Output Tables

In 1990, North Carolina produced 60% of the total scrap mica the remainder was produced in Connecticut, Georgia, New Mexico, Pennsylvania, South Carolina, and South Dakota. In 1991, the five largest producers produced 67% of the nation s total output (Table 9) (15). 

Combustion. The primary reaction carried out in the gas turbine combustion chamber is oxidation of a fuel to release its heat content at constant pressure. Atomized fuel mixed with enough air to form a close-to-stoichiometric mixture is continuously fed into a primary zone. There its heat of formation is released at flame temperatures deterruined by the pressure. The heat content of the fuel is therefore a primary measure of the attainable efficiency of the overall system in terms of fuel consumed per unit of work output. Table 6 fists the net heat content of a number of typical gas turbine fuels. Net rather than gross heat content is a more significant measure because heat of vaporization of the water formed in combustion cannot be recovered in aircraft exhaust. The most desirable gas turbine fuels for use in aircraft, after hydrogen, are hydrocarbons. Fuels that are liquid at normal atmospheric pressure and temperature are the most practical and widely used aircraft fuels kerosene, with a distillation range from 150 to 300 °C, is the best compromise to combine maximum mass —heat content with other desirable properties. For ground turbines, a wide variety of gaseous and heavy fuels are acceptable. 

The range of directions used in the search is determined from a set of look-up tables based on the aspect ratio of the area source, the stability category, and the downwind distance. The SCREEN model also provides the user an option to specify a wind direction orientation relative to the long axis of the rectangular area. The second option may be used to estimate the concentration at a particular receptor location relative to the area. The output table for area sources includes the wind direction associated with the maximum concentration at each distance. 

The results are very encouraging, and show that, as expected, the power consumption of the electrochemically promoted unit, which is promotional to A 1, is negligible in comparison to the Diesel engine power output (Table 12.3). This work demonstrates the great potential of electrochemical promotion for practical applications. The first fifty Dinex units were sold in 2001. 

Step 13. Generate the output table of temperature, observed densities, estimated uncertainties, and difference between observed and calculated densities and arrange it in order of year of publication with authors. For data from a particular source, arrange in order of temperature. 

To begin the analysis, Marx s numerical example of expanded reproduction can be recast as an input-output framework. Table 2.4(a) re-expresses the numerical elements of Table 2.2 as an input-output table. The advantage of this table is that it shows explicitly how Marx assumes capitalists spend their 1,750 units of surplus value on 500 units of new constant capital (dC), 150 new variable capital (clV) and 1,100 capitalist consumption (u). 

Table 2.4 Expanded reproduction in an input-output table...

It can now be shown how this result can be derived using an input-output interpretation of the simple reproduction schema. Following the same procedure first introduced in Chapter 2, Table 6.2(a) re-expresses the numerical elements of Table 6.1 as an input-output table. 

Table 6.2(b) is an algebraic representation, using Marxian categories, of the input-output table for simple reproduction. In comparison with Table 6.1, this provides a clearer and more detailed representation of simple reproduction, since the expenditure of surplus value on capitalist consumption is shown explicitly as u. Moreover, the condition of simple reproduction is embodied in the assumption that total inputs are equal to total outputs (see Sweezy 1942 162). Writing out these input-output balances explicitly,... 

The IO model used for ISIS is based on the most recent input output tables of the European Statistical Office (Eurostat, 2004) for the year 2000. It can be assigned to... 

The higher prices of cars, which is balanced by subsidies, has two impacts in ASTRA first, car manufacturers increase their revenues and output, compared with BAU, and second, a few other sectors that manufacture significant shares of the fuel cell also benefit. HyWays estimates that about one third of a car s price is related to the drive train. For hydrogen-fuel-cell cars, out of this one third about 30% is assumed to be provided by the chemical sector and 40% by the electronics sector in ASTRA. The remaining 30% is still manufactured by the vehicle sector. Hence, the according shares of demand for H2 fuel-cell vehicles are shifted from the vehicles sector, which before produced 100% of the drive train, to the chemicals and electronics sectors, respectively. This affects the sectoral final demand and the input-output table calculations in ASTRA. 

