Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Blood anesthetic solubility

The concentration of an inhaled anesthetic in a mixture of gases is proportional to its partial pressure (or tension). These terms are often used interchangeably in discussing the various transfer processes involving anesthetic gases within the body. Achievement of a brain concentration of an inhaled anesthetic necessary to provide an adequate depth of anesthesia requires transfer of the anesthetic from the alveolar air to the blood and from the blood to the brain. The rate at which a therapeutic concentration of the anesthetic is achieved in the brain depends primarily on the solubility properties of the anesthetic, its concentration in the inspired air, the volume of pulmonary ventilation, the pulmonary blood flow, and the partial pressure gradient between arterial and mixed venous blood anesthetic concentrations. [Pg.539]

A highly flammable compound, ethylene forms dangerously explosive mixtures with air. It is phytotoxic (toxic to plants). Ethylene, itself, is not very toxic to animals, but it is a simple asphyxiant (see Section 13.3 and Table 13.1). At high concentrations, it acts as an anesthetic to induce unconsciousness. The only significant pathway of human exposure to ethylene is through inhalation. This exposure is limited by the low blood-gas solubility ratio of ethylene, which applies at levels below saturation of blood with the gas. This ratio for ethylene is only 0.14, compared, for example, with the very high value of 15 for chloroform.4... [Pg.295]

Desflurane is identical in structure to isoflurane, except that it is halogenated completely with fluorine instead of fluorine and chlorine. Desflurane is a volatile anesthetic that combines low blood gas solubility with moderate potency and high volatility. Its pharmacology has been reviewed (1,2). [Pg.1072]

Inhaled anesthetics with low blood gas solubility characteristically have a fast onset of action and a short duration of recovery. The new agent described here resembles nitrous oxide but is much more potent, as indicated by its low MAC value. Not all halogenated anesthetics undergo hepatic metabolism. The answer is (D). [Pg.236]

In other applications of CT, orally administered barium sulfate or a water-soluble iodinated CM is used to opacify the GI tract. Xenon, atomic number 54, exhibits similar x-ray absorption properties to those of iodine. It rapidly diffuses across the blood brain barrier after inhalation to saturate different tissues of brain as a function of its lipid solubility. In preliminary investigations (99), xenon gas inhalation prior to brain CT has provided useful information for evaluations of local cerebral blood flow and cerebral tissue abnormalities. Xenon exhibits an anesthetic effect at high concentrations but otherwise is free of physiological effects because of its nonreactive nature. [Pg.469]

The toxic effect depends both on lipid and blood solubility. I his will be illustrated with an example of anesthetic gases. The solubility of dinitrous oxide (N2O) in blood is very small therefore, it very quickly saturates in the blood, and its effect on the central nervous system is quick, but because N,0 is not highly lipid soluble, it does not cause deep anesthesia. Halothane and diethyl ether, in contrast, are very lipid soluble, and their solubility in the blood is also high. Thus, their saturation in the blood takes place slowly. For the same reason, the increase of tissue concentration is a slow process. On the other hand, the depression of the central nervous system may become deep, and may even cause death. During the elimination phase, the same processes occur in reverse order. N2O is rapidly eliminated whereas the elimination of halothane and diethyl ether is slow. In addition, only a small part of halothane and diethyl ether are eliminated via the lungs. They require first biotransformation and then elimination of the metabolites through the kidneys into the... [Pg.260]

The ability of the anesthetic agent to function is related to the partial pressure of the drug in the brain. Two major factors dictate the concentration of anesthetic agent in the neural tissue (1) the pressure gradients from lung alveoli to the brain (i.e., inhaled gas —> alveoli — bloodstream —> brain) and (2) the lipid solubility of the drug that enables it to pass between the blood-brain barrier to the central nervous system. [Pg.81]

The distribution of anesthetic throughout the entire body may be viewed as an equilibration process (Fig. 7.1.13), with tissues characterized by high blood flows reaching equilibration faster than muscle and fatJ4 Nevertheless, an anesthetic that is excessively soluble in blood will not partition substantially into brain and other tissues. The anesthetic properties of nitrous oxide and diethyl ether have been known since the 1840s. Zeneca Pharmaceuticals introduced the first modem inhalation anesthetic fluothane in 1957. Methoxyfluorane followed in 1960, enflurane 1973, isoflurane 1981, desflurane by Anaquest (Liberty Comer, NJ) in 1992, and sevoflurane by Abbott Laboratories in 1995J6 ... [Pg.81]

