Alkaline hydrolysis effect

It is frequently advisable in the routine examination of an ester, and before any derivatives are considered, to determine the saponification equivalent of the ester. In order to ensure that complete hydrolysis takes place in a comparatively short time, the quantitative saponi fication is conducted with a standardised alcoholic solution of caustic alkali—preferably potassium hydroxide since the potassium salts of organic acids are usuaUy more soluble than the sodium salts. A knowledge of the b.p. and the saponification equivalent of the unknown ester would provide the basis for a fairly accurate approximation of the size of the ester molecule. It must, however, be borne in mind that certain structures may effect the values of the equivalent thus aliphatic halo genated esters may consume alkali because of hydrolysis of part of the halogen during the determination, nitro esters may be reduced by the alkaline hydrolysis medium, etc. 

Anionic and nonionic polyacrylamides effectively remove suspended soHds such as silt and clay from potable water. SuppHers provide special grades which meet EPA/FDA regulations for residual acrylamides. A recent pubHcation (102) states that hydrolyzed polyacrylamides with narrow interchain charge distributions provide better performance in flocculation of clay. These polymers were prepared by alkaline hydrolysis. (See Flocculating agents.)... 

Hydrolysis. The first effect of either acid hydrolysis or alkaline hydrolysis (saponification) is the removal of the fatty acids. The saponification value of commercial lecithin is 196. Further decomposition into glycerol, phosphoric acid, and head groups (ie, choline, ethanolamine, etc) may foUow prolonged heating. Lecithin may also be hydrolyzed by enzymes. 

Steric and inductive effects determine the rate of formation of the pentacovalent siUcon reaction complex. In alkaline hydrolysis, replacement of a hydrogen by alkyl groups, which have lower electronegativity and greater steric requirements, leads to slower hydrolysis rates. Replacement of alkyl groups with bulkier alkyl substituents has the same effect. Reaction rates decrease according to ... 

Manufacture. A limited, amount of natural cinnamyl alcohol is produced by the alkaline hydrolysis of the cinnamyl cinnamate present in Styrax Oil. Thus treatment of the essential oil with alcohoHc potassium hydroxide Hberates cinnamyl alcohol of reasonable purity which is then subjected to distillation. This product is sometimes preferred in fine fragrance perfumery because it contains trace impurities that have a rounding effect in finished formulations. 

Neutralization to terrninate processing was effected by the polymeric acid layer of the covet sheet the onset of this reaction was controlled by the rate of permeation of the overlying polymeric timing layers. MobiUty of the transferred dyes was also reduced by reaction with a mordant contained in the image-receiving layer. A development inhibitor released from one of the timing layers by the alkaline hydrolysis of its precursor assisted in restraining further development and consequent additional dye release. 

In the acidic and alkaline hydrolysis rates of the same ester, the steric and resonance effects. re the same. 

The polar effects are much greater in alkaline hydrolysis than in acid hydrolysis. 

The carbonyl group reactivities in thiophenes and benzenes are very similar, as shown by the similar rates of alkaline hydrolysis of esters and by the great similarity of the thiophenealdehydes to benzaldehyde in numerous carbonyl group reactions. This has been ascribed to the counteracting —I- -M effects of the thienyl group in this kind of reactions. ... 

In the manner outlined, a few attempts have been made to apply the Hammett equation to the transmission of substituent effects in the pyridine series. In the alkaline hydrolysis of 5-substituted ethyl picolinates (5-R-2-COOEt) in 85% ethanol at 25, 35, and 45°, the reaction constants are about 60% as large as those in the corresponding benzene series the overall fit to the Hammett equation, however, is at best fair, since out of four points (R = Et, H, I, Ac) one (Ac) deviates widely. 

Imoto and co-workers have also studied the pA values of substituted thiazolecarboxylic acids and the alkaline hydrolysis of their ethyl esters, each in three relative positions (2-B-4-Y, 2-B-5-Y, and 5-II-2-Y). In the case of the pA values, the p-values are far from constant, varying from 0.83 to 2,35, This variation is likely to be due to the intervention of tautomeric equilibria and of hydrogen bonds. The /3-ratios for the three sets of ester hydrolyses are roughly constant (0,61-0.73), and, assuming that the introduction of two heteroatoms leads to cumulative (multiplicative) effects on the transmission, this result is of the same order of magnitude as the product of the and values discussed above, i.e. 1.0 and 0.6, respectively. The lowest value for the pA (0,83) for the 2-R-5-COOH series is also of the same order of magnitude. All the available reaction constants are summarized in Table VI. 

The rate acceleration imposed by 0-cyclodextrin was explained in terms of a microsolvent effect 6> The inclusion of the substrate within the hydrophobic cavity of cyclodextrin simulates the changes in solvation which accompany the transfer of the substrate from water to an organic solvent. Uekama et al.109) have analyzed the substituent effect on the alkaline hydrolysis of 7-substituted coumarins (4) in the... 

An alternative method for generating enriched 1,2-diols from meso-epoxides consists of asymmetric copolymerization with carbon dioxide. Nozaki demonstrated that a zinc complex formed in situ from diethylzinc and diphenylprolinol catalyzed the copolymerization with cyclohexene oxide in high yield. Alkaline hydrolysis of the isotactic polymer then liberated the trans diol in 94% yield and 70% ee (Scheme 7.20) [40]. Coates later found that other zinc complexes such as 12 are also effective in forming isotactic polymers [41-42]. 

