Kinetic ketone

Ketone imine anions can also be alkylated. The prediction of the regioselectivity of lithioenamine formation is somewhat more complex than for the case of kinetic ketone enolate formation. One of the complicating factors is that there are two imine stereoisomers, each of which can give rise to two regioisomeric imine anions. The isomers in which the nitrogen substituent R is syn to the double bond are the more stable.114... 

Table 13.6 shows the various aldol adducts that can be obtained if one reacts a quantitatively formed ester enolate or a quantitatively formed (kinetic) ketone enolate with three representative carbonyl compounds. Crossed aldol adducts are adducts that result from the addition of the enolate of one carbonyl compound to the C=0 double bond of a second carbonyl compound (center column in Table 13.6). 

Table 10.5 shows the various aldol adducts that can be obtained if one reacts a quantitatively formed ester enolate or a quantitatively formed (kinetic) ketone enolate with... 

V-Butylanilinomanganese chloride, PhN(Bul.MaC Regioselective enoUzation. The kinetic ketone ganese amides. Polyalkylation with such enolater is 1... 

The efficient trapping of kinetic ketone-enolates with cyanation reagents has previously eluded the synthetic organic chemist. A new procedure has now been developed and utilizes p-toluenesulphonyl cyanide as the cyanation reagent for the preparation of /3-ketonitriles from cyclic ketones (Scheme 27). 

Kinetic measurements were performed employii UV-vis spectroscopy (Perkin Elmer "K2, X5 or 12 spectrophotometer) using quartz cuvettes of 1 cm pathlength at 25 0.1 C. Second-order rate constants of the reaction of methyl vinyl ketone (4.8) with cyclopentadiene (4.6) were determined from the pseudo-first-order rate constants obtained by followirg the absorption of 4.6 at 253-260 nm in the presence of an excess of 4.8. Typical concentrations were [4.8] = 18 mM and [4.6] = 0.1 mM. In order to ensure rapid dissolution of 4.6, this compound was added from a stock solution of 5.0 )j1 in 2.00 g of 1-propanol. In order to prevent evaporation of the extremely volatile 4.6, the cuvettes were filled almost completely and sealed carefully. The water used for the experiments with MeReOj was degassed by purging with argon for 0.5 hours prior to the measurements. All rate constants were reproducible to within 3%. 

The ketone is added to a large excess of a strong base at low temperature, usually LDA in THF at -78 °C. The more acidic and less sterically hindered proton is removed in a kineti-cally controlled reaction. The equilibrium with a thermodynamically more stable enolate (generally the one which is more stabilized by substituents) is only reached very slowly (H.O. House, 1977), and the kinetic enolates may be trapped and isolated as silyl enol ethers (J.K. Rasmussen, 1977 H.O. House, 1969). If, on the other hand, a weak acid is added to the solution, e.g. an excess of the non-ionized ketone or a non-nucleophilic alcohol such as cert-butanol, then the tautomeric enolate is preferentially formed (stabilized mostly by hyperconjugation effects). The rate of approach to equilibrium is particularly slow with lithium as the counterion and much faster with potassium or sodium. 

Each act of proton abstraction from the a carbon converts a chiral molecule to an achi ral enol or enolate ion The sp hybridized carbon that is the chirality center m the start mg ketone becomes sp hybridized m the enol or enolate Careful kinetic studies have established that the rate of loss of optical activity of sec butyl phenyl ketone is equal to Its rate of hydrogen-deuterium exchange its rate of brommation and its rate of lodma tion In each case the rate determining step is conversion of the starting ketone to the enol or enolate anion... 

T[[dotb]he nature of the initial attack by the water (eq. 10) is a matter of some controversy (205,206). Stereochemical and kinetic studies of model systems have been reported that support trans addition of external water (207,208) or internal addition of cis-coordinated water (209), depending on the particular model system under study. Other paHadium-cataly2ed oxidations of olefins ia various oxygen donor solvents produce a variety of products including aldehydes (qv), ketones (qv), vinyl acetate, acetals, and vinyl ethers (204). However the product mixtures are complex and very sensitive to conditions. 

The idea of kinetic versus thermodynamic control can be illustrated by discussing briefly the case of formation of enolate anions from unsymmetrical ketones. This is a very important matter for synthesis and will be discussed more fully in Chapter 1 of Part B. Most ketones, highly symmetric ones being the exception, can give rise to more than one enolate. Many studies have shown tiiat the ratio among the possible enolates that are formed depends on the reaction conditions. This can be illustrated for the case of 3-methyl-2-butanone. If the base chosen is a strong, sterically hindered one and the solvent is aptotic, the major enolate formed is 3. If a protic solvent is used or if a weaker base (one comparable in basicity to the ketone enolate) is used, the dominant enolate is 2. Enolate 3 is the kinetic enolate whereas 2 is the thermodynamically favored enolate. 

