Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Pseudo first order rate constant

The effective rate law correctly describes the pressure dependence of unimolecular reaction rates at least qualitatively. This is illustrated in figure A3,4,9. In the lunit of high pressures, i.e. large [M], becomes independent of [M] yielding the high-pressure rate constant of an effective first-order rate law. At very low pressures, product fonnation becomes much faster than deactivation. A j now depends linearly on [M]. This corresponds to an effective second-order rate law with the pseudo first-order rate constant Aq ... [Pg.788]

Kinetic measurements were performed employii UV-vis spectroscopy (Perkin Elmer "K2, X5 or 12 spectrophotometer) using quartz cuvettes of 1 cm pathlength at 25 0.1 C. Second-order rate constants of the reaction of methyl vinyl ketone (4.8) with cyclopentadiene (4.6) were determined from the pseudo-first-order rate constants obtained by followirg the absorption of 4.6 at 253-260 nm in the presence of an excess of 4.8. Typical concentrations were [4.8] = 18 mM and [4.6] = 0.1 mM. In order to ensure rapid dissolution of 4.6, this compound was added from a stock solution of 5.0 )j1 in 2.00 g of 1-propanol. In order to prevent evaporation of the extremely volatile 4.6, the cuvettes were filled almost completely and sealed carefully. The water used for the experiments with MeReOj was degassed by purging with argon for 0.5 hours prior to the measurements. All rate constants were reproducible to within 3%. [Pg.123]

Herein k js is the observed pseudo-first-order rate constant. In the presence of micelles, analogous treatment of the experimental data will only provide an apparent second-order rate constant, which is a weighed average of the second-order rate constants in the micellar pseudophase and in the aqueous phase (Equation 5.2). [Pg.130]

The effect of micelles of SDS, CTAB and C12E7 on the apparent second-order rate constants of the Diels-Alder reaction between nonionic 5.1a, anionic 5.1 f and cationic 5.1g with 5.2 is reported in Table 5.1. These apparent rate constants are calculated from the observed pseudo-first-order rate constants by dividing the latter by the overall concentration of 5.2. [Pg.133]

Herein [5.2]i is the total number of moles of 5.2 present in the reaction mixture, divided by the total reaction volume V is the observed pseudo-first-order rate constant Vmrji,s is an estimate of the molar volume of micellised surfactant S 1 and k , are the second-order rate constants in the aqueous phase and in the micellar pseudophase, respectively (see Figure 5.2) V is the volume of the aqueous phase and Psj is the partition coefficient of 5.2 over the micellar pseudophase and water, expressed as a ratio of concentrations. From the dependence of [5.2]j/lq,fe on the concentration of surfactant, Pj... [Pg.135]

Assuming complete binding of the dienophile to the micelle and making use of the pseudophase model, an expression can be derived relating the observed pseudo-first-order rate constant koi . to the concentration of surfactant, [S]. Assumirg a negligible contribution of the reaction in the aqueous phase to the overall rate, the second-order rate constant in the micellar pseudophase lq is given by ... [Pg.156]

When the dienophile does not bind to the micelle, reaction will take place exclusively in the aqueous phase so that the second-order rate constant of the reaction in the this phase (k,) is directly related to the ratio of the observed pseudo-first-order rate constant and the concentration of diene that is left in this phase. [Pg.157]

The value for the pseudo-first-order rate constant is determined by solving equation 13.6 for k and making appropriate substitutions thus... [Pg.626]

The conditions chosen make the reaction appear to be first-order overall, although the reaction is really not first-order overall, unlessjy and happen to be 2ero. If a simple exponential is actually observed over a reasonable extent (at least 90—95%) of decay the assumptions are considered vaUdated and is obtained with good precision. The pseudo-first-order rate constant is related to the k in the originally postulated rate law by... [Pg.508]

The two main termination steps for neutral solutions are HO + HO — H2O2 + 2 O3 and HO + HO3 — H2O2 + O3 + O2. An alternative mechanism has been proposed that does not involve HO and HO but has a different initiation step (26). Three ozone molecules are destroyed for each primary event. In the presence of excess HO radical scavengers, ie, bicarbonate, the pseudo-first-order rate constant at 20°C for the initiation step is 175 X. This yields an ozone half-hfe of 66 min at pH 8. In distilled water = 50 mmol/L), the half-hfe is significantly lower, ie, 7 min. [Pg.491]

