Bromination kinetics

Other 6-substituted dihydrodiazepinium salts may also be brominated. Kinetic measurements show that 6-methyl derivatives undergo addition of bromine at position 6 in a fast reaction between bromine molecules and dihydrodiazepinium cations [75JCS(P2)325]. The bromination of both 6-bromo and 6-methyl derivatives can be accommodated within a single reaction scheme, but the rate-determining steps are different for the two types of compounds. For 6-methyl derivatives the initial bromination is rate-determining, whereas for the 6-bromo derivatives the subsequent hydrolysis is rate-determining [75JCS(P2)325]. 

Chlorination and bromination of pyridine and some alkylpyridines in the (3-position can be effected in the liquid phase at 100°C using excess AlCl3as catalyst. -Bromination of pyridine and 2- and 4-picoline is conveniently effected in oleum at 80-120°C. Bromination kinetics using HOBr in aqueous HC104 indicate that the partial rate factor for bromination of the pyridinium cation is 10 13, comparable to that for nitration. 

The rates of ketonization are usually easier to determine (by flash photolysis) than the much slower rates of enolization that require laborious conventional methods such as measuring bromination kinetics and analysis of the reaction products. Thus the shape of the profile is conveniently explored by flash photolysis over a wide range of pH for kK, and only a single point on the lower curve is then required to determine the enolization constant Ke-... 

This important dissociation energy D(R-H) was obtained from the thermochemical relationship D(R-H) = Z)(H-I) + Ef- Ef. This method was exploited by Benson and co-workers to great effect to obtain large numbers of BDE values. Parallel but less extensive work was done on bromination kinetic studies (by Kistiakowsky, Whittle and others). 

Equally important is the molecularity of an elementary reaction. One of the fast steps in the hydrogen bromine kinetic sequence (4.5) is... 

Kinetic data are available for the nitration of a series of p-alkylphenyl trimethylammonium ions over a range of acidities in sulphuric acid. - The following table shows how p-methyl and p-tert-h xty augment the reactivity of the position ortho to them. Comparison with table 9.1 shows how very much more powerfully both the methyl and the tert-butyl group assist substitution into these strongly deactivated cations than they do at the o-positions in toluene and ferf-butylbenzene. Analysis of these results, and comparison with those for chlorination and bromination, shows that even in these highly deactivated cations, as in the nitration of alkylbenzenes ( 9.1.1), the alkyl groups still release electrons in the inductive order. In view of the comparisons just... 

When unsubstituted, C-5 reacts with electrophilic reagents. Thus phosphorus pentachloride chlorinates the ring (36, 235). A hydroxy group in the 2-position activates the ring towards this reaction. 4-Methylthiazole does not react with bromine in chloroform (201, 236), whereas under the same conditions the 2-hydroxy analog reacts (55. 237-239. 557). Activation of C-5 works also for sulfonation (201. 236), nitration (201. 236. 237), Friede 1-Crafts reactions (201, 236, 237, 240-242), and acylation (243). However, iodination fails (201. 236). and the Gatterman or Reimer-Tieman reactions yield only small amounts of 4-methyl-5-carboxy-A-4-thiazoline-2-one. Recent kinetic investigations show that 2-thiazolones are nitrated via a free base mechanism. A 2-oxo substituent increases the rate of nitration at the 5-position by a factor of 9 log... 

Octabromodiphenyl Oxide. Octabromodiphenyl oxide [32536-52-0] (OBDPO) is prepared by bromination of diphenyl oxide. The degree of bromination is controlled either through stoichiometry (34) or through control of the reaction kinetics (35). The melting poiat and the composition of the commercial products vary somewhat. OBDPO is used primarily ia ABS resias where it offers a good balance of physical properties. Poor uv stabiUty is the primary drawback and use ia ABS is being supplanted by other brominated flame retardants, primarily TBBPA. 

In the section dealing with electrophilic attack at carbon some results on indazole homocyclic reactivity were presented nitration at position 5 (Section 4.04.2.1.4(ii)), sulfon-ation at position 7 (Section 4.04.2.1.4(iii)) and bromination at positions 5 and 7 (Section 4.04.2.1.4(v)). The orientation depends on the nature (cationic, neutral or anionic) of the indazole. Protonation, for instance, deactivates the heterocycle and directs the attack towards the fused benzene ring. A careful study of the nitration of indazoles at positions 2, 3, 5 or 7 has been published by Habraken (7UOC3084) who described the synthesis of several dinitroindazoles (5,7 5,6 3,5 3,6 3,4 3,7). The kinetics of the nitration of indazole to form the 5-nitro derivative have been determined (72JCS(P2)632). The rate profile at acidities below 90% sulfuric acid shows that the reaction involves the conjugate acid of indazole. 

