst (Section 4.2.54, p. 453), but palladium-on-barium sulphate in the presence of quinoline, or palladium-on-calcium carbonate, is also recommended. In these cases it is advisable to... 

---