Acyclic Ethers

Michael Addition Reactions of Enamines and Enol Ethers, Acyclic Stereocontrol... 

The cyclic sulfates 85 can be reduced easily electrochemically under one-electron transfer conditions to yield a complex product mixture of cyclic ethers, acyclic alkanes, and unsaturated alcohols <1984BCJ3160>. Their alkaline hydrolysis has been studied carefully by ab initio MO calculations <1996J(P2)767> and it was found, in comparison with other cyclic sulfates, to be strongly dependent on the ring size <1997J(P1)3173>. 

Cleavage of Acyclic and Cyclic Ethers. Acyclic ethers are readily cleaved by (methylthio)trimethylsilane (eq 3). In... 

The first step of the reaction involves the formation of the S-C bond with the elimination of a molecule of ammonium salt. The fact that it has been possible to isolate the acyclic intermediate (176), R = Me or Ph, would confirm this hypothesis, particularly when the reaction is carried out for a short time in the cold in ethereal solution (27, 82). These intermediates (176) can be cyclized quantitatively on standing or on being treated by hydrochloric acid. However, no evidence has been advanced concerning their structures. 

By condensing the salts or the esters of either dithioformic (207) or dithiophenacetic acids with a-aminonitriles (206) 5-aminothiazoles (209), in which R] = hydrogen, benzyl and Rj = phenyl, carbethoxy, or car-bophenoxy, were obtained in fairly good yields (Scheme 108) (271). These reactions were carried out in aqueous ethereal solution at room temperature. Acyclic thioamides as intermediates in this reaction have been isolated in some cases (208). 

These show marked similarities to their acyclic counterparts, e.g. tetrahydrofuran closely resembles diethyl ether. The minor differences which arise between these two types of compounds are due to the less sterically hindered nature of the heteroatoms in the cyclic compounds. The basicities of tetrahydropyrrole (pHTa 10.4), tetrahydrofuran (-2.1) and... 

Bilirubin [635-65-4] M 584.7, e450nm t OO in CHCI3, pKE t 3 0. An acyclic tetrapyrrole bile pigment with impurities which can be eliminated by successive Soxhiet extraction with diethyl ether and MeOH. It crystallises from CHCI3 as deep red-brown rhombs, plates or prisms, and is dried to constant weight at 80 under vacuum, [Gray et al. J Chem Soc 2264, 2276 1961.]... 

Perfluoroallyl fluorosulfate is prepared by the treatment oiperfluoropropene with sulfur tnoxide m the presence of boron catalysts [2, 3, 4, 5, 6, 7] (equation 2) Perfluoroisopropyl allyl ether reacts similarly to give 58% polyfluoroallyl fluorosulfate in a cis/trans ratio of 6 4 [S] Sultones are the exclusive products without catalyst. Polyfluoroolefins such as 2-hydropentafluoropropylene [9], (2,3-dichloropropyl)tri-fluoroethylene [70], perfluoropropene [2, i], perfluoroisopropyl alkenyl ethers [S], and acyclic polyfluoroallyl ethers [77] undergo sulfur trioxidation to regioselectively produce the corresponding P-sultones in high yield... 

Recently, Charette et al. have also demonstrated this behavior in the stereoselective cyciopropanations of a number of enantiopure acyclic allylic ethers [47]. The high degree of acyclic stereocontrol in the Simmons-Smith cyclopropanation has been extended to synthesis several times, most notably in the synthesis of small biomolecules. Schollkopf et al. utilized this method in their syntheses of cyclopropane-containing amino acids [48 a, b]. The synthesis of a cyclopropane-containing nucleoside was also preformed using acyclic stereocontrol [48c]. 

