Liquids homogenous catalysis

Conclusions for Two-Phase Gas-Liquid Homogeneous Catalysis. For two-phase gas-liquid systems, the conclusions for single-phase systems and particularly criteria I and II must be considered. In addition two new considerations apply to type A systems because of the presence of gas-liquid mass transfer. 

Catalysis in a single fluid phase (liquid, gas or supercritical fluid) is called homogeneous catalysis because the phase in which it occurs is relatively unifonn or homogeneous. The catalyst may be molecular or ionic. Catalysis at an interface (usually a solid surface) is called heterogeneous catalysis, an implication of this tenn is that more than one phase is present in the reactor, and the reactants are usually concentrated in a fluid phase in contact with the catalyst, e.g., a gas in contact with a solid. Most catalysts used in the largest teclmological processes are solids. The tenn catalytic site (or active site) describes the groups on the surface to which reactants bond for catalysis to occur the identities of the catalytic sites are often unknown because most solid surfaces are nonunifonn in stmcture and composition and difficult to characterize well, and the active sites often constitute a small minority of the surface sites. 

Many transition metal complexes dissolve readily in ionic liquids, which enables their use as solvents for transition metal catalysis. Sufficient solubility for a wide range of catalyst complexes is an obvious, but not trivial, prerequisite for a versatile solvent for homogenous catalysis. Some of the other approaches to the replacement of traditional volatile organic solvents by greener alternatives in transition metal catalysis, namely the use of supercritical CO2 or perfluorinated solvents, very often suffer from low catalyst solubility. This limitation is usually overcome by use of special ligand systems, which have to be synthesized prior to the catalytic reaction. 

Since no special ligand design is usually required to dissolve transition metal complexes in ionic liquids, the application of ionic ligands can be an extremely useful tool with which to immobilize the catalyst in the ionic medium. In applications in which the ionic catalyst layer is intensively extracted with a non-miscible solvent (i.e., under the conditions of biphasic catalysis or during product recovery by extraction) it is important to ensure that the amount of catalyst washed from the ionic liquid is extremely low. Full immobilization of the (often quite expensive) transition metal catalyst, combined with the possibility of recycling it, is usually a crucial criterion for the large-scale use of homogeneous catalysis (for more details see Section 5.3.5). 

However, a number of limitations are still evident when tetrafluorohorate and hexafluorophosphate ionic liquids are used in homogeneous catalysis. The major aspect is that these anions are still relatively sensitive to hydrolysis. The tendency to anion hydrolysis is of course much less pronounced than that of the chloroalu-minate melts, hut it still occurs and this has major consequences for their use in transition metal catalysis. For example, the [PF ] anion of l-hutyl-3-methylimida-2olium ([BMIM]) hexafluorophosphate was found (in the author s laboratories) to hydrolyze completely after addition of excess water when the sample was kept for 8 h at 100 °C. Gaseous HF and phosphoric acid were formed. Under the same conditions, only small amounts of the tetrafluorohorate ion of [BMlMjjBFJ was converted into HF and boric acid [10]. The hydrolytic formation of HF from the anion of the ionic liquid under the reaction conditions causes the following problems with... 

The combination of ionic liquids and compressed CO2 - at opposite extremes of the volatility and polarity scales - offers a new and intriguing immobilization technique for homogeneous catalysis. 

Recently, room temperature ionic liquids (RT-ILs) have attracted much attention for their excellent properties, e.g., wide temperature range of liquid phase, ultra-low vapor pressure, chemical stability, potential as green solvents, and high heat capacities [64,65]. These properties make them good candidates for the use in many fields, such as thermal storage [66], electrochemical applications, homogeneous catalysis [67], dye sensitized solar cells [68], and lubricants [69,70]. 

In homogeneous catalysis, both the catalyst and the reactants are in the same phase, i.e. all are molecules in the gas phase, or, more commonly, in the liquid phase. One of the simplest examples is found in atmospheric chemistry. Ozone in the atmosphere decomposes, among other routes, via a reaction with chlorine atoms ... 

Edward Tiekink and gold complexes in liquid crystals by Pablo Espinet. Homogenous catalysis by gold complexes is not included here since a book dedicated especially to this topic edited by Stephen Hashmi will also appear in 2009 from this publishing house. 

In homogeneous catalysis soluble catalysts are applied, usually in the liquid phase, in contrast to heterogeneous catalysis, where solid catalysts are used. Homogeneous catalysis is applied in many processes in both bulk and fine chemicals production. 

Because homogeneous catalysis is usually carried out in the liquid phase, temperature control is relatively easy. However, the temperature must not be too high to prevent degradation of the catalyst complexes. 

Homogeneous catalytic processes are those in which the catalyst is dissolved in a liquid reaction medium. There are a variety of chemical species that may act as homogeneous catalysts (e.g., anions, cations, neutral species, association complexes, and enzymes). All such reactions appear to involve a chemical interaction between the catalyst and the substrate (the substance undergoing reaction). The bulk of the material in this section will focus on acid-base and enzyme catalysis. Students interested in learning more about these subjects and other aspects of homogeneous catalysis should consult appropriate texts (11-12, 16-29) or the original literature. 

Immobilization of catalysts is an important process design feature (see Chapter 9.9). A recent example of catalyst immobilization is the biphasic approach which seems superior to immobilization on solids, as successfully proven in the Ruhrchemie/Rhone Poulenc process for the hydro-formylation of olefins.286 Supported liquid phase catalysis was devised as a method for the immobilization of homogeneous catalysts on solids. When the liquid phase is water, a water-soluble catalyst may be physically bound to the solid. 

Several studies have reported the catalysis of the liquid-phase water gas shift reaction (WGSR). Actually, homogeneous catalysis of the WGSR is not competitive with its heterogeneous counterpart due to the limited rate, instability of the catalysts, and high costs. Scheme 64 shows the most important steps. 

In classical homogenous catalysis, an organic compound, i.e., a real liquid phase (a solvent) dissolves all of the reactants, catalysts, and products. The role of the solvent is underlined by the fact that it has to be separated from the reaction products by an additional and costly step, for example by distillation. 

Aqueous biphasic catalysis is a special case of the two-phase processes of homogeneous catalysis. Despite the academic literature s provocative question "Why water " [18a, 18b], the advantages of water as the second phase and the "liquid support" are numerous. On the one hand, the search for the necessary solubility gap is much easier with water than with various organic-phase liquids (Figure 5.2). Additionally, water has many properties which predestine it as a ideal liquid support in homogeneous catalysis (see T able 5.1)[18c,18d]. 

The term Supported Ionic Liquid Phase (SILP) catalysis has recently been introduced into the literature to describe the heterogenisation of a homogeneous catalyst system by confining an ionic liquid solution of catalytically active complexes on a solid support [68], In comparison to the conventional liquid-liquid biphasic catalysis in organic-ionic liquid mixtures, the concept of SILP-catalysis offers very efficient use of the ionic liquid. Figure 7.10 exemplifies the concept for the Rh-catalysed hydroformylation. 

---