Halogenation kinetics

Arriya PA, Khalizov A, Gidas A. 2002. Reactions of gaseous mercury with atomic and molecular halogens kinetics, product studies, and atmospheric implications. J Phys Chem A(106) 7310-7320. 

Using halogen, kinetic and thermodynamic products / 268 The use of enol acetates / 271... 

Atom abstraction occurs when a dissociation reaction occurs on a surface in which one of the dissociation products sticks to the surface, while another is emitted. If the chemisorption reaction is particularly exothennic, the excess energy generated by chemical bond fomiation can be chaimelled into the kinetic energy of the desorbed dissociation fragment. An example of atom abstraction involves the reaction of molecular halogens with Si surfaces [27, 28]. In this case, one halogen atom chemisorbs while the other atom is ejected from the surface. 

The equihbrium constant of this reaction is 5.4 x 10 at 25°C, ie, iodine hydrolyzes to a much smaller extent than do the other halogens (49). The species concentrations are highly pH dependent at pH = 5, about 99% is present as elemental at pH = 7, the and HIO species are present in almost equal concentrations and at pH = 8, only 12% is present as and 88% as HIO. The dissociation constant for HIO is ca 2.3 x 10 and the pH has tittle effect on the lO ion formation. At higher pH values, the HIO converts to iodate ion. This latter species has been shown to possess no disinfection activity. An aqueous solution containing iodate, iodide, and a free iodine or triodide ion has a pH of about 7. A thorough discussion of the kinetics of iodine hydrolysis is available (49). 

Kinetics are slow and many hours are requited for a 95% conversion of the reactants. In the case of the subject compound, there is evidence that the reaction is autocatalytic but only when approximately 30% conversion to the product has occurred (19). Reaction kinetics are heavily dependent on the species of halogen ia the alkyl haHde and decrease ia the order I >Br >C1. Tetrabutylphosphonium chloride exhibits a high solubiHty ia a variety of solvents, for example, >80% ia water, >70% ia 2-propanol, and >50% ia toluene at 25°C. Its analogues show similar properties. One of the latest appHcations for this phosphonium salt is the manufacture of readily dyeable polyester yams (20,21). 

The reactivity of halogens in pyridazine N- oxides towards nucleophilic substitution is in the order 5 > 3 > 6 > 4. This is supported by kinetic studies of the reaction between the corresponding chloropyridazine 1-oxides and piperidine. In general, the chlorine atoms in pyridazine A-oxides undergo replacement with alkoxy, aryloxy, piperidino, hydrazino, azido, hydroxylamino, mercapto, alkylmercapto, methylsulfonyl and other groups. 

Enolization is the rate-determining step in the halogenation of normal ketones. Where alternate directions for enolization exist, the preferred direction (and hence the position of kinetic bromination) depends on the substituents and stereochemistry. Furthermore, the orientation of the bromine introduced depends on stereochemical and stereoelectronic factors. 

A commonly used alternative to the direct bromination of ketones is the halogenation of enol acetates. This can be carried out under basic conditions if necessary. Sodium acetate, pyridine or an epoxide is usually added to buffer the reaction mixture. The direction of enolization is again dependent upon considerations of thermodynamic and kinetic control therefore, the proportion of enol acetates formed can vary markedly with the reaction conditions. Furthermore, halogenation via enol acetates does not necessarily give the same products as direct halogenation of ketones 3. 23... 

Kinetic evidence in the hydroxide-catalyzed halogenation of acetone provides definitive mechanistic information. The overall reaction is... 

The rate equation is first-order in acetone, first-order in hydroxide, but it is independent of (i.e., zero order in) the halogen X2. Moreover, the rate is the same whether X2 is chlorine, bromine, or iodine. These results can only mean that the transition state of the rds contains the elements of acetone and hydroxide, but not of the halogen, which must enter the product in a fast reaction following the rds. Scheme VI satisfies these kinetic requirements. 

It should be pointed out that the existence of stable structures of the intermediate-complex type (also known as a-complexes or Wheland complexes) is not of itself evidence for their being obligate intermediates in aromatic nucleophilic substitution. The lack of an element effect is suggested, but not established as in benzene derivatives (see Sections I,D,2 and II, D). The activated order of halogen reactivity F > Cl Br I has been observed in quantita-tivei36a,i37 Tables II, VII-XIII) and in many qualitative studies (see Section II, D). The reverse sequence applies to some less-activated compounds such as 3-halopyridines, but not in general.Bimolecular kinetics has been established by Chapman and others (Sections III, A and IV, A) for various reactions. 

Chloroquinoline (401) reacts well with potassium fluoride in dimethylsulfone while its monocyclic analog 2-chloropyridine does not. Greater reactivity of derivatives of the bicyclic azine is evident also from the kinetic data (Table X, p. 336). 2-Chloroquinoline is alkoxylated by brief heating with methanolic methoxide or ethano-lic potassium hydroxide and is converted in very high yield into the thioether by trituration with thiocresol (20°, few hrs). It also reacts with active methylene carbanions (45-100% yield). The less reactive 3-halogen can be replaced under vigorous conditions (160°, aqueous ammonia-copper sulfate), as used for 3-bromoquino-line or its iV-oxide. 4-Chloroquinoline (406) is substituted by alcoholic hydrazine hydrate (80°, < 8 hr, 20% yield) and by methanolic methoxide (140°, < 3 hr, > 90% yield). This apparent reversal of the relative reactivity does not appear to be reliable in the face of the kinetic data (Tables X and XI, pp. 336 and 338) and the other qualitative comparisons presented here. 

Halogenation of steroid 3-ketones can lead to complicated mixtures by virtue of the fact that the kinetic enol leads to 3 halo products, whereas the thermodynamic product is that halogenated at the 4 position. Carefully controlled reaction of the 5a-androstanolone with chlorine thus leads to the 2a-chloro derivative (29). Reaction of that intermediate with O(p-nitrophenyl)-hydroxylamine affords the androgenic agent ni stremine acetate (30). ... 

Evidence for the mechanism shown in Figure 22.4 includes the observation that acid-catalyzed halogenations show second-order kinetics and follow the rate law... 

Atomic velocity distribution, 130,131 Atomic volume, 94, 98 alkali metals, 94 halogens, 97 inert gases, 91 third-row elements, 101 Atomic weight, 33 table, inside back cover Atoms, 21 conservation of, 40 electrical nature of, 236 measuring dimensions of, 245 Avogadro, Amadeo hypothesis, 25, 52 hypothesis and kinetic theory, 58 law, 25 number, 33 Azo dyes, 344... 

R.C. Paule, Kinetics of Peroxide-Catalyzed Addition Reactions of Halogenated Compounds to Olefins , Florida Univ Contract No nr-1017 (00), ONR (1956) 6) L.P. Kuhn C. Well-... 

A comprehensive and detailed review of the literature relating to the decomposition reactions of the salts of halogen oxyacids has recently been given by Solymosi [1279], This book discusses many aspects of the chemical characteristics of this group of compounds. It includes a large amount of kinetic data and provides access to the original publications. 

---