Yukawa and coworkers (1972)84 determined a0 values from the rate constants for alkaline hydrolysis of m- and p-substituted-benzyl benzoates in 70% (v/v) aqueous acetone at 25 °C. ap° values for SOMe and S02Me were found to be 0.573 and 0.749 respectively. These were compared with 0.564 and 0.721, respectively, for values determined from the rate constants of alkaline hydrolysis of substituted ethyl benzoates in 85% aqueous ethanol. From these values there is no evidence for any — R cross-conjugative effect of SOMe as a substituent in the benzoate moiety, which is eliminated when it is in the benzyl. However, both the values for SOMe are substantially higher than most of the ap values for SOMe which we have surveyed previously. For S02Me the order ap° > if significant,... 

An example will show the nature of electrical effects (resonance and field) on reactivity. In the alkaline hydrolysis of aromatic amides (10-11), the rate-determining step is the attack of hydroxide ion at the carbonyl carbon ... 

PETP flakes produced from used soft drinks bottles were subjected to alkaline hydrolysis in aqueous sodium hydroxide. A phase transfer catalyst (trioctylmethylammonium bromide) was used to enable the depolymerisation reaction to take place at room temperature and under mild conditions. The effects of temperature, alkali concentration, PETP particle size, PETP concentration and catalyst to PETP ratio on the reaction kinetics were studied. The disodium terephthalate produced was treated with sulphuric to give terephthalic acid of high purity. A simple theoretical model was developed to describe the hydrolysis rate. 17 refs. 

Amides, alkaline hydrolysis, 215 Anharmonic systems, direct evaluation of quantum time-correlation functions, 93 Apollo DSP—160, CHARMM performance, 129/ simulations, solvent effects, 83... 

A. Alkaline Hydrolysis. -The low kinetic isotope effect observed in the protonation of carbanions formed in phosphonium salt hydrolysis leads to the idea that there is little breaking of the phosphorus-carbon bond and correspondingly little transfer of a proton to the incipient carbanion in the transition state (87) of the rate-determining step. ... 

Rates of hydrolysis may be influenced by the presence of dissolved organic carbon, or organic components of soil and sediment. The magnitude of the effect is determined by the structure of the compound and by the kinetics of its association with these components. For example, whereas the neutral hydrolysis of chlorpyrifos was unaffected by sorption to sediments, the rate of alkaline hydrolysis was considerably slower (Macalady and Wolf 1985) humic acid also reduced the rate of alkaline hydrolysis of 1-octyl 2,4-dichlo-rophenoxyacetate (Perdue and Wolfe 1982). Conversely, sediment sorption had no effect on the neutral hydrolysis of 4-chlorostilbene oxide, although the rate below pH 5 where acid hydrolysis dominates was reduced (Metwally and Wolfe 1990). 

An effect similar to that of cetyltrimethylammonium bromide micelles can be realized through the use of microgels with trimethylamino side-chain function and this may then allow solid supported microgels to be used in a continuous reaction. Evans et al. (1995) have utilized microgels incorporating 2-tetradecyl dimethyl amino/ethyl methacrylate bromide, which solubilizes aryl laurate esters in an aquous solution and catalyses the alkaline hydrolysis. 

Hydrolysis may be effected with 10-20 per cent, sodium hydroxide solution (see TolunitrUe and Benzonitrile in Section IV,66) or with 10 per cent, methyl alcoholic sodium hydroxide. For difficult cases, e.g., OL-Naphthonitrile (Section IV.163), a mixture of 50 per cent, sulphuric acid and glacial acetic acid may be used. In alkaline hydrolysis the boiling is continued until no more ammonia is evolved. In acid hydrolysis 2-3 hours boiling is usually sufficient the reaction product is poured into water, and the organic acid is separated from any unchanged nitrile or from amide by means of sodium carbonate solution. The resulting acid is identified as detailed in Section IV,175. 

Cationic accelerants vary in their efficacy [161]. Other types of accelerant have also been evaluated. In one study [162], comparisons were made between tetra-ethylammonium bromide, benzyltriethylammonium chloride, polyfdiallyldimethylammonium chloride) and the diethyldimethylammonium derivative of a benzenesulphonate polyglycol ester. It was found that the cationic polymers had a greater effect than the simple quaternary ammonium compounds of lower molecular mass. This effect was attributed to the capability of the polymers to enter into hydrophobic interaction with the fibre surface. Ethylenediamine has also been found to accelerate the alkaline hydrolysis of polyester [163]. 

Alkaline hydrolysis in a solvent (dimethylformamide, dimethylsulphoxide or dimethyl-acetamide) containing sodium hydroxide has been investigated [164]- Fabric geometry [165] and the degree of heat setting of the polyester also influence the results. As the temperature of heat setting was increased, the accelerating effect of dodecylbenzyldimethylammonium chloride decreased [166]. Basic-dyeable polyester is particularly sensitive to alkaline hydrolysis [167]. In some cases, saponification has been used to produce special effects such as a leather-like finish [168]. 

As a simple model for the enzyme penicillinase, Tutt and Schwartz (1970, 1971) investigated the effect of cycloheptaamylose on the hydrolysis of a series of penicillins. As illustrated in Scheme III, the alkaline hydrolysis of penicillins is first-order in both substrate and hydroxide ion and proceeds with cleavage of the /3-lactam ring to produce penicilloic acid. In the presence of an excess of cycloheptaamylose, the rate of disappearance of penicillin follows saturation kinetics as the cycloheptaamylose concentration is varied. By analogy to the hydrolysis of the phenyl acetates, this saturation behavior may be explained by inclusion of the penicillin side chain (the R group) within the cycloheptaamylose cavity prior to nucleophilic attack by a cycloheptaamylose alkoxide ion at the /3-lactam carbonyl. The presence of a covalent intermediate on the reaction pathway, although not isolated, was implicated by the observation that the rate of disappearance of penicillin is always greater than the rate of appearance of free penicilloic acid. 

---