Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Dodecylsulfate

In this section the influence of micelles of cetyltrimethylammonium bromide (CTAB), sodium dodecylsulfate (SDS) and dodecyl heptaoxyethylene ether (C12E7) on the Diels-Alder reaction of 5.1a-g with 5.2 in the absence of Lewis-add catalysts is described (see Scheme 5.1). Note that the dienophiles can be divided into nonionic (5.1a-e), anionic (5.If) and cationic (5.1g) species. A comparison of the effect of nonionic (C12E7), anionic (SDS) and cationic (CTAB) micelles on the rates of their reaction with 5.2 will assess of the importance of electrostatic interactions in micellar catalysis or inhibition. [Pg.133]

It turned out that the dodecylsulfate surfactants Co(DS)i Ni(DS)2, Cu(DS)2 and Zn(DS)2 containing catalytically active counterions are extremely potent catalysts for the Diels-Alder reaction between 5.1 and 5.2 (see Scheme 5.1). The physical properties of these micelles have been described in the literature and a small number of catalytic studies have been reported. The influence of Cu(DS)2 micelles on the kinetics of quenching of a photoexcited species has been investigated. Interestingly, Kobayashi recently employed surfactants in scandium triflate catalysed aldol reactions". Robinson et al. have demonshuted that the interaction between metal ions and ligand at the surface of dodecylsulfate micelles can be extremely efficient. ... [Pg.139]

Procedure. A vitamin B complex tablet Is crushed and placed In a beaker with 20.00 mL of a 50% v/v methanol solution that Is 20 mM In sodium tetraborate and contains 100.0 ppm of o-ethoxybenzamIde. After mixing for 2 min to ensure that the B vitamins are dissolved, a 5.00-mL portion Is passed through a 0.45- xm filter to remove Insoluble binders. An approximately 4-nL sample Is loaded Into a 50- xm Internal diameter capillary column. For CZE the capillary column contains a 20 mM pH 9 sodium tetraborate/sodlum dIhydrogen phosphate buffer. For MEKC the buffer Is also 150 mM In sodium dodecylsulfate. A 40-kV/m electric field Is used to effect both the CZE and MEKC separations. [Pg.607]

The order of elution when using MEKC is vitamin B3 (5.58 min), vitamin Be (6.59 min), vitamin 82 (8.81 min), and vitamin Bi (11.21 min). What conclusions can you make about the solubility of the B vitamins in the sodium dodecylsulfate micelles ... [Pg.608]

Fig. 1. Photograph illustrating the microstmcture of the foam which stiU persists two hours after shaking an aqueous solution containing 5% sodium dodecylsulfate. The bubble shapes ate more polyhedral near the top, where the foam is dry, and more spherical near the bottom, where the foam is wet. Fig. 1. Photograph illustrating the microstmcture of the foam which stiU persists two hours after shaking an aqueous solution containing 5% sodium dodecylsulfate. The bubble shapes ate more polyhedral near the top, where the foam is dry, and more spherical near the bottom, where the foam is wet.
Size Isomers. In solution, hGH is a mixture of monomer, dimer, and higher molecular weight oligomers. Furthermore, there are aggregated forms of hGH found in both the pituitary and in the circulation (16,17). The dimeric forms of hGH have been the most carefully studied and there appear to be at least three distinct types of dimer a disulfide dimer connected through interchain disulfide bonds (8) a covalent or irreversible dimer that is detected on sodium dodecylsulfate- (SDS-)polyacrylamide gels (see Electroseparations, Electrophoresis) and is not a disulfide dimer (19,20) and a noncovalent dimer which is easily dissociated into monomeric hGH by treatment with agents that dismpt hydrophobic interactions in proteins (21). In addition, hGH forms a dimeric complex with ( 2). Scatchard analysis has revealed that two ions associate per hGH dimer in a cooperative... [Pg.196]

The model was tested by the micellar liquid chromatography separ ation of the five rarbornicin derivatives and four ethers of hydroxybenzoic acid. Micellar mobile phases were made with the sodium dodecylsulfate and 1-pentanol or isopentanol as modifier. In all cases the negative signs of the coefficients x and y indicate that at transition of the sorbat from the mobile on the stationar y phase the number of surfactant monomers as well as the number of modifier molecules increases in its microenvironment. [Pg.81]

The effect of concentration of cationic (cetylpyridinium chloride, CPC), anionic (sodium dodecylsulfate, SDS) and nonionic (Twin-80) surfactants as well as effect of pH value on the characteristics of TLC separ ation has been investigated. The best separ ation of three components has been achieved with 210 M CPC and LIO M Twin-80 solutions, at pH 7 (phosphate buffer). Individual solution of SDS didn t provide effective separation of caffeine, theophylline, theobromine, the rate of separ ation was low. The separ ation factor and rate of separ ation was increase by adding of modifiers - alcohol 1- propanol (6 % vol.) or 1-butanol (0.1 % vol.) in SDS solution. The optimal concentration of SDS is 210 M. [Pg.350]

Distribution of benzodiazepines in system micellar pseudophase - water was investigated in micellar solutions of sodium dodecylsulfate. The protonization constants of benzodiazepines were determined by the UV-spectophotometry. Values of protonization constants increase with increasing of sodium dodecylsulfate concentration. The binding constants of two protolytic forms of benzodiazepines with a micellar pseudo-phase and P, values were evaluated from obtained dependence. [Pg.392]

