Diazonium, decomposition

The diazoamino-compounds are usually yellow in colour, and do not dissolve in acid they can usually be isolated and crystallized without decomposition. When treated with HNO2 two molecules of diazonium salt are formed. Form an azo compound when warmed with an amine and its hydrochloride, e.g. 

Diazonium compounds are usually very soluble in water, and cannot be readily isolated, since on warming their aqueous solutions, decomposition occurs with the formation of a phenol ... 

The solution of the aniline hydrochloride should be cooled to 5°C., and this temperature maintained throughout the addition of the sodium nitrite solution. External cooling has to be maintained, otherwise the heat of the reaction would cause the temperature to rise, with the consequent decomposition of the diazonium chloride and the production of phenol. If, on the other hand, the temperature is reduced to about o , diazotisation becomes extremely slow and unchanged nitrous acid may remain in the solution for an impracticably long time. 

Dissolve 15 ml. (15-4 g.) of aniline in a mixture of 40 ml. of concentrated hydrochloric acid and 40 ml. of water contained in a 250 ml. conical flask. Place a thermometer in the solution, immerse the flask in a mixture of ice and water, and cool until the temperature of the stirred solution reaches 5°. Dissolve I2 5 g. of powdered sodium nitrite in 30 ml. of water, and add this solution in small quantities (about 2-3 ml. at a time) to the cold aniline hydrochloride solution, meanwhile keeping the latter well stirred by means of a thermometer. Heat is evolved by the reaction, and therefore a short interval should be allowed between consecutive additions of the sodium nitrite, partly to allow the temperature to fall again to 5°, and partly to ensure that the nitrous acid formed reacts as completely as possible with the aniline. The temperature must not be allowed to rise above 10°, otherwise appreciable decomposition of the diazonium compound to phenol will occur on the other hand, the temperature... 

The diazonium hydrogen sulphate is used for this reaction in preference to the diazonium chloride since the latter by direct decomposition always forms small quantities of the chloro-hydrocarbon as a by-product ... 

When an aqueous solution of a diazonium salt is added to an alkaline solution of a phenol, coupling occurs with formation of an azo-compound (p. 188). If ho vc cr the ntiueous solution of the diazonium salt, t. . ., />-bromohenzene diazonium chloride, is mixed with an excess of an aromatic hydrocarbon, and aqueous sodium hydroxide then added to the vigorously stirred mixture, the diazotate which is formed, e.g., BrC,H N OH, dissolves in the hydrocarbon and there undergoes decomposition with the formation of nitrogen and two free radicals. The aryl free radical then reacts with the hydrocarbon to give a... 

Gattermann (1890) found that the preparation of the cuprous halide may be avoided by making use of the fact that finely-divided copper (e.g., freshly-precipitated or reduced by hydrogen or copper bronze) acts catal3d.ically in the decomposition of solutions of diazonium salts, for example ... 

The controlled thermal decomposition of dry aromatic diazonium fluoborates to yield an aromatic fluoride, boron trifluoride and nitrogen is known as the Schiemann reaction. Most diazonium fluoborates have definite decomposition temperatures and the rates of decomposition, with few exceptions, are easily controlled. Another procedure for preparing the diazonium fluoborate is to diazotise in the presence of the fluoborate ion. Fluoboric acid may be the only acid present, thus acting as acid and source of fluoborate ion. The insoluble fluoborate separates as it is formed side reactions, such as phenol formation and coupling, are held at a minimum temperature control is not usually critical and the temperature may rise to about 20° without ill effect efficient stirring is, however, necessary since a continuously thickening precipitate is formed as the reaction proceeds. The modified procedure is illustrated by the preparation of -fluoroanisole ... 

It may be mentioned that diazonium fluoborates containing the nitro group usually decompose suddenly and with violence upon heating, hence if o- or p-fluonitrobenzene are required, the fluoborates (in 10-20 g. quantities) should he mixed with 3-4 times their weight of pure dry sand (or barium sulphate or sodium fluoride) and heated cautiously until decomposition commences intermittent heating will be required to complete the reaction. 

Difluorodiphenyl. Bis-diazotise a solution of 46 g. of benzidine (Section IV,88) in 150 ml. of concentrated hydrochloric acid and 150 ml. of water by means of a solution of 35 g. of sodium nitrite in 60 ml. of water add about 200 g. of crushed ice during the process (compare p-Fbtorotoluene above). Filter the solution and add it to a filtered solution of 85 g. of sodium borofluoride in 150 ml. of water. Stir for several minutes, collect the precipitated bis-diazonium borofluoride by suction filtration, wash with 5 ml. of ice-cold water, and dry at 90-100°. Place the dry salt in a flask fitted with an air condenser, immerse the flask in an oil bath, and slowly raise the temperature to 150° (Fume Cupboard ). When decomposition of the salt is complete, steam distil the mixture collect the 4 4 difluoro-diphenyl which passes over and recrystallise it from ethanol. The yield is 21 g., m.p. 92-93°. 

Decomposition of diazonium salts obtained from 2-aminothiazole (4) (29, 34. 35) could be an interesting reaction to introduce O in A-4-thiazoline-2-one. Acidic hydrolvsis of ethers (36. 37). oxidative hydrolysis... 

Figure 22 5 shows what happens when a typical primary alkylamine reacts with nitrous acid Because nitrogen free products result from the formation and decomposition of diazonium ions these reactions are often referred to as deamination reactions Alkyl... 

Aromatic Ring Fluorination. The formation of an aryl diazonium fluoride salt, followed by decomposition, is a classical reaction (the Schiemaim reaction) for aryl fluoride preparation (21). This method has been adapted to the production-scale manufacture of fluorobenzene [462-06-6]... 