For gases and vapors, the amount absorbed is highly dependent on the partial pressure of the gas and the solubility of the gas in blood. Let s take the simple case of a gas that is not metabolized and is excreted by exhalation (e.g., an anesthetic gas or a Halon-type fire-extinguishing agent). At any given concentration (or partial pressure) in the atmosphere, the concentration in the blood will reach a steady state in the blood. Accordingly, prolonged exposure does not lead to continual buildup. [Pg.700]

Gases that do not react irreversibly with epithelial tissue, such as anesthetic gases, may diffuse into the bloodstream and will ultimately be eliminated from the body. A different and earlier model developed by DuBois and Rogers estimates the rate of uptake of inhaled gas from the tracheobronchial tree in terms of diffusion through the epithelial tissue, rate of blood flow, and solubility of the gas in blood. The rate of uptake from the airway lumen is determined by the equation ... [Pg.311]

The object of inhalation anesthetics is to obtain a concentration (partial pressure) of the drug in the brain sufficient to reach the desired level of anesthesia. In order to do this, anesthetic molecules must pass through the lungs into the brain through various biological phases. Therefore, inhalation anesthetics must be soluble in blood and interstitial tissue. [Pg.1]

The inhalational anesthetics have distinctly different solubility (affinity) characteristics in blood as well as in other tissues. These solubility differences are usually expressed as coefficients and indicate the number of volumes of a particular agent distributed in one phase, as compared with another, when the partial pressure is at equilibrium (Table 25.3). For example, isoflurane has a blood-to-gas partition coefficient (often referred to as the Ostwald solubility coefficient) of approximately 1.4. Thus, when the partial pressure has reached equilibrium, blood will contain 1.4 times as much isoflurane as an equal volume of alveolar air. The volume of the various anesthetics required to saturate blood is similar to that needed to saturate other body tissues (Table 25.3) that is, the blood-tissue partition coefficient is usually not more than 4 (that of adipose tissue is higher). [Pg.301]

Frequently it is desirable to overcome the slow rate of rise of alveolar tension associated with such factors as the high blood solubility of some anesthetics and increased pulmonary blood flow. Since both of these factors retard tension development by increasing the uptake of anesthetic, the most effective way to alleviate the problem is to accelerate the input of gas to the alveoli. A useful technique to increase the input of anesthetic to the lung is to elevate the minute alveolar ventilation. This maneuver, which causes a greater quantity of fresh anesthetic gas to be delivered to the patient per unit of time, is most effective with highly soluble agents (Fig. 25.4). [Pg.302]

Methoxyflurane (Penthmne) is the most potent inhala-tional agent available, but its high solubility in tissues limits its use as an induction anesthetic. Its pharmacological properties are similar to those of halothane with some notable exceptions. For example, since methoxyflurane does not depress cardiovascular reflexes, its direct myocardial depressant effect is partially offset by reflex tachycardia, so arterial blood pressure is better maintained. Also, the oxidative metabolism of methoxyflurane results in the production of oxalic acid and fluoride concentrations that approach the threshold of causing renal tubular dysfunction. Concern for nephrotoxicity has greatly restricted the use of methoxyflurane. [Pg.304]

Sevoflurane (Ultane) is the most recently introduced inhalation anesthetic. It has low tissue and blood solubility, which allows for rapid induction and emergence and makes it useful for outpatient and ambulatory procedures. It has the advantage of not being pungent, a characteristic that permits a smooth inhalation induction, and is particularly useful in pediatric anesthesia. [Pg.305]

One of the most important factors influencing the transfer of an anesthetic from the lungs to the arterial blood is its solubility characteristics (Table 25-2). The blood gas partition coefficient is a useful index of solubility and defines the relative affinity of an anesthetic for the blood compared with that of inspired gas. The partition coefficients for desflurane and nitrous oxide, which are relatively insoluble in blood, are extremely low. When an anesthetic with low blood solubility... [Pg.539]

Tensions of three anesthetic gases in arterial blood as a function of time after beginning inhalation. Nitrous oxide is relatively insoluble (blood gas partition coefficient = 0.47) methoxyflurane is much more soluble (coefficient = 12) and halothane is intermediate (2.3). [Pg.541]

