Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Oxidation tert.butyl hydroperoxide

The Sharpless-Katsuki asymmetric epoxidation reaction (most commonly referred by the discovering scientists as the AE reaction) is an efficient and highly selective method for the preparation of a wide variety of chiral epoxy alcohols. The AE reaction is comprised of four key components the substrate allylic alcohol, the titanium isopropoxide precatalyst, the chiral ligand diethyl tartrate, and the terminal oxidant tert-butyl hydroperoxide. The reaction protocol is straightforward and does not require any special handling techniques. The only requirement is that the reacting olefin contains an allylic alcohol. [Pg.50]

This procedure is not a domino process in its strictest definition, but since the oxidant tert-butyl hydroperoxide is added after allylation is complete, it is a very impressive and useful transformation for the rapid assembly of three contiguous stereogenic centers, including a tertiary alcohol moiety. [Pg.198]

The metal at the heart of the active catalyst is titanium. This holds everything together—the tartrate ligand, the substrate (the allylic alcohol) and the oxidant tert-butyl hydroperoxide t-BuOOH. The structure of the catalyst before substrate or ligand binding is thought to be as shown in the figure below. There are two titanium atoms and two unsymmetrically bound tartrate units. [Pg.529]

Another oxidative Ugi-3CR was reported by Xie et al. for the synthesis of a-amino imides from tertiary amines by direct activation of sp C—Hs adjacent to nitrogen using an oxidant (tert-butyl hydroperoxide (TBHP)) and a copper salt [23]. Notably, the reaction could be conducted under mild... [Pg.251]

Peroxide mechanisms are common in hydrocarbon oxidation. tert-Butyl hydroperoxide (BuOOH) can be used as an oxidizing agent with a palladium trifluoroacetate catalyst. The catalyst is [Pd(OCOCF3)(OOBu)], which adds to the alkene linkage to give 25. Decomposition of this intermediate to ketone... [Pg.315]

Fig, 22.27p Propylene oxide-tert-butyl hydroperoxide process. (Encyclopedia of Chemical Technology, Kfrk and Othmer. 3rd ed., Vol. 13, p, 259, 1980. Copyright by John Wihy Sons, Inc. and used by permission of the copyright owner.)... [Pg.833]

The first practical method for asymmetric epoxidation of primary and secondary allylic alcohols was developed by K.B. Sharpless in 1980 (T. Katsuki, 1980 K.B. Sharpless, 1983 A, B, 1986 see also D. Hoppe, 1982). Tartaric esters, e.g., DET and DIPT" ( = diethyl and diisopropyl ( + )- or (— )-tartrates), are applied as chiral auxiliaries, titanium tetrakis(2-pro-panolate) as a catalyst and tert-butyl hydroperoxide (= TBHP, Bu OOH) as the oxidant. If the reaction mixture is kept absolutely dry, catalytic amounts of the dialkyl tartrate-titanium(IV) complex are suflicient, which largely facilitates work-up procedures (Y. Gao, 1987). Depending on the tartrate enantiomer used, either one of the 2,3-epoxy alcohols may be obtained with high enantioselectivity. The titanium probably binds to the diol grouping of one tartrate molecule and to the hydroxy groups of the bulky hydroperoxide and of the allylic alcohol... [Pg.124]

The parent indolo[2,3-fl]carbazole (1) has also been the subject of a study probing its reactivity toward oxidizing agents. One of the substrates involved, namely 85 (prepared from 1 and 2,5-dimethoxytetrahydrofuran in the presence of acid), was subjected to treatment with m-chloroperbenzoic acid, to give the dione 86 as the major product and a sensitive compound assigned the hydroxy structure 87. A cleaner reaction took place when 85 underwent oxidation with tert-butyl hydroperoxide assisted by VO(acac)2, to produce 86 exclusively in 86% yield. Likewise, A,N -dimethylindolo[2,3-fl]carbazole furnished the dione 88 on treatment with this combination of reagents (96J(X 413). [Pg.17]

A similar study of the oxidation of sulphoxides by potassium tert-butyl hydroperoxide found similar results70. [Pg.977]

