Butanone from oxidation

Fig. 21. The variation with surface of the initial percentage yield of major products from the oxidation of n-pentane. Initial temperature = 290 °C initial pressure of n-pentane = 25 torr initial pressure of oxygen = 12.5 torr total pressure = 82 torr volume of reaction vessel = 500 cm. , pent-2-ene o, 2-methyltetrahydrofuran e, acetone , pent-l-ene e, butanone. (From ref. 106.)...

A similar strategy has been investigated by Barco et al. in their approach to the synthesis of piperidin-4-one derivatives 461 (Scheme 69). Starting from Merrifield-SH resin, Barco et al. prepared 4-benzylsulfonyl-l-triphenyl-phosphoranylidene-2-butanone 457 via addition of butanone/AcOH, oxidation of the sulfide to sulfone and selective bromination of the terminal methyl group. After reaction with aldehydes 458 to a. S-unsaturated ketones 459 a cyclization-elimination process occurs via addition of N-nucleophiles like benzylamine 460. 

Butane-Naphtha Catalytic Liquid-Phase Oxidation. Direct Hquid-phase oxidation ofbutane and/or naphtha [8030-30-6] was once the most favored worldwide route to acetic acid because of the low cost of these hydrocarbons. Butane [106-97-8] in the presence of metallic ions, eg, cobalt, chromium, or manganese, undergoes simple air oxidation in acetic acid solvent (48). The peroxidic intermediates are decomposed by high temperature, by mechanical agitation, and by action of the metallic catalysts, to form acetic acid and a comparatively small suite of other compounds (49). Ethyl acetate and butanone are produced, and the process can be altered to provide larger quantities of these valuable materials. Ethanol is thought to be an important intermediate (50) acetone forms through a minor pathway from isobutane present in the hydrocarbon feed. Formic acid, propionic acid, and minor quantities of butyric acid are also formed. 

Other Rea.ctlons, The anhydride of neopentanoic acid, neopentanoyl anhydride [1538-75-6] can be made by the reaction of neopentanoic acid with acetic anhydride (25). The reaction of neopentanoic acid with acetone using various catalysts, such as titanium dioxide (26) or 2irconium oxide (27), gives 3,3-dimethyl-2-butanone [75-97-8] commonly referred to as pinacolone. Other routes to pinacolone include the reaction of pivaloyl chloride [3282-30-2] with Grignard reagents (28) and the condensation of neopentanoic acid with acetic acid using a rare-earth oxide catalyst (29). Amides of neopentanoic acid can be prepared direcdy from the acid, from the acid chloride, or from esters, using primary or secondary amines. 

Methyl ethyl ketone MEK (2-butanone) is a colorless liquid similar to acetone, but its boiling point is higher (79.5°C). The production of MEK from n-butenes is a liquid-phase oxidation process similar to that used to... 

Starting from n-butane, 2-butoxides that rapidly convert to 2-butanone are found over MgCr204 [24]. However, the further oxidation of adsorbed 2-butanone only gives rise to the acetate species, while starting from n-butane, formate species are also observed. This can be explained assuming that sec-butoxides can partly isomerize to rert-butoxides before further oxidation. This implies that the C-O bond formed is partly ionic and the alkyl moiety has the... 

Since the reactants (R02 ketone) and the transition state have a polar character, they are solvated in a polar solvent. Hence polar solvents influence the rate constants of the chain propagation and termination reactions. This problem was studied for reactions of oxidized butanone-2 by Zaikov [81-86]. It was observed that kp slightly varies from one solvent to another. On the contrary, kt changes more than ten times from one solvent to another. The solvent influences the activation energy and pre-exponential factor of these two reactions (see Table 8.16). 

In reactions carried out for 24 h at room temperature, a 95% yield of cyclo-hexanol from cyclohexanone was obtained. Other ketones and aldehydes were also hydrogenated under identical conditions, but with slower rates (38% conversion for hydrogenation of 2-hexanone, 25% conversion of acetophenone, 45% for 3-methyl-2-butanone). Insertion of the C=0 bond of the ketone or aldehyde into the Cr-H bond was proposed as the first step, producing a chromium alk-oxide complex that reacts with acid to generate the alcohol product. The anionic chromium hydride [(COJsCrH]- is regenerated from the formate complex by... 

