Retardation effect

Nylon Finishes. Halogens are less effective flame retardants on nylon than on polyester. Most of the flame retardants effective on ceUulosics... 

Additives. Because of their versatility, imparted via chemical modification, the appHcations of ethyleneimine encompass the entire additive sector. The addition of PEI to PVC plastisols increases the adhesion of the coatings by selective adsorption at the substrate surface (410). PEI derivatives are also used as adhesion promoters in paper coating (411). The adducts formed from fatty alcohol epoxides and PEI are used as dispersants and emulsifiers (412). They are able to control the viscosity of dispersions, and thus faciHtate transport in pipe systems (413). Eatty acid derivatives of PEI are even able to control the viscosity of pigment dispersions (414). The high nitrogen content of PEIs has a flame-retardant effect. This property is used, in combination with phosphoms compounds, for providing wood panels (415), ceUulose (416), or polymer blends (417,418) with a flame-retardant finish. 

Models for transport distinguish between the unsaturated zone and the saturated zone, that below the water table. There the underground water moves slowly through the sod or rock according to porosity and gradient, or the extent of fractures. A retardation effect slows the motion of contaminant by large factors in the case of heavy metals. For low level waste, a variety of dose calculations are made for direct and indirect human body uptake of water. Performance assessment methodology is described in Reference 22. 

The thiophthalimide (CTP) and sulfenamide classes of retarders differ from the organic acid types by thek abiUty to retard scorch (onset of vulcanization) without significantly affecting cure rate or performance properties. Much has been pubUshed on the mechanism of CTP retardation. It functions particularly well with sulfenamide-accelerated diene polymers, typically those used in the the industry. During the initial stages of vulcanization, sulfenamides decompose to form mercaptobenzothiazole (MBT) and an amine. The MBT formed reacts with additional sulfenamide to complete the vulcanization process. If the MBT initially formed is removed as soon as it forms, vulcanization does not occur. It is the role of CTP to remove MBT as it forms. The retardation effect is linear with CTP concentration and allows for excellent control of scorch behavior. 

Foams are thermodynamically unstable. To understand how defoamers operate, the various mechanisms that enable foams to persist must first be examined. There are four main explanations for foam stabiUty (/) surface elasticity (2) viscous drainage retardation effects (J) reduced gas diffusion between bubbles and (4) other thin-film stabilization effects from the iateraction of the opposite surfaces of the films. 

Antimony trioxide - also provides a tlarne retardant effect... 

Here n indicates an active surface site, and X— indicates die species X adsorbed on an active site. The first reaction allows for the possibility that methane may occupy more than one active site on adsorption. The dik d and fourth reactions show die observed retarding effects of steam and hydrogen... 

The reaction mechanisms are quite complicated in these syntheses, the kinetics depending on inter-diffusion rates in neighbouring particles, the formation of transient liquid phases, and in some cases, the vapour transport of a reactant. The presence of the latter can be detected by dre retarding effect of increased pressure in an inert surrounding atmosphere. 

Antimony trioxide (SbaOj). It is produced from stibnite (antimony sulphide). Some typical properties are density 5.2-5.67 g/cm- pH of water suspension 2-6.5 particle size 0.2-3 p,m specific surface area 2-13 m-/g. Antimony trioxide has been the oxide universally employed as flame retardant, but recently antimony pentoxide (SbaOs) has also been used. Antimony oxides require the presence of a halogen compound to exert their fire-retardant effect. The flame-retarding action is produced in the vapour phase above the burning surface. The halogen and the antimony oxide in a vapour phase (above 315 C) react to form halides and oxyhalides which act as extinguishing moieties. Combination with zinc borate, zinc stannate and ammonium octamolybdate enhances the flame-retarding properties of antimony trioxide. 

Note that the subscript on the a matrices refers to the particle, and a here includes all of the tlx, tty and components in eq. (8.4). The first correction term in the square brackets is called the Gaunt interaction, and the whole term in the square brackets is the Breit interaction. The Dirac matiices appear since they represent the velocity operators in a relativistic description. The Gaunt term is a magnetic interaction (spin) while the other term represents a retardation effect. Eq. (8.27) is more often written in the form... 

Brems-vermdgen, n. braking power, retarding power, -wirkung, /. braking or retarding effect,... 

