Free Fluid

HF-D Water-free fluids. These usually refer to fluids... 

In his original demonstration Gibbs (1874) showed that the surface layer may be considered as a third phase having specific values of density, energy, and entropy, and further that the results of the theory are quite independent of the actual extent of the capillary layer and the way in which it merges into the free fluids on either side. As a matter of fact, the transition... 

Nb-free fluid (at Nb/U=0) would have a ratio of 0.7 if the Pa-U data were... 

If the NMR response is capable of estimating the pore size distribution, then it also has the potential to estimate the fraction of the pore space that is capable of being occupied by the hydrocarbon and the remaining fraction that will only be occupied by water. The Free Fluid Index (FFI) is an estimate of the amount of potential hydrocarbons in the rock when saturated to a given capillary pressure. It is expressed as a fraction of the rock bulk volume. The Bulk Volume Irreducible (BVI) is the fraction of the rock bulk volume that will be occupied by water at the same capillary pressure. The fraction of the rock pore volume that will only be occupied by water is called the irreducible water saturation (Siwr = BVI/cj>). The amount of water that is irreducible is a function of the driving force to displace water, i.e., the capillary pressure. Usually the specified driving force is an air-water capillary pressure of 0.69 MPa (100 psi). 

C. Straley, C. E. Morriss, W. E. Kenyon, J. J. Howard 1995, (NMR on partially saturated rocks Laboratory insights on free fluid index and comparison with borehole logs), Log Analyst 36 (1), 40-56. 

As argued by Reed [4], the Beltrami vector field originated in hydrodynamics and is force-free. It is one of the three basic types of field solenoidal, complex lamellar, and Beltrami. These vector fields originated in hydrodynamics and describe the properties of the velocity field, flux or streamline, v, and the vorticity V x v. The Beltrami field is also a Magnus force free fluid flow and is expressed in hydrodynamics as... 

Flow-Based Systems Needle-type sensors with a fluid flowing over the sensor tip seem to resist biofouling and extend sensor lifetime.31 There are numerous methods that have been investigated for flow-based sensors, such as microperfusion systems,75 microdialysis,76 77 and ultrafiltration.78 Reduced fouling was found with an open microflow system where slow flow of protein-free fluid over the sensor surface at the implant site is effected.73 Different from the other flow-based sensors, the open microflow is controlled by the subcutaneous tissue hydrostatic pressure and does not require a pump. 

Adhesives on the basis of a rubber are applied as watery dispersions, as solvents, or as solvent-free fluids. Sometimes the rubber is vulcanised after the gluing process, sometimes it remains uncured. Polymers often used are butyl rubber, polyisobutylene, and polychloroprene. A more recent development is the use of... 

Diffusion in macropores occurs mainly by the combined effects of bulk molecular diffusion (as in the free fluid) and Knudsen flow, with generally smaller contributions from other mechanisms such as surface diffusion and Poiseuille flow. Knudsen flow, which has the characteristics of a diffusive process, occurs because molecules striking the pore wall are instantaneously adsorbed and re-emitted in a random direction. The relative importance of bulk and Knudsen diffusion depends on the relative frequency of molecule-molecule and molecule-wall collisions, which in turn depends on the ratio of the mean free path to pore diameter. Thus Knudsen flow becomes dominant in small pores at low pressures, while in larger pores and at higher pressures diffusion occurs mainly by the molecular mechanism. Since the mechanism of diffusion may well be different at different pressures, one must be cautious about extrapolating from experimental diffusivity data, obtained at low pressures, to the high pressures commonly employed in industrial processes. 

Fig. 2.4. Uptake of methionine by Hymenolepis diminuta in Na + or Na+-free fluids of varying pH. (After Lussier et at, 1979.)...

Starved electrolyte battery — A -> battery with minimum amount of -> electrolyte. The electrolyte in starved electrolyte cells or batteries exists in the porous structure of the - electrodes and absorbed in the separator, so it contains little or no free fluid electrolytic solution. This type of batteries is used in certain constructions of sealed - lead-acid and -> nickel-cadmium batteries that rely on gas diffusion and recombination on the electrodes during charging or overcharging in order to maintain maintenance-free conditions, and to suppress pressure buildup. Starved electrolyte batteries benefit from larger - energy density due to the reduced amount of electrolyte. This design may suffer from poor heat dissipation compared with -> flooded batteries, thus for high power applications this point has to be taken into account. 

Figure 3 Hydrate crystal formations in the free fluid phase between glass beads (light balls)...

Electrophoretic methods are widely used alternatives for the analytical determination of the enantiomeric purity of chiral compounds [194]. Due to the high elTi-ciency of capillary electrophoresis, separations can be achieved even when very low selectivities are observed. At a preparative scale, these methods are well established for the purification of proteins and cells [195] but there is very little published on enantioselective separations. Only recently, some interest in chiral preparative applications has been manifested. Separation of the enantiomers ofterbu-taline [196] and piperoxan [197] have been reported by classical gel electrophoresis using sulfated cyclodextrin as a chiral additive, while the separation of the enantiomers of methadone could be successfully achieved by using free-fluid isotachophoresis [198] and by applying a process called interval-flow electrophoresis [199]. 

An objective response rate of less than 10% is anticipated for IP cisplatin in patients who fail to demonstrate at least a partial response to initial systemic cisplatin." Thns IP cisplatin should not be nsed in cisplatin-refractory patients. In addition to platinnm sensitivity and tumor size, extent of tumor spread must also be considered. IP therapy is most beneficial when the tmnor is confined to the abdomen." "" IP therapy is unlikely to have an advantage in patients with bnlky disease because drug penetration into larger tnmor nodnles is limited. AdditionaUy, patients best suited for IP administration shonld have limited IP adhesions with free fluid distribution. 

---