Ether, absolute preparation

In view of the high cost of methyl iodide in the above preparation of anisole, and the fact that, unless absolute methanol is used, the ready hydrolysis of the methyl iodide may cause a low yield of the ether, the preparation of anisole may be ad antageously replaced by that of phenetole. I he reaction is not of course a methylation, but is nevertheless of the same type as that used in the preparation of anisole. 

The preparation of aniline nitrate is fully described on p. 375 under the preparation of diazobenzene nitrate. The crude product therein obtained is recrystallised by dissolving in a little absolute alcohol and precipitating therefrom with ether. The preparation and purification of aniline hydrochloride are exactly similar. 

Isoeugenol methyl ether was prepared from eugenol methyl ether by mixing eugenol methyl ether (150 parts) with potassium hydroxide (1.5 parts) and absolute ethyl alcohol (3.2 parts) at 160 to 165°C with stirring. The temperature of the mixture rose rapidly to 190 to 195° C and after 30 minutes the heat was turned off, by which time the temperature had fallen to 170°C. When the mixture reached room temperature, water was added. The oily layer was separated off, dried and vacuum distilled. The distillate (130 parts) was substantially all cis and tran.s isoeugenol methyl other. Source Bush 1968... 

A solution of CHjMgCl in absolute ether is prepared in a manner analogous to that of CHjMgBr. (See preparation of tetramethyltin. 

Absolute diethyl ether. The chief impurities in commercial ether (sp. gr. 0- 720) are water, ethyl alcohol, and, in samples which have been exposed to the air and light for some time, ethyl peroxide. The presence of peroxides may be detected either by the liberation of iodine (brown colouration or blue colouration with starch solution) when a small sample is shaken with an equal volume of 2 per cent, potassium iodide solution and a few drops of dilute hydrochloric acid, or by carrying out the perchromio acid test of inorganic analysis with potassium dichromate solution acidified with dilute sulphuric acid. The peroxides may be removed by shaking with a concentrated solution of a ferrous salt, say, 6-10 g. of ferrous salt (s 10-20 ml. of the prepared concentrated solution) to 1 litre of ether. The concentrated solution of ferrous salt is prepared either from 60 g. of crystallised ferrous sulphate, 6 ml. of concentrated sulphuric acid and 110 ml. of water or from 100 g. of crystallised ferrous chloride, 42 ml. of concentrated hydiochloric acid and 85 ml. of water. Peroxides may also be removed by shaking with an aqueous solution of sodium sulphite (for the removal with stannous chloride, see Section VI,12). 

The silver nitrite may be prepared as described in Section 11,50, 17. The product supplied by Johnson, Matthey and Co. Ltd., of Hatton Garden, London, E.C. 1, is satisfactory it. should be washed with absolute methyl or ethyl alcohol, followed by sodium-dried ether, and dried in an electrically-heated oven at 100 for 30 minutes (longer heating results in darkening on the surface) the substance should be kept in a vacuum desiccator until required. 

To prepare the solid phenyldlazonlum chloride or sulphate, the reaction is conducted in the absence of water as far as possible. Thus the source of nitrous acid is one of its organic esters (e.g., amyl nitrite) and a solution of hydrogen chloride gas in absolute alcohol upon the addition of ether only the diazonium salt is precipitated as a crystalline solid, for example ... 

Hate 1. This excess was used to be absolutely sure that all a-chloroether would have reacted. Traces of this compound, if still present in the reaction mixture, will hydrolyse during the aqueous work up. The acid that is liberated can cause hydrolysis of the product to H2C=CH-C(=0)CH(CH3)0C2H5. HoLp. A. Prepared by introducing 0.30 mol of dry gaseous HCl (weight increase) into 45 ml of freshly distilled ethyl vinyl ether (excess) at -30°C. 

Hydrolysis of the ester is achieved by refluxing in aqueous N or 2N NaOH solution until the insoluble ester dissolves. The solution is then cooled, and the alcohol is extracted into a suitable solvent, e.g. ether, toluene or alcohol-free chloroform. The extract is dried (CaS04, MgS04) and distilled, then fractionally distilled if liquid or recrystallised if solid. (The p-nitrobenzoic acid can be recovered by acidification of the aqueous layer.) In most cases where the alcohol to be purified can be readily extracted fi-om ethanol, the hydrolysis of the ester is best achieved with N or 2N ethanolic NaOH or 85% aqueous ethanolic N NaOH. The former is prepared by dissolving the necessary alkali in a minimum volume of water and diluting with absolute alcohol. The ethanolic solution is refluxed for one to two hours and hydrolysis is complete when an aliquot gives a clear solution on dilution with four or five times its volume of water. The bulk of the ethanol is distilled off and the residue is... 

