Cis-trans ratio

The poly(vinyl alcohol) made for commercial acetalization processes is atactic and a mixture of cis- and /n j -l,3-dioxane stereoisomers is formed during acetalization. The precise cis/trans ratio depends strongly on process kinetics (16,17) and small quantities of other system components (23). During formylation of poly(vinyl alcohol), for example, i j -acetalization is more rapid than /ra/ j -acetalization (24). In addition, the rate of hydrolysis of the trans-2iQ. -A is faster than for the <7 -acetal (25). Because hydrolysis competes with acetalization during acetal synthesis, a high cis/trans ratio is favored. The stereochemistry of PVF and PVB resins has been studied by proton and carbon nmr spectroscopy (26—29). 

Perfluoroallyl fluorosulfate is prepared by the treatment oiperfluoropropene with sulfur tnoxide m the presence of boron catalysts [2, 3, 4, 5, 6, 7] (equation 2) Perfluoroisopropyl allyl ether reacts similarly to give 58% polyfluoroallyl fluorosulfate in a cis/trans ratio of 6 4 [S] Sultones are the exclusive products without catalyst. Polyfluoroolefins such as 2-hydropentafluoropropylene [9], (2,3-dichloropropyl)tri-fluoroethylene [70], perfluoropropene [2, i], perfluoroisopropyl alkenyl ethers [S], and acyclic polyfluoroallyl ethers [77] undergo sulfur trioxidation to regioselectively produce the corresponding P-sultones in high yield... 

R r R Solvent Reaction nme (hj Olefin Yield (%) cis. tran. Ratio... 

A quite different type of titanium catalyst has been used in an inverse electron-demand 1,3-dipolar cycloaddition. Bosnich et al. applied the chiral titanocene-(OTf)2 complex 32 for the 1,3-dipolar cycloaddition between the cyclic nitrone 14a and the ketene acetal 2c (Scheme 6.25). The reaction only proceeded in the presence of the catalyst and a good cis/trans ratio of 8 92 was obtained using catalyst 32, however, only 14% ee was observed for the major isomer [70]. 

An excellent method for the diastereoselective synthesis of substituted amino acids is based on optically active bislactim ethers of cyclodipeptides as Michael donors (Schollkopf method, see Section 1.5.2.4.2.2.4.). Thus, the lithium enolates of bislactim ethers, from amino acids add in a 1,4-fashion to various a,/i-unsaturated esters with high diastereofacial selectivity (syn/anti ratios > 99.3 0.7-99.5 0.5). For example, the enolate of the lactim ether derivative 6, prepared from (S)-valine and glycine, adds in a highly stereoselective manner to methyl ( )-3-phenyl-propenoate a cis/trans ratio of 99.6 0.4 and a syn/anti ratio of 91 9, with respect to the two new stereogenic centers, in the product 7 are found105, los. 

Many authors have observed that the cis-trans ratio of the products of the metathesis reaction is equal to the thermodynamic equilibrium value. This suggests that the reaction is not highly stereoselective. However, under certain conditions the product distribution is influenced by kinetic factors. For instance, it proves to be possible to prepare from cyclopentene... 

The mechanism of B polymerization is summarized in Scheme 4,9. 1,2-, and cis- and trews-1,4-butadiene units may be discriminated by IR, Raman, or H or nC MMR speclroseopy.1 92 94 PB comprises predominantly 1,4-rra//.v-units. A typical composition formed by radical polymerization is 57.3 23.7 19.0 for trans-1,4- c7a -1,4- 1,2-. While the ratio of 1,2- to 1,4-units shows only a small temperature dependence, the effect on the cis-trans ratio appears substantial. Sato et al9J have determined dyad sequences by solution, 3C NMR and found that the distribution of isomeric structures and tacticity is adequately described by Bernoullian statistics. Kawahara et al.94 determined the microslructure (ratio // measurements directly on PB latexes and obtained similar data to that obtained by solution I3C NMR. They94 also characterized crosslinked PB. 

The cis/trans ratio of the products varies significantly with the polarity of the reaction medium the higher the polarity of the solvent, the lower is the yield of the cis-product. 

H-NMR spectroscopy can be used to determine alkenesulfonates in mixtures [115]. Under normal conditions, 1-alkenesulfonate shows a signal separated from the other positional isomers [122]. Moreover, the utilization of a lanthanide shift reagent makes possible even the separation of the signals of isomeric alkenesulfonic acids and hydroxyalkanesulfonic acids as their methyl esters [124]. 13C-NMR spectroscopy, which is not as quantitative, simply gives the cis/trans ratio of the main positional isomer. 

