Oils, nitrated

Oils, Nitrated. See under Fats, Fatty Oils, Tallows, Butters, Waxes and Fatty Acids in Vol 8, F8-L to F9-L... 

Mutagenicity tests and gas chromatographic analyses of motor oils exposed to NO2 indicated the presence of many mutagenic nitroaromatic compounds. Comparison of motor oil nitrated with NO2 and used automobile oil show similar behavior448. 

Animal ond Vegetable Fats and Oils, Nitrated. See Fats and Oiis, Nitrated... 

Note For information on rictnoleic acid, see Vol 2, C87-R to C88-R under Castor Oil, Hydrogenated and Castor Oil, Nitrated Ricinolein Nitrate (or Nitroricinolein). Obtd by nitration of ricinolein and used with NC (1/9 p) as an expl component... 

LMNR see Lead mononiiroresorcinaic LOX see Liquid oxygen explosives Lubricating oils, nitration if (to produce anti Corroston materials) 21S... 

Nitration of Petroleum Oils Nitration by-products can be monitored by measuring the absorbance area from the NO2 symmetric and asymmetric stretch over the range of 1650-1600 cm (Fig. 16.16). The nitration measurement uses the same general baseline as the oxidation measurement. 

The reaction is exothermic, and multitubular reactors are employed with indirect cooling of the reactor via a heat transfer medium. A number of heat transfer media have been proposed to carry out the reactor cooling, such as hot oil circuits, water, sulfur, mercury, etc. However, the favored heat transfer medium is usually a molten heat transfer salt which is a eutectic mixture of sodium-potassium nitrate-nitrite. 

Steam is by far the most widely used medium, useful up to about 475 K. Up to about 700 K organic liquids such as the dowtherms and mineral oil may be used. Mercury and molten salts, such as the eutectic mixture of sodium nitrite, sodium nitrate and potassium nitrate may be used up to 875 K, while above this temperature air and flue gases must be used. 

Obtained by the catalytic hydrogenation of naphthalene. Owing to the presence of one aromatic ring it can be nitrated and sulphon-ated. It is non-toxic and is used as a solvent for fats, oils and resins. 

In a 500 ml. three-necked flask, equipped with a thermometer, mechanical stirrer and efficient reflux condenser, dissolve 16 g. of sodium hydroxide pellets in 95 ml. of hot methyl alcohol. Add 49 g. of guanidine nitrate, stir the mixture at 50-65° for 15 minutes, and then cool to about 20°. Filter oflF the separated sodium nitrate and wash with two 12 ml. portions of methyl alcohol. Return the combined filtrates to the clean reaction flask, add 69 g. of sulphanilamide (Section IX,9) and stir at 50-55° for 15 minutes. Detach the reflux condenser and, with the aid of a still-head ( knee-tube ), arrange the apparatus for distillation from an oil bath with stirring about 100 ml. of methyl alcohol are recovered. Add 12 g. of pure cycZohexanol. Raise the temperature of the oil bath to 180-190° and continue the distillation. Reaction commences with the evolution of ammonia when the uiternal temperature reaches 145°. Maintain the... 

Gr. iodes, violet) Discovered by Courtois in 1811, Iodine, a halogen, occurs sparingly in the form of iodides in sea water from which it is assimilated by seaweeds, in Chilean saltpeter and nitrate-bearing earth, known as caliche in brines from old sea deposits, and in brackish waters from oil and salt wells. 

Analytical Procedures. Standard methods for analysis of food-grade adipic acid are described ia the Food Chemicals Codex (see Refs, ia Table 8). Classical methods are used for assay (titration), trace metals (As, heavy metals as Pb), and total ash. Water is determined by Kad-Fisher titration of a methanol solution of the acid. Determination of color ia methanol solution (APHA, Hazen equivalent, max. 10), as well as iron and other metals, are also described elsewhere (175). Other analyses frequendy are required for resia-grade acid. For example, hydrolyzable nitrogen (NH, amides, nitriles, etc) is determined by distillation of ammonia from an alkaline solution. Reducible nitrogen (nitrates and nitroorganics) may then be determined by adding DeVarda s alloy and continuing the distillation. Hydrocarbon oil contaminants may be determined by ir analysis of halocarbon extracts of alkaline solutions of the acid. 

Lubricants, Fuels, and Petroleum. The adipate and azelate diesters of through alcohols, as weU as those of tridecyl alcohol, are used as synthetic lubricants, hydrauHc fluids, and brake fluids. Phosphate esters are utilized as industrial and aviation functional fluids and to a smaH extent as additives in other lubricants. A number of alcohols, particularly the Cg materials, are employed to produce zinc dialkyldithiophosphates as lubricant antiwear additives. A smaH amount is used to make viscosity index improvers for lubricating oils. 2-Ethylhexyl nitrate [24247-96-7] serves as a cetane improver for diesel fuels and hexanol is used as an additive to fuel oil or other fuels (57). Various enhanced oil recovery processes utilize formulations containing hexanol or heptanol to displace oil from underground reservoirs (58) the alcohols and derivatives are also used as defoamers in oil production. 

In the batch process which finds occasional use, the steps used in the successive nitrations are similar and include acid mixing, addition of the oil, digesting (cooking) the reaction to completion, cooling and settling the mix, and separating the oil from the acid. The nitrators are made of stainless steel... 

Pure ammonium nitrate decomposes in a complex manner in a series of progressive reactions having different thermochemical effects (Table 17). Oxygen is Hberated from combination with combustibles only at temperatures above 300°C. When a combustible material such as fuel oil is present in stoichiometric proportions (ca 5.6%) the energy evolved increases almost threefold... 

Water-in-od emulsion explosives have been made as typified by a formulation containing 20% water, 12% oil, 2% microspheres, 1% emulsifier, and 65% ammonium nitrate. The micro droplets of an emulsion explosive offer the advantage of intimate contact between fuel and oxidizer, and tend to equal or outperform conventional water-based slurries. 

S. R. Brinkley and W. E. Gordon, "Explosive Properties of the Ammonium Nitrate-Fuel Oil System," in Proceedings of 31st Inst. Congress of Industrial Chemisty, Liege, Belg., 1958. 

Ammonia from coal gasification has been used for fertilizer production at Sasol since the beginning of operations in 1955. In 1964 a dedicated coal-based ammonia synthesis plant was brought on stream. This plant has now been deactivated, and is being replaced with a new faciUty with three times the production capacity. Nitric acid is produced by oxidation and is converted with additional ammonia into ammonium nitrate fertilizers. The products are marketed either as a Hquid or in a soHd form known as Limestone Ammonium Nitrate. Also, two types of explosives are produced from ammonium nitrate. The first is a mixture of fuel oil and porous ammonium nitrate granules. The second type is produced by emulsifying small droplets of ammonium nitrate solution in oil. 

Lead antimonate [13510-89-9] (Naples yellow), Pb2(Sb0 2> mol wt 993.07, d = 6.58g/cm, is an orange-yeUow powder that is insoluble in water and dilute acids, but very slightly soluble in hydrochloric acid. Lead antimonates are modifiers for ferroelectric lead titanates, pigments in oil-base paints, and colorants for glasses and glazes (see Colorants for ceramics). They are made by the reaction of lead nitrate and potassium antimonate solutions, followed by concentration and crystallization. 

---