Fig. 8.P3I. Plot of the pseudo-first-order rate constants for hydrolysis of thioesters A (O), B ( ), C (A), D (A) as a fiinction of pH at 50°C and ionic strength 0.1 (KCI). Lines are from fits of the data to = kon(K /H+)) + (k KJK + [//+])) where koH is the hydroxide term and is the intramolecular assistance term for B and C and from linear regression for A and D. Reproduced from problem reference 31 by permission of the American Chemical Society. Fig. 8.P3I. Plot of the pseudo-first-order rate constants for hydrolysis of thioesters A (O), B ( ), C (A), D (A) as a fiinction of pH at 50°C and ionic strength 0.1 (KCI). Lines are from fits of the data to = kon(K /H+)) + (k KJK + [//+])) where koH is the hydroxide term and is the intramolecular assistance term for B and C and from linear regression for A and D. Reproduced from problem reference 31 by permission of the American Chemical Society.
The intermediate diphenylhydroxymethyl radical has been detected after generation by flash photolysis. Photolysis of benzophenone in benzene solution containing potential hydrogen donors results in the formation of two intermediates that are detectable, and their rates of decay have been measured. One intermediate is the PhjCOH radical. It disappears by combination with another radical in a second-order process. A much shorter-lived species disappears with first-order kinetics in the presence of excess amounts of various hydrogen donors. The pseudo-first-order rate constants vary with the structure of the donor with 2,2-diphenylethanol, for example, k = 2 x 10 s . The rate is much less with poorer hydrogen-atom donors. The rapidly reacting intermediate is the triplet excited state of benzophenone. [Pg.755]

Calculate die pseudo-first order rate constant kj = k2[S20g ] and, hence, k2. [Pg.177]

The results give the pseudo-first order rate constant, and kj = 3.312 a... [Pg.179]

The initial anhydride concentration was about 3 x 10 M, and the amine concentration was much larger than this. The reaction was followed spectrophoto-metrically, and good first-order kinetics were observed hence, the reaction is first-order with respect to cinnamic anhydride. It was not convenient analytically to use the isolation technique to determine the order with respect to allylamine, because it is easier to observe the cinnamoyl group spectrophotometrically than to follow the loss of amine. Therefore, the preceding experiment was repeated at several amine concentrations, and from the first-order plots the pseudo-first-order rate constants were determined. These data are shown in Table 2-1. Letting A represent... [Pg.26]

Table 2-1. Determination of Reaction Order from Pseudo-First-Order Rate Constants ... Table 2-1. Determination of Reaction Order from Pseudo-First-Order Rate Constants ...
The isolation technique showed that the reaction is first-order with respect to cin-namoylimidazole, but treatment of the pseudo-first-order rate constants revealed that the reaction is not first-order in amine, because the ratio k Jc is not constant, as shown in Table 2-2. The last column in Table 2-2 indicates that a reasonable constant is obtained by dividing by the square of the amine concentration hence the reaction is second-order in amine. For the system described in Table 2-2, we therefore find that the reaction is overall third-order, with the rate equation... [Pg.27]

We can reach two useful conclusions from the forms of these equations First, the plots of these integrated equations can be made with data on concentration ratios rather than absolute concentrations second, a first-order (or pseudo-first-order) rate constant can be evaluated without knowing any absolute concentration, whereas zero-order and second-order rate constants require for their evaluation knowledge of an absolute concentration at some point in the data treatment process. This second conclusion is obviously related to the units of the rate constants of the several orders. [Pg.34]

Table 2-4 gives data for the alkaline hydrolysis of phenyl cinnamate under pseudo-first-order conditions, with calculations made in order to apply the Guggenheim method. The plot according to Eq. (2-55) is shown in Fig. 2-9. From the slope the pseudo-first-order rate constant is 3.37 x 10 s . ... [Pg.37]

These are pseudo-first-order rate constants for the alkaline hydrolysis of ethyl / -nitrobenzoate at 25°C. [Pg.54]

Considering the attention that we have given in this chapter to concentrationtime curves of complex reactions, it may seem remarkable that many kinetic studies never generate a comprehensive set of complicated concentration-time data. The reason for this is that complex reactions often can be studied under simplified conditions constituting important special cases for example, whenever feasible one chooses pseudo-first-order conditions, and then one studies the dependence of the pseudo-first-order rate constant on variables other than time. This approach is amplified below. [Pg.121]