The optimal conditions for the complexation were found. The luminescence of Tb " in (L ) complex was established to observed in a range of pH 2,0-11,0 with maximum at 7,0-7,5. The Tb (III) luminescence in complex with (L ) aslo depends on amount of reagents, solvent nature, amount of surfactants and trioctylphosphinoxide (TOPO). It was shown that introduction into the system Tb-L the 3-fold excess sodium dodecylsulfate (SDS) increases the luminescence intensity by 40 times and introduction into the system Tb-L the 3-fold excess TOPO increases the luminescence intensity by 25 times by the order value connecting with the crowding out of water molecules from the inner sphere of complexes. [Pg.394]

Ammonium dodecylsulfate [2235-54-3] M 283.4. Recrystd first from 90% EtOH and then twice from abs EtOH, finally dried in a vacuum. [Pg.393]

Lithium dodecylsulfate [2044-56-6] M 272.3. Recrystd twice from absolute EtOH and dried under vacuum. [Pg.436]

Magnesium dodecylsulfate [3097-08-3] M 555.1. Recrystd three times from EtOH and dried in a vacuum. [Pg.437]

Sodiiun dodecylsulfate, cetyltrimethylam-monium chloride, sodium cholate, -cyclodextrin dansylated amino acids and polycyclic aromatic hydrocarbons > 45-fold 1% in water the greatest enhancement of fluorescence is that of sodium cholate on pyrene [263]... [Pg.108]

For the determination of a wide range of neutral, acidic and basic pollutants, two precolumns can be coupled in series (75). A PFRP-S precolum is used to trap the neutral and non-ionized acidic pollutants and a precolumn packed with the same sorbent and loaded with a sodium dodecylsulfate (SDS) (to form the ion-pair) is used to trap the positively charged (basic) pollutants. Each precolumn is coupled to one analytical column. [Pg.358]

Micellar catalysis of azo coupling reactions was first studied by Poindexter and McKay (1972). They investigated the reaction of a 4-nitrobenzenediazonium salt with 2-naphthol-6-sulfonic and 2-naphthol-3,6-disulfonic acid in the presence of sodium dodecylsulfate or hexadecyltrimethylammonium bromide. With both the anionic and cationic additives an inhibition (up to 15-fold) was observed. This result was to be expected on the basis of the principles of micellar catalysis, since the charges of the two reacting species are opposite. This is due to the fact that either of the reagents will, for electrostatic reasons, be excluded from the micelle. [Pg.376]

Data of Siitterlin (22.). Figure 4 shows that EPM is also able to predict the classical Smith-Ewart (2) dependence of the particle number on initiator concentration at high levels of added surfactant (sodium dodecylsulfate =... [Pg.374]

Data of Badder and Brooks (24). Figure 7 shows the comparisons of EPM with the experimental data obtained by Badder and Brooks (2A) in a CSTR (run C-24). The reactor feed contained 22.8% styrene, 0.64% emulsifier (sodium dodecylsulfate), and 0.39% initiator (ammonium persulfate). The residence time was 114 min. The initial reactor charge was water and emulsifier. In this case the size of the primary precursors was varied slightly from its baseline value of 1 nm to 0.8 nm. Although the experimental data show some scatter, EPM reproduces very well both the transient and steady state... [Pg.375]

Bruce, D.W. and Hudson, S.A. (1994) Mesomorphic complexes of silver trifluoromethane sulfonate and silver dodecylsulfate with 2- and 3-fluoro-4-alkoxy-4-stilbazoles. Journal of Materials Chemistry, 4, 479-486. [Pg.393]

Kuczynski and Thomas who used a sol stabilized with sodium dodecylsulfate, observed that illumination at high intensity levels and high concentrations... [Pg.144]

The last, and less extensively studied field variable driving percolation effects is chemical potential. Salinity was examined in the seminal NMR self-diffusion paper of Clarkson et al. [12] as a component in brine, toluene, and SDS (sodium dodecylsulfate) microemulsions. Decreasing levels of salinity were found to be sufficient to drive the microemulsion microstructure from water-in-oil to irregular bicontinuous to oil-in-water. This paper was... [Pg.251]


See other pages where Dodecylsulfate is mentioned: [Pg.488]    [Pg.128]    [Pg.154]    [Pg.156]    [Pg.178]    [Pg.262]    [Pg.606]    [Pg.606]    [Pg.904]    [Pg.427]    [Pg.198]    [Pg.296]    [Pg.380]    [Pg.384]    [Pg.470]    [Pg.503]    [Pg.560]    [Pg.562]    [Pg.154]    [Pg.213]    [Pg.484]    [Pg.343]    [Pg.374]    [Pg.486]    [Pg.729]    [Pg.159]   
See also in sourсe #XX -- [ Pg.226 ]

See also in sourсe #XX -- [ Pg.179 ]

See also in sourсe #XX -- [ Pg.231 ]

See also in sourсe #XX -- [ Pg.152 ]

See also in sourсe #XX -- [ Pg.71 ]

See also in sourсe #XX -- [ Pg.53 ]




SEARCH



Alkali dodecylsulfates

Dodecylsulfate salts

Dodecylsulfate surfactants, alkali

Fluorescence with sodium dodecylsulfate

Potassium dodecylsulfate

SDS, sodium dodecylsulfate

Sodium dodecylsulfate

Sodium dodecylsulfate acid esters

Sodium dodecylsulfate electrophoresis

Sodium dodecylsulfate in water

Sodium dodecylsulfate polyacrylamide

Sodium dodecylsulfate polyacrylamide electrophoresis

Sodium dodecylsulfate, micelle

Sodium dodecylsulfate, micelle water

Surfactant sodium dodecylsulfate

© 2024 chempedia.info