Structural effects on the rates of deprotonation of ketones have also been studied using veiy strong bases under conditions where complete conversion to the enolate occurs. In solvents such as THF or DME, bases such as lithium di-/-propylamide (LDA) and potassium hexamethyldisilylamide (KHMDS) give solutions of the enolates in relative proportions that reflect the relative rates of removal of the different protons in the carbonyl compound (kinetic control). The least hindered proton is removed most rapidly under these... 

Equilibrium between the various enolates of a ketone can be established by the presence of an excess of the ketone, which permits proton transfer. Equilibration is also favored by the presence of dissociating solvents such as HMPA. The composition of the equilibrium enolate mixture is usually more closely balanced than for kinetically... 

Scheme 7.1. Composition of Ketone-Enoiate Mixtures Formed under Kinetic and Thermodynamic Conditions"...

A number of studies of the acid-catalyzed mechanism of enolization have been done. The case of cyclohexanone is illustrative. The reaction is catalyzed by various carboxylic acids and substituted ammonium ions. The effectiveness of these proton donors as catalysts correlates with their pK values. When plotted according to the Bronsted catalysis law (Section 4.8), the value of the slope a is 0.74. When deuterium or tritium is introduced in the a position, there is a marked decrease in the rate of acid-catalyzed enolization h/ d 5. This kinetic isotope effect indicates that the C—H bond cleavage is part of the rate-determining step. The generally accepted mechanism for acid-catalyzed enolization pictures the rate-determining step as deprotonation of the protonated ketone ... 

The dienol is unstable, and two separate processes have been identified for ketonization. These are a 1,5-sigmatropic shift of hydrogen leading back to the enone and a base-catalyzed proton transfer which leads to the / ,y-enone. The deconjugated enone is formed because of the kinetic preference for reprotonation of the dienolate at the a carbon. Photochemical deconjugation is a synthetically useful way of effecting isomerization of a,) -unsaturated ketones and esters to the j ,y-isomers. 

Protonation of the a-carbanion (50), which is formed both in the reduction of enones and ketol acetates, probably first affords the neutral enol and is followed by its ketonization. Zimmerman has discussed the stereochemistry of the ketonization of enols and has shown that in eertain cases steric factors may lead to kinetically controlled formation of the thermodynamically less stable ketone isomer. Steroidal unsaturated ketones and ketol acetates that could form epimeric products at the a-carbon atom appear to yield the thermodynamically stable isomers. In most of the cases reported, however, equilibration might have occurred during isolation of the products so that definitive conclusions are not possible. 

If the equilibrium were established rapidly, reduction of the free ketone as it formed would result in a substantial loss of product. Lithium enolates are more covalent in character than are those of sodium and potassium and consequently are the least basic of the group. This lower thermodynamic basicity appears to be paralleled by a lower kinetic basicity several workers have shown that lithium enolates are weaker bases in the kinetic sense than are those of sodium and potassium." As noted earlier, conjugated enones... 

Site-specificity of the reaction is established in the first step since enolate formation involves the carbonyl carbon and the former halide bearing carbon, while the stereospecificity of the incoming deuterium is determined during the second step. It appears that the ketonization in deuterioacetic acid yields mainly the kinetic product (axial attack) although deuteration is... 

Enolization is the rate-determining step in the halogenation of normal ketones. Where alternate directions for enolization exist, the preferred direction (and hence the position of kinetic bromination) depends on the substituents and stereochemistry. Furthermore, the orientation of the bromine introduced depends on stereochemical and stereoelectronic factors. 

A commonly used alternative to the direct bromination of ketones is the halogenation of enol acetates. This can be carried out under basic conditions if necessary. Sodium acetate, pyridine or an epoxide is usually added to buffer the reaction mixture. The direction of enolization is again dependent upon considerations of thermodynamic and kinetic control therefore, the proportion of enol acetates formed can vary markedly with the reaction conditions. Furthermore, halogenation via enol acetates does not necessarily give the same products as direct halogenation of ketones 3. 23... 

The enolization of 5a-3-ketones appears to be cleanly directed to C-2, whereas that of 5j5-3-ketones is less selective. Remote substituents can have a significant effect on the kinetic and thermodynamic enol acetylation of 5j3-steroids. ... 

In general bromination of 20-ketones is directed to the introduction of functionality at C-21. However, on occasion 17-bromo compounds are required for dehydrobromination to A -20-ketones, although these are generally obtained in other ways. Kinetic enolization of a 20-ketone gives the A °-enol, whereas the thermodynamic product is the A kjsomer. An interesting enolate trapping reaction has been used recently to prepare 16-methyl-A -20-ketones ... 

---