Condition factor

The optimal conditions for accelerating of investigated reaction by ions Fe(III) and Ag(I) ai e the following pH 5,0 (acetic buffer), Cj. . =l,6T0 M, CpMSA=4T0 M, Cpp =2-10 M. Under these conditions, factors of sensitivity for kinetic determination of metals mentioned above were established as a slope s tangent of the calibration curves that is a plot of reaction velocity (change of optical density of ferroin s solution for 4 minutes) versus analyte s concentration. Factors of sensitivity for determination of Mn(II), Fe(III), Ag(I), Pd(II), Co(II) ai-e 5,5-10" 1,1-10" 2,5-10" 2,0-10" 8,0-10", respectively. 

Soil Conditions/Factors Affecting Plant Growth... 

Whole animal Condition factor Cc N/A General fitness... 

Sorensen, E.M.B., P.M. Cumbie, T.L. Bauer, J.S. Bell, and C.W. Harlan. 1984. Histopathological, hematological, condition-factor, and organ weight changes associated with selenium accumulation in fish from Belews Lake, North Carolina. Arch. Environ. Contam. Toxicol. 13 153-162. 

Data for the development of design limits shall be obtained from a sound scientific program carried out in accordance with recognized technology for both the material and the intended service conditions. Factors to be considered include... 

In this case, a simple kinetic model could not be derived to explain all the experimental observations. Independently prepared hexadecyl trimethyl ammoniurn persulfate was found to be soluble in toluene/AN mixtures and to catalyze polymerization in this homogeneous system at approximately the same rate as that observed in the two phase system. This result implies that anion exchange at the interface (see below) must be essentially complete under these conditions. Factors which complicated further analysis of the mechanism included a) precipitation of poly(acrylonitri 1 e) during the polymerization ... 

Note When the pump is on the test stand and water is used as the test fluid, seal leakage does not necessarily indicate seal performance under the specified operating conditions. Factors such as test fluid, pressure, temperature, and system cleanliness have an appreciable effect on seal leakage. 

In general, when the cells of the endothelium in the lungs are the target cells of interest (see Chapters 7 and 9 on aspects of targeting drugs to endothelium in inflammatory diseases and cancer, respectively), systemic administration seems the route of choice. Bronchial epithelium on the other hand can more easily be reached via the pulmonary route. The accessibility of other cells in the lungs is most hkely governed by disease conditions, factors that can affect epithehal permeability and vascular permeability, and others as described earher. 

Operating costs are dependent on site conditions. Factors that impact cost include the amount of site preparation required, properties of the media to be treated (density, water content, etc.), volume of material to be processed, depth of processing, unit price of electricity, and season of the year. Costs can vary by 55 to 77/metric ton between treating dry soil and treating fully saturated soil. In such cases, predrying the soil may become cost effective (D136016, pp. 853-854). 

The final costs are highly dependent upon site-specific conditions. Factors contributing to the final cost include the waste characteristics, such as its physical form and chemical makeup the amount of pretreatment required transportation of raw materials to the site and treated materials from the site and other factors such as health and safety requirements and regulatory factors (D150141, p. 7.100). 

Condition factor CF General condition Nutritional status environmental pollutants Whole animal 17-30... 

Multivariate models have been successful in identifying source contributions in urban areas. They are not independent of Information on source composition since the chemical component associations they reveal must be verified by source emissions data. Linear regressions can produce the typical ratio of chemical components in a source but only under fairly restrictive conditions. Factor and principal components analysis require source composition vectors, though it is possible to refine these source composition estimates from the results of the analysis (6.17). 

All components must be present at the proper time and in adequate amounts. Plant resistance may result from disruption of the normal sequence of events or reduced presence of kairomones or enhancement of allomones ( ). This resistance is under genetic control but may vary with environmental conditions factors involved in ecological resistance have been reviewed (25). 

O Brien, Charles P., Anna R. Childress, and A. Thomas McLellan. 1991. "Conditioning Factors May Help to Understand and Prevent Relapse in Patients Who Are Recovering from Drug Dependence." National Institute on Drug Abuse Research Monograph Series 106 293-312. 

Shaham, Yavin. 1993. "Immobilization Stress-Induced Oral Opioid Self-Administration and Withdrawal in Rats Role of Conditioning Factors and the Effect of Stress on Relapse to Opioid Drugs." Psycfwpharmacotogy 111 477-85. 

---