Diethyl esters

Oxamide differs from most aliphatic acid amides in being almost insoluble in water, and therefore can be readily prepared from the diethyl ester by Method 2(a). Place a mixture of 5 ml. of concentrated [d o-88o) ammonia solution and 5 ml. of water in a 25 ml. conical flask, for which a welTfitting cork is available. (The large excess of... 

The diethyl ester which is precipitated rapidly solidifies on stirring. Filter it at the pump, wash with water (2 portions each of about 20 ml.), and recrystallise from methylated spirit or from 95% ethanol. Yield of pale yellow crystals, 8-9 g. m.p. 135-I37 ... 

This reaction consists of the condensation of two molecular equivalents of a 1,3 diketone (or a J3-keto-ester) with one equivalent of an aldehyde and one of ammonia. Thus the interaction of ethyl acetoacetate and acetaldehyde and ammonia affords the 1,4-dihy dro-pyridine derivative (1), which when boiled with dilute nitric acid readily undergoes dehydrogenation and aromatisation" to gb e the diethyl ester of collidine (or 2,4,6-trimethyl-pyridine-3,5 dicarboxylic acid (II)). For the initial condensation the solid aldehyde-ammonia can conveniently be used in place of the separate reagents. 

Gently warm a mixture of 32 g. (32 ml.) of ethyl acetoacetate and 10 g. of aldehyde-ammonia in a 400 ml. beaker by direct heating on a gauze, stirring the mixture carefully with a thermometer. As soon as the reaction starts, remove the heating, and replace it when the reaction slackens, but do not allow the temperature of the mixture to exceed 100-no the reaction is rapidly completed. Add to the mixture about twice its volume of 2A -hydrochloric acid, and stir the mass until the deposit either becomes solid or forms a thick paste, according to the quality of the aldehyde-ammonia employed. Decant the aqueous acid layer, repeat the extraction of the deposit with more acid, and again decant the acid, or filter off the deposit if it is solid. Transfer the deposit to a conical flask and recrystallise it twice from ethanol (or methylated spirit) diluted with an equal volume of water. The i,4-dihydro-collidine-3,5-dicarboxylic diethyl ester (I) is obtained as colourless crystals, m.p. 130-131°. Yield 12 5 g,... 

Fig. 41(A) and (b), p. 65) into which the ethereal extract is allowed to run from a dropping-funnel at approximately the rate at which the solvent is distilling. When the ether has been removed, fit a capillary tube and thermometer, and continue the distillation at water-pump pressure. The diethyl ester of collidine-3,5-dicarboxylic acid (II) distils as a pale golden oil, b.p. i76 178°/i4 mm. Yield, 5 g. from 6 g. of the ester (I). 

Alkyl sulphates. The dimethyl and diethyl esters may be prepared infer alia by the interaction of chlorosulphonic acid with the anhydrous alcohol, followed by distillation of the resulting alkyl sulphuric acid under diminished pressure, for example ... 

Physical Properties. Industrially, the most important esters are dimethyl malonate [108-59-8] and diethyl malonate [105-53-3] whose physical properties are summarized in Table 2. Both are sparingly soluble in water (1 g/50 mL for the diethyl ester) and miscible in all proportions with ether and alcohol. 

Hydrochloric acid [7647-01-0], which is formed as by-product from unreacted chloroacetic acid, is fed into an absorption column. After the addition of acid and alcohol is complete, the mixture is heated at reflux for 6—8 h, whereby the intermediate malonic acid ester monoamide is hydroly2ed to a dialkyl malonate. The pure ester is obtained from the mixture of cmde esters by extraction with ben2ene [71-43-2], toluene [108-88-3], or xylene [1330-20-7]. The organic phase is washed with dilute sodium hydroxide [1310-73-2] to remove small amounts of the monoester. The diester is then separated from solvent by distillation at atmospheric pressure, and the malonic ester obtained by redistillation under vacuum as a colorless Hquid with a minimum assay of 99%. The aqueous phase contains considerable amounts of mineral acid and salts and must be treated before being fed to the waste treatment plant. The process is suitable for both the dimethyl and diethyl esters. The yield based on sodium chloroacetate is 75—85%. Various low molecular mass hydrocarbons, some of them partially chlorinated, are formed as by-products. Although a relatively simple plant is sufficient for the reaction itself, a si2eable investment is required for treatment of the wastewater and exhaust gas. 

Dipynylmethanes. The most important dipyrrylmethanes are the 2,2 derivatives. The parent compound is not very stable, but electron-withdrawing substituents increase its stabiUty considerably. Symmetrical dipyrrylmethanes, eg, the diethyl ester of... 