Imidazole, 4-methyl-annular tautomerism, 5, 363 association, 5, 362 boiling point, 5, 362 bromination, 5, 398 deuteration, 5, 417 diazo coupling, 5, 403 hydrogen bonding, S, 350 hydroxymethylation, 5, 404 iodination, 5, 400 kinetics, 5, 401 mass spectra, 5, 358 melting point, 5, 362 methylation, 5, 364 sulfonation, 5, 397 synthesis, 5, 479-480, 482, 484, 489 Imidazole, 5-methyl-annular tautomerism, 5, 363 Imidazole, l-methyl-4-chloro-ethylation, 5, 386 Imidazole, l-methyl-5-chloro-ethylation, 5, 386 nitration, 5, 395... 

Because the product composition is kinetically controlled, the isomer ratio will be governed by the relative magnitudes of AG, AGI, and AG, the energies of activation for the ortho, meta, and para transition states, respectively. In Fig. 4.7 a qualitative comparison of these AG values is made. At the transition state, a positive charge is present on the benzene ring, primarily at positions 2, 4, and 6 in relation to the entering bromine. 

The distribution of a-bromoketones formed in the reaction of acetylcyclopentane with bromine was studied as a function of deuterium substitution. On the basis of the data given below, calculate the primaiy kinetic isotope effect for enolization of... 

Molecular bromine is believed to be the reactive brominating agent in uncatalyzed brominations. The brominations of benzene and toluene are first-order in both bromine and the aromatic substrate in trifluoroacetic acid solution, but the rate expressions become more complicated when these reactions take place in the presence of water. " The bromination of benzene in aqueous acetic acid exhibits a first-order dependence on bromine concentration when bromide ion is present. The observed rate is dependent on bromide ion concentration, decreasing with increasing bromide ion concentration. The detailed kinetics are consistent with a rate-determining formation of the n-complex when bromide ion concentration is low, but with a shift to reversible formation of the n-complex... 

Bromination has been shown not to exhibit a primary kinetic isotope effect in the case of benzene, bromobenzene, toluene, or methoxybenzene. There are several examples of substrates which do show significant isotope effects, including substituted anisoles, JV,iV-dimethylanilines, and 1,3,5-trialkylbenzenes. The observation of isotope effects in highly substituted systems seems to be the result of steric factors that can operate in two ways. There may be resistance to the bromine taking up a position coplanar with adjacent substituents in the aromatization step. This would favor return of the ff-complex to reactants. In addition, the steric bulk of several substituents may hinder solvent or other base from assisting in the proton removal. Either factor would allow deprotonation to become rate-controlling. 

Bromination is catalyzed by Lewis acids, and a study of the kinetics of bromination of benzene and toluene in the presence of aluminum chloride has been reported. Toluene is found to be about 35 times more reactive than benzene under these conditions. The catalyzed reaction thus shows a good deal less substrate selectivity than the uncatalyzed reaction, as would be expected on the basis of the greater reactivity of the aluminum chloride-bromine complex. 

Enolization is the rate-determining step in the halogenation of normal ketones. Where alternate directions for enolization exist, the preferred direction (and hence the position of kinetic bromination) depends on the substituents and stereochemistry. Furthermore, the orientation of the bromine introduced depends on stereochemical and stereoelectronic factors. 

The positions of substitution, orientation, and configuration of the stable form are determined by a balance between opposing steric and dipole ef-fects. There is less agreement regarding the factors influencing kinetically controlled reaction (see below). Essentially neutral conditions, such as provided by an acetate or pyridine buffer, are required to avoid isomerization. Frequently, however, bromination will not proceed under these conditions, and a compromise has been used in which a small amount of acid is added to start and maintain reaction, while the accumulation of hydrogen bromide is prevented by adding exactly one equivalent of acetate... 

A commonly used alternative to the direct bromination of ketones is the halogenation of enol acetates. This can be carried out under basic conditions if necessary. Sodium acetate, pyridine or an epoxide is usually added to buffer the reaction mixture. The direction of enolization is again dependent upon considerations of thermodynamic and kinetic control therefore, the proportion of enol acetates formed can vary markedly with the reaction conditions. Furthermore, halogenation via enol acetates does not necessarily give the same products as direct halogenation of ketones 3. 23... 

