Chromatography defined

Rf, Rg, Rf A measure of retention of solute in chromatography defined as the ratio of the distance travelled by the solute to the distance travelled by the mobile phase. 

What is H anyway The original interpretation, taken from distillation theory, was height equivalent to a theoretical plate, or HETP. We have seen that this concept was inadequate, and the preceding discussion of the van Deemter equation has presented it as a measure of the extent of spreading of an analyte zone as it passes through a column. Thus, a more appropriate term might be column dispersivity. In fact, another, independent approach to the theory of chromatography defines H as... 

This is a retention index derived from thin-layer and paper chromatography defined as [Bate-Smith and Westall, 1950]... 

The theory of chromatography defines k as the ratio of the mass of a sample component present in the stationary phase and mobile phase. Thus, k is proportional to the apparent thermodynamic equihbrium constant. 

Explain the ion-exchange process and how it differs from adsorption and chromatography define the molar selectivity coefficient. 

There are otlier teclmiques for mass separation such as tire quadmpole mass filter and Wien filter. Anotlier mass spectrometry teclmique is based on ion chromatography, which is also capable of measuring tire shapes of clusters [30, 31]. In tills metliod, cluster ions of a given mass are injected into a drift tube witli well-defined entrance and exit slits and filled witli an inert gas. The clusters drift tlirough tills tube under a weak electric potential. Since the... 

The goal of chromatography is to separate a sample into a series of chromatographic peaks, each representing a single component of the sample. Resolution is a quantitative measure of the degree of separation between two chromatographic peaks, A and B, and is defined as... 

In their original theoretical model of chromatography, Martin and Synge treated the chromatographic column as though it consists of discrete sections at which partitioning of the solute between the stationary and mobile phases occurs. They called each section a theoretical plate and defined column efficiency in terms of the number of theoretical plates, N, or the height of a theoretical plate, H where... 

Selectivity In chromatography, selectivity is defined as the ratio of the capacity factors for two solutes (equation 12.11). In capillary electrophoresis, the analogous expression for selectivity is... 

Large quantities of butane are shipped under contract standards rather than under national or worldwide specifications. Most of the petrochemical feedstock materials are sold at purity specifications of 95—99.5 mol %. Butane and butane—petroleum mixtures intended for fuel use are sold worldwide under specifications defined by the Gas Processors Association, and the specifications and test methods have been pubHshed (28). Butanes may be readily detected by gas chromatography. Butanes commonly are stored in caverns (29) or refrigerated tanks. 

Contaminant by-products depend upon process routes to the product, so maximum impurity specifications may vary, eg, for CHA produced by aniline hydrogenation versus that made by cyclohexanol amination. Capillary column chromatography has improved resolution and quantitation of contaminants beyond the more fliUy described packed column methods (61) used historically to define specification standards. Wet chemical titrimetry for water by Kad Eisher or amine number by acid titration have changed Httle except for thein automation. Colorimetric methods remain based on APHA standards. 

The most widely used method of analysis for methyl chloride is gas chromatography. A capillary column medium that does a very good job in separating most chlorinated hydrocarbons is methyl siUcone or methyl (5% phenyl) siUcone. The detector of choice is a flame ionisation detector. Typical molar response factors for the chlorinated methanes are methyl chloride, 2.05 methylene chloride, 2.2 chloroform, 2.8 carbon tetrachloride, 3.1, where methane is defined as having a molar response factor of 2.00. Most two-carbon chlorinated hydrocarbons have a molar response factor of about 1.0 on the same basis. 

The value of for calcium hydroxyapatite can be defined by charge of Ca + and PO ions. From this point of view calcium hydroxyapatite can be used as high-selective adsorbents for high performance liquid chromatography because with increasing of will be rise a selectivity coefficient a. 

The function (vm + Kvs) is termed the plate volume and so the flow through the column will be measured in plate volumes instead of milliliters. The plate volume is defined as that volume of mobile phase that can contain all the solute in the plate at the equilibrium concentration of the solute in the mobile phase. The meaning of plate volume must be understood, as it is an important concept and is extensively used in different aspects of chromatography theory. 

Many HPLC instruments are already furnished with temperature controls for the column. Unified chromatography requires a much wider temperature range than is currently practiced in HPLC. Until better defined by experience, a temperature range from about —60 to about 350°C seems reasonable as a specification. Since this is well in the range of a GC oven with subambient temperature capability, no new technology is required. 

This chapter will first cover the nature of electrophoretic separations, especially those concerning capillary electrophoresis. Comprehensive multidimensional separations will then be defined, specifically in terms of orthogonality and resolution. The history of planar and non-comprehensive electrodriven separations will then be discussed. True comprehensive multidimensional separations involving chromatography and capillary electrophoresis will be described next. Finally, the future directions of these multidimensional techniques will be outlined. 

---