In a related reaction, primary aromatic amines have been oxidized to azo compounds by a variety of oxidizing agents, among them Mn02, lead tetraacetate, O2 and a base, barium permanganate, and sodium perborate in acetic acid, tert Butyl hydroperoxide has been used to oxidize certain primary amines to azoxy compounds. [Pg.1519]

The cobaltous acetate reduction of tert-butyl hydroperoxide in acetic acid yields mainly ter/-butanol and oxygen the metal ion stays in the +2 oxidation state because of the reactivity of Co(III) towards hydroperoxides (p. 378) °. The rate law is... [Pg.465]

A recent stndy (13,27) describes the use of Co-Si-TUD-1 for the liquid-phase oxidation of cyclohexane. Several other metals were tested as well. TBHP (tert-butyl hydroperoxide) was used as an oxidant and the reactions were carried out at 70°C. Oxidation of cyclohexane was carried out using 20 ml of a mixture of cyclohexane, 35mol% TBHP and 1 g of chlorobenzene as internal standard, in combination with the catalyst (0.1 mmol of active metal pretreated overnight at 180°C). Identification of the products was carried out using GC-MS. The concentration of carboxylic side products was determined by GC analysis from separate samples after conversion into the respective methyl esters. Evolution and consumption of molecular oxygen was monitored volumetrically with an attached gas burette. All mass balances were 92% or better. [Pg.374]

The activity of the FePeCli6-S/tert-butyl hydroperoxide (TBHP) catalytic system was studied under mild reaction conditions for the synthesis of three a,p-unsaturated ketones 2-cyclohexen-l-one, carvone and veibenone by allylic oxidation of cyclohexene, hmonene, and a-pinene, respectively. Substrate conversions were higher than 80% and ketone yields decreased in the following order cyclohexen-1-one (47%), verbenone (22%), and carvone (12%). The large amount of oxidized sites of monoterpenes, especially limonene, may be the reason for the lower ketone yield obtained with this substrate. Additional tests snggested that molecular oxygen can act as co-oxidant and alcohol oxidation is an intermediate step in ketone formation. [Pg.435]

The heterogeneous catalytic system iron phthalocyanine (7) immobilized on silica and tert-butyl hydroperoxide, TBHP, has been proposed for allylic oxidation reactions (10). This catalytic system has shown good activity in the oxidation of 2,3,6-trimethylphenol for the production of 1,4-trimethylbenzoquinone (yield > 80%), a vitamin E precursor (11), and in the oxidation of alkynes and propargylic alcohols to a,p-acetylenic ketones (yields > 60%) (12). A 43% yield of 2-cyclohexen-l-one was obtained (10) over the p-oxo dimeric form of iron tetrasulfophthalocyanine (7a) immobilized on silica using TBHP as oxidant and CH3CN as solvent however, the catalyst deactivated under reaction conditions. [Pg.436]

Basically, three reactions were evoked to support the occurrence of 5a-C-centered radicals 10 in tocopherol chemistry. The first one is the formation of 5a-substituted derivatives (8) in the reaction of a-tocopherol (1) with radicals and radical initiators. The most prominent example here is the reaction of 1 with dibenzoyl peroxide leading to 5a-a-tocopheryl benzoate (11) in fair yields,12 so that a typical radical recombination mechanism was postulated (Fig. 6.6). Similarly, low yields of 5a-alkoxy-a-tocopherols were obtained by oxidation of a-tocopherol with tert-butyl hydroperoxide or other peroxides in inert solvents containing various alcohols,23 24 although the involvement of 5 a-C-centered radicals in the formation mechanism was not evoked for explanation in these cases. [Pg.169]

The chemically catalyzed oxidation of carotenoids by metalloporphyrins has also been described in the literature. In 2000, French et al. described a central cleavage mimic system (ruthenium porphyrin linked to cyclodextrins) that exhibited a 15,1 S -regiosclectivity of about 40% in the oxidative cleavage of [3-carotene by tert-butyl hydroperoxide in a biphasic system (French et al. 2000). [Pg.221]

