Kinetic order ketones

Discussion of ketone oxidation has centred around the identity of the molecule undergoing oxidation. This has been clearly resolved in some, but not all, cases, the evidence resting on (i), the relative rates of enolisation and oxidation, (ii) kinetic orders and (ih) isotope effects. A general feature of the oxidations of ketones by one-equivalent reagents is that the rate for a given oxidant exceeds that for oxidation of a secondary alcohol by the same oxidant. The most attractive explanation is that the radical formed from a ketone is stabilised by delocalisation, viz. 

The values of x = 0.5 and = 1 for the kinetic orders in acetone [1] and aldehyde [2] are not trae kinetic orders for this reaction. Rather, these values represent the power-law compromise for a catalytic reaction with a more complex catalytic rate law that corresponds to the proposed steady-state catalytic cycle shown in Scheme 50.3. In the generally accepted mechanism for the intermolecular direct aldol reaction, proline reacts with the ketone substrate to form an enamine, which then attacks the aldehyde substrate." A reaction exhibiting saturation kinetics in [1] and rate-limiting addition of [2] can show apparent power law kinetics with both x and y exhibiting orders between zero and one. 

Kinetic measurements were performed employii UV-vis spectroscopy (Perkin Elmer "K2, X5 or 12 spectrophotometer) using quartz cuvettes of 1 cm pathlength at 25 0.1 C. Second-order rate constants of the reaction of methyl vinyl ketone (4.8) with cyclopentadiene (4.6) were determined from the pseudo-first-order rate constants obtained by followirg the absorption of 4.6 at 253-260 nm in the presence of an excess of 4.8. Typical concentrations were [4.8] = 18 mM and [4.6] = 0.1 mM. In order to ensure rapid dissolution of 4.6, this compound was added from a stock solution of 5.0 )j1 in 2.00 g of 1-propanol. In order to prevent evaporation of the extremely volatile 4.6, the cuvettes were filled almost completely and sealed carefully. The water used for the experiments with MeReOj was degassed by purging with argon for 0.5 hours prior to the measurements. All rate constants were reproducible to within 3%. 

The only kinetic data reported are in a Ph.D. thesis (41). Integral order kinetics were usually not obtained for the reaction of a number of ketones with piperidine and a number of secondary amines with cyclohexanone. A few of the combinations studied (cyclopentanone plus piperidine, pyrrolidine, and 4-methylpiperidine, and N-methylpiperazine plus cyclohexanone) gave reactions which were close to first-order in each reactant. Relative rates were based on the time at which a 50% yield of water was evolved. For the cyclohexanone-piperidine system the half-time (txn) for the 3 1 ratio was 124 min and for the 1 3 ratio 121 min. It appears that an... 

Carboxyl-related and acyl substituents. Included here are cyano, protonated amidinium ion, thionoacyl, acyl (Ar—CO, H—CO, Alkyl—CO), carboxamido, carboaryloxy, carboalkoxy, carboxy (unionized), amidino (unionized), and carboxylate anion, listed approximately in order of decreasing electron attraction or activation. The relative activation by some of these groups (e.g., ketone, aldehyde, nitrile) will change upon reversible interaction with the nucleophile, which will vary with the group and with the nucleophile (e.g., MeO , N3, NCS ). Irreversible interaction will be obvious when the reaction products in kinetic studies are characterized. 

A few kinetic measurements on the acid permanganate oxidation of cyclohexanone have been reported by Littler . The reaction is first order in ketone but the order in oxidant was not clearly established. 

Mercuric perchlorate has been shown to attack cyclohexanone, the reaction being zero-order in the salt and the rate being that of enolisation with a primary kinetic isotope effect of the same magnitude, to give a mercurated ketone ... 

Hydride transfer from [(bipy)2(CO)RuH]+ occurs in the hydrogenation of acetone when the reaction is carried out in buffered aqueous solutions (Eq. (21)) [39]. The kinetics of the reaction showed that it was a first-order in [(bipy)2(CO)RuH]+ and also first-order in acetone. The reaction proceeds faster at lower pH. The proposed mechanism involved general acid catalysis, with a fast pre-equilibrium protonation of the ketone followed by hydride transfer from [(biPy)2(CO)RuH]+. 

Kinetic and mechanistic studies by Casey et al. provided further insight into the mechanistic details of the hydrogenation of ketones and aldehydes, using a more soluble analogue of Shvd s catalyst (with p-tolyl groups instead of two of the Ph groups) [72]. The kinetics of hydrogenation of benzaldehyde by the Ru complex shown in Eq. (43) were first order in aldehyde and first order in the Ru complex the... 

Field studies on the transformation of endrin in the atmosphere were not located in the available literature. Photochemical isomerization of endrin, primarily to the pentacyclic ketone commonly called delta ketoendrin or endrin ketone, was observed after exposure of thin layers of solid endrin on glass to sunlight (Burton and Pollard 1974). Minor amounts of endrin aldehyde were also formed in this reaction. Results of seasonal studies indicated that this isomerization would proceed with a half-life (first-order kinetics) of 5-9 days in intense summer sunlight, with complete conversion to the pentacyclic ketone in 15-19 days. Knoevenagel and Himmelreich (1976) reported that photodegradation of solid endrin in the laboratory... 

The primary literature now contains a very large body of kinetic data for the catalysis of enolization and ketonization, not only of ketones and aldehydes but also of )3-diketones, )3-keto esters, and dienones, much of which could be treated by the Kurz approach. Also, data exist for third-order enolization, due to combined general acid and base catalysis, that could also be analysed. Such treatment is beyond the scope the present review. However, one study of metal ion catalysis of enolization is discussed later in this section. 

Ashby and Yu have studied the kinetics of reduction of benzophenone with TIBA in ether and showed that the overall kinetic rate expression is second order, first order in TIBA and first order in ketone (151). The observed activation parameters were AG - 18.8 kcal/mol AH = 15.8 kcal/mol and AS = - 10.1 e.u. The negative entropy of activation is consistent with a cyclic transition state for the rate-determining hydride-transfer step. A Hammett study gave a value of p = 0.362, supporting nucleophilic attack by the aluminum alkyl on the carbonyl group in the rate-determining step. 

CI2 evolution reaction, 38 56 electrochemical desorption, 38 53-54 electrode kinetics, 38 55-56 factors that determine, 38 55 ketone reduction, 38 56-57 Langmuir adsorption isotherm, 38 52 recombination desorption, 38 53 surface reaction-order factor, 38 52 Temkin and Frumkin isotherm, 38 53 real-area factor, 38 57-58 regular heterogeneous catalysis, 38 10-16 anodic oxidation of ammonia, 38 13 binding energy quantification, 38 15-16 Haber-Bosch atrunonia synthesis, 38 12-13... 

Conjugate additions to a, j5-unsaturated ketones and esters are the most important cuprate reactions. Kinetic studies by Krauss and Smith on Me2CuLi and a variety of ketones revealed the following kinetic characteristics (Eq. 10.5), first order both in cuprate dimer and in the enone [60]. 

---