Other purification procedures include the formation of the picrate, prepared in benzene soln and crystd to constant melting point, then decomposed with warm 10% NaOH and extracted into ether the extract was washed with water, and distd under reduced pressure. The oxalate has also been used. The base has been fractionally crystd by partial freezing and also from aq 80% EtOH then from absolute EtOH. It has been distd from zinc dust, under nitrogen. 

If an alcohol-free solution of diazomcthane is required, absolute ether should be used throughout this preparation. 

For the identification of limonene, one of the most useful compounds is the crystalline tetrabromide, Cj(,HjgBr. This body is best prepared as follows the fraction of the oil containing much limonene is mixed with four times its volume of glacial acetic acid, and the mixture cooled in ice. Bromine is then added, drop by drop, so long as it becomes decolorised at once. The mixture is then allowed to stand until crystals separate. These are filtered off, pressed between porous paper, and recrystallised from acetic ether. Limonene tetrabromide melts at 104 5° and is optically active, its specific rotation being + 73 3°. The inactive, or dipeutene, tetrabromide melts at 124° to 125°. In the preparation of the tetrabromide traces of moisture are advisable, as the use of absolutely anhydrous material renders the compound very diflftcult to crystallise. 

Bornyl Acetate.—The acetic acid ester is the most important of the series. It is a constituent of pine-needle and rosemary oils, and has a most fragrant and refreshing odour. It is prepared artificially by the action of acetic anhydride on borneol, in the presence of sodium acetate, or by the condensation of borneol with glacial acetic acid in the presence of a small amount of a mineral acid. It is absolutely necessary in the reproduction of any pine odour. It is a crystalline body, crystallising from peDroleum ether in rhombic hemihedric crystals melting at 29°. The optical activity depends on that of the borneol from which it has been prepared. It has the following characters —... 

The hydrochloride is prepared in the usual manner by dissolving the amine in anhydrous ether and adding to it the requisite amount of dry gaseous hydrochloric acid,dissolved in absolute alcohol. There is obtained a white crystalline powder melting at 150°C, very soluble in water and alcohol,very slightly soluble in ether and ethyl acetate. 

A mixture consisting of 2 grams of 2-hydroxy-3-(N,N-diethylcarboxamido)-9,10-dimethoxy-1,2,3,4,6,7-hexahydro-1 Ib-H-benzopyridocoline (OH-axial) hydrochloride (prepared by treating the base with hydrogen chloride gas in absolute ether) dissolved in 7 ml of acetic anhydride containing 3 ml of pyridine was heated at 100°C for 2 hours under a nitrogen atmosphere. At the end of this period, a crystalline precipitate had formed and the resultant mixture was subsequently diluted with an equal volume of diethyl ether and filtered. 

A Grignard solution is prepared by introducing methyl chloride into a boiling suspension of 36 g of magnesium in 1,000 cc of absolute ether until all the magnesium has reacted. 

The free base was then dissoived in absolute methanol, and the resulting solution was then adjusted to an acid pH value with an ethereal hydrochloric acid solution. The acidified solution was purified with charcoal and then dry ether was added thereto until crystallization took place. The hydrochloride, prepared in this customary manner, had a melting point of 305°C according to U.S. Patent 3,202,660. 

The free base is liberated from the acid solution with 20% sodium hydroxide solution and taken up in ether. The ether layer is washed with water, saturated with NaCI and then shaken with solid potassium hydroxide. The ether is removed by distillation, 200 parts of benzene added and distilled off. The residue is distilled in vacuo and the fraction 150°-165°C/2 mm is collected and amounts to 433 parts. The hydrochloride salt is prepared by dissolving the free base in anhydrous ether and slowly adding an alcoholic solution of hydrogen chloride. The solid is recrystallized from absolute alcohol-ether mixture or isopro-panol-ether mixture and has a MP of 161°-162°C. 

C) Preparation of Doxapram Hydrochloride [3,3-Diphenyl-1-Ethyl-4-(2-Morpholino-Ethylj-2-Pyrrolidinone Hydrochloride Monohydrate] A solution of 25 grams (0.076 mol) of 4-(2-chloroethyl)-3,3-diphenyl-1-ethyl-2-pyrrolidinone and 13.3 grams (0.153 mol) of morpholine in 500 ml of absolute ethanol was heated at 95°-120°C for 21 hours in a closed system and concentrated in vacuo. The residue was dissolved in 3(X) ml of two normal hydrochloric acid and extracted with 150 ml of ethyl acetate. A solid crystallized (13 g) during the extraction and was removed by filtration. MP 217°-219°C. The acid extracts were made basic with sodium hydroxide and extracted with ether, and the ether solution was concentrated in vacuo and the residue was suspended in six normal hydrochloric acid. Additional crystalline product formed and was recrystallized from two normal hydrochloric acid. Yield, 10 grams MP 217°-219°C. Total yield, 23 grams (70%). 

---