Because the direct electrochemical oxidation of NAD(P)H has to take place at an anode potential of + 900 mV vs NHE or more, only rather oxidation-stable substrates can be transformed without loss of selectivity—thus limiting the applicability of this method. The electron transfer between NADH and the anode may be accellerated by the use of a mediator. At the same time, electrode fouling which is often observed in the anodic oxidation of NADH can be prevented. Synthetic applications have been described for the oxidation of 2-hexene-l-ol and 2-butanol to 2-hexenal and 2-butanone catalyzed by yeast alcohol dehydrogenase (YADH) and the alcohol dehydrogenase from Thermoanaerobium brockii (TBADH) repectively with indirect electrochemical... 

Titanium enolates.1 This Fischer carbene converts epoxides into titanium enolates. In the case of cyclohexene oxide, the product is a titanium enolate of cyclohexanone. But the enolates formed by reaction with 1,2-epoxybutane (equation I) or 2,3-epoxy butane differ from those formed from 2-butanone (Equation II). Apparently the reaction with epoxides does not involve rearrangement to the ketone but complexation of the epoxide oxygen to the metal and transfer of hydrogen from the substrate to the methylene group. 

Photolytic. Major products reported from the photooxidation of butane with nitrogen oxides under atmospheric conditions were acetaldehyde, formaldehyde, and 2-butanone. Minor products included peroxyacyl nitrates and methyl, ethyl and propyl nitrates, carbon monoxide, and carbon dioxide. Biacetyl, tert-butyl nitrate, ethanol, and acetone were reported as trace products (Altshuller, 1983 Bufalini et al, 1971). The amount of sec-butyl nitrate formed was about twice that of n-butyl nitrate. 2-Butanone was the major photooxidation product with a yield of 37% (Evmorfopoulos and Glavas, 1998). Irradiation of butane in the presence of chlorine yielded carbon monoxide, carbon dioxide, hydroperoxides, peroxyacid, and other carbonyl compounds (Hanst and Gay, 1983). Nitrous acid vapor and butane in a smog chamber were irradiated with UV light. Major oxidation products identified included 2-butanone, acetaldehyde, and butanal. Minor products included peroxyacetyl nitrate, methyl nitrate, and unidentified compounds (Cox et al., 1981). 

Several products were also detected in base-degraded D-fructose solution acetoin (3-hydroxy-2-butanone 62), l-hydroxy-2-butanone, and 4-hydroxy-2-butanone. Three benzoquinones were found in the product mixture after sucrose had been heated at 110° in 5% NaOH these were 2-methylbenzoquinone, 2,3,5-trimethylbenzoquinone, and 2,5-dimethyl-benzoquinone (2,5-dimethyl-2,5-cyclohexadiene-l,4-dione 61). Compound 62 is of considerable interest, as 62 and butanedione (biacetyl 60) are involved in the formation of 61 and 2,5-dimethyl-l,4-benzenediol (63) by a reduction-oxidation pathway. This mechanism, shown in Scheme 10, will be discussed in a following section, as it has been proposed from results obtained from cellulose. 

A highly selective method for determination of lipid hydroperoxides is based on the oxidation of ferrocenecarboxylic acid (201) to the corresponding ferrocenium compound (202), as shown in equation 69, followed by amperometric reduction of this complex with a GCE set at —100 mV vs. SCSE, in phosphate buffer at pH 5.5. The method is insensitive to dissolved oxygen and no interference is observed, either from reductors such as ascorbic acid (22) or uric acid (29) nor from other hydroperoxides such as H2O2 and f-BuOOH at the 1 xM concentration level. At this concentration, a slight interference is observed for cumyl hydroperoxide (27) and 2-butanone peroxide (46 4- 47). The LOD... 

The Sharpless reagent, i.e. Ti(OPr-i)4/TBHP/diethyl tartrate, has been tested in the asymmetric BV oxidation of mono and bicyclic butanones . Conversions are low in all cases and ee values range from moderate to good. The best result has been obtained with the most bulky bicyclic ketone of the series, oxidized to the corresponding lactone with ee values up to 75%, using (+)-diethyl tartrate as ligand (equation 79). The use of a modified Sharpless reagent, based on Ti-TADDOL catalyst , increased the reaction rates, but decreased the enantiomeric excesses . ... 