Fluoroaromatics are produced on an industrial scale by diazotization of substituted anilines with sodium nitrite or other nitrosating agents in anhydrous hydrogen fluoride, followed by in situ decomposition (fluorodediazoniation) of the aryldiazonium fluoride (21). The decomposition temperature depends on the stabiHty of the diazonium fluoride (22,23). A significant development was the addition of pyridine (24), tertiary amines (25), and ammonium fluoride (or bifluoride) (26,27) to permit higher decomposition temperatures (>50° C) under atmospheric pressure with minimum hydrogen fluoride loss. 

Analytical and Test Methods. o-Nitrotoluene can be analyzed for purity and isomer content by infrared spectroscopy with an accuracy of about 1%. -Nitrotoluene content can be estimated by the decomposition of the isomeric toluene diazonium chlorides because the ortho and meta isomers decompose more readily than the para isomer. A colorimetric method for determining the content of the various isomers is based on the color which forms when the mononitrotoluenes are dissolved in sulfuric acid (45). From the absorption of the sulfuric acid solution at 436 and 305 nm, the ortho and para isomer content can be deterrnined, and the meta isomer can be obtained by difference. However, this and other colorimetric methods are subject to possible interferences from other aromatic nitro compounds. A titrimetric method, based on the reduction of the nitro group with titanium(III) sulfate or chloride, can be used to determine mononitrotoluenes (32). Chromatographic methods, eg, gas chromatography or high pressure Hquid chromatography, are well suited for the deterrnination of mononitrotoluenes as well as its individual isomers. Freezing points are used commonly as indicators of purity of the various isomers. 

Nitroimidazoles and 2-azidoimidazoles are available via the diazonium fluoroborates, and photolytic decomposition of the fluoroborates gives 2-fluoroimidazoles (80AHC(27)24i). 

Owing to their particular interest two individual reactions will now be discussed separately. The reaction of methoxycarbonylhydrazine and 3-bromo-2,4-pentanedione affords, in addition to the expected pyrazole (608), a pyrazolium salt (609), the structure of which was established by X-ray crystallography (74TL1987). Aryldiazonium salts have been used instead of arylhydrazines in the synthesis of pyrazolines (610) and pyrazoles (611) (82JOC81). These compounds are formed by free radical decomposition of diazonium salts by titanium(n) chloride in the presence of a,/3-ethylenic ketones. 

Claisen condensation, 6, 156 reactions, S, 92 IsothiazoIe-3-carboxyIic acids decarboxylation, 6, 156 Isothiazole-4-carboxylic acids decarboxylation, 6, 156 Isothiazole-5-carboxylic acids decarboxylation, S, 92 6, 156 IR spectroscopy, 6, 142 Isothiazole-3-diazonium borofluoride decomposition, 6, 158 IsothiazoIe-4-diazonium chloride, 3-methyl-reactions with thiourea, 6, 158 Isothiazole-5-diazonium chloride, 4-bromo-3-methyl-halogen exchange, 6, 163 Isothiazole-5-diazonium chloride, 3-methyl-reactions... 

Two mechanisms are among those that have been postulated for decomposition of aryl diazonium salts in aqueous solution containing nucleophilic anions, A ... 

Phenyl cations are formed by thermal decomposition of aryl diazonium ions. The cation is so extremely reactive that under some circumstances it can recrqrture the nitrogen... 

Because a neutral molecule is eliminate4 rather than an anion, there is no electrostatic attraction (ion pairing) between the products of the dissociation step. As a result, the carbocations generated by diazonium-ion decomposition frequently exhibit somewhat different behavior from those generated from halides or sulfonates under solvolytic conditions. ... 

This reaction is commonly achieved by diazotization of the amine in fluoro-boric acid, followed by decomposition of the diazonium salt (Schiemann reaction).Thus, l-amino-4-methylestra-l,3,5(10)-trien-17-one (50) is converted to the fluoro derivative (51) in 29% yield. The synthesis of 3-fluoroestra-l,3,5(10)-triene-17-one (55) from estrone proceeds via (52) and (53)... 

Thermal decomposition of solid estrone 2- and 4- diazonium fluoro-borate salts leads to 2- and 4-fluoroestradiol. ... 

Trifluoromethyl-substituted diazonium betaines [176]. Synthetic routes to trifluoromethyl-substituted diazo alkanes, such as 2,2,2-trifluorodiazoethane [ 177, 7 78, 179] and alkyl 3,3,3-trifluoro-2-diazopropionates [24], have been developed Rhodium-catalyzed decomposition of 3,3,3-tnfluoro-2-diazopropionates offers a simple preparative route to highly reactive carbene complexes, which have an enormous synthetic potential [24] [3-1-2] Cycloaddition reactions were observed on reaction with nitnles to give 5-alkoxy-4-tnfluoromethyloxazoles [750] (equation 41)... 

On the laboratory scale, pure BF3 is best made by thermal decomposition of a diazonium tetrafluo-... 

AUcyl amines also react with NaN02 and aqueous acid, but no diazonium ions can be isolated. Rather, alcohols and alkenes are obtained, products that might result from decomposition of RN2 - If RN2 does indeed form in these reactions (and there is evidence that it may not), why is it so unstable compared to PhN2 ... 

Decomposition of the diazonium salt of 2-amino-iV-methyl-iV-3 -pyridylaniline (205) in aqueous acid solution with copper powder at room temperature gave overall yields of cyclized products consisting of a mixture of i id-iV-methyl-3-carboline (206) (47.5%) and ind-N-methyl-jS-carboUne (207) (25.5%), in agreement with the proposed homolytic character of the reaction under these conditions. This constituted the first unambiguous synthesis of a simple 3-carboline derivative. 

---