In general bromination of 20-ketones is directed to the introduction of functionality at C-21. However, on occasion 17-bromo compounds are required for dehydrobromination to A -20-ketones, although these are generally obtained in other ways. Kinetic enolization of a 20-ketone gives the A °-enol, whereas the thermodynamic product is the A kjsomer. An interesting enolate trapping reaction has been used recently to prepare 16-methyl-A -20-ketones ... 

The optical rotatory dispersion curves of steroidal ketones permit a distinction to be made between the conformations, and assignment of configuration is possible without resorting to chemical methods (see, e.g. ref. 36) which are often tedious. The axial halo ketone rule and, in the more general form, the octant rule summarize this principle and have revealed examples inconsistent with the theory of invariable axial attack in ketone bromination. 2-Methyl-3-ketones have been subjected to a particularly detailed analysis. There are a considerable number of examples where the products isolated from kinetically controlled brominations have the equatorial orientation. These results have been interpreted in terms of direct equatorial attack rather than initial formation of the axial boat form. 

In the absence of steric factors e.g. 5 ), the attack is antiparallel (A) (to the adjacent axial bond) and gives the axially substituted chair form (12). In the presence of steric hindrance to attack in the preferred fashion, approach is parallel (P), from the opposite side, and the true kinetic product is the axially substituted boat form (13). This normally undergoes an immediate conformational flip to the equatorial chair form (14) which is isolated as the kinetic product. The effect of such factors is exemplified in the behavior of 3-ketones. Thus, kinetically controlled bromination of 5a-cholestan-3-one (enol acetate) yields the 2a-epimer, (15), which is also the stable form. The presence of a 5a-substituent counteracts the steric effect of the 10-methyl group and results in the formation of the unstable 2l5-(axial)halo ketone... 

Bromination of 5j5-3-ketones yields the equatorial 4 -bromo compounds (22) as the thermodynamic or kinetic products,although the presence of a considerable amount of 2-bromo isomer has been reported in bromination with phenyltrimethylammonium bromide-perbromide. This is in keeping with other evidence that enolization of 5j5-3-ketones is not specifically directed to C-4. Cleaner results would probably be obtained via thermodynamic enol acelylation. ... 

Further bromination of the 4 -bromo compound, under thermodynamic or kinetic conditions, yields the 2, 4)S-dibromo compound (23) which apparently contains a little of the 2,2-dibromo isomer. Again, the 2,4-dibromo compound is best obtained directly from the parent ketone with two moles of bromine in acid. " With suitable methods of dehydrobromination (see... 

This ionic mechanism is supported by kinetic data. A free radical mechanism has been proposed for the unique bromination (with bromine) of 3a, 12a-diacetoxypregnan-20-one ethylene ketal, which gives the 21-bromo derivative in excellent yield. ... 

Each act of proton abstraction from the a carbon converts a chiral molecule to an achiral enol or enolate ion. The 5/) -hybridized carbon that is the chirality center in the starting ketone becomes 5/) -hybridized in the enol or enolate. Careful kinetic studies have established that the rate of loss of optical activity of 5cc-butyl phenyl ketone is equal to its rate of hydrogen-deuterium exchange, its rate of bromination, and its rate of iodina-tion. In each case, the rate-detennining step is conversion of the starting ketone to the enol or enolate anion. 

The rate equation is first-order in acetone, first-order in hydroxide, but it is independent of (i.e., zero order in) the halogen X2. Moreover, the rate is the same whether X2 is chlorine, bromine, or iodine. These results can only mean that the transition state of the rds contains the elements of acetone and hydroxide, but not of the halogen, which must enter the product in a fast reaction following the rds. Scheme VI satisfies these kinetic requirements. 

Thermodynamics and kinetics need not go hand in hand. Consider all possible products resulting from addition of one equivalent of bromine to phenylacetylene (phenylacetylene+Br2) and to styrene (styrene+Br2). Calculate the heat of reaction for each addition. (The energy of Br2 is given at right.) Is addition to the alkyne or to the alkene more favorable ... 

The influence of other groups in a pyridine or similar ring system is more difficult to assess because no kinetic data are available. The deactivating effect of the bromine atom in the 2-position is greater than that in the 3-position, while 2,6-dibromopyridine is very slow to react with dimethyl sulfate. Esters, amides, and nitriles of nicotinic and isonicotinic acids undergo fairly easy quaternization at about... 

---