The synthetically most useful method for the preparation of dioxiranes is the reaction of appropriate ketones (acetone, trill uoroacetone, 2-butanone, cyclohexanone etc.) with Caroate, commercially available as the triple salt of potassium monoperoxysul-fate (KHSOs). The catalytic cycle of the dioxirane formation and oxidation is shown in Scheme 1 in general form. For acetone as the ketone, by simple distillation at a slightly reduced pressure ca 100 torr) at room temperature ca 20 °C), Jeyaraman and Murray successfully isolated dimethyldioxirane (DMD) as a pale yellow solution in acetone (maximally ca 0.1 M). This pivotal achievement in 1985 fomented the subsequent intensive research activity in dioxirane chemistry, mainly the synthetic applications but also the mechanistic and theoretical aspects. The more reactive (up to a thousandfold ) fluorinated dioxirane, methyl(trifluoromethyl)dioxirane (TFD), was later isolated in a similar manner by Curd, Mello and coworkers". For dioxirane derived from less volatile ketones, e.g. cyclohexanone, the salting-out technique has been developed by Murray and coworkers to obtain the corresponding dioxirane solution. 

Since nicotine is the major precursor to NNN in tobacco and tobacco smoke, the reaction of nicotine with sodium nitrite was studied to provide information on formation of other tobacco specific nitrosamines, especially NNK and NNA, which could arise by oxidative cleavage of the l -2 bonds or l -5 bond of nicotine followed by nitrosation (26). The reaction was investigated under a variety of conditions as summarized in Table I. All three nitrosamines were formed when the reaction was done under relatively mild conditions (17 hrs, 20 ). The yields are typical of the formation of nitrosamines from tertiary amines (27). At 90 , with a five fold excess of nitrite, only NNN and NNK were detected. Under these conditions, both NNK and NNA gave secondary products. NNK was nitrosated a to the carbonyl to yield 4-(N-methyl-N-nitrosamino)-2-oximino-l-(3-pyridyl)-1-butanone while NNA underwent cyclization followed by oxidation, decarboxylation and dehydration to give l-methyl-5-(3-pyridyl)pyrazole, as shown in Figure 4. Extensive fragmentation and oxidation of the pyrrolidine ring was also observed under these conditions. The products of the reaction of nicotine and nitrite at 90 are summarized in Table II. 

Under the same reaction conditions, acetaldehyde and butyraldehyde displayed near-complete conversion (greater than 95%). The photocatalytic oxidation of the alcohol 1-butanol displayed similarly high conversion levels, although conversion of methanol was somewhat lower. The oxygenated compounds methyl-t-butyl ether (MTBE), methyl acrylate, 1,4 dioxane, and vinyl acetate displayed conversion levels ranging from 92% to 100%. The lowest conversion levels of the oxygenated compounds studied were seen with the ketones used [acetone and 2-butanone (methylethylketone)], which displayed conversions of approximately 80%. The initial conversion levels seen with -hexane were similar... 

An efficient general synthesis of a variety of 3(2i/)-furanones has been developed. Aldol condensation of aldehydes with the enolate derived from 3-methyl-3-(trimethylsiloxy)-2-butanone (183) followed by Collins oxidation afforded 1,3-diketones (184). Acid catalyzed cyclodehydration leads to the corresponding 3(2//)-furanones (185) (Scheme 43)... 

Mercury(II) oxide and acetic acid effect the cyclization of l,4-diaryloxybut-2-ynes to 4-aryloxymethylchromenes. The transformation was attributed to cyclization of the butanone which resulted from hydration of the alkyne (72JHC489). However, it has since been shown that similar butanones do not cyclize to chromenes under the cyclization conditions (78JOC3856). Instead, a mechanism is proposed which involves a charge-induced Claisen rearrangement which is triggered by 7r-complex formation between the metal ion... 

The 2-butanone oxime could be readily separated from the oximes arising by interaction of the nitric oxide with the initially formed radicals from the decomposition of the substrate. By this mixed-inhibitor technique, low concentrations of NO could be used, and the NO(4II)-photosensitization of the alkane could therefore be obviated. 

---