At these high frequencies, the retarding effect of the ion-atmosphere on the movement of a central ion is greatly decreased and conductance tends to be increased. The capacitance effect is related to the absorption of energy due to induced polarisation and the continuous re-alignment of electrically unsymmetrical molecules in the oscillating field. With electrolyte solutions of low dielectric constant, it is the conductance which is mainly affected, whilst in solutions of low conductance and high dielectric constant, the effect is mostly in relation to capacitance. 

Sassoon and Rabani [79] also prepared a two polymer system in which a chromophore was covalently bound to one polyelectrolyte and a donor or acceptor was electrostatically held by the other polyelectrolyte, and showed that its back ET underwent a similar retardation effect. They employed 26 as a photosensitizer, MV2+ as a mediator, and ferricyanide as an acceptor electrostatically bound to the added polycation (polybrene). 

There are several reports scattered in the literature of the retarding effect of simple furan derivatives in the polymerization of a specific monomer. Hardy69, U6 found that furan, 2-furoic acid and its esters, and 5-substituted-2-furoie acids were strong retarders in the radical polymerization of vinyl acetate, but did not act likewise with styrene. He proposed that as a result of the reactions of the free radicals with the furan derivatives, dihydro- and tetrahydrofurans would form, but he did not produce any evidence to support these speculations. Clarke, Howard and Stock-... 

From the rate-retarding effect on the transformation of the competing substance. 

An evaluation of the retardation effects of surfactants on the steady velocity of a single drop (or bubble) under the influence of gravity has been made by Levich (L3) and extended recently by Newman (Nl). A further generalization to the domain of flow around an ensemble of many drops or bubbles in the presence of surfactants has been completed most recently by Waslo and Gal-Or (Wl). The terminal velocity of the ensemble is expressed in terms of the dispersed-phase holdup fraction and reduces to Levich s solution for a single particle when approaches zero. The basic theoretical principles governing these retardation effects will be demonstrated here for the case of a single drop or bubble. Thermodynamically, this is a case where coupling effects between the diffusion of surfactants (first-order tensorial transfer) and viscous flow (second-order tensorial transfer) takes place. Subject to the Curie principle, it demonstrates that this retardation effect occurs on a nonisotropic interface. Therefore, it is necessary to express the concentration of surfactants T, as it varies from point to point on the interface, in terms of the coordinates of the interface, i.e.,... 

No satisfactory analysis has been made with acetyl nitrate but the qualitative retarding effect of addition of acetic anhydride100 has been likewise interpreted as resulting from the preformation of dinitrogen pentoxide. 

For a CN group also, the rate-retarding effect is reduced by this kind of resonance A carbocation with an a COR group has been isolated. ... 

When the reaction was followed in an nmr probe, the appearance and disappearance of two intermediates 66 and 67 was observed along with the buildup of product 65. The rate of reaction of 64 at 75° in formic acid, k = 3xl0" sec, is six times faster than the rate of the corresponding saturated system, 2,2-dimethyl-1-pentyl tosylate, k = 5xl0" sec, under identical conditions. If the inductive rate retarding effect of the triple bond is taken into account, then the calculated rate enhancement resulting from triple-bond participation in the solvolysis of 64 is about 3000(81). The... 

The data from Fig. 3 show that at all experiments with alkali and alkali-earth chlorides the amount of the formed amide groups is smaller than the content of the amide groups of the pectin from the control sample. Ca " " ions have the strongest retarding effect. Only at the experiments with NH4CI, higher values for the content of amide groups have been observed, but this increase is relatively small - about 10 %. 

Kinetic parameters for NOx reduction are summarized in Table 1. It is obvious that the addition of Ir to ln/H-ZSM-5 led to the decrease in reaction orders with respect to NO, CH4, and O2 in the NO-CH4-O2 reaction. The decrease in the order for NO can explain that lr/ln/H-ZSM-5 was effective for the reduction of NO at low concentrations. On the contrary, the reaction orders with respect to NO2, CH4, and O2 in the NO2-CH4-O2 reaction were not significantly changed by the addition of Ir. The retarding effect of CH4... 

An increase in viscosity usually accompanies competition. Water molecules bound by the hydrocolloid are no longer effective as solvent molecules and the concentration of the solution is thereby increased. Increase in viscosity itself has a retarding effect on crystal growth. 

---