The chiral BOX-copper(ll) complexes, (S)-21a and (l )-21b (X=OTf, SbFg), were found by Evans et al. to catalyze the enantioselective cycloaddition reactions of the a,/ -unsaturated acyl phosphonates 49 with ethyl vinyl ether 46a and the cyclic enol ethers 50 giving the cycloaddition products 51 and 52, respectively, in very high yields and ee as outlined in Scheme 4.33 [38b]. It is notable that the acyclic and cyclic enol ethers react highly stereoselectively and that the same enantiomer is formed using (S)-21a and (J )-21b as the catalyst. It is, furthermore, of practical importance that the cycloaddition reaction can proceed in the presence of only 0.2 mol% (J )-21a (X=SbF6) with minimal reduction in the yield of the cycloaddition product and no loss of enantioselectivity (93% ee). 

In a more recent work the same research group has applied cyclic and acyclic vinyl ethers in the oxazaborolidinone-catalyzed 1,3-dipolar cycloaddition reaction with nitrones [30]. The reaction between nitrone 5 and 2,3-dihydrofuran 6 with 20 mol% of the phenyl glycine-derived catalyst 3c, gave the product 7 in 56% yield as the sole diastereomer, however, with a low ee of 38% (Scheme 6.9). 

In an analogous study by Meske, the impact of various oxazaborolidinone catalysts for the 1,3-dipolar cycloaddition reactions between acyclic nitrones and vinyl ethers was studied [31]. Both the diastereo- and the enantioselectivities obtained in this work were low. The highest enantioselectivity was obtained by the application of 100 mol% of the tert-butyl-substituted oxazaborolidinone catalyst 3d [27, 32] in the 1,3-dipolar cycloaddition reaction between nitrone la and ethyl vinyl ether 8a giving endo-9a and exo-9a in 42% and 27% isolated yield, respectively, with up to 20% ee for endo-9a as the best result (Scheme 6.10). 

The above described reaction has been extended to the application of the AlMe-BINOL catalyst to reactions of acyclic nitrones. A series chiral AlMe-3,3 -diaryl-BINOL complexes llb-f was investigated as catalysts for the 1,3-dipolar cycloaddition reaction between the cyclic nitrone 14a and ethyl vinyl ether 8a [34], Surprisingly, these catalysts were not sufficiently selective for the reactions of cyclic nitrones with ethyl vinyl ether. Use of the tetramethoxy-substituted derivative llg as the catalyst for the reaction significantly improved the results (Scheme 6.14). In the presence of 10 mol% llg the reaction proceeded in a mixture of CH2CI2 and petroleum ether to give the product 15a in 79% isolated yield. The diastereoselectiv-ity was the same as in the acyclic case giving an excellent ratio of exo-15a and endo-15a of >95 <5, and exo-15a was obtained with up to 82% ee. 

The reactions of nitrones constitute the absolute majority of metal-catalyzed asymmetric 1,3-dipolar cycloaddition reactions. Boron, aluminum, titanium, copper and palladium catalysts have been tested for the inverse electron-demand 1,3-dipolar cycloaddition reaction of nitrones with electron-rich alkenes. Fair enantioselectivities of up to 79% ee were obtained with oxazaborolidinone catalysts. However, the AlMe-3,3 -Ar-BINOL complexes proved to be superior for reactions of both acyclic and cyclic nitrones and more than >99% ee was obtained in some reactions. The Cu(OTf)2-BOX catalyst was efficient for reactions of the glyoxylate-derived nitrones with vinyl ethers and enantioselectivities of up to 93% ee were obtained. 

The rearrangement with ring contraction probably is the most important synthetic application of the Favorskii reaction it is for example used in the synthesis of steroids. Yields can vary from good to moderate. As solvents diethyl ether or alcohols are often used. With acyclic a-halo ketones bearing voluminous substituents in a -position, yields can be low a tcrt-butyl substituent will prevent the rearrangement. 

