Mobile phase, chromatographic studies

The first observation of the enantioselective properties of an albumin was made in 1958 (28) when it was discovered that the affinity for L-tryptophan exceeded that of the D-enantiomer by a factor of approximately 100. This led to more studies in 1973 of the separation of DL-tryptophan [54-12-6] C22H22N2O2, on BSA immobilized to Sepharose (29). After extensive investigation of the chromatographic behavior of numerous racemic compounds under different mobile-phase conditions, a BSA-SILICA hplc column (Resolvosil-R-BSA, Macherey-Nagel GmvH, Duren, Germany) was... 

The influence of NH., and CO, on the chromatographic behaviour of benzoic acid and its derivatives (o-, m-, p-hydroxybenzoic, nitrobenzoic, aminobenzoic, chlorobenzoic acids) was studied. The work was carried out by means of upgoing TLC on Sorbfil plates. Isopropanol- and ethyl acetate-containing water-organic eluents were used as mobile phases in the absence or presence of gaseous modifiers in the MP. The novel modification of TLC has been found to separate benzoic acids with different values of their dissociation constants more effectively than water-organic mobile phases. 

The solvent used was 5 %v/v ethyl acetate in n-hexane at a flow rate of 0.5 ml/min. Each solute was dissolved in the mobile phase at a concentration appropriate to its extinction coefficient. Each determination was carried out in triplicate and, if any individual measurement differed by more than 3% from either or both replicates, then further replicate samples were injected. All peaks were symmetrical (i.e., the asymmetry ratio was less than 1.1). The efficiency of each solute peak was taken as four times the square of the ratio of the retention time in seconds to the peak width in seconds measured at 0.6065 of the peak height. The diffusivities obtained for 69 different solutes are included with other physical and chromatographic properties in table 1. The diffusivity values are included here as they can be useful in many theoretical studies and there is a dearth of such data available in the literature (particularly for the type of solutes and solvents commonly used in LC separations). 

If some fields may be empty in the sublevels, all the fields in the main level are required for each entry. A new chiral separation record can be added in CHIRBASE solely if the authors correctly identify both sample and CSP. Since the beginning of the project, our policy has been to contact the authors of all publications containing incomplete, ambiguous or inconsistent data and to ask for additional information. Providing the separations with unique case numbers helps us considerably in this essential task, and also facilitates avoiding redundancies in the database. When chiral separations are reported for the second time in a new publication with exactly the same chromatographic conditions, this is stated in a footnote added in the field comments . In this field, miscellaneous information that cannot appear elsewhere are listed (detection limit, description of a reported chromatogram, racemization study, mobile phase limitations, etc.). 

We think, therefore, that the conformation, chain and segment mobilities in the attached macromolecules can play a significant role in the shielding behavior of the polymeric stationary phase as well as in the processes of its formation of complexes with solutes. Obviously, the chromatographic studies relevant to composite supports suffer from a lack of information on the structure of the attached polymer. Nevertheless, we will attempt to point out some relevant data from independent studies on polymer adsorption and/or graft polymerization. 

A review on TLC and PLC of amino adds, peptides, and proteins is presented in the works by Bhushan [24,25]. Chromatographic behavior of 24 amino acids on silica gel layers impregnated tiraryl phosphate and tri-n-butylamine in a two-component mobile phase (propanol water) of varying ratios has been studied by Sharma and coworkers [26], The effect of impregnation, mobile phase composition, and the effect of solubility on hRf of amino acids were discussed. The mechanism of migration was explained in terms of adsorption on impregnated silica gel G and the polarity of the mobile phase used. 

The metabolic and pharmacokinetic profile of sucralose (this is a novel intense sweetener with a potency about 600 times that of sucrose) in human volunteers was studied by Roberts and coworkers [82]. Part of this study was realized using PLC in the following chromatographic system in which the stationary phase was silica gel and the mobile phase was ethyl acetate-methanol-water-concentrated ammonia (60 20 10 2, v/v). Separated substances were scraped off separately, suspended in methanol, and analyzed by filtration, scintillation counting, or enzymatic assay. It was shown that the characteristics of sucralose include poor absorption, rapid elimination, limited conjugative metabolism of the fraction absorbed, and lack of bio-accumulative potential. 

The different organic modifiers used to derive the most suitable mobile phases lead to different parameters namely isocratic logfe and extrapolated logkw. The extrapolation method has no reality in terms of chromatographic behavior of solutes. However, mainly by correlation with log Pod (Eqs. 2 and 3) several studies have demonstrated the interest of these extrapolated retention factors as predictors of the lipophilicity of solutes. 