Reactions catalyzed by hydrogen ion or hydroxide ion, when studied at controlled pH, are often described by pseudo-first-order rate constants that include the catalyst concentration or activity. Activation energies determined from Arrhenius plots using the pseudo-first-order rate constants may include contributions other than the activation energy intrinsic to the reaction of interest. This problem was analyzed for a special case by Higuchi et al. the following treatment is drawn from a more general analysis. ... [Pg.256]

An effective experimental design is to measure the pseudo-first-order rate constant k at constant pH and ionic strength as a function of total buffer concentration 6,. Very often the buffer substance is the catalyst. Let B represent the conjugate base form of the buffer. Because pH is constant, the ratio (B]/[BH ] is constant, and the concentrations of both species increase directly with 6 where B, = [B] -t-[BH"]. [Pg.268]

Throughout this section the hydronium ion and hydroxide ion concentrations appear in rate equations. For convenience these are written [H ] and [OH ]. Usually, of course, these quantities have been estimated from a measured pH, so they are conventional activities rather than concentrations. However, our present concern is with the formal analysis of rate equations, and we can conveniently assume that activity coefficients are unity or are at least constant. The basic experimental information is k, the pseudo-first-order rate constant, as a function of pH. Within a senes of such measurements the ionic strength should be held constant. If the pH is maintained constant with a buffer, k should be measured at more than one buffer concentration (but at constant pH) to see if the buffer affects the rate. If such a dependence is observed, the rate constant should be measured at several buffer concentrations and extrapolated to zero buffer to give the correct k for that pH. [Pg.273]

This leads, after the usual development, to Eq. (6-80) for the pseudo-first-order rate constant k. [Pg.288]

Quantitative structure-reactivity analysis is one of the most powerful tools for elucidating the mechanisms of organic reactions. In the earliest study, Van Etten et al. 71) analyzed the pseudo-first-order rate constants for the alkaline hydrolysis of a variety of substituted phenyl acetates in the absence and in the presence of cyclodextrin. The... [Pg.82]

Table 4. Pseudo-first-order rate constants (kob,d) for p-nitrophenol release from p-nitrophenyl picolinate... Table 4. Pseudo-first-order rate constants (kob,d) for p-nitrophenol release from p-nitrophenyl picolinate...
Table 7. Pseudo-first-order rate constants, kc and K values in the Cu2 + ion catalyzed reaction of 1... Table 7. Pseudo-first-order rate constants, kc and K values in the Cu2 + ion catalyzed reaction of 1...
Table 9. Pseudo-first-order rate constants for the release of p-nitrophenol in the reactions of optically active esters in a CTAB micelle... Table 9. Pseudo-first-order rate constants for the release of p-nitrophenol in the reactions of optically active esters in a CTAB micelle...

See other pages where Pseudo first order rate constant is mentioned: [Pg.152]    [Pg.768]    [Pg.1099]    [Pg.2947]    [Pg.66]    [Pg.633]    [Pg.2189]    [Pg.251]    [Pg.23]    [Pg.56]    [Pg.167]    [Pg.181]    [Pg.256]    [Pg.83]    [Pg.146]    [Pg.154]    [Pg.157]   
See also in sourсe #XX -- [ Pg.23 ]

See also in sourсe #XX -- [ Pg.12 ]

See also in sourсe #XX -- [ Pg.111 ]

See also in sourсe #XX -- [ Pg.152 ]

See also in sourсe #XX -- [ Pg.668 ]




SEARCH



First-order constants

First-order pseudo

First-order rate constant

Hydrolysis rate constant, pseudo-first-order

Open pseudo-first-order rate constant

Order constant

Order pseudo

Pseudo First-Order Kinetics and HX Rate Constants

Pseudo first order constants

Pseudo first order rate constants for

Pseudo first-order rate constant esters

Pseudo rate constant

Pseudo-first order intrinsic rate constant

Pseudo-first-order rate constant laser flash photolysis

Pseudo-first-order rate constant oxygen reactions

Pseudo-first-order reaction rate constants

Pseudo-order rate constant

Rate constant, base hydrolysis pseudo first-order

Rate-first order

Rates pseudo order

© 2024 chempedia.info