Secondly, the interaction of hindered amines with hydroperoxides was examined. At room temperature, using different monofunctional model hydroperoxides, a direct hydroperoxide decomposition by TMP derivatives was not seen. On the other hand, a marked inhibitory effect of certain hindered amines on the formation of hydroperoxides in the induced photooxidation of hydrocarbons was observed. Additional spectroscopic and analytical evidence is given for complex formation between TMP derivatives and tert.-butyl hydroperoxide. From these results, a possible mechanism for the reaction between hindered amines and the oxidizing species was proposed. [Pg.65]

Decomposition of Peroxides by Various Stabilizers. The efficiency of tert-butyl hydroperoxide decomposition in tert-butyl alcohol by various additives was determined (Table 9). Under the conditions of these experiments, the phenolic antioxidants and dilauryl thiodipropionate had little or, often, no effect on the hydroperoxide decomposition. The three zinc salts effectively inhibited peroxide decomposition. This effect might briefly inhibit the onset of substrate oxidation under weathering-test conditions, but the peroxide would decompose whenever its concentration reached a sufficient level to permit significant light... [Pg.157]

Recently, the oxidation of primary aliphatic amines to the corresponding nitro compounds has also been achieved using the catalyst system based on zirconium tetra tert-butoxide and tert-butyl hydroperoxide in a molecular sieve (50-98% yield) (Eqs. 2.56 and 2.57 and Table... [Pg.21]

In contrast to numerous literature data, which indicate that protein oxidation, as a rule, precedes lipid peroxidation, Parinandi et al. [66] found that the modification of proteins in rat myocardial membranes exposed to prooxidants (ferrous ion/ascorbate, cupric ion/tert-butyl-hydroperoxide, linoleic acid hydroperoxide, and soybean lipoxygenase) accompanied lipid peroxidation initiated by these prooxidant systems. [Pg.829]

Diaryl diselenides and benzisoselenazole-3(27/)-ones are used as efficient catalysts in the process of imine oxidation with hydrogen peroxide and tert-butyl-hydroperoxide (25). [Pg.131]

This compound is notorious as a hard sulfide that cannot be removed from petroleum by current hydrodesulfurization processing. Oxidation by tert-butyl hydroperoxide occurs readily when 1 is used as the catalyst. After trying several combinations, this was the most effective 0.5 mmol of DMDBT, 1.75 mmol B OOH, and 0.05 mol% of 1 were placed in refluxing toluene (384 K). A quantitative yield of the dioxide was obtained in 2h. The oxidation product is insoluble in toluene and can readily be removed by filtration (42). [Pg.183]

The flask was filled with dry dichloromethane (50 mL) and L-(+)-diisopro-pyl tartrate (350 mg). The mixture was cooled to — 35 °C using the cooling bath, then activated powdered 4 A molecular sieves (1.2g), titanium Aoprop-oxide (297 pL) and a solution of tert-butyl hydroperoxide (5.5 M in isooc-tane, 7.2mL) were added sequentially. The mixture was stirred at —35 °C for 1 hour. [Pg.77]

Vinylallenes can also be cydized oxidatively. Vinylallene 61 when treated with vanadyl acetonacetonate and tert-butyl hydroperoxide in benzene produced cyclopen-tenone 63, the immediate precursor of methylenomytin B (cf. 5, Eq. 13.1), in 50%... [Pg.826]


See other pages where Oxidation tert.butyl hydroperoxide is mentioned: [Pg.64]    [Pg.69]    [Pg.64]    [Pg.69]    [Pg.434]    [Pg.645]    [Pg.649]    [Pg.666]    [Pg.677]    [Pg.188]    [Pg.1044]    [Pg.185]    [Pg.93]    [Pg.138]    [Pg.442]    [Pg.150]    [Pg.58]    [Pg.223]    [Pg.158]    [Pg.507]    [Pg.258]    [Pg.183]    [Pg.27]    [Pg.292]   
See also in sourсe #XX -- [ Pg.137 ]




SEARCH



Butyl hydroperoxide

Hydroperoxides oxidation

Hydroperoxides tert-butyl hydroperoxide

Tert-Butyl hydroperoxides

© 2024 chempedia.info