The concentration of an inhaled anesthetic in the inspired gas mixture has direct effects on both the maximum tension that can be achieved in the alveoli and the rate of increase in its tension in arterial blood. Increases in the inspired anesthetic concentration increase the rate of induction of anesthesia by increasing the rate of transfer into the blood according to Fick s law (see Chapter 1). Advantage is taken of this effect in anesthetic practice with inhaled anesthetics that possess moderate blood solubility (eg, enflurane, isoflurane, and halothane). For example, a 1.5% concentration of isoflurane may be administered initially to increase the rate of rise in the brain concentration the inspired concentration is subsequently reduced to 0.75-1% when an adequate depth of anesthesia is achieved. In addition, these moderately soluble anesthetics are often administered in combination with a less soluble agent (eg, nitrous oxide) to reduce the time required for loss of consciousness and achievement of a surgical depth of anesthesia. [Pg.541]

During the induction phase of anesthesia (and the initial phase of the maintenance period), the tissues that exert greatest influence on the arteriovenous anesthetic concentration gradient are those that are highly perfused (eg, brain, heart, liver, kidneys, and splanchnic bed). These tissues receive over 75% of the resting cardiac output. In the case of volatile anesthetics with relatively high solubility in highly perfused tissues, venous blood concentration will initially be very low, and equilibrium with the arterial blood is achieved slowly. [Pg.542]

During maintenance of anesthesia with inhaled anesthetics, the drug continues to be transferred between various tissues at rates dependent on the solubility of the agent, the concentration gradient between the blood and the tissue, and the... [Pg.542]

Inhaled anesthetics that are relatively insoluble in blood (ie, possess low blood gas partition coefficients) and brain are eliminated at faster rates than the more soluble anesthetics. The washout of nitrous oxide, desflurane, and sevoflurane occurs at a rapid rate, leading to a more rapid recovery from their anesthetic effects compared with halothane and isoflurane. Halothane is approximately twice as soluble in brain tissue and five times more soluble in blood than nitrous oxide and desflurane its elimination therefore takes place more slowly, and recovery from halothane- and isoflurane-based anesthesia is predictably less rapid. [Pg.543]

The duration of exposure to the anesthetic can also have a significant effect on the recovery time, especially in the case of the more soluble anesthetics (eg, halothane and isoflurane). Accumulation of anesthetics in muscle, skin, and fat increases with prolonged exposure (especially in obese patients), and blood tension may decline slowly during recovery as the anesthetic is slowly eliminated from these tissues. Although recovery may be rapid even with the more soluble agents following a short period of exposure, recovery is slow after prolonged administration of halothane or isoflurane. [Pg.543]

Inhaled anesthetics decrease the metabolic rate of the brain. Nevertheless, the more soluble volatile agents increase cerebral blood flow because they decrease cerebral vascular resistance. The increase in cerebral blood flow is clinically undesirable in patients who have increased intracranial pressure because of a brain tumor or head injury. Volatile anesthetic-induced increases in cerebral blood flow increase cerebral blood volume and further increase intracranial pressure. [Pg.547]

Of the inhaled anesthetics, nitrous oxide is the least likely to increase cerebral blood flow. At low concentrations, all of the halogenated agents have similar effects on cerebral blood flow. However, at higher concentrations, the increase in cerebral blood flow is less with the less soluble agents such as desflurane and sevoflurane. If the patient is hyperventilated before the volatile agent is started, the increase in intracranial pressure can be minimized. [Pg.547]

The advantages of administration by intramuscular injection are that the muscle can act as a depot, and the rate of disappearance of drug from the site of injection can be calculated. Inhalational, intranasal, and intratracheal administration are normally reserved for vapors and aerosols including anesthetics. Absorption is facilitated by small-sized particles, high lipid solubility, sufficient pulmonary blood flow, and a large absorptive surface area, as it is present in healthy lungs. Administration by these routes can be very rapid when several of the factors favoring increased absorption are combined. [Pg.14]


See other pages where Blood anesthetic solubility is mentioned: [Pg.95]    [Pg.295]    [Pg.151]    [Pg.445]    [Pg.137]    [Pg.60]    [Pg.310]    [Pg.293]    [Pg.298]    [Pg.304]    [Pg.308]    [Pg.204]    [Pg.335]    [Pg.29]    [Pg.537]    [Pg.540]    [Pg.540]    [Pg.541]    [Pg.542]    [Pg.543]    [Pg.543]    [Pg.546]    [Pg.547]    [Pg.549]    [Pg.552]    [Pg.1263]   
See also in sourсe #XX -- [ Pg.111 , Pg.111 ]




SEARCH



Anesthetic

Anesthetics,blood

© 2024 chempedia.info