However, eclipsing effects are not the only factors that affect the cis/trans ratio in anti E2 eliminations. Other factors are the nature of the leaving group, the base, the solvent, and the substrate. Not all these effects are completely understood. ... 

If the Criegee mechanism operated as shown above, the cis/trans ratio for each of the two cross ozonides would have to be identical for the cis and trans alkenes, since in this mechanism they are completely cleaved. 

While the chemical addition of HCN to 4-(2-propenyl)cyclohexanone affords a cis/trans ratio of 13 82, the MeHNL-catalyzed addition gives almost exclusively the c 5-isomer (>96%). The chemoenzymatic syntheses of rengyol and isorengyol are other examples for applications of HNL-catalyzed additions of HCN to cyclohexanones. ... 

The use of stoichiometric ruthenium-NHC complexes generated in situ from [Ruljd-COCKp-cymene)], an imidazohnm salt [4] or an imidizol(idin)ium-2-carboxylate [4] has been applied in the cyclopropanation of styrene 5 with ethyl diazoacetate (EDA) 6 (Scheme 5.2). No base was necessary when imidazolium-2 carboxylate were employed. The diastereoselectivity was low and the cis/trans ratio was around 50/50 (Table 5.1). Although the diastereoselectivity was moderate, the reaction was highly chemoselectivity as possible side reactions (homologation, dimerisation and metathesis) were totally or partially suppressed. 

The use of excess diazoalkane in its reaction with sulfur dioxide will necessarily lead to symmetrically substituted thiirane dioxides. When monoalkyl or monoaryl diazoalkanes are used, mixtures of cis- and trans-isomers are formed The cis/trans ratio of the products varies significantly with the polarity of the reaction medium the higher the polarity of the solvent, the lower is the yield of the cis-product. 

Entry 21 involves addition to a glyoxylic hydrazone and the cis ring junction is dictated by strain effects. The primary phenylselenyl group is reductively removed under the reaction conditions. Entry 22 involves generation of a stannyloxy radical by addition of the stannyl radical at the carbonyl oxygen. Cyclization then ensues, with the cis-trans ratio being determined by the conformation of the cyclization TS. 

The hydrogenation of para-substituted anilines over rhodium catalysts has been investigated. An antipathetic metal crystallite size effect was observed for the hydrogenation of /Moluidinc suggesting that terrace sites favour the reaction. Limited evidence was found for catalyst deactivation by the product amines. Catalysts with pore diameters less than 13.2 nm showed evidence of diffusion control on the rate of reaction but not the cis trans ratio of the product. 

The hydrogenation of toluene, aniline, /r-toluidine, and 4-tert-butylaniline was examined over catalyst M1273. The reaction profile for the reactions is shown in Figure 2. From this it can be seen that the order of reactivity is aniline > toluene > /Moluidinc > 4-fer f-butylaniline. The hydrogenation products were methylcyclohexane from toluene, cyclohexylamine from aniline, 4-methyl-cyclohexylamine (4-MCYA) from /Holuidine. and 4-feri-butylcyclohexylamine (4-tBuCYA) from 4-tert-butylaniline. At 50 % conversion the cis trans ratio of 4-MCYA was 2, while tBuCYA it was 1.6. 

In Figure 5 the variation of the 4-tBuCYA cis trans ratio is plotted against the conversion for each of the catalysts. 

Figure 5 Variation in 4-tBuCYA cis trans ratio with conversion and catalyst.

Changing catalyst support from carbon to calcium carbonate leads to dramatic improvement of the cis/tran ratio from 6 1 to 18 1, that is the cis selectivity increases from 85.7% to 94.7%. The reason for better selectivity on CaC03 supported catalyst is attributed to its lower surface area leading to lower hydrogenation activity, but more selective to the desired product. The successful commercialization of the new route for sertraline synthesis demonstrates that for a stereoselective hydrogenation reaction, improve product selectivity can be achieved by proper selection of catalyst support. 

Diastereoselectivity of the reactions of the cation 26 and the anion 29 derived from 25 (R2 = Me) was modeled by self-consistent reaction field solvation models obtained from ab initio SCF-MO calculations. The experimentally found cis/trans ratios confirmed the model (Scheme 1) <2002JOC2013>. 

Thorough investigations with dimethyl diazomalonate and catalysts of the type (RO)3P CuX have revealed that the efficiency of competing reaction paths, the synjanti or EjZ selectivity in cyclopropane formation as well as the cis/trans ratio of carbene dimers depend not only on catalyst concentration and temperature but also on the nature of R58) and of the halide anion X 57 6". Furthermore, the cyclopropane yield can be augmented in many cases at the expense of carbene dimer... 

---