EUROSTAT (2004). Input Output Tables - Data, http //epp.eurostat.ec.europa.eu. 

The fundamental elements of deterministic models involve a combination of chemical and meteorologic input, preprocessing with data transmission, logic that describes atmospheric processes, and concentration-field output tables or displays. In addition to deterministic models, there are statistical schemes that relate precursors (or emission) to photo-chemical-oxidant concentrations. Models may be classified according to time and space scales, depending on the purposes for which th are designed. 

For starch production, we refer to published inventory data [13] prepared based on 1995 Input-Output Tables. The economic value of starch is based on 1995 Input-Output Tables [14]. 

National Institute for Environmental Studies (2002) Embodied energy and emission intensity data for Japan using input-output tables (3EID). National Institute for Environmental Studies, Japan... 

Management and Coordination Agency (1999) 1995 input-output tables. MCA, Government of Japan, Tokyo... 

Choosing the one-factor option (which must have replicate data, although not necessarily the same number of repeats for each instance of the factor), the output includes an ANOVA table shown in spreadsheet 2,5, In the output table, SS stands for sum of squares, df is degrees of freedom, and MS is... 

Such equations allow calculations to be carried out to quantify the materials used and produced during the course of a fermentation in the same manner as for a chemical reaction process. If the fermentation scheme is simplified to the situation shown in Fig. 5.40, then an input-output table can be drawn up for the streams shown, given the composition of, say, the carbon and energy feed stream and the gaseous product stream. 

Theoretical output Table 3.3 (C3 and C4 from top isoC5 and normal C5 from middle of column C6, C7, and C8 from bottom). 

Tiering is often applied in risk assessment in order to reduce expenditures in time, money, and labor when the assessment requires only simple and possibly conservative output. Table 5.3 provides a suggested tiered approach in mixture extrapolation and is further described in the bulleted list below. The tiering is based on the way that mixture mechanisms are addressed in the approach. It is assumed that issues such as matrix and media extrapolation have been addressed according to the methods described in the pertinent chapters. 

If you select the option for Dunnett s test in your statistical package, you will additionally have to indicate that platinum is to act as the control. The generic output (Table 13.5) shows the difference of each metal in turn from platinum. Platinum is demonstrated to be inferior to palladium and the alloy, but there is no statistically significant evidence of a difference from rhodium or iridium. 

The final output (Table 14.8) shows an adjusted f+squared value of 0.873, which is higher than the value of0.724 achieved by simple regression using rainfall alone. The... 

In the generic output (Table 15.1) the data have been supplied in summarized form, indicating 50 cases examined and 42 classified as successes . 

Congress a) Part INBS Special Publication 511-1, SD Stock No. SN-003-003-01926-7 b) Part II NBS Special Publication 511-2 Appendix B. A report to NBS by Battelle Columbus Laboratories, SD Stock No. SN-003-003-01927-5, US Govt. Printing Office, Washington, DC, 1978 c) Part III, Appendix C, Battelle Columbus Input/Output Tables, NBs GCR 78-122, PB-279 430, National Technical Information Service, Springfield, VA, 1978. 

Rows below the last one shown can be used to calculate intermediate quantities.) Execute enough runs (including the two shown above) to determine the effea on the stack gas composition of each of the five input parameters. Then for the values of p, q, r, and x% given in part (a), find the minimum percentage excess air needed to keep the dry-basis SO2 composition below 700 ppm. (Make this the last run in the output table.)... 

With a long-term decline in the levels of domestic crude oil production, imports have increased to meet the demand for petroleum products and to sustain the fairly stable levels of U.S.-based refinery output. Tables 4-5, 4-6, and 4-7 summarize trends in petroleum product imports, exports, and levels of U.S. demand (use) for these products. 

---