Solid-phase microextraction (SPME) consists of dipping a fiber into an aqueous sample to adsorb the analytes followed by thermal desorption into the carrier stream for GC, or, if the analytes are thermally labile, they can be desorbed into the mobile phase for LC. Examples of commercially available fibers include 100-qm PDMS, 65-qm Carbowax-divinylbenzene (CW-DVB), 75-qm Carboxen-polydimethylsiloxane (CX-PDMS), and 85-qm polyacrylate, the last being more suitable for the determination of triazines. The LCDs can be as low as 0.1 qgL Since the quantity of analyte adsorbed on the fiber is based on equilibrium rather than extraction, procedural recovery cannot be assessed on the basis of percentage extraction. The robustness and sensitivity of the technique were demonstrated in an inter-laboratory validation study for several parent triazines and DEA and DIA. A 65-qm CW-DVB fiber was employed for analyte adsorption followed by desorption into the injection port (split/splitless) of a gas chromatograph. The sample was adjusted to neutral pH, and sodium chloride was added to obtain a concentration of 0.3 g During continuous... 

The most common method for varying the chromatographic selectivity for neutral molecules in RPC is to change the type of organic modifier in the mobile phase. In numerous studies using binary mobile phases, equation (4.15) has been shown to describe reasonably well the variation of solute retention with the volume fraction of organic solvent in an aqueous-organic mobile phase... 

Aleksic et al. [47] estimated the hydrophobicity of miconazole and other antimycotic drugs by a planar chromatographic method. The retention behavior of the drugs have been determined by TLC by using the binary mobile phases acetone-n-hexane, methanol toluene, and methyl ethyl ketone toluene containing different amounts of organic modifier. Hydrophobicity was established from the linear relationships between the solute RM values and the concentration of organic modifier. Calculated values of RMO and CO were considered for application in quantitative structure activity relationship studies of the antimycotics. 

Guillaume et al. [69] presented a high performance liquid chromatographic method for an association study of miconazole and other imidazole derivatives in surfactant micellar using a hydrophilic reagent, Montanox DF 80. The thermodynamic results obtained showed that imidazole association in the surfactant micelles was effective over a concentration of surfactant equal to 0.4 pM. In addition, an enthalpy-entropy compensation study revealed that the type of interaction between the solute and the RP-18 stationary phase was independent of the molecular structure. The thermodynamic variations observed were considered the result of equilibrium displacement between the solute and free ethanol (respectively free surfactant) and its clusters (respective to micelles) created in the mobile phase. 

The influence of various structural and physicochemical parameters of the stationary and mobile phases on the tailing of a cationic dye in reversed-phase chromatography has been studied in detail. Measurements were performed in a C8 reversed-phase column (80 X 4.6 mm). The isocratic mobile phase was ACN-0.01 M aqueous HC1 (90 10, v/v). Analyses were carried out at 20°C and the flow rate was 1-5 ml/min. The concentration of the cationic dye, l,l -didodecyl-3,3,3, 3 -tetramethylindocarbocyanine perchlorate (Dil) in the model solutions varied between 0.9-309 pM. The dependence of the chromatographic profile of the dye on the injected concentration is illustrated in Fig. 3.112. Calculations and mathematical modelling indicated that the peak tailing of the dye can be... 

Various liquid chromatographic techniques have been frequently employed for the purification of commercial dyes for theoretical studies or for the exact determination of their toxicity and environmental pollution capacity. Thus, several sulphonated azo dyes were purified by using reversed-phase preparative HPLC. The chemical strctures, colour index names and numbers, and molecular masses of the sulphonated azo dyes included in the experiments are listed in Fig. 3.114. In order to determine the non-sulphonated azo dyes impurities, commercial dye samples were extracted with hexane, chloroform and ethyl acetate. Colourization of the organic phase indicated impurities. TLC carried out on silica and ODS stationary phases was also applied to control impurities. Mobile phases were composed of methanol, chloroform, acetone, ACN, 2-propanol, water and 0.1 M sodium sulphate depending on the type of stationary phase. Two ODS columns were employed for the analytical separation of dyes. The parameters of the columns were 150 X 3.9 mm i.d. particle size 4 /jm and 250 X 4.6 mm i.d. particle size 5 //m. Mobile phases consisted of methanol and 0.05 M aqueous ammonium acetate in various volume ratios. The flow rate was 0.9 ml/min and dyes were detected at 254 nm. Preparative separations were carried out in an ODS column (250 X 21.2 mm i.d.) using a flow rate of 13.5 ml/min. The composition of the mobile phases employed for the analytical and preparative separation of dyes is compiled in Table 3.33. 

---