Sahcyhc acid, upon reaction with amyl alcohol and sodium, reduces to a ring-opened ahphatic dicarboxyhc acid, ie, pimelic acid (eq. 5). The reaction proceeds through the intermediate cyclohexanone-2-carboxyhc acid. This novel reaction involves the fission of the aromatic ring to i j -hexahydrosahcyhc acid when sahcyhc acid is heated to 310°C in an autoclave with strong alkah. Pimelic acid is formed in 35—38% yield and is isolated as the diethyl ester. 

Selected properties of dimethyl and diethyl esters of sulfuhc acid are Hsted in Table 2. 

The first in this series to be reported was 4-oxoisoxazoline-3,5-dicarboxylic acid diethyl ester, which was formed by the reaction of nitrous acid on diethyl acetonedicarboxylate in 1891. Quilico described a number of syntheses in his 1962 review and the most general include the reaction of hydroxylamine and a-hydroxy-(or acetoxy)- 3-diketones and the conversion of 4-isoxazolediazonium salts to the hydroxy moiety (62HC(17)1, p. 3). Additional syntheses reported were the oxygenation of a 4-boric acid derivative (67JOM(9)l9) and peroxide oxidation of a 4-nitro-2-isoxazoline (Scheme 151) (79ZOR2436). 

Diaziridine, 3-methyl-electron diffraction, 7, 199 (74CC397) Diaziridine-3,3-dicarboxylic acid, diethyl ester ESR, 7, 202 (76TU205)... 

Triazole-4,5-dicarboxylic acid, 2-(tributylstannyl)-, diethyl ester... 

H-Azepine, 2,6,7-tri(methoxycarbonyl)-ring inversion, 7, 499 Azepine-1-carboxylic acid tricarbonylruthenium complexes, 7, 523 1 H-Azepine-2,3-dicarboxylic acid, 4,7-dihydro-6-phenyl-diethyl ester synthesis, 7, 539-540 1 H-Azepine-3,6-dicarboxylic acid... 

Aziridine, 2,3-diphenyl-l-(2,4,6-trinitrophenyl)-irradiation, 7, 61 Aziridine, 1,2-divinyl-rearrangement, 7, 539 Aziridine, 2,3-divinyl-rearrangement, 7, 42, 65, 539 Aziridine, N-ethyl-inversion, 7, 6 Aziridine, 2-halo-reactions, 7, 74 Aziridine, A/-halo-invertomers, 7, 6 Aziridine, 2-methyl- N NMR, 7, 11 Aziridine, methylene-ring-ring valence isomerizations, 7, 22 synthesis, 7, 92 Aziridine, iV-nitroso-reactions, 7, 74 Aziridine, iV-phosphino-inversion, 7, 7 Aziridine, 1-phthalimido-UV irradiation, 7, 62-63 Aziridine, l-(3-thienyl)-2-vinyl-rearrangement, 4, 746 Aziridine, 7V-trimethylsilyl-inversion, 7, 7 Aziridine, 1,2,3-triphenyl-irradiation, 7, 61 Aziridine, vinyl-isomerization, S, 287 Aziridinecarboxylic acid ring expansion, 7, 262 Aziridine-2,2-dicarboxylic acid, 1-methoxy-diethyl ester... 

Benzo[b]furan-2-carboxylic acid, 6,6 -[(2-hydroxy-l,3-propanediyl)bis(oxy)]bis(3-hydroxy-diethyl ester trisodium salt trihydrate applications, 4, 709... 

Isocoumarin-3,4-dicarboxylic acid diethyl ester hydrolysis, 3, 691 Isocoumarins... 

Isoxazole-3,5-dicarboxyIic acid, 4-hydroxy-diethyl ester synthesis, 6, 85, 87 synthesis, 6, 66... 

Isoxazoline-3,5-dicarboxylic acid, 4-oxo-diethyl ester synthesis, 6, 106 Isoxazoline-4,5-dione, 3-methyl-4-oxime... 

Pyran-2,6-dicarboxylic acid, 4-oxo-, 3, 692, 703, 710 diethyl ester polymers, 1, 288 synthesis, 3, 811... 

Pyrrole-2,5-dicarboxylic acid, 3,4-dimethyl-diethyl ester bromination, 4, 271... 

Pyrrole-3,5-dicarboxylic acid, 1-aryl-2-hydroxy-diethyl ester synthesis, 4, 123... 

---