Cyclic and acyclic silyl enol ethers can be nitrated with tetranitromethane to give ct-nitro ketones in 64-96% yield fEqs. 2.42 and 2.43. " The mechanism involves the electron transfer from the silyl enol ether to tetranitromethane. A fast homolydc conphng of the resultant cadon radical of silyl enol ether with NO leads tn ct-nitro ketones. Tetranitromethane is a neutral reagent it is commercially available or readdy prepared. " ... 

In this review, recent development of active transport of ions accross the liquid membranes using the synthetic ionophores such as crown ethers and other acyclic ligands, which selectively complex with cations based on the ion-dipole interaction, was surveyed,... 

For the most part, cyclic ethers behave like acyclic ethers. The chemistry of the ether functional group is the same, whether it s in an open chain or in a ring. Common cyclic ethers such as tetrahydrofuran and dioxane, for example, are often used as solvents because of their inertness, yet they can be cleaved by strong acids. 

Most heterocycles have the same chemistry as their open-chain counterparts. Lactones and acyclic esters behave similarly, lactams and acyclic amides behave similarly, and cyclic and acyclic ethers behave similarly. In certain cases, however, particularly when the ring is unsat lira ted, heterocycles have unique and interesting properties. 

The C2-symmetric epoxide 23 (Scheme 7) reacts smoothly with carbon nucleophiles. For example, treatment of 23 with lithium dimethylcuprate proceeds with inversion of configuration, resulting in the formation of alcohol 28. An important consequence of the C2 symmetry of 23 is that the attack of the organometallic reagent upon either one of the two epoxide carbons produces the same product. After simultaneous hydrogenolysis of the two benzyl ethers in 28, protection of the 1,2-diol as an acetonide ring can be easily achieved by the use of 2,2-dimethoxypropane and camphor-sulfonic acid (CSA). It is necessary to briefly expose the crude product from the latter reaction to methanol and CSA so that the mixed acyclic ketal can be cleaved (see 29—>30). Oxidation of alcohol 30 with pyridinium chlorochromate (PCC) provides alde-... 

Acyclic Oxime Ethers 1.4.1.5.1.1. Auxiliary-Induced Diastereoselection Stereogenic Center at Carbon... 

In the first example of an intramolecular Sakurai reaction, a six-membered ring was formed in the presence of boron trifluoride-diethyl ether complex starting from an acyclic enone36. 

Kuokkanen evaluated a series of constants. Kpeg for substituted diazonium ions with PEG 1000 and found a reaction constant (p = 1.12) comparable to those for complexation with the three crown ethers investigated by Nakazumi et al. (1983), p = 1.18-1.38). It is therefore likely that the host-guest interaction of diazonium ions with acyclic polyethers is basically similar to that with crown ethers. A dual substituent parameter analysis (DSP, see Sec. 8.3) for (Nakazumi et al., 1987)... 

Direct treatment of TIPS enol ethers of a variety of cyclic and acyclic ketones with the strong-base combination of n-BuLi/KO-t-Bu leads to /3-ketosilanes (2) after aqueous work-up. In contrast with the earlier method, this rearrangement appears to proceed through allylic, rather than vinylic, metallation, since enol ethers lacking an allylic a-proton are unreactive. 

The addition of sulphinyl chlorides to trimethylsilyl enol ether 138 affording a-ketosulphoxides 139 (equation 76) represents an extension of the reaction of sulphinyl chlorides with ketones. This reaction has attracted attention only recently. Sergeev and coworkers192 reported that treatment of sulphinyl chlorides with acyclic enol ethers afforded a-ketosulphoxides 139 in good to excellent yields. Meanwell and Johnson193 observed that in the case of cyclic enol ethers the corresponding sulphoxides were formed only in very low yields. They found, however, that the introduction of an equivalent amount of a Lewis acid into the reaction mixture markedly promotes the desired reaction, whereas the use of catalytic amounts of a Lewis acid led to a substantial reduction in the yield. This is most probably due to the formation of a complex, between the a-ketosulphoxide and the Lewis acid. 

---